• Journal of the Institute of Convergence Signal Processing
• /
• v.3 no.2
• /
• pp.7-14
• /
• 2002

This paper proposes a camera motion estimation technique using special relations of motion vectors of geometrically symmetrical triple points of two consecutive views of single camera. The proposed technique uses camera-induced motion vectors and their relations other than feature points and epioplar constraints. As contrast to the time consuming iterations or numerical methods in the calculation of E-matrix or F-matrix induced by epipolar constraints, the proposed technique calculates camera motion parameters such as panning, tilting, rolling, and zooming at once by applying the proposed linear equation sets to the motion vectors. And by devised background discriminants, it effectively reflects only the background region into the calculation of motion parameters, thus making the calculation more accurate and fast enough to accommodate MPEG-4 requirements. Experimental results on various types of sequences show the validity and the broad applicability of the proposed technique.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.15 no.3
• /
• pp.167-178
• /
• 2010

To diagnose a stator winding fault caused by a short-circuited turn in a permanent magnet synchronous motor (PMSM), an on-line based fault detecting scheme during motor operation is presented. The proposed scheme is based on monitoring the second-order harmonic components in q-axis current obtained through the harmonic analysis and a winding fault is detected by comparing these components with those in normal conditions. The linear interpolation method is employed to determine harmonic data in arbitrary normal operating conditions. To verify the effectiveness of the proposed fault detecting scheme, a test motor to allow inter-turn short in the stator winding has been built. The entire control system including harmonic analysis algorithm and fault detecting algorithm is implemented using DSP TMS320F28335. The proposed scheme does not require any additional hardware and can effectively detect a fault during motor operation so long as the steady-state condition is satisfied.

• Korean Chemical Engineering Research
• /
• v.49 no.4
• /
• pp.456-459
• /
• 2011

Among the various activated carbons available in the market, an optimum mixing method of two kind activated carbons with different adsorbability was investigated in this study. The representative adsorption behaviors of the activated carbon are the adsorption isotherm plots obtained by the BET-Analysis which suggests also basic information of adsorption filter design. So we have tested three cases with certifications, the one was the extreme case of coal cokes based activated carbon with highest BET-model and coconut-shell based activated carbon with the lowest Langmuir-model, the other middle and cross case were applied this method to two kinds of activated carbons with higher and lower specific surface areas which are not available but supplied as research samples by an authority of an Korean Research Institute.

• Management & Information Systems Review
• /
• v.31 no.4
• /
• pp.377-395
• /
• 2012

The purposes of this research was to examine the relationship between two forms of satisfaction, commitment and turnover intentions at organization, job. Also consistent with the Meyer et al(1993) notion of the three-component model of organizational commitment. Although researchers have examined organizational commitment in relation to a wide range of variables, there has been no discriminant validity of commitment at occupation and job. The purpose of the present article, are to compare the relation between satisfaction forms, commitment forms and turn intentions forms. Confirmatory factor analysis supported the proposed distinction between the three forms of commitment and two turnover intentions forms at the measurement level in the distribution industry(N=156). Results using structural equation analysis with AMOS18 showed that job satisfaction had an positive impact on job commitment forms. Organizational satisfaction positive impact on two turnover intentions forms. However it revealed that no significant relation between organizational satisfaction and job commitment, job commitment and job turnover intentions.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.2
• /
• pp.109-116
• /
• 2005

The high performance drives of the slotless Permanent Magnet Brushless DC(PM BLDC) motor can be achieved by the current control, where the currents flow according to the rotor position and the current phase is suitably controlled according to the operational condition. Rotor position information can be provided by Hall-IC or sensorless algorithm. So, the Hall-ICs are set up in this motor to detect the main flux from the rotor. Instead of using three Hall-ICs and encoder, this paper uses only two Hall-ICs for the permanent magnet rotor position and the speed feedback signals, and uses a micro-controller of 16-bit type (80C196KC). Also because of low resolution obtained by using Hall-IC even low-cost and simple structure, to improve the wide range of speed response characteristic more exactly, we propose the rotor position signal synthesizer using PLL circuit based on two Hall-ICs.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.2 no.3
• /
• pp.3-8
• /
• 2009

