• KIPS Transactions on Computer and Communication Systems
• /
• v.11 no.1
• /
• pp.35-42
• /
• 2022

Visible light communication (VLC) is a method of transmitting data through LED blinking and is vulnerable to eavesdropping because the illumination affects the wide range of area. IEEE standard 802.15.7 defines On-Off Keying (OOK), Variable Pulse Position Modulation (VPPM), and Color Shift Keying (CSK) as modulation. In this paper, we propose an encryption method in VPPM for secure communication. The VPPM uses an encoding method called 4B6B where 16 different outputs are represented with 6-bit. This paper extends the number of outputs to 20, to add complexity while not violating the 4B6B generation conditions. Then each entry in the extended 4B6B table is scrambled using vigenère cipher. The probability of decrypting each 6-bit data is $\frac{1}{20}$. Eavesdropper should perform $\sum\limits_{k=1}^{n}20^k$ number of different trials to decrypt the message if the number of keys is n. The proposed method can be applied to OOK of PHY II and CSK of PHY III. We further discuss the secure encoding that can be used in OOK and CSK without performance degradation.

• Journal of Advanced Navigation Technology
• /
• v.22 no.5
• /
• pp.449-455
• /
• 2018

For the size reduction, we propose a microstrip-fed monopole antenna with half X-slot in the radiation patch and cover WLAN dual band 2.4 GHz band (2.4 ~ 2.484 GHz) and 5 GHz band (5.15 ~ 5.825 GHz). The frequency characteristics such as impedance bandwidth and resonant frequencies were satisfied by optimizing the numerical values of various parameters, while the reflection loss in 5 GHz was improved by using defected ground structure (DGS). The proposed antenna is designed and fabricated on a FR-4 substrate with dielectric constant 4.3, thickness of 1.6 mm, and size of $24{\times}41mm^2$. The measured impedance bandwidths (${\mid}S_{11}{\mid}{\leq}-10dB$) of fabricated antenna are 450 MHz (2.27 ~ 2.72 GHz) in 2.4 GHz band and 1340 MHz (4.79 ~ 6.13 GHz) in 5 GHz band which sufficiently satisfied with the IEEE 802. 11n standard in dual band. In particular, radiation patterns which are stable as well as relatively omni-direction could be obtained, and the gain of antennas in each band was 1.31 and 1.98 dBi respectively.

• Journal of Digital Convergence
• /
• v.10 no.3
• /
• pp.265-271
• /
• 2012

This paper proposes a communication distance performance evaluation method for mobility of service robots equipped with a Wi-Fi module. Service robots have function of mobile communication system according to classified services and utilize a (preferred) communication method, wireless lan(IEEE802.11 a/b/gin) communication method of ISM band(2.4GHz and 5.8GHz). For evaluating degradation performance of wireless data for the service robot's mobility. We measured and presented reference vectors obtained by utilizing a distance attenuation correlation method in the real world environment. To evaluate performance of the proposed method, path loss of reference vectors was assigned to the Azimuth 301W and then transmission rate and the transmit throughput of the test sample were measured by the Chariot. The proposed measurement method is necessary for securing wireless LAN communication distance for mobility of mobile smart device and service robots. In addition, if the proposed measurement method os adopted, It would be expected that mobile smart device vendors would utilize the method as an effective wireless LAN mobility communication distance performance evaluation method.

