• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.12
• /
• pp.5931-5937
• /
• 2011

The effects of coupling beam, which is generally used in high-rise building structure system as shear wall-coupling beam, on the lateral drift of high-rise buildings are studied in this paper. Six different analytical models, which are combination of two inputs, such as concrete strength and wall thickness, are selected and analyzed on lateral drifts with different stiffness of coupling beams. MIDAS GEN was used for analysis. Calculated lateral drifts were compared with allowable limits(H/400~H/500) proposed by standard CEN EC 3/1, in order to analyze the control evaluation of coupling beams. Calculated x-direction displacements were 68~87 percent of allowable limit(H/500). With increase of wall thickness(100mm) and concrete strength(5Mpa), eight to ten percent and four percent of x and y-direction displacement were decreased individually. About three percent of lateral displacement was increased with 20 percent decrease of coupling beam stiffness and additional 20 percent decrease resulted in additional five to eight percent increase.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.7
• /
• pp.13-23
• /
• 2008

In this study, the centrifuge tests and numerical analyses were performed to investigate the lateral flow behavior and stability of abutment when high filling was applied on the soft ground improved by SCP. The centrifuge model tests and numerical analyses were fulfilled in the case of the back of abutment filled by EPS (case 1) and soil (case 2), and the potentiometer was installed on the abutment and fill to measure the vertical and horizontal displacement at the top of abutment. As a result of the centrifugal tests, the horizontal displacement of abutment in the case 1 was 1.4cm that is almost coincide with the results of numerical and satisfy the allowable standard. On the other hand, the horizontal displacement of abutment in the case 2 was 12 cm that is 18% greater than that of numerical analysis and exceed the allowable standard. As a result of analysis, the maximum horizontal displacement of pile was 1.26 cm in case 1 that satisfies the criterion of allowable horizontal displacement (1.5 cm). In contrast, the maximum horizontal displacement of pile was 1.005 m in case 2 that greatly exceeds the allowable horizontal displacement.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2011.04a
• /
• pp.473-476
• /
• 2011

본 논문에서는 열차와 교량의 상호작용과 주행속도에 의해 결정되어지는 진동지속시간과 차체연직가속도 증폭효과를 고려하여 철도교량의 진동사용성 허용처짐을 제시하고자 하였다. 열차가 교량을 통과할 때의 처짐 형상을 사인파로 가정하고 열차와 교량의 상호작용을 진동전달함수로 표현하여 철도교량의 진동 사용성 허용처짐을 유도하였다. 그리고 진동지속시간을 고려하기 위해 연직가속도 허용기준으로서 진동지속시간을 고려한 교량구조물의 진동사용성기준을 사용하였다. 매개변수연구를 통하여 열차 주행속도의 증가에 비례하여 차체연직가속도는 증가하지만 교량최대변위의 변화는 미미함이 확인됨으로 인하여 차체연직가속도 증가와 동반하여 연직가속도 허용기준역시 증가하는 것을 보정할 필요가 있을 것으로 판단하였다. 따라서 전개된 철도교량의 진동사용성 허용처짐식에 매개변수연구를 통하여 가정한 가속도 증폭계수를 적용하여 열차의 증속에 의한 가속도증폭효과를 고려하였다.

• Journal of Korean Society of Disaster and Security
• /
• v.12 no.4
• /
• pp.43-52
• /
• 2019

To analyze the influence on the stability, resulting from application of upgrade pipe roof structure (UPRS) method to the structure existed under subway Station, physical properties of a ground, elasticity and elasto-plastic theories, including displacement analysis of finite elements, stress analysis of finite elements, displacement caused by steel pipe propulsion and internal excavation, and stress change in a steel pipe, were introduced. Then, the influence on structural stability when applying the UPRS method was compared and reviewed based on the construction management standard of the Ministry Land, Infrastructure and Transport and foreign sources, using numerical analysis with a model which assumes that each microelement divided into a structurally stable point consists of the connection of finite points. As a result of the finite element analysis, 7.21 mm maximum displacement, 1/3,950 angular displacement, 70.28 MPa bending compressive stress of steel pipe structure constructed with UPRS (non-excavation) method and 477.38 MPa maximum shear strength were within their allowable standards (25.00 mm, 1/500, 210.00 MPa and 120.00 MPa, respectively), and therefore, the results showed that the design and construction are stable.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.1
• /
• pp.5-13
• /
• 2013