Environmental pollution caused by fossil fuel use and energy sources, the big concern is the rise of the current situation, one of the ways to overcome the interest in renewable energy is Gozo. Located on the west coast, especially the Saemangeum area and the northwest wind, the big advantage of the vast area that's got quite a number of wind turbines is expected. This study affirms that these expectations can be a wind energy resource survey sea area of the average wind speed of Kunsan 5 ~ 7m / s is enough, books are linked to the local marine wind farms can safely say that none of choejeokji said. In addition, the emergence of the wind resource to determine the density of the Weibull distribution is calculated using the number 1, the shape factor as a parameter to calculate the density of the wind a result, Gunsan Province was able to predict the emergence of the wind. In addition, by controlling the remote monitoring through the measurement exceeded the convenience and reliability at the same time you can achieve great results.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.6
• /
• pp.55-62
• /
• 2006

For the fault diagnosis of three-phase induction motors, we construct a experimental unit and then develop a diagnosis algorithm based on pattern recognition. The experimental unit consists of machinery module for induction motor drive and data acquisition module to obtain the fault signal. As the first step for diagnosis procedure, preprocessing is performed to make the acquired current simplified and normalized. To simplify the data, three-phase current is transformed into the magnitude of Concordia vector. As the next step, feature extraction is performed by kernel principal component analysis(KPCA) and linear discriminant analysis(LDA). Finally, we used the classifier based on radial basis function(RBF) network. To show the effectiveness, the proposed diagnostic system has been intensively tested with the various data acquired under different electrical and mechanical faults with varying load.

• Korean Journal of Optics and Photonics
• /
• v.14 no.6
• /
• pp.636-642
• /
• 2003

We proposed the optical system using two divided halftone images to hide the original image and a joint transform correlator. The encryption procedure is performed by the Fourier transform of the product of each divided image by visual cryptography and the same random image which is generated by computer processing. As a result, we can obtain two Fourier divided images which are used as the encrypted image and the decrypting key, respectively. In the decryption procedure, both the encrypted image and the decrypting key are located on the joint input plane. Then the original image is reconstructed on a CCD camera which is located in the output plane. An autocorrelation term of joint transform correlator contributes to decrypt the original image. To demonstrate the efficiency of the proposed system, computer simulations and noise analysis are performed. The result show that the proposed system is a very useful optical certification system.

• 한국노년학
• /
• v.38 no.1
• /
• pp.203-223
• /
• 2018

This study examined the validity and the reliability of the perceived elderly stigma scale. Moreover, we investigated the relationships between the perceived elderly stigma and demographic factors (age, gender, education, and income). The initial scale consisted of 5 factors (ability, personality, appearance, authoritarian dependency, and child-obsession) and 28 items. In order to test the validity and the reliability of the scale, this study conducted a survey with 693 adults aged 18 to 65. Based on the confirmatory factor analysis (CFA), the scale was modified to 5 factors (ability, personality, appearance, authoritarian dependency, and child-obsession) and 15 items and its convergent validity and discriminant validity were confirmed. In terms of the relationships between the perceived elderly stigma and demographic factors, age had a negative relationship with the "ability" stigma, and education was a negatively associated with the "appearance" stigma.

• Journal of Convergence for Information Technology
• /
• v.11 no.4
• /
• pp.35-45
• /
• 2021

The e-commerce industry using mobile or web is growing rapidly, and the emergence of various platform services is causing innovative changes in the e-commerce industry. This study aims to identify the attachment types of e-commerce users and to demonstrate the relationship between the PPerceived Usefulness, and Perceived Ease of Use by TAM. In order to empirically verify the research model of this study, a survey was conducted on ordinary people with experience using e-commerce and path analysis was conducted by using PLS to analyze its Internal consistency, Confirmatory factor analysis, Discriminant validity and Goodness-of-fit verification. As a result, a significant relationship between Perceived Stability, Perceived Usefulness, and Perceived Ease of Use was identified, could verify the association with the TAM and Acceptance Intention.