• 해양환경안전학회지
• /
• 제30권2호
• /
• pp.165-175
• /
• 2024

수소는 기후변화 위기에 대응하기 위한 에너지원 중 하나로 주목받고 있다. 그러나, 수소는 밀폐된 공간에 누출되면 천장으로 상승하여 축적되고, 점화원과 만나면 화재나 폭발의 위험이 있다. 특히, 수소를 운송하거나 연료로 사용하는 선박은 여러 밀폐된 공간으로 구성되어 있기 때문에 수소를 안전하게 사용하기 위해서는 공간 내에서의 확산 특성을 파악해야 한다. 본 연구는 선박 내 밀폐된 공간에서 수소와 유사한 특성을 가진 헬륨의 누출방향에 따른 확산 특성을 실험적으로 파악하고, CFD 시뮬레이션을 통해 환기횟수가 25, 30, 35, 40, 45ACH로 증가함에 따라 누출방향에 따른 산소농도 변화를 파악하는 것이 목적이다. 연구 결과, 산소농도감소율은 -z 방향의 누출이 2%, +x와 +z 방향의 누출이 1%였으며, 환기소요시간은 -z 방향 누출이 15분 30초, +x 방향 누출이 7분, +z 방향 누출이 9분으로 누출방향에 따라 산소농도와 환기소요시간에 차이가 있음을 보여준다. 또한, 실험공간에서 환기횟수 35ACH 이상부터는 모든 누출 방향에서의 산소농도감소율과 환기소요시간에 유의미한 차이가 없었다. 따라서, 환기횟수를 증가하여도 산소농도와 환기소요시간이 개선되지 않았기 때문에 본 실험환경에서의 적정 환기횟수는 35ACH임을 알 수 있었다.

• Journal of the Korean Wood Science and Technology
• /
• 제45권6호
• /
• pp.828-835
• /
• 2017

Airtightness of buildings is one of critical aspects of its energy performance. To build up references of airtightness of wooden houses built in Korea, blower door tests have been carried out in 42 houses since 2006. Causes of air leakage were investigated recently. The average value of air change rate was $3.7h^{-1}$ for light frame house and $5.5h^{-1}$ for post-beam construction at ACH50 (air change per hour at 50 Pa air pressure difference). Foam type insulation was more advantageous in ensuring building airtightness than glass fiber batt. Airtightness of wooden houses which were constructed after 2010 was improved to have less than $1.5h^{-1}$ of ACH50, threshold for application of artificial air change. The average air change rate of CLT (cross laminated timber) houses showed the lowest value, $1.1h^{-1}$, among the tested structures.

• 설비공학논문집
• /
• 제27권12호
• /
• pp.633-638
• /
• 2015

This study evaluates the capacity of night purging in office buildings to reduce the cooling load. RTS-SAREK is used to estimate the performance of night purging on the steady state. To overcome steady state RTS program limitations, we added unsteady heat transfer equations. When the ACH (Air Change per Hour) increases, the wall temperature decreases in both the steady and unsteady states. The unsteady heat transfer rate is different from the steady transfer rate, which validates the unsteady calculation. When ACH is low, the heat transfer rate increases continuously with time. When ACH becomes higher, the heat transfer rate increases and decreases with time. When ACH is quite high, there exists a large difference in the heat transfer rate between the steady and unsteady calculations, which emphasizes the importance of the unsteady calculation.

• 한국환경보건학회지
• /
• 제29권3호
• /
• pp.43-49
• /
• 2003

ETS concentrations in the PC game rooms and factors affecting ETS concentrations were measured. Nicotine, 3-EP, respirable dust and UVPM were used as tracers for ETS. ETS concentrations are 2-3 times higher than those of other results. The concentration of ETS at the commercial district was higher than that of the residential district. The correlations between these tracers and SD/ ACH, a factor affecting to ETS concentration, were calculated. The correlation between 3-ethenylpyridine among tracers and SD/ACH was highest. The correlation between respirable dust and SD/ ACH was lowest. It was difficult to recommend respirable dust as a tracer of ETS.

• 한국환경과학회지
• /
• 제23권2호
• /
• pp.207-218
• /
• 2014

A ventilation model was developed for predicting the air change per hour(ACH) in buildings and the airflow rates between zones of a multi-room building. In this model, the important parameters used in the calculation of airflow are wind velocity, wind direction, terrain effect, shielding effect by surrounding buildings, the effect of the window type and insect screening, etc. Also, the resulting set of mass balance equations required for the process of calculation of airflow rates are solved using a Conte-De Boor method. When this model was applied to the building which had been tested by Chandra et al.(1983), the comparison of predicted results by this study with measured results by Chandra et al. indicated that their variations were within -10%~+12%. Also, this model was applied to a building with five zones. As a result, when the wind velocity and direction did not change, terrain characteristics influenced the largest and window types influenced the least on building ventilation among terrain characteristics, local shieldings, and window types. Except for easterly and westerly winds, the ACH increased depending on wind velocity. The wind direction had influence on the airflow rates and directions through openings in building. Thus, this model can be available for predicting the airflow rates within buildings, and the results of this study can be useful for the quantification of airflow that is essential to the research of indoor air quality(temperature, humidity, or contaminant concentration) as well as to the design of building with high energy efficiency.