Soils around a pile are highly constrained when the vertical load is applied to the pile. However, the conventional direct shear test cannot evaluate the shear strength of the soils under the normal confinement condition. The goal of this study is to evaluate the shear behaviors according to the normal displacement confinement condition including free normal displacement (FND) and constrained normal displacement (CND) during direct shearing. Jumunjin sands were prepared at the different relative densities and loaded at the different normal stresses. The specimens were sheared according to the normal confinement conditions. Experimental results show that shear strengths obtained by the CND tests are higher than those obtained by the FND tests. In addition, for the constrained normal displacement condition, the increment of shear strength increases with the increase of relative density, while the increment of shear strength decreases with the initial normal stress. This study suggests that the effect of confinement condition on the shear strength should be considered when the stability of constrained soils is analyzed.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.671-675
• /
• 2002

영화관의 구조설계에서 중요한 고려 인자 중에서 음향적 관점뿐만 아니라, 영사기의 진동으로 인한 영상의 떨림 현상은 관람석에서 미치는 구조물의 동적 특성 문제에 있다. 이는 영사기-스크린-관람객 사이의 3인자에 내한 상대진동허용변위에 의해 지배됨을 고려하여, 이를 만족시키는 변수 등에 따른 진동허용규재치를 결정하는 절차가 필요하다. 본 연구에서는 영화관의 진동허용규제치를 이들 3인자에 대한 변수들을 고려한 결정 과정을 공학적인 차원에서 정리하였으며, 복합상가 건물내의 영화관 영사실에 이를 만족하기 위한 진동 저감설계 자료에 활용하였다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11a
• /
• pp.367.2-367
• /
• 2002

영화관의 구조설계에서 중요한 고러 인자 중에서 음향적 관점뿐만 아니라, 영사기의 진동으로 인한 영상의 떨림 현상은 관람석에서 미치는 구조물의 동적 특성 문제가 있다. 이는 영사기-스크린-관람객 사이의 3인자에 대한 상대진동허용변위에 의해 지배됨을 고려하여, 이를 만족시키는 변수 등에 따른 진동허용규제치를 결정하는 절차가 필요하다 본 연구에서는 영화관의 진동허용규제치를 이들 3인자에 대한 변수들을 고려한 결정 과정을 공학적인 차원에서 정리하였으며, 복합상가 건물내의 영화판 영사실에 이를 만족하기 위한 진동 저감설계 자료에 활용하였다.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.199-208
• /
• 2001

본 연구의 목적은 교대가 설치된 지반의 사면안전율과 교대측방변위의 관계를 분석하여 교대의 측방이동 판정기준을 마련하고자 함에 있다. 이를 위하여 국내의 연약지반에 설치된 30개 교대의 측방이동사례를 조사하고, SLOPILE (Ver 2.0)프로그램을 이용하여 교대의 측방변위와 교대기초말뚝의 사면안정효과를 고려한 사면안정해석을 실시한다. 해석결과 교대기초말뚝의 실측측방변위를 고려할 경우 1.8이상 되어야 한다. 또한, 교대기초말뚝의 허용측방변위량에 따른 사면안정 해석결과, 교대의 허용측방변위가 작게 규정될수록 사면안정성에 기여하는 말뚝의 효과는 감소하고 있음을 알 수 있다.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.14 no.1
• /
• pp.29-34
• /
• 2001

구조물설계에 있어서 영향선은 최대반력, 최대전단력, 최대휨모멘트 등을 계산하는데 아주 유용하게 사용된다. 모멘트분배법, 인도행렬법, 전달행렬법, 그리고 Muller-Breslau 원리에 의한 단순보와 연속보의 영향선은 잘 알려져 있고 또 교량공학에서 널리 사용되고 있다. 그러나 변위를 허용하는 특별한 구조물의 영향선을 계산할 경우에는 약간의 어려움이 있다. 이 연구에서는 절점변위를 허용하는 문형라멘의 영향선을 전달행렬법에 의하여 구하고 유한요소법에 의하여 얻은 영향선과 비교하였고 그 결과는 좋은 일치를 보이고 있다.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.20 no.2
• /
• pp.40-48
• /
• 2016

To observe the rail-slab interaction in continuous welded railway(CWR) bridge when earthquake occurs, additional axial rail stresses and relative longitudinal displacements between rail and bridge deck were calculated with input of various load combinations and 3 different types of seismic loads to an analytical model. As results of analysis, it can be found that standard response spectrum proposed by Korea Rail(KR) network authority for earthquake design showed less additional axial rail stresses than allowable levels, but greater relative longitudinal displacement between rail and bridge deck, which means that adjustment of relative longitudinal displacement within a standard level is much more difficult than axial train stress. Additionally, if a large-scaled earthquake as occurred at Kobe, Japan comes up, then both of additional axial rail stress and relative displacement in rail-bridge deck may exceed allowable levels, which indicates to make proper design guides against sudden earthquake occurrence.