• Journal of Acupuncture Research
• /
• v.19 no.3
• /
• pp.64-76
• /
• 2002

Objective : The purpose of this study is to investigate the mechanism and effect of moxibustion objectively and to be used as the quantitative data for developing the new thermal stimulating treatment by observing the combustion characteristics of commercial moxaes. Methods : We have selected two types(large-size moxa A(LMA), large-size moxa B(LMB)) among large moxaes used widely in the clinic. We examined combustion times, temperatures, temperature gradients in each period during a combustion of moxa. Results : 1. The ascending temperature gradient measured in the central point of non-contacted surface was fastest, the average ascending temperature gradient of both moxaes was $0.0384^{\circ}C/sec$, $0.0123^{\circ}C/sec$ respectively, 3.1 times faster in LMA. The maximum ascending temperature gradient was also about 2.9 times faster in LMA. The time required for the maximum ascending temperature gradient from ignition was 254sec, 411sec respectively. 2. The minimum descending temperature gradient in the retaining period was $-0.0250^{\circ}C/sec$, $-0.0090^{\circ}C/sec$ respectively and the average descending temperature gradient was $-0.0160^{\circ}C/sec$, $-0.0037^{\circ}C/sec$ respectively on the non-contact surface. 3. On the basis of the non-contact surface($A_I$), the time at which the effective stimulus period began to occur was about 264sec, 796sec respectively after an ignition, the time at which the maximum temperature began to occur was about 373sec, 1323sec respectively after an ignition, and the maximum temperature was $0.9^{\circ}C$ higher in LMA. The maximum ascending temperature gradient was also about 4.2 times faster in LMA. Conclusion : It was thought that not only the figure of moxicombustion device, but also the form and size of moxa had influence on the combustion characteristics deciding the performance of stimulus seriously.

• Journal of Korea Water Resources Association
• /
• v.37 no.7
• /
• pp.541-552
• /
• 2004

In this paper, ascending functions of the pool-and-weir fishway which has been established for the upstream migration of migratory fish at Jamsil Weir in the lower part of the Han River was assessed by applying tile Existing Fishway Measurement Method, and measures to improve these functions were suggested. The primary fish which ascended the fishway during the period of measurement was Erythroculter erythropterus Basilewsky, greater than 29cm in the body length. A total of 361 individual fish were collected with traps established at the exit of the fishway The maximum ascending capacity for the fish was 2.53${\times}$10^{-3}$ fish/hr/g. The fishway of Jamsil Weir does not satisfy the various fish species inhabiting in the river. Especially, small fishes of lower swimming ability may not ascend the fishway because the difference in water levels between upper and lower pools in the fishway was too large at the exit and there was too much discharge flowing into the fishway. This fishway does not have a roll in the ascending function for other species except Erythroculter erythropterus Basilewsky and Hemibarbus labeo Pallas, for which swimming ability is great. In order to improve the ascending function of the fishway, the structures of the fishway need to be changed so that various species in the river can easily ascend and the fishway function be taken into consideration in operation of the gates of the weir. Additional construction of fishways on both sides of the lower flow channel are needed to correct a decline in the fishway effectiveness due to continuous flow over the fixed part of the weir.

• Journal of the Korea Computer Graphics Society
• /
• v.23 no.1
• /
• pp.49-55
• /
• 2017

Computed tomographic angiography (CTA) is widely used in the diagnosis and treatment of coronary artery disease because it shows not only the whole anatomical structure of the cardiovascular three-dimensionally but also provides information on the lesion and type of plaque. However, due to the large size of the image, there is a limitation in manually extracting coronary arteries, and related researches are performed to automatically extract coronary arteries accurately. As the coronary artery originate from the ascending aorta, the ascending aorta and ostium should be detected to extract the coronary tree accurately. In this paper, we propose an automatic segmentation for the ostium as a starting structure of coronary artery in CTA. First, the region of the ascending aorta is initially detected by using Hough circle transform based on the relative position and size of the ascending aorta. Second, the volume of interest is defined to reduce the search range based on the initial area. Third, the refined ascending aorta is segmented by using a two-dimensional geodesic active contour. Finally, the two ostia are detected within the region of the refined ascending aorta. For the evaluation of our method, we measured the Euclidean distance between the result and the ground truths annotated manually by medical experts in 20 CTA images. The experimental results showed that the ostia were accurately detected.

