• The Science & Technology
• /
• v.21 no.12 s.235
• /
• pp.60-67
• /
• 1988

31년 전 창업한 디지틀 이큅먼트사(DEC)는 연간 매출고 1백억 달러에 이익 10억 달러를 올리는 컴퓨터계의 제2인자가 되었다. DEC는 IBM에 비해 규모는 6분의 1에 지나지 않지만 지난 20년대 이 '정보산업의 거인'IBM의 가장 두려운 도전자의 자리를 지켜왔다. 그래서 업계에서는 DEC를 골리앗IBM에 대항하는 '다윗'으로 비유하고 있다. DEC의 매출고는 1984년이래 중형 컴퓨터인 백스 미니컴퓨터의 큰 성공에 힘입어 불과 4년간에 2배로 급증했다. 대당 1만 5천 달러에서 70만 달러의 이 중형 컴퓨터시장에서 DEC의 시장점유율은 1984년의 19%에서 현재 25%으로 뛰어올랐으나 IBM은 24%에서 16%로 오히려 줄어들었다.

• Nuclear Engineering and Technology
• /
• v.41 no.2
• /
• pp.155-162
• /
• 2009

Since the 90's, EDF and AREVA-NP have irradiated, up to very high burnups, lead assemblies housing $M5^{(R)}$ cladded fuels. Post-irradiation examination of high burnup $UO_2$ pellets show an increase in the fission-gas release rate, an increase in fuel swelling, and formation of fission-gas bubbles throughout the pellets. Xenon abundances were quantified, and phenomena leading to this bubble formation were identified. All examinations provided valuable data on the complex state of the fuel during irradiation. They show the good behavior of these fuels, exhibiting various microstructures at very high burnups, none of which is likely to lead to problems during irradiation.

• Clean Technology
• /
• v.21 no.2
• /
• pp.124-129
• /
• 2015

The constant-volume method was used to determine the solubility of CO₂ in various physical absorbents such as DMPEG (dimethyl ether of polyethylene glycol), DEC (diethyl carbonate), DMC (dimethyl carbonate), and TAT (triacetin) in the total pressure range from 5 to 30 bar. The Peng-Robinson equation of state has been used to describe the equilibrium behavior of these mixtures. It was found that the solubility of absorbents was in the of DMPEG250 > TAT > DEC > DMC at the same temperature. Futhermore, the solubiity of blended absorbent of DMPEG250 and DEC is higher than that of DMPEG 250 alone. Therefore, blended absorbent of DMPEG250 and DEC is expected to be an effective and low cost absorbent for physical absorption in precombustion CO₂ capture.

• Journal of Life Science
• /
• v.28 no.11
• /
• pp.1268-1276
• /
• 2018

The cytidine analog decitabine (DEC) acts as a nucleic acid synthesis inhibitor, whereas ammonium pyrrolidine dithiocarbamate (PDTC) is an inhibitor of nuclear factor-${\kappa}B$. The aim of this study was to investigate the possible synergistic inhibitory effect of these two inhibitors on proliferation of human gastric cancer AGS cells. The inhibitory effect of PDTC on AGS cell proliferation was significantly increased by DEC in a concentration-dependent manner, and this inhibition was associated with cell cycle arrest at the G2/M phase and the induction of apoptosis. This induction of apoptosis by the co-treatment with PDTC and DEC was related to the induction of DNA damage, as assessed by H2AX phosphorylation. Further studies demonstrated that co-treatment with PDTC and DEC induced the disruption of mitochondrial membrane potential, increased the generation of intracellular reactive oxygen species (ROS) and the expression of pro-apoptotic Bax, and down-regulated the expression of anti-apoptotic Bcl-2, ultimately resulting in the release of cytochrome c from the mitochondria into the cytoplasm. Co-treatment with PDTC and DEC also activated caspase-8 and caspase-9, which are representative caspases of the extrinsic and intrinsic apoptosis pathways. Co-treatment also activated caspase-3, which was accompanied by proteolytic degradation of poly (ADP-ribose) polymerase. Taken together, these data clearly indicated that co-treatment with PDTC and DEC suppressed the proliferation of AGS cells by increasing DNA damage and activating the ROS-mediated extrinsic and intrinsic apoptosis pathways.

• Journal of Embryo Transfer
• /
• v.26 no.3
• /
• pp.153-158
• /
• 2011

This study was performed in order to simplify the operation and minimize stress of donor and be readily available in the field with low cost and high quality embryos using the Direct Embryo Collection (DEC). Donors, at random stages of the estrous cycle, received a CIDR. 7 days later, 200 mg FSH was treated with 40, 30, 20, 10 mg FSH levels in declining doses twice daily by intramuscular injection for 4 days. On the 3rd day administration of FSH, 25 mg $PGF_2{\alpha}$ was administered and CIDR was withdrawn. After FSH injections were complete, donors were artificially inseminated twice at 12 hr intervals. The donor cattle received 250 ${\mu}g$ GnRH at time of 1 st insemination and embryos were recovered 8 days after the 1st insemination. Embryo collection from superovulated donors was performed to flushing by non-surgical methods of 3-way, 2-way and DEC (l-way). The average number of recovered embryos were 11.25${\pm}$0.63, 12.5${\pm}$0.65 and 11.75${\pm}$0.48 from operations of 3-way, 2-way and DEC methods, respectively. There were no significant differences among the embryo collection methods. Also, The average number of transferable embryos were 6.25${\pm}$0.48, 7.25${\pm}$0.48 and 7.25${\pm}$0.63 from each embryo collection procedures. The number of transferable embryos was no differences among the 3-way, 2-way and DEC methods, respectively. Meanwhile, the ratio of transferable embryos for all recovered embryos from DEC methods was higher as 61.7 % than 55.6 %, 58 % from methods of 3-way, 2-way. And the flushing solution required for recovering embryos by DEC method was significantly lower as 0.28${\pm}$0.32 1 than 1.8${\pm}$0.12 1, 1.75${\pm}$0.10 1 from 3-way, 2-way methods (p<0.05). Also, the time required for recovering embryos by DEC methods was significantly lower as 27${\pm}$2 min than 51${\pm}$3, 45${\pm}$2 min, respectively (p<0.05). In conclusion, these results suggest that DEC method for embryo collection may be effectively used for production of in vivo embryos using less flushing solution and, it might be effectively available in the field compared to conventional embryo recovery methods using 3-way or 2-way balloon catheter.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.33 no.4
• /
• pp.455-463
• /
• 2023