• Journal of KIISE:Information Networking
• /
• v.41 no.4
• /
• pp.192-201
• /
• 2014

User scheduling boosts the Multi-User Multi-Input Multi-Output (MU-MIMO) gain by selecting an optimal set of users to increase the 802.11 Wi-Fi system capacities. Many kinds of user scheduling algorithms, however, fail to realize the advantages of MU-MIMO due to formidable Channel State Information (CSI) overhead. In this paper, we propose a user scheduling method considering such CSI exchange overhead and its MAC protocol, called ACE (Active CSI Exchange based User Scheduling for MU-MIMO Transmission). Unlike most proposals, where user scheduling is performed after an Access Point (AP) receives CSI from all users, ACE determines the best user set during the CSI exchange phase. In particular, the AP broadcasts a channel hint about previously scheduled users, and the remaining users actively send CSI reports according to their Effective Channel Gains (ECGs) calculated from the hint. Through trace-driven MATLAB simulations, we prove that the proposed scheme improves the throughput gain significantly.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.7
• /
• pp.2972-2991
• /
• 2016

WLAN is the best choice in the place where complex network is hard to set up. Intelligent terminals are more and more assembled in some areas now. However, according to IEEE 802.11n/802.11ac, the access-point (AP) can only serve one user at a single frequency channel. The spectrum efficiency urgently needs to be improved. In theory, AP with multi-antenna can serve multiple users if these users do not interfere with each other. In this paper, we propose a user clustering scheme that could achieve multi-user selection through the mutual cooperation among users. We focus on two points, one is to achieve multi-user communication with multiple antennas technique at a single frequency channel, and the other one is to use a way of distributed users' collaboration to determine the multi-user selection for user clustering. Firstly, we use the CSMA/CA protocol to select the first user, and then we set this user as a source node using users' cooperation to search other proper users. With the help of the users' broadcast cooperation, we can search and select other appropriate user (while the number of access users is limited by the number of antennas in AP) to access AP with the first user simultaneously. In the network node searching, we propose a maximum degree energy routing searching algorithm, which uses the shortest time and traverses as many users as possible. We carried out the necessary analysis and simulation to prove the feasibility of the scheme. We hope this work may provide a new idea for the solution of the multiple access problem.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.4
• /
• pp.53-63
• /
• 2009

This work proposes a 10b 100MS/s 27.2mW $0.8mm^2$ 0.18um CMOS ADC for WLAN such as an IEEE 802.11n standard. The proposed ADC employs a three-stage pipeline architecture and minimizes power consumption and chip area by sharing as many circuits as possible. Two multiplying DACs share a single amplifier without MOS switches connected in series while the shared amplifier does not show a conventional memory effect. All three flash ADCs use only one resistor ladder while the second and third flash ADCs share all pre-amps to further reduce power consumption and chip area. The interpolation circuit employed in the flash ADCs halves the required number of pre-amps and an input-output isolated dynamic latch reduces the increased kickback noise caused by the pre-amp sharing. The prototype ADC implemented in a 0.18um n-well 1P6M CMOS process shows the DNL and INL within 0.83LSB and 1.52LSB at 10b, respectively. The ADC measures an SNDR of 52.1dB and an SFDR of 67.6dB at a sampling rate of 100MS/s. The ADC with an active die area of $0.8mm^2$ consumes 27.2mW at 1.8V and 100MS/s.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.12
• /
• pp.2783-2790
• /
• 2010

In this paper, we first review LDPC codes in general and a belief propagation algorithm that works in logarithm domain. LDPC codes, which is chosen 802.11n for wireless local access network(WLAN) standard, require a large number of computation due to large size of coded block and iteration. Therefore, we presented three kinds of low computational algorithms for LDPC codes. First, sequential decoding with partial group is proposed. It has the same H/W complexity, and fewer number of iterations are required with the same performance in comparison with conventional decoder algorithm. Secondly, we have apply early stop algorithm. This method reduces number of unnecessary iterations. Third, early detection method for reducing the computational complexity is proposed. Using a confidence criterion, some bit nodes and check node edges are detected early on during decoding. Through the simulation, we knew that the iteration number are reduced by half using subset algorithm and early stop algorithm is reduced more than one iteration and computational complexity of early detected method is about 30% offs in case of check node update, 94% offs in case of check node update compared to conventional scheme. The LDPC decoder have been implemented in Xilinx System Generator and targeted to a Xilinx Virtx5-xc5vlx155t FPGA. When three algorithms are used, amount of device is about 45% off and the decoding speed is about two times faster than convectional scheme.

