• Journal of Bio-Environment Control
• /
• v.14 no.3
• /
• pp.190-195
• /
• 2005

This research was conducted to investigate the changes in soil chemical properties of root media as influenced by incorporation rate of a polyacryl amide hydrogel, Stocksorb C. The pH at 5 weeks after treatment in four root media such as peatmoss + vermiculite (1:1, v/v; PV), peatmoss + composted rice hull (1:1; PR), peatmoss + composted saw dust (1:1; PD) and peatmoss + composted pine bark (1:1; PB) containing STSB were in the range from 7.04 to 7.30, which was too high. Elevated incorporation rate of STSB resulted in increase of EC in soil solution of four root media with linear and quadratic response. The concentrations of $NH_4^+-N,\;NO_3^--N,\;PO_4-P^{3-},\;K^+,\;Ca^{2+}and\;Mg^{2+}$ in four kinds of root media increased as incorporation rates of STSB were elevated. But the $NO_3^-$-N concentrations in PS media were lower than those in other there root media tested. The Fe concentrations in PV, PR and PS media increased as incorporation rates of STSB were elevated, but those in PB medium did not show significant different. The concentrations of $Fe^{2+},\;Mn^{2+},\;Zn^{2+}and\;Cu^{2+}$ in PS media were higher than those in other three root media.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.4
• /
• pp.435-445
• /
• 2022

In this study, the reverberation of a bistatic sonar operated in southeastern coast in the East Sea in July 2020 was analyzed. The reverberation sensor data were collected through an LFM sound source towed by a research vessel and a horizontal line array receiver 1 km to 5 km away from it. The reverberation sensor data was analyzed by various methods including geo-plot after signal processing. Through this, it was confirmed that the angle reflected from the sound source through the scatterer to the receiver has a dominant influence on the distribution of the reverberation sound, and the probability distribution characteristics of bistatic sonar reverberation varies for each beam. In addition, parametric factors of K distribution and Rayleigh distribution were estimated from the sample through moment method estimation. Using the Kolmogorov-Smirnov test at the confidence level of 0.05, the distribution probability of the data was analyzed. As a result, it could be observed that the reverberation follows a Rayleigh probability distribution, and it could be estimated that this was the effect of a low reverberation to noise ratio.

• Journal of the Korean Applied Science and Technology
• /
• v.38 no.6
• /
• pp.1466-1475
• /
• 2021

Compound K (20-O-β-(_D-glucopyranosyl)-20(S)-protopanaxadiol) is an active ingredient of ginsenosides. Compound K has been known to produce from biotransformation by β-glucosidase action of human intestinal microbes after oral admistration of ginseng. We have investigated the cytotoxicity of compound K obtained from bio-converted ginseng extract. As a result, compound K showed no significant cytotoxicity in the concentration of 0.001 to 1 ㎍/mL and inhibited the production of TNF-α, MCP-1, IL-6 and NO in RAW 264.7 cells induced by LPS inflamation. In the same concentration, HaCaT cells induced by inflammation with TNF-α and IFN-γ decreased IL-8 production due to compound K treatment. In the brine shrimp lethality assay, the LC₅₀ of compound K was 0.37 mg/mL indicating some toxicity, but the bioconverted product containing 35% compound K showed relatively low toxicity with an LC₅₀ of 0.87 mg/mL. These results suggest that the compound K enriched extract is a potential functional material for acne relief cosmetic products.

• Restorative Dentistry and Endodontics
• /
• v.31 no.4
• /
• pp.263-268
• /
• 2006

Recently, self-etching adhesive system has been introduced to simplify the clinical bonding proce- dures. It is less acidic compared to the phosphoric acid, thus there is doubt whether this system has enough bond strength to enamel. The purpose of this study was to investigate the influence of additional etching on the adhesion of resin composite to enamel. Ninety extracted bovine permanent anterior teeth were used. The labial surfaces of the crown were ground with 600-grit abrasive paper under wet condition. The teeth were randomly divided into six groups of 15 teeth each. Clearfil SE $Bond^{\circledR},\;Adper^{TM}$ Prompt L-Pop and Tyrian $SPE^{TM}$ were used as self-etching primers. Each self-etching primers were applied in both enamel specimens with and without additional etching. For additional etching groups, enamel surface was pretreated with 32% phosphoric acid (UNI-ETCH, Bisco, Inc., Schaumburg, IL. USA). Hybrid resin composite Clearfil AP-X, (Kuraray Co., Ltd., Osaka, Japan) was packed into the mold and light-cured for 40 seconds. Twenty-four hours after storage, the specimens were tested in shear bond strength. The data for each group were subjected to independent t - test at p < 0.01 to make comparisons among the groups. In Clearfil SE $Bond^{\circledR}$, shear bond strength of additional etching group was higher than no additional etching group (p < 0.01). In $Adper^{TM}$ Prompt L-Pop and Tyrian SPE, there were no significant difference between additional etching and non-etching groups (p > 0.01). In conclusion, self-etching adhesive system with weak acid seems to have higher bond strength to enamel with additional etching, while self-etching adhesive system with strong acid seems not.