Objectives: The aim of this study was to develop an air sampling and analytical method for estimating worker exposure to linear carbonate solvents and to evaluate the method. Methods: The target substances were three linear carbonates: DMC, DEC, EMC. GC/FID was used for sample analysis. Laboratory experiments were conducted to determine desorption solvents and sample capacity, and to evaluate storage stability, accuracy, and precision. Results: Coconut Shell Charcoal (CSC, 100/50 mg) was used as the air sampling media, and a desorption solvent of 5% methanol/95% dichloromethane was selected. Recommended sampling capacities were 1~11 ℓ for DMC, 1~18 ℓ for DEC, and 1~24 ℓ for EMC. The stability of three linear carbonates was demonstrated over 30 days in a refrigerator (4℃). Detection limits were determined as follows: DMC 0.26 ㎍/sample, DEC 0.24 ㎍/sample, and EMC 0.25 ㎍/sample. The total coefficient of variation was calculated as DMC 0.064, DEC 0.079, and EMC 0.07. Conclusions: This sampling and analysis method is suitable for estimating personal exposure to linear carbonates in the workplace.

• Journal of the Korean Electrochemical Society
• /
• v.5 no.3
• /
• pp.99-105
• /
• 2002

This study investigated characteristics of ICR18650 batteries with different electrolyte compositions in the range of $80^{\circ}C\~-30^{\circ}C$. ICR18650 cells using $1M\;LiPF_6,\;EC:\;DEC:\;DMC(3:5:5)\;and\; 1M\;LiPF_6,\;EC:\;DEC:\;DMC:\;EMC(3:5:4:1)$ electrolyte systems, which DMC and EMC solvent were added in $1M\;LiPF_6,\;EC:\;DEC$ electrolytes have high specific energy in the wide range of temperature. The specific energy of ICR18650 batteries using $1M\;LiPF_6,\;EC:\;DEC:\;DMC(3:5:5)\;and\; 1M\;LiPF_6,\;EC:\;DEC;\:\;DMC:\;EMC(3:5:4:1)$ electrolyte at $-30^{\circ}C\;was\;64\%\;and\;59\%$ of room temperature$(25^{\circ}C)$, respectively.

• 한국전기화학회:학술대회논문집
• /
• 2000.10a
• /
• pp.35-35
• /
• 2000

• Journal of Veterinary Clinics
• /
• v.15 no.2
• /
• pp.432-441
• /
• 1998

The electrocardiogram (ECG) and electrolytes were measured to obtain diagnostic data after experimental obstruction of duodenum in 8 dogs. Clinical signs of these appeared lower heart rate, temperatures respiration and blood pressure than signs of preoperation. In changes of electrolytes and acid-base balances, all dogs appeared hyponatremiai hypochloremia, metabolic alkalosis, and increased pHi HCO3, scot in blood, but potassium values appeared to increase in 3 cases fl-inc.) and to decrease in 5 cases (K- dec.) Two of three in K-inc. and three of five in K-dec. died at 60 hrs and 72 hrs after obstruction respectly. In changes of ECGI amplitudes of the K-inc cases appeared high in T wave and low in R wave, but amplitudes of the K-dec cases appeared low T waver 57 segment and high in R wave. Conduction times of the K-inc appeared the shorted PR intervals but the K-dec appeared the prolonged PR interval. The changes of these appeared apparently in lead II.

• Journal of the Korean Society of Safety
• /
• v.38 no.5
• /
• pp.8-14
• /
• 2023

Lithium ions can induce the thermal runaway phenomenon and lead to reignition due to electrical, mechanical, and environmental factors such as high temperature, smoke generation, explosions, or flames, which is extremely likely to create safety concerns. Therefore, one of the ways to improve the flame retardancy of the electrolyte is to use a flame-retardant additive. Comparing the associated characteristic value of existing substances with the required experimental value, it was found that these values were either considerably different or were not documented. It is vital to know a substance's combustion characteristic values, flash point, explosion limit, and autoignition temperature (AIT) as well as its combustion characteristics before using it. In this research, the flash point and AIT of materials were measured by mixing a highly volatile and flammable substance, diethyl carbonate (DEC), with flame-retardant dimethyl methylphosphonate (DMMP). The flash point of DEC, which is a pure substance, was 29℃, and that for DMMP was 65℃. Further, the lower explosion limit calculated using the measured flash point of DEC was 1.79 Vol.%, while that for DMMP was 0.79 Vol.%. The AIT was 410℃ and 390℃ for DEC and DMMP, respectively. In particular, since the AIT of DMMP has not been discussed in any previous study, it is necessary to ensure safety through experimental values. In this study, the experimental and regression analysis revealed that the average absolute deviation (ADD) for the flash point of the DEC+DMMP DEC+DMMP system is 0.58 sec and that the flash point tends to increase according to changes in the composition employed. It also revealed that the AAD for the AIT of the mixture was 3.17 sec and that the AIT tended to decrease and then increase based on changes in the composition.