• Journal of Astronomy and Space Sciences
• /
• v.25 no.2
• /
• pp.227-238
• /
• 2008

GNSS (Global Navigation Satellite System) Ground Station monitors navigation satellite signal, analyzes navigation result, and uploads correction information to satellite. GNSS Ground Station is considered as a main object for constructing GNSS infra-structure and applied in various fields. ETRI (Electronics and Telecommunications Research Institute) is developing Monitoring and Control subsystem, which is subsystem of GNSS Ground Station. Monitoring and Control subsystem acquires GPS and Galileo satellite signal and provides signal monitoring data to GNSS control center. In this paper, the configurations of GNSS Ground Station and Monitoring and Control subsystem are introduced and the preliminary design of Monitoring and Control subsystem is performed. Monitoring and Control subsystem consists of data acquisition module, data formatting and archiving module, data error correction module, navigation solution determination module, independent quality monitoring module, and system operation and maintenance module. The design process uses UML (Unified Modeling Language) method which is a standard for developing software and consists of use-case modeling, domain design, software structure design, and user interface structure design. The preliminary design of Monitoring and Control subsystem enhances operation capability of GNSS Ground Station and is used as basic material for detail design of Monitoring and Control subsystem.

• Journal of the Korean Society of Radiology
• /
• v.5 no.5
• /
• pp.283-287
• /
• 2011

In this study, fine $Gd_2O_2S$:Tb powder was synthesized by using a low temperature solution-combustion method for a high-resolution digital x-ray imaging detector. From the fabricated phosphor power, the fine scintillator films was fabricated by particle sedimentation method and was investigated the luminescent property. From the experimental results of relative light output as a function of terbium concentration, the highest luminescent efficiency has at 5 wt% Tb concentration, and luminescent intensity decreased rapidly according to quenching effect about higher Tb concentration. Also, the relative light output of $270{\mu}m$-$Gd_2O_2S$:Tb film has 2945 pC/$cm^2$/mR. And light intensity was saturated at higher film thickness. Finally, to evaluate an image acquisition performance of fabricated phosphor, images were obtained by using commercial CMOS sensor and measured the MTF, NPS, and DQE. DQE(0 lp/mm) of fine phosphor film has 37%. But, DQE improvement of fine phosphor film is possible by resolving problem of film fabrication process and has a significant potential in the application of digital radiation imaging system later.

• Management & Information Systems Review
• /
• v.30 no.2
• /
• pp.81-111
• /
• 2011

Relationship Marketing has been dealt with as an effective strategy to sustain customer loyalty in many previous researches. For relationship development, a customer's efforts are necessary as well as an organization's efforts. However, the role of customers for the development of the relationship with an organization has been dealt in few previous researches so far. Furthermore, whereas researchers understand the importance of consumers' motivation in the relationship, few researchers had paid attention. This research is based on the Self-Determination Theory (SDT) to explain the role of customer motivation in the process of relationship development and performance. We started by using SDT to confirm the psychological side of relationship development in customer aspects. Then, this paper verified the relationships among environmental factors(informative communication, perceived personalization), relationship motivation(identified motivation, internal motivation) and relational factors(affective commitment, relationship strength). It suggested that customer's roles in psychological parts be inevitable in developing the relationship and it acquired by such stimulations from service providers. In conclusion, this paper has several marketing implications on customer acquisition and retention. For service providers, they should recognize the fact that a customer's perception of self-determination factors can generate tangible and intangible performance in relationship development.

• Journal of Astronomy and Space Sciences
• /
• v.28 no.4
• /
• pp.319-332
• /
• 2011

