• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.63-64
• /
• 2006

In this paper, the open loop antenna using a strip-conductor for an RFID reader at dual-band frequency(910MHz, 2.45GHz) is proposed. The impedance is matched by varying the antenna parameters such as the length of strip-conductor and the gap of between two strip-conductors. Return loss and gain of designed antenna are -11.919dB, 2.5dBi at 910MHz, and -15.766dB, 5.65dBi at 2.45GHz, respectively.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.1
• /
• pp.38-46
• /
• 1999

o.25${\mu}m$ T-shaped gate P-HEMT is fabricated and used for design of X0band three stage monolithic microwave integrated circuit(MMIC) low noise amplifier(LNA). The fabricated P-HEMT exhibits an extrinsis transconductance of 400mS/mm and a drain current of 400mA/mm. The RF and noise characteristics show that the current gain cut off frequency is 65GHz and minimum noise figure(NFmin) of 0.7dB with an associated gain of 14.8dB at 9GHz. In the design of the three stage LNA, we have used the inductive series feedback circuit topology with the short stub. The effects of series feedback to the noise figure, the gain, and the stability have been investigated to find the optimal short stub length. The designed three staage LNA showed a gain of above 33dB, a noise figure of under 1.2dB, and ainput/output return loss of under 15dB and 14dB, respectively. The results show that the fabricated P-HEMT is very suitable for a X-band LNA with high gain.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.2 no.2 s.3
• /
• pp.65-72
• /
• 2003

In this work a 6-stage hybrid power amplifier which can be used for the wireless communication systems for MMC(hficrowave Micro Cell) and ITS wireless communication system is designed and fabricated. Ihe power amplifier's each stages was fabricated Hetero-junction Power FET of bare chip type and an alumina substrate with $\varepsilon_{r}$=9.9 and 15-mil thickness. The measured results of power amplifier module showed 33.2$\~$36.5 dB small signal gain, 33.0$\~$34.0 dBm output power at forward frequency (17.6 GHa $\~$ 17.9 CHz) and 36.0$\~$37.0 dB small signal gain, 33.0$\~$34.5 dBm output power at reverse frequency (19.0 GHz $\~$19.2GHz).

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.61 no.3
• /
• pp.149-152
• /
• 2012

In this paper, a wideband monopole antenna with ring loop by modified ground plane is presented. The proposed antenna consist of monopole antenna, ring loop by ground plane. This antenna is fed CPW-fed and wide slot antenna of a novel structure for broadband characteristics is proposed. To enhance the impedance bandwidth of the wide slot antenna, we proposed the wide slot structure with CPW-fed which is combined with four ${\lambda}/2$ rectangular radiation modified monopole and inductively coupled. The measured impedance bandwidth is about 2.5 GHz(3.65~6.15 GHz) then less -10 dB.

• Transactions on Electrical and Electronic Materials
• /
• v.16 no.5
• /
• pp.250-253
• /
• 2015

A novel implantable CPW fed Apollian shaped antenna embedded into human tissue is proposed for ISM band biomedical applications. The proposed antenna is made compatible for implantation by embedding it in an alumina ceramic substrate(ε_r=9.8 and thickness= 0.65 mm). The proposed antenna covers the ISM band of 2.45 GHz. The radiation parameters such as return loss, xy-plane, xz-plane, and yz-plane etc., are measured and analyzed using the agilent vector network analyzer. The proposed antenna has substantial advantages, including low profile, miniaturization ability, lower return loss, better impedance matching, and high gain over conventional implanted antennas.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.1
• /
• pp.143-146
• /
• 2016

A new area-efficient multi-phase clock frequency multiplier is presented. The proposed fractional-ratio frequency multiplying DLL (FFMDLL) is implemented in a 65 nm CMOS process and occupies an active area of just $0.01mm^2$. The proposed FFMDLL provides 8-phase output clocks and achieves a frequency range of 0.6-1.0 GHz with programmable multiplication ratios of N/M, where N = 4, 5, 8, 10 and M = 1, 2, 3. It achieves an effective peak-to-peak jitter of 5 ps and dissipates 3.4 mW from a 1.0 V supply at 1 GHz.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.22 no.4
• /
• pp.33-38
• /
• 1985

By the complemental frequency characteristics of directional filter in passband and stopband the method of isolation between microwave RF and low frequency If is derived. And when this characteristic of microstrip directional filter is applied to MIC balanced mixer from 3.7 to 4.2 GHz, the experimental results of isolation and return loss are more than 20 65 in this band. This balanced mixer with the microstrip coupled directional filter is suitable for the DBS microwave receiver system.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.29A no.2
• /
• pp.18-23
• /
• 1992

Recently, SSPAs(Solid-State Power Amplifiers) with high linearity and efficiency replace TWTAs (Traveling-Wave-Tube Amplifiers) in satellite transponders. In this paper, a power amplifier with maximum output power is designed and constructed using GaAs FET(MGF-1302) as a test model for the development of SSPAs. For conjugate matching of input and output network, transimission lines and stubs are optimized using microwave CAD program, LINMIC+. Power amplifier is realized on the teflon substrate($\in$S1rT=2.45) with a bandwidth of 1GHz at a center frequency of 8GHz. Maximum stable gain of simulation and simulation and experimental result is obtained 9.23, 7.65 dB, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.6
• /
• pp.682-690
• /
• 2012

In this paper, a highly linear self oscillating mixers(SOM) using second harmonic injections are presented. The H-slot defected ground structure(DGS) is designed as a balanced resonator for oscillation in the proposed SOM. Since the H-slot DGS resonator achieves a high Q factor, it is a suitable structure to provide low phase noise for the oscillator. The single balanced mixer is utilized in this work and it provides good LO-RF isolation since balanced LO signals are suppressed at the RF input port. In order to inject the second harmonic of the IF, we propose two different methods using feedback loops. In the first method, IF achieves a 3.08 dB conversion gain at 226 MHz with input power of -20 dBm at 5 GHz RF input signal. The IF achieves 2 dB conversion gain at 423 MHz with the input power of -20 dBm at 5.2 GHz RF input signal in the second method. The measured IMD3s are 61.8 dB and 65 dB for the each method. These SOMs present improved linearity compared to that without the second harmonic injection because IMD3s are improved by 18. dB and 21 dB for each method.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.65 no.1
• /
• pp.72-75
• /
• 2016

In this paper, we proposes a internal antenna for wireless DVI dongle device using the folded monopole structure. The proposed antenna uses a basic structure of spiral and monopole. The antenna optimized for parameters length, gap, width, and rectangle of folded monopole antenna using the spiral structure. To confirm the characteristics of the antenna parameters, HFSS from ANSYS Inc. was used for the analysis. We used an FR4 dielectric substrate with a dielectric constant of 4.4. The DVI dongle size of the proposed antenna is $50{\times}40{\times}1.6mm$, and the size of the antenna area is $10{\times}40mm$. There is a value of return loss less then -10dB in 2.4GHz and 5.8GHz, band and the maximum antenna gain is -4.13dBi. The utilization possibility of the wireless DVI Dongle antenna have a folded monopole with spiral shape could be confirmed according to compare and analyze the simulation and measurement data.