• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.373-373
• /
• 2011

$Cu(In,Ga)Se_2$(CIGS) 박막 태양전지는 Chalcopyrite계 박막 태양전지로 Cu, In, Ga, Se 각 원소의 조성을 적절히 조절하여 박막을 성장시킨다. 성장시킨 CIGS 박막은 광흡수계수가 105cm-1로 다른 물질 보다 뛰어나고 직접 천이형 반도체로서 얇은 두께로도 고효율의 박막 제작이 가능하다. 얇은 두께로도 충분히 빛의 흡수가 가능하지만, cell 표면 반사에 의한 광 손실은 cell 효율을 떨어뜨리게 된다. 본 연구에서는 CIGS 박막 태양전지의 광 흡수 향상을 위해 굴절률이 1.86인 ITO 위에 ITO보다 굴절률이 작은 $MgF_2$ (n=1.377) [1]를 80, 100, 120, 140 nm로 증착하여 $MgF_2$/Al/Ni/ITO/i-ZnO/CdS/CIGS/Mo/SLG 시료를 제작하고, optical reflectance, Quantum Efficiency를 이용하여 분석하였다. optical reflectance 분석 결과, $MgF_2$ AR coating을 한 경우, 두께가 두꺼워짐에 따라 광 반사도가 감소하는 경향을 보였다. 또한 AR coating 두께가 커짐에 따라 fluctuation이 점점 커지며, 파형이 장파장 쪽으로 shift하는 것을 관찰 할 수 있었다. Quantum efficiency (QE)를 분석한 결과 $MgF_2$ AR coating 할 경우, 측정된 대부분의 파장에서 QE가 향상되는 것을 확인할 수 있었다. 하지만 AR coating 두께에 따른 변화는 뚜렷한 차이를 보이지 않았다. AR coating 결과, JSC가 증가하여 efficiency가 향상되는 것을 확인 할 수 있다. 그러나 $MgF_2$ AR coating 80~140 nm 범위에서 cell 효율 변화의 뚜렷한 차이는 관찰할 수 없었다.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.987-988
• /
• 2007

리니어 모터는 일반적으로 회전하는 모터와 같이 여러 형상의 극간에서 발생되는 힘의 균형에 의해서 구동되는 것이 일반적이다. 특히 하나의 극간에서 미소 구동하는 리니어 모터는 구동력과 실제 이동하는 위치 사이에서 댐핑이나 무게와 함 사이에서 발생하는 가속력의 차이에 의해서 주어진 힘의 파형과 움직이는 위치의 괴적이 만들어가는 이동자의 위치 사이에는 다소 시간 처짐이 발생하게 된다. 본 논문에서는 구동력과 실제 이동하는 위치 사이의 시간 처짐의 원인으로 알려져 있는 여러 요소중 주파수와 입력전류를 변화시키고 이에 따른 선형전동기의 power factor의 변화와 공진주파수의 관계 등 선형전동기의 구동력 변화를 알아보았다. IT 기기 냉각용으로 제작한 횡자속 선형전동기에서 공진구동용 스프링을 장착하고 공진주파수 부근과 power factor가 가장 큰 값을 가지는 부근의 주파수를 선정하고 입력전류에 따른 전류, 전압, 위치, 역율을 알아보았다.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.9 no.2
• /
• pp.32-39
• /
• 2005

The effectiveness of the pogo suppression device (PSD) on the response of the piping system simulating the fuel (or oxidizer) supply lines of the rocket engines was investigated. The system response defined as the ratio of the flow rate to the pressure in the main tube was obtained for various PSD gas volumes $((0\~2)\times10^{-3}m^3)$ and three different baffle hole diameters (5, 50, 115mm). Existence of a gas volume in the PSD reduced the system resonance frequency. With a larger gas volume, the resonance frequency became lower, but only slightly, while the fluctuations of the main tube pressure and the flow rate damped down considerably. The resonance frequency decreased with the increase of the PSD inlet restriction (or the decrease of the baffle hole diameter), though slightly. However, with a larger inlet restriction, the PSD pressure wave showed a delayed response with the smaller amplitude compared to the pressure variation in the main tube.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.16 no.1
• /
• pp.36-41
• /
• 2013

In this paper time series wave data are simulated using wave spectrum with random phases of the wave signal. The simulated wave signals are used to study the effect of the sampling rate on the ocean wave characteristics. Effect of sampling rate on wave data which include extreme wave such as freak waves are examined and various wave characteristics including abnormality index (AI), kurtosis of wave profile and maximum wave height are examined. Various wave heights are decreased as the sampling rate decreases. The zero-th moment of the wave spectrum does not affect much on the sampling rate but the second moment are greately affected on the sampling rate. The error due to the sampling rate is decreases as the wave period increases. The error in significant wave height based on the wave spectrum $H_s$ is smaller than that on the time domain method $H_{1/3}$. AI index and kurtosis of wave profile do not deviate much from the exact date as long as the sampling rate is greater than 1 Hz. Ocean wave measurement with the sampling frequency higher than 1 Hz will result the error less than 5% in estimating the height of extreme waves.

