• 제어로봇시스템학회논문지
• /
• 제12권9호
• /
• pp.856-860
• /
• 2006

A CCD camera is used to determine the position of the point sources that influence the measurement accuracy in the absolute interferometer. The principle of determination method is based on the GPS in which the position is determined by more than 3 distance information from the known positions. Two-dimensional array of photo-detectors in the CCD camera is used as known positions. Performing optimization of the cost function constructed with phase values measured at each pixel on the CCD camera, the position coordinates of each source is precisely determined.

• 대한화학회지
• /
• 제57권3호
• /
• pp.370-376
• /
• 2013

A back propagation artificial neural network model with one hidden layer is established to correlate the liquid-liquid equilibrium data of hydrocarbon-water systems. The model has four inputs and two outputs. The network is systematically trained with 48 data points in the range of 283.15 to 405.37K. Statistical analyses show that the optimised neural network model can yield excellent agreement with experimental data(the average absolute deviations equal to 0.037% and 0.0012% for the correlated mole fractions of hydrocarbon in two coexisting liquid phases respectively). The comparison in terms of average absolute deviation between the correlated mole fractions for each binary system and literature results indicates that the artificial neural network model gives far better results. This study also shows that artificial neural network model could be developed for the phase equilibria for a family of hydrocarbon-water binaries.

• 대한핵의학회지
• /
• 제1권2호
• /
• pp.75-84
• /
• 1967

$^{131}I$-labeled-O-iodohippurate renograms in 15 cases of epidemic hemorrhagic fever(E.H. fever)during oliguric, diuretic and convalescent phase were analysed quantitatively and qualitatively, namely by its configuration, Tmax T 1/2 and renal index of Hirakawa. The results were as following: 1) Changes on the renograms in E.H. fever showed simultaneous bilateral renal impairment. 2) The characteristic configurations of renogram in the oliguric phase were: (1) Moderately decreased absolute amplitude of initial spike. (2) Continous rising second slope. (3) No appearance of terminal descent. Those were mast likely to those of renograms in acute ureteral obstruction or acute dehydration state. 3) During the diuretic phase, the renogram showed the point of maximal amplitude, but the steepness of 2nd slope was markedly decreased. The appearance of terminal descents was observed with unusually high amplitude despite of the tremendously large amount of urinary output during this phase. 4) In convalescence, the renograms were essentially normal in configuration, but the renal index of Hirakawa was not recovered until this phase. 5) Renograms in E.H. fever showed the characteristic patterns in each phase of its clinical course. 6) $^{131}I$-OIH-Renogram might be an useful method for the evaluation of renal function in E.H. fever during its course.

• ETRI Journal
• /
• 제35권1호
• /
• pp.100-108
• /
• 2013

In this paper, a feature extraction (FE) method is proposed that is comparable to the traditional FE methods used in automatic speech recognition systems. Unlike the conventional spectral-based FE methods, the proposed method evaluates the similarities between an embedded speech signal and a set of predefined speech attractor models in the reconstructed phase space (RPS) domain. In the first step, a set of Gaussian mixture models is trained to represent the speech attractors in the RPS. Next, for a new input speech frame, a posterior-probability-based feature vector is evaluated, which represents the similarity between the embedded frame and the learned speech attractors. We conduct experiments for a speech recognition task utilizing a toolkit based on hidden Markov models, over FARSDAT, a well-known Persian speech corpus. Through the proposed FE method, we gain 3.11% absolute phoneme error rate improvement in comparison to the baseline system, which exploits the mel-frequency cepstral coefficient FE method.

• 대한기계학회논문집
• /
• 제19권6호
• /
• pp.1529-1538
• /
• 1995

In this study, a liquid sheet type co-axial nozzle has been used to investigate the turbulent atomization characteristics which could result in the experimental data to be used in designing a jet nozzle with high performance. Image processing technique and immersion sampling method were employed to measure droplet size. In atomizing characteristics, droplet size distributions and absolute droplet sizes, SMD(Sauter Mean Diameter) have been investigated in the wide ranges of flow field depending upon the air-water mass ratios. And the comparisons between the present data and the semi-empirical curves have been conducted semi-empirical correlation for SMD has been derived in the present analysis.

