• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.248-249
• /
• 2008

ZnO (Zinc Oxide) thin film can be applied to various devices. Recently, ZnO film has been promoted in transparent TFTs (thin film transistors) because of high transparency and low temperature process. In this paper, ZnO thin films were grown on glass with the three conditions of RF sputtering power, which are 50W, 75W, 100W. Their structural, electrical and optical properties were investigated by using XRD, UV-Visible spectrometer and 4-point probes. In the ZnO film with 50W process, good crystallinity, high transmittance, and high sheet resistance were shown. In conclusion, the ZnO film with 50W can be an optimal channel layer of TFTs.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.6
• /
• pp.893-906
• /
• 2011

The effect of ultrasound pretreatment on sludge degragability was investigated at different condotions: ultrasonic frequency(28, 40, 50kHz), intensity(10, 25, 50W), sonication time(10, 20, 30, 60min). Total suspended solid(TSS) and soluble chemical oxygen demand(SCOD) concentration were measured for the evaluation of pretreatment efficiency. The pretreated sludge was used as the feedstock for anaerobic digestion process. Biogas production and volatile suspended solid(VSS) removal were determined for evaluating the process performance. 1. TSS concentration of the sludge decreased at a constant rate as sonication operation was applied. The degradation rate of TSS increased when ultrasound frequency was decreased from 50kHz to 28kHz and intensity was increased from 10W to 50W. Efficiency of TSS degradation per input energy increased as ultrasonic frequency and intensity were decreased. At the frequency of 28 and 40kHz, SCOD concentration rapidly increased during the initial 30min of sonication time, and then it gradually increased. At 50kHz, SCOD concentration constantly increased for 60min of the sonication time. The SCOD production rate increased with increasing intensity under all ultrasound frequencies. 2. The optimum condition of ultrasound treatment was 28kHz, 50W and 60min for maximizing the biogas production, methane fraction, VSS removal. The highest values in biogas production, methane fraction in biogas, VSS removal were 370ml, 70%, 2.45g, respectively. Methane production rate per input energy increased at ultrasonic frequency and intensity decreased. 3. When raw sludge was pretreated at the condition of ultrasonic frequency of 28 and 40kHz in series, sequential-frequency sonication, intensity of 50W and 60min, biogas production, methane fraction, VSS removal were about the same that of 28kHz single-frequency sonication. When sequential-frequency sonication of 28 and 50kHz was applied in series, biogas production, methane fraction, VSS removal were 356 ~ 423ml, 69 ~ 71%, 2.41 ~ 2.78g, respectively. The pretreatment efficiency of 28-50kHz sequential-frequency sonication which sonication time of 28kHz and 50kHz was 40min and 20min was higher than that of 28kHz single-frequency sonication.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.219-221
• /
• 2006

This paper presents the performance results of 50kW grid-connected PV (Photovoltaic) system for monitoring periods. Form these performance monitoring results, the PV system performance has been evaluated and analyzed for component perspective (PV array and power conditioning unit) and global perspective (system efficiency, capacity factor, and electrical power energy and power quality etc.).

• Proceedings of the KIEE Conference
• /
• 2005.04a
• /
• pp.105-107
• /
• 2005

A high-speed brushless DC motor for a 50-kW, 70-krpm turbo-compressor was developed based on a 2-D analytical method, of which design was verified using the FE analysis. A prototype machine was also fabricated and tested to confirm the analytical design. Preliminarily obtained experimental data using the prototype machine shows the validity of the analytical approach.

• Transactions on Electrical and Electronic Materials
• /
• v.15 no.6
• /
• pp.328-332
• /
• 2014