• Korean Journal of Food Science and Technology
• /
• v.39 no.5
• /
• pp.506-514
• /
• 2007

In this study, carrot juice was treated with high voltage pulsed electric fields (PEF) and the changes in its physical and chemical properties during storage at $4^{\circ}C$ and $25^{\circ}C$ were investigated. The sterility fur bacteria, yeast and mold in carrot juice increased with increasing electric field strength and treatment temperature. While yeast and mold were completely inactivated at 65kV/cm with a treatment time of $200{\mu}s$ in a continuous PEF treatment system, bacteria were reduced by four log cycles. The results also showed that square wave pulse treatment was more effective for inactivating microorganisms than exponential decay pulse, and this effect was more apparent for carrot juice of lower pH. Although we observed significant changes in physical and chemical properties such as soluble solid content, pH, acidity, color, and carotene retention when the PEF treated samples were stored at the ambient temperature $(20^{\circ}C)$, no significant physical and chemical changes were found at the cold storage temperature $(4^{\circ}C)$ during 28 days of storage. The results indicate that the PEF treated carrot juice is appropriate for commercial refrigerated storage.

• Journal of Biomedical Engineering Research
• /
• v.25 no.4
• /
• pp.269-275
• /
• 2004

Different biological tissues have different values of electrical resistivity. In EIT (electrical impedance tomography), we try to provide cross-sectional images of a resistivity distribution inside an electrically conducting subject such as the human body mainly for functional imaging. However, it is well known that the image reconstruction problem in EIT is ill-posed and the quality of a reconstructed image highly depends on the measurement error. This requires us to develop a high-performance EIT system. In this paper, we describe the development of a 16-channel digital EIT system including a single constant current source, 16 voltmeters, main controller, and PC. The system was designed and implemented using the FPGA-based digital technology. The current source injects 50KHz sinusoidal current with the THD (total harmonic distortion) of 0.0029% and amplitude stability of 0.022%. The single current source and switching circuit reduce the measurement error associated with imperfect matching of multiple current sources at the expense of a reduced data acquisition time. The digital voltmeter measuring the induced boundary voltage consists of a differential amplifier, ADC, and FPGA (field programmable gate array). The digital phase-sensitive demodulation technique was implemented in the voltmeter to maximize the SNR (signal-to-noise ratio). Experimental results of 16-channel digital voltmeters showed the SNR of 90dB. We used the developed EIT system to reconstruct resistivity images of a saline phantom containing banana objects. Based on the results, we suggest future improvements for a 64-channel muff-frequency EIT system for three-dimensional dynamic imaging of bio-impedance distributions inside the human body.

• Journal of Korea Game Society
• /
• v.12 no.1
• /
• pp.103-111
• /
• 2012

Games in 1970s have used the savings of analog wavelength as in music and the like on hardwares of small cassette, gramophone, and the like. Due to these configuration elements, durability has to be declined so much. In the event of using the music on the video game, more affordable method is to use the computer chip to convert the analog sound into the computer code to convert into the electric wavelength to send to the speaker. The sound effect of the game is generated in this method. The technical limit has been gradually overcome to grant more freedom to the composers and the sound track pre-recorded on the optic disc and the like has emerged. The game developers of today have made several attempts on the technology to produce the game music. This study has contemplated the process of advancement in the change of game music production with the influence on technology and business.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.2
• /
• pp.145-151
• /
• 2012

The pulsimeter is a representative device in the oriental medicine, which can analysis a risk factor in a cardiovascular diseases. However, most of the previous methods have the limit by the contacted sate of the brachial pulse and sensor in the measuring time, the inaccuracy of detected pulse, and the difficulty of pulse analysis. Accordingly, we propose the moving pulse image analysis based pulsimeter that can acquire a pulse of patient in real time by analyzing a moving image. then this video is shot the state change of the T.S. occurred by a pulse in capillary. In order to evaluate the performance of the our pulsimeter, we measured a respective detecting-rate about the essential 5 feature-points in the pulse analysis from the detected original pulse. As a result, the proposed method is very successful.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.21 no.1
• /
• pp.54-62
• /
• 2009

The present study investigates the behaviour of overtopping flows falling on the leeside of a caisson breakwater with dissipating blocks through laboratory measurements. The falling overtopping flows in the leeside are expected to directly affect the leeside stability of the breakwater. This study focuses on not the resultant stability but the characteristic pattern of the overtopping flows depending on wave conditions through examining front velocity and plunging distance in the leeside. Regular waves were used to investigate the dependence of the overtopping flow pattern on wave conditions and a modified image velocimetry combining the shadowgraphy and cross-correlation method was employed for measurements of image and velocity. From the measurements, it is shown that the plunging distance and front velocity of the overtopping flow in the breakwater leeside increase as the wave period or height increases. From non-dimensional relationships between the variables, empirical formula for the velocity and overtopping distance are suggested.

• Journal of the Society of Naval Architects of Korea
• /
• v.37 no.1
• /
• pp.82-90
• /
• 2000

An experimental study has been carried out at circulating water channel to investigate the non-breaking and breaking waves generated by a submerged circular cylinder steadily moving under the free surface. Free surface profiles and pressure distributions on cylinder surface were measured at various submerged depths of cylinder. They were complemented by the measurements of velocities, head losses and turbulence intensities in the wakes of body and "breaker". Part 1 of this three-part paper describes the experimental arrangement and the patterns of wave profile and pressure distribution at various depths of submergence. These databank contributions are of special interest in traditional ship hydrodynamics. In Part 2, special focuses are made to elucidate the viscous and turbulent aspects of flow field. Finally Part 3 will deal with the visualization of instantaneous vortical flow to study the mutual interaction between vorticies shedded from the free-surface and the cylinder using a Particle Image Velocimetry.