• Journal of Radiation Protection and Research
• /
• v.23 no.3
• /
• pp.123-138
• /
• 1998

Characteristics of element responses of Panasonic UD802 personnel dosimeters in the X, ${\beta}$, ${\gamma}$, ${\gamma}/X$, ${\gamma}/{\beta}$ and ${\gamma}$/neutron mixed fields were assessed. A dose-response algorithm has been developed to decide the high probability of a radiation type and energy by using the distribution in all six ratios of the multi-element TLD. To calculate the 4-element response factors and ratios between the elements of the Panasonic TLDs in the X, $\beta$, and $\gamma$ radiation fields, Panasonic’s UD802 TLDs were irradiated with KINS’s reference irradiation facility. In the photon radiation field, this study confirms that element-3 (E3) and element-4 (E4) of the Panasonic TLDs show energy dependent both in low- and intermediate-energy range, while element-1 (E1) and element-2 (E2) show little energy dependency in the entire whole range. The algorithm, which was developed in this study, was applied to the Panasonic personnel dosimetry system with UD716AGL reader and UD802 TLDs. Performance tests of the algorithm developed was conducted according to the standards and criteria recommended in the ANSI N13.11. The sum of biases and standard deviations was less than 0.232. The values of biases and standard deviations are distributed within a triangle of a lateral value of 0.3 in the ordinate and abscissa, With the above algorithm, Panasonic TLDs satisfactorily perform optimum dose assessment even under an abnormal response of the TLD elements to the energy imparted. This algorithm can be applied to a more rigorous dose assessment by distinguishing an unexpected dose from the planned dose for the most practical purposes, and is useful in conducting an effective personnel dose control program.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.9A
• /
• pp.906-912
• /
• 2006

In this paper, N-shaped slot antenna for $5.15GHz{\sim}5.35GHz$ is designed, fabricated, and measured. The prototype consist of meander corrugated N-shaped slot. To obtain suitable bandwidth, the form layer is inserted between ground plane and substrate. Important parameters in the design are N-slot length, width, position, air-gap height, and feed point position. From these parameters optimized, a four N-shaped slot antenna is fabricated and measured. The measured results of the antenna are obtained as follows results. The resonant frequency of the fabrication N-shaped slot antenna is 5.25GHz bandwidth for approximately 300MHz(VSWR<2.0) and the gain is $1.3{\sim}2.64dBi$. The experimental far-field patterns are stable across the pass band. The 3dB bandwidth in H-Plane and E-Plane are $80.21^{\circ}\;and\;103.38^{\circ}$, respectively.

• Electronics and Telecommunications Trends
• /
• v.22 no.1 s.103
• /
• pp.114-118
• /
• 2007

국내외적으로 지능형 차량 및 텔레매틱스/ITS 연구 개발을 통해서 차량에 IT 기술 접목을 위한 노력을 가속화하고 있다. 우리나라의 경우 산업자원부가 미래 10대 전략품목으로 자동차 부분에서 지능형 차량을 선정하였으며, 정보통신부는 u-IT839의 핵심서비스로 텔레매틱스/ITS 서비스를 추진하고 있다. EU는 i2010 Flagship에서 intelligentcar initiative 프로젝트를 통해 지능형 차량 및 보안을 위한 전략 수립과 세부과제를 수행하고 있다. 또한, IEEE 802.11p/P1609(WAVE)와 ISO TC204/WG16CALM에서는 차량 통신 보안 및 서비스에 대해서 고려하고 있다. 현재 지능형 차량과 관련하여서는 다양한 사업 모델이 제시되고 있으며, 자동차 업계의 BM과 이동통신 업계의 AM이 동반 성장하고 있다. 본 기고문은 지능형 차량 및 텔레매틱스/ITS와 관련한 보안 기술 동향을 살펴본다.