• Journal of Chest Surgery
• /
• v.44 no.3
• /
• pp.215-219
• /
• 2011

Background: Selective antegrade perfusion via axillary artery cannulation along with circulatory arrest under deep hypothermia has became a recent trend for performing surgery on the ascending aorta and aortic arch and when direct aortic cannulation is not feasible. The authors of this study tried using moderate hypothermia with right brachial and femoral artery perfusion to complement the pitfalls of single axillary artery cannulation and deep hypothermia. Materials and Methods: A retrospective analysis was performed on 36 patients who received ascending aorta or aortic arch replacement between July 2005 and May 2010. The adverse outcomes included operative mortality, permanent neurologic dysfunction and temporary neurologic dysfunction. Results: Of these 36 patients, 32 (88%) were treated as emergencies. The mean age of the patients was 61.9 years (ranging from 29 to 79 years) and there were 19 males and 17 females. The principal diagnoses for the operation were acute type A aortic dissection (31, 86%) and aneurysmal disease without aortic dissection (5, 14%). The performed operations were ascending aorta replacement (9, 25%), ascending aorta and hemiarch replacement (13, 36%), ascending aorta and total arch replacement (13, 36%) and total arch replacement only (1, 3%). The mean cardiopulmonary bypass time was $209.4{\pm}85.1$ minutes, and the circulatory arrest with selective antegrade perfusion time was $36.1{\pm}24.2$ minutes. The lowest core temperature was $24{\pm}2.1^{\circ}C$. There were five deaths within 30 post-op days (mortality: 13.8%). Two patients (5.5%) had minor neurologic dysfunction and six patients, including three patients who had preoperative cerebral infarction or unconsciousness, had major neurologic dysfunction (16.6%). Conclusion: When direct aortic cannulation is not feasible for ascending aorta and aortic arch replacement, the right brachial and femoral artery can be used as arterial perfusion routes with the patient under moderate hypothermia. This technique resulted in acceptable outcomes.

• Journal of Chest Surgery
• /
• v.15 no.2
• /
• pp.222-229
• /
• 1982

The aneurysmal dilatation of ascending aorta with the aortic regurgitation presents typical surgical problems. Over the years, various surgical procedures had been used for the management of the dilated segment of sending aorta and the aortic regurgitation. The surgical technique Is still in the state of evolution. The one method is the super coronary replacement of the ascending aorta with vascular graft and replacement of the aortic valve with preservation of the coronary ostia as advocated by Miller and his colleague at Stanford University, so called conventional technique". The other is the replacement of aortic valve and the dilated segment of the ascending aorta using a composite graft and transplantation of the coronary ostia as described by Bentall and DeBono in 1968. The controversy appears to evolve around 3 technical problems. One is bleeding from the grafted area. Two is later development of the aneurysmal dilatation of the subcoronary aortic wall when non-composite graft is employed. Three is a management of the coronary arteries. The purpose of this article is to present our experience with 7 cases of annuloaortic ectasia in whom both of these surgical techniques at that employed and to review some of the problems that encountered during the management of these patients .

• Journal of Chest Surgery
• /
• v.17 no.4
• /
• pp.753-761
• /
• 1984

Most patients having annuloaortic ectasia are associated with marked dilatation of the sinuses of Valsalva and the aortic annulus as well as the huge aneurysm of the ascending aorta. A 19 year old male patient complaining of tightness on left posterior chest wall underwent cardiac angiography in which demonstrated annuloaortic ectasia with ascending aortic aneurysm and aortic insufficiency. The patient had corrective operation replacing the ascending aorta and aortic valve with a composite graft[Dacron prosthesis containing a Bjork-Shiley aortic valve] within the aneurysmal sac. The coronary orifices were anastomosed to the tubular Dacron prosthesis [30 mm in diameter] by means of a second smaller Gore-Tex tube [8mm in diameter]. The aneurysmal sac was trimmed by removing the redundant wall and then wrapped outer wall of the Dacron prosthesis. Postoperatively, mediastinal bleeding was temporarily observed in the operative day and satisfactory blood pressure was maintained with small dose of dopamine. One week later, large amount of serous effusion was drained out of the retrosternal space making partial disruption of the skin which was healed well by daily local dressing. The patient discharged in good condition on postoperative 29th day with no residual complications and is doing very well on the 4 months follow-up.