The objectives of this study are to analyze the satellite visibility at the randomly established ground sites, to determine the five optimal ground sites to perform the optical surveillance and tracking of domestic satellites, and to verify the acquisition of the optical observation time sufficient to maintain the precise ephemeris at optimal ground sites that have been already determined. In order to accomplish these objectives, we analyzed the visibility for sun-synchronous orbit satellites, low earth orbit satellites, middle earth orbit satellites and domestic satellites as well as the continuous visibility along with the fictitious satellite ground track, and calculate the effective visibility. For the analysis, we carried out a series of repetitive process using the satellite tool kit simulation software developed by Analytical Graphics Incorporated. The lighting states of the penumbra and direct sun were set as the key constraints of the optical observation. The minimum of the observation satellite elevation angle was set to be 20 degree, whereas the maximum of the sun elevation angle was set to be -10 degree which is within the range of the nautical twilight. To select the candidates for the optimal optical observation, the entire globe was divided into 84 sectors in a constant interval, the visibility characteristics of the individual sectors were analyzed, and 17 ground sites were arbitrarily selected and analyzed further. Finally, five optimal ground sites (Khurel Togoot Observatory, Assy-Turgen Observatory, Tubitak National Observatory, Bisdee Tier Optical Astronomy Observatory, and South Africa Astronomical Observatory) were determined. The total observation period was decided as one year. To examine the seasonal variation, the simulation was performed for the period of three days or less with respect to spring, summer, fall and winter. In conclusion, we decided the optimal ground sites to perform the optical surveillance and tracking of domestic satellites and verified that optical observation time sufficient to maintain the precise ephemeris could be acquired at the determined observatories.

• Korean Journal of Construction Engineering and Management
• /
• v.21 no.6
• /
• pp.103-112
• /
• 2020

In this study, based on actual project implementation cases, task management plans for construction management related green building certification were derived in major stages. Accordingly, the importance from details of construction management tasks for the operation and management process of the schematic design phase, design development phase, and construction document phase, focusing on G-SEED certification, was analyzed. In addition, major items were derived based on the weight of additional construction costs and acquisition scores through previous research cases on the analysis of construction costs for G-SEED certification, and the importance from details of construction management tasks on the major items of G-SEED certification was analyzed. As a result, the review and confirmation of the elements of reflection related to G-SEED in the schematic design phase, the adequacy of design documents and the connectivity of design phase in the design development phase were important. And the review and confirmation of the items directly related to the construction phase in the construction document phase were important.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.47 no.6
• /
• pp.19-27
• /
• 2010

This paper proposes a method for enhancing detection performance and reducing computational cost when detecting a human face by applying B-spline active contour to the frame difference of consecutive images. Firstly, the method estimates amount of user's motion using kurtosis. If the kurtosis is smaller than a pre-defined threshold, it is considered that the amount of user's motion is insufficient and thus the contour fitting is not applied. Otherwise, the contour fitting is applied by exploiting the fact that the amount of motion is sufficient. Secondly, for the contour fitting, difference edges are detected by combining the distance transformation of the binarized frame difference and the edges of current frame. Lastly, the face is located by assigning the contour fitting process to the detected difference edges. Kurtosis-based motion amount estimation can reduce a computational cost and stabilize the results of the contour fitting. In addition, distance transformation-based difference edge detection can enhance the problems of contour lag and discontinuous difference edges. Experimental results confirm that the proposed method can reduce the face localization error caused by the contour lag and discontinuity of edges, and decrease the computational cost by omitting approximately 39% of the contour fitting.

• Communications of Mathematical Education
• /
• v.30 no.2
• /
• pp.161-178
• /
• 2016

Mathematics problem based learning(PBL), which has recently attracted much attention, is a teaching and learning method to increase mathematical ability and help learning mathematical concepts and principles through problem solving using students' mathematical prerequisite knowledge. In spite of such a quite attention, it is not easy to apply and practice PBL actually in school mathematics. Furthermore, the recent instructional situations or environments has focused on student's self construction of their learning and its process. Because of this reason, to whom is related to mathematics education including math teachers, investigation and recognition on the degree of students' acquisition of mathematical thinking skills and strategies(for example, inductive and deductive thinking, critical thinking, creative thinking) is an very important work. Thus, developing mathematical thinking skills is one of the most important goals of school mathematics. In particular, recently, connection or integration of one subject and the other subject in school is emphasized, and then mathematics might be one of the most important subjects to have a significant role to connect or integrate with other subjects. While considering the reason is that the ultimate goal of mathematics education is to pursue an enhancement of mathematical thinking ability through the enhancement of problem solving ability, this study aimed to implement basically what is the meaning of the integrated thinking ability in problem based learning theory in Mathematics. In addition, using historical materials, this study was to develop mathematical materials and a sample of a concrete instructional guideline for enhancing integrated thinking ability in problem based learning program.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.37 no.6
• /
• pp.545-554
• /
• 2019

