• Journal of the Korean Society for Railway
• /
• v.17 no.5
• /
• pp.373-380
• /
• 2014

With a view to the commercialization of the Korean automatic variable-gauge bogie in the Eurasia railway system, the aim of this research was to perform an economic analysis concerning the possible introduction and operation of this bogie at the present time. For this purpose, we compared the possible types of freight connection service for container transportation, transshipment and the gauge-adjustable system, estimating the total life-cycle cost (LCC) incurred by each system, depending on type and quantity, over the whole process of acquisition, operation, maintenance and disposal. Based on this, we presented a case-by case analysis. Furthermore, in estimating economic feasibility, we analyzed the cost-benefit ratio taking into account not only the objective LCC, but also the reduced time required for the gauge-change and customer convenience. After estimating the LCC and analyzing the cost-benefit ratio of the respective systems, we demonstrated the economic superiority of view of the gauge adjustable system.

• Spatial Information Research
• /
• v.21 no.5
• /
• pp.33-41
• /
• 2013

Recently, the number of disasters has been seriously increasing. The total damages by the natural or man-made disasters during the past years resulted in tremendous fatalities and recovery costs. It is necessary to have efficient emergency evacuation management which is concerned with identifying evacuation route, and the estimation of evacuation and clearance times. An emergency evacuation model is important in identifying critical locations, and developing various evacuation strategies. In that existing evacuation models have focused on route analysis for indoor evacuation, there are only a few models for areawide emergency evacuation analysis. Therefore, we developed a mesoscopic model by using Cube Avenue and performed evacuation simulation, targeting road network in City of Fargo, North Dakota. Consequently, a mesoscopic model developed in this study is used to carry out dynamic analysis using network and input variable of existing travel demand model. The results of this study show that the model is an appropriate tool for areawide emergency evacuation analysis to save time and cost. Henceforth, the results of this study can be applied to develop a disaster evacuation model which can be used for a variety of disaster simulation and evaluation based on scenarios in the local metropolitan area.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.4
• /
• pp.54-62
• /
• 2018

As a part of realization of artificial intelligence signal(AI Signal), this study proposed an actuated signal algorithm based on vehicle queue length that estimates in real time by deep learning. In order to implement the algorithm, we built an API(COM Interface) to control the micro traffic simulator Vissim in the tensorflow that implements the deep learning model. In Vissim, when the link travel time and the traffic volume collected by signal cycle are transferred to the tensorflow, the vehicle queue length is estimated by the deep learning model. The signal time is calculated based on the vehicle queue length, and the simulation is performed by adjusting the signaling inside Vissim. The algorithm developed in this study is analyzed that the vehicle delay is reduced by about 5% compared to the current TOD mode. It is applied to only one intersection in the network and its effect is limited. Future study is proposed to expand the space such as corridor control or network control using this algorithm.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.23 no.4
• /
• pp.221-232
• /
• 2021

Most of measurement sensors used for maintenance are continuously exposed to various environmental factors such as transportation and rainfall, so the possibility of breakage increases gradually. The maintenance measurement sensor of domestic subway tunnel shows an average of 14.2% to 14.8% of loss rate after about 5 to 6 years from installation, and it shows a sensor loss rate of about 13.9% in case of foreign countries. As a result, it can be seen that an average of 15% of maintenance measurement sensors at home and abroad cannot send measuring values after 5~6 years. In order to continuously collect accurate data, measurement data must be recovered by performing repair or replacement of the sensor, but some lost measurement sensors are buried after installation. So, there are many difficulties in repairing sensors, including cost and time. Therefore, in this paper, we propose lost measurement sensor data estimation technology based on data trend analysis using adjacent sensors.

• Journal of Korean Society of Transportation
• /
• v.24 no.2 s.88
• /
• pp.91-100
• /
• 2006

This paper examines the situation and tasks of UK rail privatization, especially focusing on after the Hatfield rail accident. Earlier research which focused on the UK's Privatization had little knowledge of the explanations for recent changes. Moreover they had difficulty making a direct comparison between national rail and the privatized rail. Therefore we aye left without a good explanation which has a comprehensive perspective. I attempt to show the change in the rail privatization Process and its outcome, focusing on after the Hatfield rail accident. This Paper argues that the UK's vail privatization process has a regulatory framework which is too complicated with overlapping responsibilities that brought about inefficiency, increasing costs and a superficial safety regime. Especially the planning of rail and infrastructure maintenance did not come to play an appropriate role. However after 2000, the government took charge of setting the strategy for railways, and the Office of Rail Regulation covered safety performance and cost. explain that these changes present a good opportunity to solve the problem of passing the buck for poor performance. Through the analysis, I find that the passenger rail network is well-suited to deliver long distance business and commuters and that the subsidy from the government is decreasing. However, performance, for example punctuality and reliability. should be improved. Especially the Hatfield rail accident caused a reduction in the satisfaction of passengers. In future. the problems of rising costs and monopoly franchise system should be addressed.

