• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.12A
• /
• pp.1843-1851
• /
• 2000

ITU-R 권고안을 토대로 미래 IMT-2000 무선망에서의 소요 서비스 채널수 및 지상계 주파수 요구량을 분석한다. IMT-2000 가입자가 요구하는 서비스를 크게 회선과 패킷교환 서비스로 분류하고 옥내, 보행자 및 차량용의 가입자 이용 환경을 고려한다. 본 논문에서는 2010년경 각종 IMT-2000 서비스에 대한 시장성과 무선 전송 기술의 파라미터 값을 이용하여 가입자의 기준 트래픽과 셀내 발생 트래픽을 계산하고 필요한 무선 채널수 및 소요 주파수를 산출한다. 또한, ITU-R에서 권고한 기준 트래픽을 바탕으로 서로 다른 가입자 수와 트래픽 분포 및 이용 환경에서 필요한 무선 채널수와 소요 주파수를 산출하며, 채널수와 주파수 요구량에 대한 패킷 서비스 지연시간의 민감도를 분석한다.

• Journal of the Korean Society for Precision Engineering
• /
• v.20 no.3
• /
• pp.112-119
• /
• 2003

This paper presents the identification of rotor dynamic parameters. The solution of the system equation can be obtained using least square method. The sensitivity analysis is performed to extract optimized solution, which is considered to be insensitive to inherent measurement errors. The cosine and sine term of orbit shapes can be obtain ed through the by experiment of the orbit analysis at a different speed after doing orbit analysis at an arbitrary selected speed. This values measured time domain are used to search the stiffness and damping coefficients of rotor bearing.

• Proceedings of the KIPE Conference
• /
• 2018.11a
• /
• pp.213-214
• /
• 2018

본 논문에서는 전기자동차 온-보드 충전기용 단상 cycloconverter-type high frequency link 컨버터의 전력 제어성능과 동적 응답특성을 개선하기 위하여 예측전류제어 기법을 적용한다. 배터리를 충전 및 방전하기 위하여 전력계통에 연결되는 V2G 충전기는 전압 변동, 고조파 왜곡 등의 외란 발생에도 강인한 동적 응답 특성을 유지하여야 한다. 예측전류제어 기법이 적용된 제어기는 계통 외란이 존재하는 경우에도 전력 레퍼런스를 빠르게 추적하고 정확한 듀티를 생성할 수 있으므로 우수한 동적 및 과도 응답특성을 갖는다. 제안하는 제어기의 성능과 파라미터 변동에 대한 민감도는 PSIM 시뮬레이션을 이용하여 평가되며, 여러 계통외란 상태에서 PI 제어기와 비교된다.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.47 no.2
• /
• pp.1-7
• /
• 2010

This paper presents empirical equations indicating the high frequency performance characteristics of air-cored induction coil sensors with their constructional parameters. An air-cored induction coil sensor is widely used due to good linearity at low frequency ranges but the sensor has weakness of relatively low sensitivity to the magnetic field. At high frequency ranges, the sensitivity can be dramatically increased, largely depending on the frequency of the injected field, and this property can be a great asset to some electromagnetic inspections, since they utilize the interrogating current with a fixed frequency. The application of this property of the coil sensor requires the estimation of its high frequency performance. We made experiments on the frequency responses of the coil sensors under diverse constructional conditions and, on the basis of the experimental results, the high frequency performance, such as the resonant frequency and the sensitivity at the frequency, was estimated, as a function of the constructional parameters of the coil sensor. The good agreements between experimental and estimated data were reported.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6C
• /
• pp.588-592
• /
• 2009

In this paper, we propose a novel method to improve the performance of the global soft decision which is based on the second-order conditional maximum a posteriori (CMAP). Conventional global soft decision scheme has an disadvantage in that the speech absence probability adjusted by a fixed-parameter was sensitive to the various noise environments. In proposed approach using the second-order CMAP, speech absence probability value is more flexible which exploit not only the current observation but also the speech activity decisions in the previous two frames. Experimental results show that the proposed improved global soft decision method based on second-order conditional MAP yields better results compared to the conventional global soft decision technique with the performance criteria of the ITU-T P. 862 perceptual evaluation of speech quality (PESQ).