• Journal of Advanced Marine Engineering and Technology
• /
• 제29권7호
• /
• pp.736-743
• /
• 2005

In this study, three different types of mechanical ventilation systems are compared based on their ventilation characteristics: tracer gas concentration decay characteristics, and ventilation effectiveness by calculating actual ventilation air flow rate. The experiments are performed by using a step-down method for measuring tracer gas. $CO_{2}$ gas, concentration in the model chamber. Application of a mixing factor, k, was used and measured values ranged from 0.68 to 0.77. The Type 2 ventilation system was found to have the highest ventilation effectiveness rather than the Types 1 and 3.

• KIEAE Journal
• /
• 제13권3호
• /
• pp.79-89
• /
• 2013

The purpose of this study is to evaluate the airtightness performance of New Han-ok and to supply fundamental data for standards establishment. Air leakage testings were accomplished by means of blower door test in 26 bedrooms of 16 Han-oks located in Jeonnam happy villages. Followings are results. 1) Air change per hour at 50 Pa(ACH50) is located on 8.42~78.38. 2) No correlation between ACH50 and volumes, floor area, above grade surface area. 3) The more wood structural elements are exposed, attached spaces, wooden sliding and casement windows, the less airtightness performance. 4) An Airtightness with ACH50/20(NL, Normalized leakage) is located on 0.42~3.92 and building leakage class following F(4%), G(11%, sufficiently leaky, No need mechanical ventilation), H(4%, Need of cost-effective tightening), I(31%), J(50%) by a single-story house the normalized leakage of ASHRAE.

• 한국환경보건학회지
• /
• 제46권3호
• /
• pp.344-352
• /
• 2020

Objectives: Much attention has been paid to indoor air quality. Ventilation within schools is important because of indoor air quality and its effect on health and learning performance. In this study, we evaluated the carbon dioxide (CO₂) concentrations and ventilation rates in schools. Methods: This study measured the concentration of CO₂ in elementary, middle, and high school classrooms over six months. The seasons during the study were summer, fall, and winter. Sensor-based monitoring was used and the basic characteristics of the classroom were investigated. The body surface area of the students was used to calculate the CO₂ generation rate, and the air change per hour (ACH) was evaluated using mass balance modeling. Results: The average CO₂ concentration measured in most schools exceeded 1000 ppm. The ventilation rates varied from season to season. Compared to the recommended ventilation rate of 4.9 ACH, the roughly 3 ACH calculated in this study indicates that most schools possessed insufficient ventilation. Conclusions: The concentration of CO₂ in school classrooms could be an indicator of indoor air quality and can affect students' learning ability. In this study, CO₂ concentrations exceeding the standard indicate a lack of ventilation along with problems with indoor air quality. Therefore, appropriate improvements are needed to overcome these problems.

• 설비공학논문집
• /
• 제27권9호
• /
• pp.449-454
• /
• 2015

In this study, the effects of lock operations on the infiltration rates for the two window types sliding and lift sliding (LS) are investigated through experiment and simulation. The airtightness levels of the two window types-with locks both on and off-were measured according to the KS F 2292 Test method of airtightness that is used for windows and doors. The air-flow rates of both window types with the locks on for a pressure differential of 10 Pa are $1.98m^3/(m^2h)$ and $1.68m^3/(m^2h)$, respectively; with the locks off, the air-flow rates of the sliding and LS windows are $2.64m^3/(m^2h)$ and $5.83m^3/(m^2h)$, respectively, whereby the air-flow rates are 33% higher for sliding and 247% higher for LS. The air change per hour (ACH) was calculated using the ventilation-simulation software CONTAM. For the sliding window, the ACH changed from 0.45 to 0.57 when the lock was operated from on to off, representing an increase of 27%. For the LS window, the ACH changed from 0.29 to 0.81, showing an increase of 179%.

• 의료ㆍ복지 건축 : 한국의료복지건축학회 논문집
• /
• 제20권1호
• /
• pp.7-14
• /
• 2014

Purpose: In this study, we performed ventilation simulations for a standard isolation ward including three intensive care rooms, one anteroom(buffer room), and its recommended ventilation equipments. The purpose of this study is to predict outflow of pathogenic bacteria from patient breath to verify the reliability and the safety of the isolation ward. Methods: We suppose three scenarios of the movement of medical staff. The leakage of patient's breath to out of the ward is predicted in these scenarios using CFD simulations. Results: The patient's breath leakage rate to out of the ward in scenario 1 according to room air changes per hour(ACH : 6 and 12) is predicted to be 0.000057% and 0.00002%, respectively. The patient's breath leakage rate to out of the ward in scenario 2 according to room air changes(ACH : 6 and 12) is predicted to be 0.00063% and 0.00019%, respectively. The patient's breath leakage rate to out of the ward in scenario 3, which is the worst case(6 room air changes) is predicted to be 0.1%. Implications: Through the ventilation simulation like that in this study, the reliability and the safety on isolation performance of various plan of isolation ward are predicted quantitatively.