• 한국재료학회지
• /
• 제5권2호
• /
• pp.232-238
• /
• 1995

The thermal stress distribution of WC and Ni binder phases In WC-26st.%Ni and WC-6wt.%Ni composites has been investigated over the temperature range 100-900 K using a time-of-flight neutron diffractometer. To determine the stress distribution, the breadths of WC and Ni peaks in the reference powder and the composites were analyzed. The peak breadths were corrected for particle size effect using a procedure based on the integral peak breadth method of particle size-strain analysis. The result shows a broad range of strain, and thus stress, is present in the WC and Ni binder phases of the composites. The strain distribution of both phases broadens as the temperature decreases, and some fraction of total strain distribution of the WC phase remains tensile regardless of the temperature. The strain distribution of the WC phase broadens as the binder content increases, and that of Ni binder phase broadens as the binder content decreases, which means the strain distribution broadens as the absolute value of residual stress increase.

• Mass Spectrometry Letters
• /
• 제5권1호
• /
• pp.30-33
• /
• 2014

A solid phase extraction (SPE) method was optimized for the quantitative analysis of perfluorooctanoic acid (PFOA) in serum using hydrophilic-lipophilic balance SPE and LC-MS/MS. Fetal bovine serums spiked with $^{13}C_8$-PFOA before or after SPE were used as test samples for evaluation of the SPE efficiency. Simultaneous evaluation of matrix effects and absolute SPE recovery for $^{13}C_8$-PFOA in serum using different sample pre-treatments and SPE conditions allowed optimization of SPE process efficiency with minimal matrix effect and decent SPE recovery. Introduction of protein precipitation as a sample pre-treatment procedure for serum samples before SPE generally decreased matrix effect in LC-MS/MS analysis and provided more stable recovery of PFOA.

• 전기학회논문지
• /
• 제65권4호
• /
• pp.576-585
• /
• 2016

The current control methods of Y-connected 7 Phase BLDC motor are sine wave current control and square wave control. The sine wave current control method needs dq axis transformation of $7{\times}7$ matrix for current control and very complex. Also this method is not suitable for multi Phase BLDC motor of trapezoidal back emf wave. Therefore, in Y connected multi phase BLDC motor, the square wave current control methods are required. Generally, in the 3Phase BLDC system, Average current control method is used for current control. The average current is obtained that the summation of absolute value of each phase current magnitude is divided by the number of conduction phase. However, if average current control method is applied to multi-phase system, there is a problem that each phase currents are different. This problem affects unbalance of each phase torque and fluctuation of total torque. This paper proposed each phase current control method of Y connected 7Phase BLDC system. Proposed method is used for PI controller of each phase for each phase current control. This method can perfect square wave current control. Also, configuration of the method is easier than DQ axis transformation. Proposed method is verified through simulation and experiments.

• 한국산학기술학회논문지
• /
• 제10권11호
• /
• pp.3023-3030
• /
• 2009

고속 삼차원 형상측정에서는 충분한 위상이송 스텝 수를 적용할 시간을 확보할 수 없기 때문에, 스텝 수를 축소하게 되면서 위상측정에서의 잡음이 증가되게 된다. 본 논문에서는, 다파장 PMP법에 있어서 두 파장의 비례관계를 이용하여 측정된 위상에 포함되어 있는 위상오차를 예측하고, 이를 보정하는 방법을 제안하였으며, 제안된 보정방법의 효용성을 확인하기 위한 실험이 진행되었다. 위상천이법에서 통상적으로 사용되는 스텝 수에 비해 월등히 많은 스텝의 위상 이송으로 측정하였으며, 또한 동일한 대상물을 고속 삼차원측정에서 적용되는 3-3 step의 위상 이송으로 측정하여, 두 경우에서의 측정결과를 비교하여 고속측정에서의 측정잡음을 산출하였다. 그리고, 본 논문에서 제안하고 있는 보정 방법을 측정된 맥놀이 위상과 절대위상에 적용한 결과, 각각에 있어서 90%와 17.2%의 잡음감소가 이루어지는 것으로 확인되었다.

• 전기학회논문지P
• /
• 제55권4호
• /
• pp.196-201
• /
• 2006

A electrical fault that may generate an electrical disaster is defined as any abnormal condition caused by reduction in the insulation strength. To find out the abnormal condition, periodical inspections have being performed every 3 years. Recently, the number of empty houses during normal working hours is rising by dramatic increase in the number of nuclear families and double income families. To define the potential risk of the electric installation, measurement of zero phase current has been being considered. But the measured value could not be adapted to an absolute reference to the installation because the measured zero phase current value also contained capacitive leakage current. Therefore, in this paper, the correlation between the condition of the electrical installation and the zero phase current was analyzed. The result focuses on to detect them in a cost efficient way.