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.12
• /
• pp.603-610
• /
• 2016

Over 12 years have passed since the first commercial operation of a Korean high-speed train. Since then, the transport capacity of the high-speed lines has become almost saturated. Therefore, studies have been carried out to increase the operating speed of the trains in order to increase their transportation capacity. This study was carried out to improve the critical speed of the KTX-Sancheon, Korean high-speed train, in order to increase its operating speed. A dynamic analysis of the KTX-Sancheon train was performed using the contact data obtained from the wheel wear profiles that were measured from a KTX-Sancheon train in commercial operation. The analysis results were verified by comparing them with the measurement acceleration data obtained from KTX-Sancheon. The suspension parameters were optimized to improve the operation speed. The critical speed of KTX-Sancheon was increased by 9.4% after the optimization by the response surface method. The optimized suspension parameters are expected to be used for the new bogie design to increase the operating speed of KTX-Sancheon from 300km/h to 350km/h.

• Journal of the Korean GEO-environmental Society
• /
• v.5 no.1
• /
• pp.55-64
• /
• 2004

Stone column is a soil improvement method and can be applicable for loose sand or weak cohesive soil. Since the lack of sand in korea, stone column seems one of the most adaptable approach for poor ground as a soil improvement technique. However, this method was not studied for practical application. In this paper, the most affective design parameters for the bearing capacity of stone column were studied. The parametric study of major design factors for single stone column was carried out under the bulging and general shear failure condition, respectively. Especially, a test result of single stone column by static load was compared with the bearing capacity values of suggested formulas. The analysis result showed that the ultimate bearing capacity by the formula was much less than the measured value by the static load test. Especially, the result of the parametric study under general shear failure condition showed that the bearing capacity has big difference between each suggested formulas with the variation of the major design parameters. Therefore, the result of this study can be appliable for the future stone column project.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.12
• /
• pp.197-205
• /
• 2013

In this study, we developed a program of optimizing stand-level carbon stock using a stand-level yield model and the Simulated Annealing (SA) heuristic method to derive a optimized forest treatment solution. The SA is one of the heuristic algorithms that can provide a desirable management solution when dealing with various management purposes. The SA heuristic algorithm applied 'thermal equilibrium test', a thresholds approach to solve the phenomenon that does not find an optimum solution and stays at a local optimum value during the process. We conducted a sensitivity test for the temperature reduction rate, the major parameter of the thermal equilibrium test, to analyze its influence on the objective function value and the total iteration of the optimization process. Using the developed program, three scenarios were compared: a common treatment in forestry (baseline), the optimized solution of maximizing the amount of harvest(alternative 1), and the optimized solution of maximizing the amount of carbon stocks(alternative 2). As the results, we found that the alternative 1 showed provide acceptable solutions for the objectives. From the sensitivity test, we found that the objective function value and the total iteration of the process can be significantly influenced by the temperature reduction rate. The developed program will be practically used for optimizing stand-level carbon stock and developing optimized treatment solutions.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.8 no.4
• /
• pp.46-54
• /
• 1994

Exhbitlon hghting design be done aftrr due consideration of the photochermcal reaction and h ~ ~ i i tc~.fficits~ upn exposure to light. In this study the balanced judgement is as follows. The most light-susceptible material shouid be illu~stratrui less than 50[k] (illurnlnance-hours per year : 120, 000k.h)and the illuminance of moderately sensitive rriatcrinl k 200[1x] (illuminance hours per year : 480, 0001x.h). Moreover to minimize damage the sources of light shoulcl not only contribute as little as heat possible but remove ultraviolt radiation by filters. Also the sources of light must have good color rendering and low color temperature.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.5
• /
• pp.360-368
• /
• 2008

A lumped parameter model of Li-ion battery in hybrid electric vehicle(HEV) is constructed and system parameters are identified by using recursive least square estimation for different C-rates, SOCs and temperatures. The system characteristics of pole and zero in the frequency domain are analyzed with the parameters obtained from different conditions. The parameterized model of a Li-ion battery indicates highly dependent of temperatures. To estimate SOC and polarization voltage, a Luenberger state observer is utilized. The P- or PI-gains of observer based on a suitable natural frequency and damping ratio is adopted for the state estimation. Satisfactory estimation accuracy of output voltage and SOC is especially obtained by a PI-gain. The feasibility of the proposed estimation method is verified through experiment under the conditions of different C-rates, SOCs and temperatures.