• Journal of Chest Surgery
• /
• v.42 no.4
• /
• pp.524-527
• /
• 2009

A stent graft has been accepted as an alternative method for treating aortic diseases or to reduce the extent of surgery. We report here on a one-stage Management of Ascending Aorta Replacement and Percutaneous Endovascular Repair for the seperate aneurysmal lesions on the ascending and descending aorta.

• Imaging Science in Dentistry
• /
• v.46 no.3
• /
• pp.223-227
• /
• 2016

A static, unilateral, and focal bone depression located lingually within the ascending ramus, identical to the Stafne's bone cavity of the angle of the mandible, is being reported. During development of the mandible, submandibular gland inclusion may lead to the formation of a lingual concavity, which could contain fatty tissue, blood vessels, or soft tissue. However, similar occurrences in the ascending ramus at the level of the parotid gland are extremely rare. Similar cases were previously reported in dry, excavated mandibles, and 3 cases were reported in living patients. A 52-year-old African American male patient was seen for pain in the mandibular teeth. Panoramic radiography showed an unusual concavity within the left ascending ramus. Cone-beam computed tomography confirmed this incidental finding. The patient was cleared for the extraction of non-restorable teeth and scheduled for annual follow-up.

• The Journal of Internal Korean Medicine
• /
• v.13 no.1
• /
• pp.167-180
• /
• 1992

This study has been carried out to investigate the cause and originative mechanism of vertigo by referring to 46 literatures. The results were as follows; 1. The 1st factors causing vertigo are exuberance of fire in the Liver (肝火偏亢). and ascending of Yang of Wind (風陽升動) resulting from thought excess (思慮太過) and melancholy (憂鬱). 2. The 2nd factors causing vertigo is a malnurtrient of the brain resulting from dispersion of the Liver function (肝血虛) and failure in ascending of the Clear Yang (淸陽不升) due to hemorrhage and so on. 3. The 3rd factors causing vertigo are failure in ascending to the Brain and deficiency of blood of the Liver (肝血虛) resulting from the injury of the essence of the Kidney (肝精虧損). 4. The 4th factors causing vertigo is a ascending of exogenous pathogenic factors (外邪) to the Brain on deficiency state. 5. The 1st factors causing vertigo are Stagnatum of clear Yang (淸陽不振) and pershing of Yang (亡陽) resulting from loss of water and damage of active thin body fluid (津氣虧損). 6. The obesity is beonged to excessiveness Symptom-Complex (實證) and the thin to deficiency Symptom-complex (虛證). 7. The vertigo is connective with the Live (肝), Spleen (脾) and the Kidney (腎), but among those, most intimative viscera is the Liver (肝).

• Journal of Chest Surgery
• /
• v.26 no.12
• /
• pp.926-933
• /
• 1993

We experienced 20 patients with Takayasu`s disease who required 22 surgical procedures for critical arterial stenoses, aneurym of descending thoracic aorta, and aortic regurgitation from 1986 to 1993.Five patients had type I arteritis, seven patients had type II , seven patients had type III, and one patients had type IV.15 patients were female and 5 patients were male.Patients` ages ranged from 17 to 47 years and mean age was 29.1 years. The surgical procedures were as follows;autotransplantations of kidney[3], aortic valve replacements[2], ascending aorta-bilateral internal carotid artery bypasses[2], unilateral renal artery bypasses[2], bilateral renal artery bypasses[3], replacement of descending thoracic aorta[1], ascending aorta-abdominal aorta bypass[1], ascending aorta-right internal carotid artery bypass[1], ascending aorta-right internal carotid artery and left subclavian artery bypass[1], left common carotid artery-left-subclavian artery bypass[1], pulmonary artery angioplasty[1], left femoro-bilateral axillary bypass[1] and others[2]. There was no hospital death.Mean duration of follow-up was 42.7 months[ranged from 3 to 96 months].There was one late death and late mortality rate is 5.9%.Two patients was underwent second vascular procedures, one after 5 years and the other after 5 months.The other patients have done well after surgery.