• The Journal of Korean Academy of Prosthodontics
• /
• v.57 no.2
• /
• pp.95-101
• /
• 2019

Purpose: The aim of this study is to evaluate the effects of various primers on the microtensile bond strength (${\mu}TBS$) of resin cements to cobalt-chromium (Co-Cr) dental casting alloy. Materials and methods: Four adhesive primers (Universal primer, Metal primer II, Alloy primer, and Metal/Zirconia primer) and two resin cements (Panavia F2.0, G-CEM LinkAce) were tested. One hundred fifty Co-Cr beams were prepared from Co-Cr ingots via casting ($6mm\;ength{\times}1mm\;width{\times}1mm\;thick$). The metal beams were randomly divided into ten groups according to the adhesive primers and resin cements used; the no-primer groups served as the control (n = 15). After sandblasting with aluminum oxide ($125{\mu}m$ grain), the metal and resin cements were bonded together using a silicone mold. Prior to testing, all metal-resin beams were examined under stereomicroscope, and subjected to the ${\mu}TBS$ test. The mean value of each group was analyzed via one-way ANOVA with Tukey's test as post hoc (${\alpha}=.05$) using SPSS software. Results: The mean ${\mu}TBS$ of all groups was ranged from 20 to 28 MPa. There is no statistically significant difference between groups (P > .05). Mixed failure, which is the combination of adhesive and cohesive failures, is the most prevalent failure mode in both the Panavia F2.0 and G-Cem LinkAce groups. Conclusion: The ${\mu}TBS$ of all tested groups are relatively high; however, the primers used in this study result in no favorable effect in the ${\mu}TBS$ of Panavia F2.0 and G-Cem LinkAce resin cement to Co-Cr alloy.

• Journal of Chest Surgery
• /
• v.38 no.7 s.252
• /
• pp.489-495
• /
• 2005

In the surgical treatment of aortic dissection, aortic arch replacement under total circulatory arrest is often performed after careful inspection to determine the severity of disease progression. Under circulatory arrest, antegrade or retrograde cerebral perfusion is required for brain protection. Recently, antegrade cerebral perfusion has been used more, because of the limitation of retrograde cerebral perfusion. This study is to compare these two methods especially in the respect to neurological complications. Material and Method: Forty patients with aortic dissection involving aortic arch from May 2000 to May 2004 were enrolled in this study, and the methods of operation, clinical recovery, and neurological complications were retrospectively reviewed. Result: In the ACP (antegrade cerebral perfusion) group, axillary artery cannulation was performed in 10 out of 15 cases. In the RCP (retrograde cerebral perfusion) group, femoral artery Cannulation was performed in 24 out of 25 cases. The average esophageal and rectal temperature under total circulatory arrest was $17.2^{\circ}C\;and\;22.8^{\circ}C$ in the group A, and $16.0^{\circ}C\;and\;19.7^{\circ}C$ in the group B, respectively. Higher temperature in the ACP group may have brought the shorter operation and cardiopulmonary bypass time. However, the length of period for postoperative clinical recovery and admission duration did not show any statistically significant differences. Eleven out of the total 15 cases in the ACP group and thirteen out of the total 25 cases in the RCP group showed neurological complication but did not show statistically significant difference. In each group, there were 5 cases with permanent neurological complications. All 5 cases in the ACP group showed some improvements that enabled routine exercise. However all 5 cases in RCP group did not show significant improvements. Conclusion: The Antegrade, cerebral perfusion, which maintains orthordromic circulation, brings moderate degree of hypothermia and, therefore, shortens the operation time and cardiopulmonary bypass time. We concluded that Antegrade cerebral perfusion is safe and can be used widely under total circulatory arrest.

• The Journal of the Korea Contents Association
• /
• v.9 no.11
• /
• pp.432-442
• /
• 2009

This research had a look at what effect of the pursing benefit has on satisfaction, behavioral intention, and attitude of the visitors to the Gwangju Biennale. The survey was conducted for 320 visitors who finished their exhibition viewing schedule starting September 5 until September 19 [15 days]. 300 questionnaires excepting 20 unfaithfully responded copies among those collected from the surveyed were used for the analysis. As for the statistical disposal of the collected data, after going through the process of Data Coding, this research conducted an frequency analysis using SPSS 12.0 for window & statistics package program AMOS 5.0, an exploratory factor analysis to test the reliability and feasibility of the data, and reliability test of each factor; then, this research tested a hypothesis using structural equation model. The research results are as follows: First, as a result of factor analysis of the 15 pursuing benefits, 4 factors were elicited, such as pursuit of an intellectual experience, pursuit of a novel, exotic experience, pursuit of interpersonal, cultural exchange, and pursuit of internal fullness, etc.; as a result of factor analysis of the 10 attitudes, three factors were elicited, such as affective, cognitive, behavioral factors; as a result of factor analysis of 12 types of satisfaction, two factors, such as satisfaction with facilities and convenience matters, etc. were elicited. Second, as a result of the suitability of research model, suitability, its fidelity came out as $x^2=107.508$, d.f.=48, p=.000, Q=2.240, GFI=.942, AGFI=.906, RMR=.024, NFI=.952, TLI=.963, CFI=.973, RMSEA=.064. Third, pursuing benefit was found out to have a positive effect on satisfaction, attitude, and behavioral intention. Fourth, attitude was found out to have a positive significant effect on satisfaction. Fifth, attitude was found out to have a positive effect on behavioral intention. Sixth, satisfaction was found out to have a positive effect on behavioral intention.