This research aims to provide a building area extraction approach over the areas where data acquisition is impossible through field surveying, aerial photography and lidar scanning. Hence, high-resolution satellite images, which have high accessibility over the earth, are utilized for the automated building extraction in this study. 3D point clouds or DSM (Digital Surface Models), derived from the stereo image matching process, provides low quality of building area extraction due to their high level of noises and holes. In this regards, this research proposes a hybrid building area extraction approach which utilizes 3D point clouds (from image matching), and color and linear information (from imagery). First of all, ground and non-ground points are separated from 3D point clouds; then, the initial building hypothesis is extracted from the non-ground points. Secondly, color based building hypothesis is produced by considering the overlapping between the initial building hypothesis and the color segmentation result. Afterwards, line detection and space partitioning results are utilized to acquire the final building areas. The proposed approach shows 98.44% of correctness, 95.05% of completeness, and 1.05m of positional accuracy. Moreover, we see the possibility that the irregular shapes of building areas can be extracted through the proposed approach.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.37 no.6
• /
• pp.481-489
• /
• 2019

Change detection, one of the main applications of multi-temporal satellite images, is an indicator that directly reflects changes in human activity. Change detection can be divided into pixel-based change detection and object-based change detection. Although pixel-based change detection is traditional method which is mostly used because of its simple algorithms and relatively easy quantitative analysis, applying this method in VHR (Very High Resolution) images cause misdetection or noise. Because of this, pixel-based change detection is less utilized in VHR images. In addition, the sensor of acquisition or geographical characteristics bring registration noise even if co-registration is conducted. Registration noise is a barrier that reduces accuracy when extracting spatial information for utilizing VHR images. In this study object-based change detection of VHR images was performed considering registration noise. In this case, object-based change detection results were derived considering various pixel-based change detection methods, and the major voting technique was applied in the process with segmentation image. The final object-based change detection result applied by the proposed method was compared its performance with other results through reference data.

• Journal of the Korean Magnetic Resonance Society
• /
• v.4 no.1
• /
• pp.19-28
• /
• 2000

Authors evaluated alterations of observable metabolite ratios between the cerebral lesion and the contralateral region related to the clinical symptomatic side in levodopa-treated Parkinson's disease (PD) and investigated correlation between age in patients with PD and metabolite ratios of the lesion. Patients with levodopa-treated PD (n = 54) and age-matched normal controls (n = 15) underwent magnetic resonance spectroscopy (MRS) examinations using a stimulated echo acquisition mode (STEAM) pulse sequence that provided 2$\times$2$\times$2 cm3 volume of interest in the selected regions of substantia nigra (SN) and putamed-globus pallidus (PG). To evaluate dependence of metabolite ratios on age, we divided into two groups (i.e., younger and older age). We quantitatively measured N-acetylaspartate (NAA), creatine (Cr), choline-containing compounds (Cho), inositols (Ins), and the sum of glutamate (Glx) and GABA levels and obtained proton metabolite ratios relative to Cr using a Marquart algorithm. Compared with the contralateral region, a significant neuronal laterality of the NAA/Cr ratio in the lesion of SN related to the clinical symptomatic side was established (P = 0.01), but was not established in the lesion of PG (P = 0.24). Also, Cho/Cr ratio tended toward significance in the lesion of SN (P = 0.07) and was statistically significant in the lesion of PG(P = 0.01). Compared with that in the younger age group, NAA/Cr ratio in the older age was decreased in the lesion of SN (P = 0.02), while NAA/Cr ratio was not statistically significant in the lesion of PG ( P = 0.21). Significant metabolic alterations of NAA/Cr and Cho/Cr ratios might be closely related with functional changes of neuropathological process in SN and PG of levodopa treated PD and could be a valuable finding for evaluation of the PD. A trend of NAA/Cr reduction, being statistically significant in older patients, could be indicative of more pronounced neuronal damage in the SN of the progressive PD.