• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.44 no.5
• /
• pp.103-111
• /
• 2007

In this paper, we propose a VLSI architecture of hardware optimized high quality image signal processor for a Single-chip CMOS Image Sensor(CIS). The Single-chip CIS is usually used for mobile applications, so it has to be implemented as small as possible while maintaining the image quality. Several image processing algorithms are used in ISP to improve captured image quality. Among the several image processing blocks, demosaicing and image filter are the core blocks in ISP. These blocks need line memories, but the number of line memories is limited in a low cost Single-chip CIS. In our design, high quality edge-adaptive and cross channel correlation considered demosaicing algorithm is adopted. To minimize the number of required line memories for image filter, we share the line memories using the characteristics of demosaicing algorithm which consider the cross correlation. Based on the proposed method, we can achieve both high quality and low hardware complexity with a small number of line memories. The proposed method was implemented and verified successfully using verilog HDL and FPGA. It was synthesized to gate-level circuits using 0.25um CMOS standard cell library. The total logic gate count is 37K, and seven and half line memories are used.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.12-20
• /
• 2013

Even though extensive research results have been applied to wireless cellular systems to improve their capacity and coverage, severe performance degradation experienced in cell boundary areas still remains as a major limiting factor to prohibit further improvement of user equipment (UE) throughput. In the Long Term Evolution-Advanced (LTE-A) standard of the Third Generation Partnership Project (3GPP), Some advanced techniques have been introduced to overcome this "cell-edge problem", including coordinated multipoint transmission and reception (CoMP) and inter-cell interference coordination (ICIC). In this paper, we propose yet another strategy to improve the performance of low-tier UEs by using the concept of multiple beam direction patterns (BDPs). Such multiple BDPs can be implemented using multi-layer antenna arrays stacked vertically at base station (BS) sites to transmit signals in different main beam directions. In comparison to conventional three-sector antennas with a fixed beam pattern, the proposed methods makes signal transmission in a rotational fashion to significantly enhance the reception quality of UEs located near sector (or cell) edge areas, preventing the situation where certain UEs are marginally covered by the BS for the whole transmission time. Performance evaluation results show that the proposed scheme outperforms the conventional three-sector transmission by 171% in low 5% UEs in terms of the UE throughput.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.16 no.3
• /
• pp.27-34
• /
• 1987

The present paper was attempted to obtain the basic date concerning a reasonable preparing method and optimum fermentation conditions of Kochujang (Red pepper paste). To establish the standard quality of Kochujang, the chemical compositions and the volatile components of Kochujang was discussed. The native Kochujang collected from 80 households contained 40.51% of moisture, 6.00% of salts, 3.25 % of crude fat, 10.30 % of crude ash, pH 4.79, 9.28ml of tillable acidity. 19.60% of reducing sugar, 179.51 mg/100g of amino nitrogen and 4.43% of total nitrogen. The volatiles of Kochujang were extracted by a steam-distillation under the reduced pressure and determined by gas chromatography-mass spectrometry (GC-MS). Total volatile components identified in the native Kochujang were 46 components, i. e., 30 components in neutral fraction, 8 components in phenolic fraction and 8 components in acidic fraction, respectively. But no components were detected basic fraction.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.271-274
• /
• 2016

CT quality assurance imaging evaluation and enforcement as quantitative assessment by phantom image evaluation, assessment items include There are also contrasting the water attenuation coefficient, uniformity, noise, resolution, spatial resolution, 10mm slice thickness evaluation, contrast resolution, space for the resolution, the slice thickness evaluation, it is possible to estimate the error due to the evaluation by the subjective judgment of the tester, using a subjective error image processing program to be computed to minimize the objective evaluation. Basic recording conditions of the CT image quality control assessment is the same as special medical equipment quality control checks, the images were evaluated quantitatively using IMAGE J. For a CT attenuation coefficient, the uniformity, noise evaluation, were evaluated as CT quality control image the standard deviation of the measured value of the digital processing of image smaller and less noise uniform images than the, contrast and resolution assessment is the size of the diameter of a circle having a large the 1 inch, 0.75 inch, 0.5 inch quality if the diameter of the circle, was evaluated in the small circle in the near circle ellipse. Spatial resolution is evaluated by using a self-extracting features of an image processing program, all of the groups of members comprising the acceptance criteria to automatically extract, was evaluated to be very useful for the quantitative assessment. When CT image quality control assessment on the basis of the results such as the above, if using an image processing program to minimize the subjective judgment of the error evaluator and is determined more efficient than would be made quantitative evaluation.

• Korean Chemical Engineering Research
• /
• v.53 no.4
• /
• pp.496-502
• /
• 2015

Hydrocarbon dew point(HCDP), a property which is the most generally used for describing natural gas condensation, is a very important parameter of natural gas quality specifications. HCDP is strongly influenced by the concentration of the heavier hydrocarbon components, especially $C_6+$, so, along with compliance with gas quality specifications, build up of procedures for obtaining accurate HCDP is essential for gas transmission company, because hydrocarbon condensation present may cause serious operational and safety problems. This study has been carried out in an attempt to measure HCDP accurately by the automatic hydrocarbon dew point meter under the actual field conditions. Measured HCDP also has been compared with calculated HCDP using the composition determined by gas chromatograph and industry accepted equation of state at multiple pressures, along with the cricondentherm. The test results are 1) the automatic hydrocarbon dew point meter was able to measure stable HCDP continuously 2) the automatic hydrocarbon dew point meter has been performed reference measurement by pure propane with a known dew point from literature, and 3) A meaningful differences was observed when comparing the automatic hydrocarbon dew point meter and gas chromatograph results for synthetic standard gas mixtures and real gas mixtures.