• Journal of Korean Society of Transportation
• /
• v.24 no.5 s.91
• /
• pp.35-44
• /
• 2006

Acceleration and deceleration curves have been used for design purposes worldwide. The curve in design level has been regarded as an single deterministic curve to be used for design of climb lanes. It should be noted that the curve was originally made using ideal driving truck and that the curve is applied during design based on the assumption of no difference between ideal and real driving conditions. However. observations show that aged vehicles and lazy behavioring drivers nay make lower performance of vehicles than the ideal performance. The present paper provides the results of truck speeds at climbing lanes then probabilistic variation of acceleration and deceleration corves. For these purposes. a study about identification of vehicle makers, and weights for trucks at freeway toll gates and then observation of vehicle-following speed were performed. The 85%ile results obtained were compared with the deterministic performance curves of 180, 200, and 220 Ib/hp. It was identified that the performance of 85%ile results obtained from vehicle-following-speed observations were lower than one from deterministic performance curves. From these results, it may be concluded that at the beginning Point of climbing lanes additional $16.19{\sim}67.94m$ is necessary and that at the end point of climbing lanes $53.12{\sim}103.24m$ of extension is necessary.

• Journal of Korean Society of Transportation
• /
• v.27 no.2
• /
• pp.23-34
• /
• 2009

This paper is described as an experimental analysis for the probabilistic directional design hour volume estimation. The main objective of this paper is to derive acceptable design rankings, PK factors, and PD factors. In order to determine an appropriate distribution for acceptable design rankings, 12 probability distribution functions were employed. The parameters were estimated based on the method of maximum likelihood. The goodness of fit test was performed with a Kolmogorov-Smirnov test. The Beta General distribution among the probability distributions was selected as an appropriate model for 2 lane roadways. On the other hand, the Weibull distribution is superior for 4 lanes. The method of the inverse cumulative distribution function came up with an acceptable design ranking of design for LOS D. An acceptable design ranking of 2 lanes is 190, while an acceptable design ranking for 4 lanes is 164. The PK factor and PD factor of 2 lanes was elicited for 0.119 (0.100-0.139) and 0.568 (0.545-0.590), respectively. On the other hand, the PK factor and PD factor for 4 lanes was elicited as 0.106 (0.097-0.114) and 0.571 (0.544-0.598), respectively.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.1
• /
• pp.71-78
• /
• 2018

Transportation is gradually changing into the era of V2X and autonomous cars. Accurate judgement of traffic conditions is an important indicator of route choice or autonomous driving. There are many ways to use probes car such as taxis, as a way to identify accurate traffic conditions. These methods may vary depending on the characteristics of the probe vehicle, and there is a problem with the cost. The V2X vehicle can solve these problems and collect traffic information in real time. If all vehicles are of V2X vehicle, these issues are expected to be resolved briefly. However, if the communication information of a V2X vehicle is represented by a traffic representative in a traffic with only V2X, the traffic information of some V2X vehicles will be able to collect traffic information. To accomplish this, a virtual network and transport were created and various scenarios were performed through SUMO simulations. It has been analyzed that 3-5 % of V2 vehicles are capable of representative the road traffic characteristics. In the future, various follow-up studies are planned.

• Land and Housing Review
• /
• v.3 no.3
• /
• pp.241-248
• /
• 2012

Although infrastructure cost comprises the great proportion of residential development cost, all of it tends to be borne by land developers which develop large area. This brings about free-riding by adjacent small development or built-up area, followed by the equity problem in terms of infrastructure development cost sharing and the privatization of development gain. This study aims to establish the method to analyze free-riding on the transportation infrastructure(roads) and investigate empirically how much the free-riding occurs. It sets several development scenarios to calculate the part generated by Bucheon Sangdong district, the case area of this study, of all the traffic flow on the roads. The Network analysis is used to estimate the proportion, by development scenarios, of traffic flow, travel time, and travel cost. As a result, the developer of Bucheon Sangdong district is responsible for 83% of the construction cost of selected roads. The methodology and empirical result of this study would contribute to determine who are liable for the infrastructure facilitation and to estimate how much of the cost the obligators have to share.

• Journal of Korean Society of Transportation
• /
• v.29 no.3
• /
• pp.61-72
• /
• 2011

In the benefits of ITS, there are intangible gains from real-time traffic information as well as classical gains such as travel time saving. These intangible gains are difficult to be estimated by existing transportation investment appraisal commonly used in SOC investment. The major reason is not because of the absence of methodology but because of the absence of generalized values of particular benefits from real time traffic information. This research explores the value of real-time traffic information on VMS that is the most representative of ITS services, by using CVM with Double Bounded Dichotomous Choice Question. Willingness-To-Pay (WTP) functions of drivers are built with survival functions using various types of probability distribution functions such as Exponential, Log-logistic, and Weibull functions. The results reveal that Log-logistic distribution is the most appropriate distribution model to estimate WTP, and the estimated coefficients are stable through LR (Likelihood Ratio) test. For the further study, it is recommended to perform statistical tests of temporal and spatial transferability that is not examined in this research due to the lack of data.