Thin film transistors (TFTs) with an amorphous silicon zinc tin oxide (a-2SZTO) channel layer have been fabricated using an RF magnetron sputtering system. The effect of the change of excitation electron on the variation of the total interfacial trap states of a-2SZTO systems was investigated depending on sputtering power, since the interfacial state could be changed by changing sputtering power. It is well known that Si can effectively reduce the generation of the oxygen vacancies. However, The a-2SZTO systems of ZTO doped with 2 wt% Si could be degraded because the Si peripheral electron belonging to a p-orbital affects the amorphous zinc tin oxide (a-ZTO) TFTs of the s-orbital overlap structure. We fabricated amorphous 2 wt% Si-doped ZnSnO (a-2SZTO) TFTs using an RF magnetron sputtering system. The a-2SZTO TFTs show an improvement of the electrical property with increasing power. The a-2SZTO TFTs fabricated at a power of 30 W showed many of the total interfacial trap states. The a-2SZTO TFTs at a power of 30 W showed poor electrical property. However, at 50 W power, the total interfacial trap states showed improvement. In addition, the improved total interfacial states affected the thermal stress of a-2SZTO TFTs. Therefore, a-2SZTO TFTs fabricated at 50 W power showed a relatively small shift of threshold voltage. Similarly, the activation energy of a-2SZTO TFTs fabricated at 50 W power exhibits a relatively large falling rate (0.0475 eV/V) with a relatively high activation energy, which means that the a-2SZTO TFTs fabricated at 50 W power has a relatively lower trap density than other power cases. As a result, the electrical characteristics of a-2SZTO TFTs fabricated at a sputtering power of 50 W are enhanced. The TFTs fabricated by rf sputter should be carefully optimized to provide better stability for a-2SZTO in terms of the sputtering power, which is closely related to the interfacial trap states.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.1068-1069
• /
• 2015

Wind turbines have an enormous potential for decentralized electricity generation. In recent years, there has been an increasing worldwide interest in small/medium wind systems. This paper presents the results of power performance testing conducted on a 50 kW turbine located in Yeonggwang test-bed. The turbine system is a pitch, active yaw, variable speed, upwind, three blade with a direct drive PMSG. This thesis covers the operation of variable speed wind turbines with pitch-yaw control. The system considered is controlled to generate maximum energy while minimizing loads. The data include power, wind speed, and direction from meteorological towers, and nacelle anemometer readings and output from turbine. The analysis concentrates on the effect of the load on the power-wind speed curve of the turbine.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.194-195
• /
• 2007

This paper presents the experimental operation of invertactive 50kW photovoltaic system for monitoring periods. Form these performance monitoring results, the PV system performance has been evaluated and analyzed for component perspective. It has produced a regression equation. Using the equation, it is possible to estimate the annual electricity generation. The result of this study will be used to determine the appropriate capacity of PV system in different systems.

• Kyungpook Mathematical Journal
• /
• v.50 no.4
• /
• pp.557-564
• /
• 2010

By using an idea of C$\u{a}$dariu and Radu [4], we prove the generalized Hyers-Ulam stability of the functional equation f(x + y,z - w) + f(x - y,z + w) = 2f(x, z) + 2f(y, w). The quadratic form $f\;:\;\mathbb{R}\;{\times}\;\mathbb{R}{\rightarrow}\mathbb{R}$ given by f(x, y) = $ax^2\;+\;by^2$ is a solution of the above functional equation.

• Advances in Traditional Medicine
• /
• v.5 no.3
• /
• pp.240-245
• /
• 2005

The effect of aqueous and alcoholic extract of seeds of Nigella sativa (N. sativa) was studied on the spontaneous movements of the whole worm (w.w) preparation and nerve muscle (n.m) complex of Setaria cervi (S. cervi). Both the extracts caused inhibition of spontaneous movements of the w.w and n.m complex characterized by initial stimulation followed by irreversible paralysis, with the exception that aqueous extract produced a partially reversible paralysis of w.w preparation. Lesser concentration of both the extracts was required to inhibit the movements of n.m complex than the w.w. Suggesting a cuticular permeability barrier. The lethal concentration $50\;(LC_{50})$ and lethal concentration $90\;(LC_{90})$ were 30 and 55 ng/ml for aqueous and 45 and 60 ng/ml for alcoholic extracts respectively.

• KSBB Journal
• /
• v.15 no.1
• /
• pp.49-54
• /
• 2000

Bioluminescence of Photobacterium phosphoreum has been used for the detection of pollutants in the environment. Immobilization method was used to maintain the stability of bioluminescence of P. phosphoreum. The carboxymethylcellulose was investigated to find out whether it was suitable for the immobilization of P. phosphoreum as a matrix without disturbing the bioluminescence emission. A maintenance of bioluminescence was determined from the P. phosphoreum immobilized on the various concentrations of carboxymethylcellulose. A relatively high bioluminescence intensity was shown with immobilized cells on 1%(w/v) carboxymethylcellulose. The effect of carboxymethylcellulose concentrations on the sensitivity of Crcompounds including $Na_{2}CrO_{4}$, $K_{2}CrO_{4}$, $CrO_{3}$, CrK$(SO_4)_{2}$ and $CrCl_{3}$ to the bioluminescence intensity. The calculated $EC_{50}$ showed that the linear relations between such substances and bioluminesence intensity were established.