• Journal of Digital Convergence
• /
• v.12 no.10
• /
• pp.317-327
• /
• 2014

To improve the efficiency of wireless channel, IEEE 802.11ac uses the DL MU-MIMO MAC scheme through which an AP transmits multiple frames to different mobile nodes simultaneously. IEEE 802.11ac DL MU-MIMO MAC needs a new step, called as TXOP sharing, between legacy IEEE 802.11n DL SU-MIMO's two operations, the obtaining an EDCA TXOP and the transmitting multiple frames for EDCA TXOP. In the TXOP sharing operation, both wireless channel destinations and frames transmitted for its TXOP period should are determined. So this paper deals with the TXOP sharing for improving IEEE 802.11ac MAC performance. However, the EDCA priority based method mentioned by IEEE 802.11ac standard document not fair among the buffers and the frames of buffers, and occurs in high_loss rate and high_delay about specific buffers. In this paper, we propose a new scheme of the TXOP sharing with sequencing p-AC, s-AC in similar properties, and all S-AC. This method provides a differentiated service without damage of EDCA characteristics.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.23 no.2
• /
• pp.168-176
• /
• 2017

HNS accidents involve large-scale fires and explosions, causing numerous human casualties and extreme environmental pollution in the surrounding area. The widespread diffusion of effects should be prevented through rapid decision making. In this study, a high-quality, standardized, and digitized HNS accident databases has been generated based on the HNS standard code proposed. Furthermore, the HNS Accident Tracking System (HATS) was applied and implemented to allow for systematic integration management and sharing. In addition, statistical analysis was performed on 76 cases of domestic HNS accident data collected over 23 years using HATS. In Korea, an average of 3.3 HNS accidents occurred each year and major HNS accident factors were Springs (41 %), Aprons (51 %), Chemical Carriers (49 %), Crew's Fault (45 %) and Xylenes (12 %). (The number in parentheses is the percentage of HNS accident factors for each HNS accident classification)

• Korean Journal of Plant Resources
• /
• v.18 no.1
• /
• pp.161-168
• /
• 2005

Tuber yield and content of general component and diosgenin which is a main bioactive property were investigated in order to determine the growth characteristics of round typed yam(Dioscorea opposita L.) and the potential of artificial culture at Suwon, Korea. Tubers of round yam were initiated to form at 60 days after planting and then enlargement of tubers lasted by 160 days after planting. Compared to short typed yam(108g), tuber weight of round yam was higher(127g) on the basis of dry weight at 200 days after planting. In comparison of general component between round yam and short yam, protein of round yam$(3.62\%)$ was higher than short yam$(2.10\%)$. Water content in round yam$(64.5\%)$ was lower in short yam$(79.4\%)$, indicating a higher dry weight ratio of round yam. Hardness of round yam was 2787.6 while short yam showed about two times higher hardness(4946.9). Lightness was higher in round yam(77.4). In tuber extracts analysis, diosgenin content was respectively $3.32\%$ in round yam and $2.61\%$ in short yam.

• Korean Journal of Food Science and Technology
• /
• v.14 no.4
• /
• pp.350-354
• /
• 1982

These studies were conducted to evaluate the milling characteristics of Korean wheat cultivars and breeding lines harvested in 1980 and 1981. The straight-grade flour yield (by Buhler experimental mill) for all tested wheats was in a range of 56 to 73% with a mean value of 65% and the flour ash content averaged 0.44%. Mean milling score for all tested wheats was about 78. Average ash values of wheats harvested in 1980 and 1981 were 665.3 and 683.5, respectively, and flour protein content averaged 10.55% and 10.25%, respectively. There were significant positive correlations between flour yield vs. milling score, ash content vs. ash value and protein content vs. ash value, while there were negative correlation between flour ash vs. milling score, protein content vs. milling score and milling score vs. ash value.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.31 no.4
• /
• pp.409-414
• /
• 2011

This study was conducted to find out an alternative way of rapid and accurate analysis of forage quality. Near Infrared Reflectance Spectroscopy (NIRS) was used to evaluate the possibility of forage analysis. 175 samples consisted of Italian ryegrass, whole crop barley and pea seeded spring in 2009 were collected. The samples were analyzed for moisture, crude protein (CP), crude ash (CA), acid detergent fiber (ADF), and neutral detergent fiber (NDF), and also scanned using NIRSystem with wavelength from 400~2,500 nm. Multiple linear regression was used with wet analysis data for developing the calibration model and validated unknown samples. The important index in this experiment were SEC, SEP. The r2 value for moisture, CP, CA, ADF, and NDF in calibration set was 0.65, 0.97, 0.93, 0.99, and 0.97 and also was 0.15, 0.94, 0.96, 0.98 and 0.98 in validation set, respectively. The results of this experiment indicates that NIRS was reliable analytical method to assess forage quality for CP, CA ADF and NDF except moisture content in forage when proper samples incorporated into the equation development.