• Journal of the Korean Geosynthetics Society
• /
• v.7 no.2
• /
• pp.41-47
• /
• 2008

This paper describes the results of model experiments in the laboratory, which were conducted to assess the behavior characteristics of geosynthetic reinforced soil walls according to different surcharge loads and reinforcement types. The model walls were built in the box having dimension, 100 cm tall, 140 cm long, and 100cm wide. Three types of geosynthetics, geonet, geogrid A and geogrid B, are used as the reinforcements. Decomposed granite soil (SM) was used as a backfill material. Seven model walls are constructed and tested. After the construction of the model wall, the LVDTs are installed to obtain the displacements of the wall face. As the results of the model tests, the maximum horizontal displacements of the model walls occurred due to uniform surcharge pressure were measured at the 0.7H from the bottom of the wall. The more the reinforcement strength increases, the more the wall displacements decrease, and also the reduction ratio of the wall displacement decrease with increasing the surcharge pressure.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.1
• /
• pp.79-89
• /
• 2002

Various geosynthetics used as liners or protection layers are installed in the solid waste landfills. The interface shear strength between geosynthetics installed at the slope of the landfill is a very important variable for the safe design of the bottom and cover systems in the solid waste landfills. The interface shear strength between Geomembrane and Geotexile is estimated by a large direct shear test in this study, The effects of normal stress, water existing between geosynthetics and surface condition of Geomembrae, i.e. smooth or textured, were investigated. The test results show that the effect varied depending on the level of normal stress and the type of geosynthetic combinations. The shear strength was evaluated by the Mohr-Coulomb failure criterion in this research. The shear strength parameters obtained from tests considering the site specific conditions such as normal stress, dry or wet, and surface condition of geosynthetic should be applied to the design of geosynthetics installed at the slope of the landfill to construct a safe solid waste landfill.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.1
• /
• pp.173-180
• /
• 2003

In spite of its potential importance in the assessment of geosynthetic-related dynamic problems, no serious attempt has yet been made to investigate a probable dependence of dynamic friction resistance of the geosynthetic interface on shear displacement rate. Hence, an experimental study of geosynthetics was carried out on a shaking table, and the relationship between dynamic friction resistance and shear displacement rate of geosynthetic interfaces was investigated. A cyclic, displacement rate-controlled experimental setup was used. The subsequent multiple rate tests showed that interfaces that involve geotextiles have such unique shearing characteristics that shear strengths tend to increase with displacement rate. In contrast, once submerged with water, the shear strength appears to be no longer dependent on the displacement rate, partly due to lubrication effect of water trapped inside the interface. The results of the experimental study can be used in the seismic safety assessment of a landfill cover and slope where the geosynthetic materials are exposed to a relatively low normal stress.

• Journal of the Korean Geosynthetics Society
• /
• v.13 no.2
• /
• pp.11-20
• /
• 2014

To create a large-scale complex, it is often the case to perform ground improvement by using vertical drain method after the reclamation of coastal soft ground, for construction period shortening and stable site renovation. During this process, the pore water migrates to the horizontal drainage layer of the ground surface through the vertical drain installed in the soft ground and discharged out to the open. In the past sand was used as the material for the horizontal drainage layer in numerous cases, however recently, due to material shortage and high pricing, the use of crushed stones has increased. To prevent mixing of the materials between the horizontal drainage layer and the upper landfill, geosynthetics (PPMat) are installed. However, the use of geosynthetics results in high additional cost for material purchase and installation, therefore it is necessary to examine the validity of the installation itself. In this study, to verify the necessity, model tests were performed. Results from the model tests indicate that the drainage ability of the horizontal drainage layer is barely affected by the application of geosynthetics.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.2
• /
• pp.67-74
• /
• 2008

Many industrialized countries of the world have many problems about the reuse of waste landfill area because of the increase of terminated waste disposal landfill. Especially, the effective use of the terminated waste disposal landfill nearby the urban area has been demanded, because of the lack of the usable land. However, in case of the construction of the building on such a landfill, ground settlement and reduced bearing capacity would be occurred without ground stabilization and proper reinforcement. This study is to evaluate the applicability of geosynthetics for the increment of bearing capacity of solid waste landfill ground. A numerical simulation has been undertaken to model a layer of weathered soil overlaying a layer of geosynthetic reinforcement and waste disposal ground. The proposed analytical model can be used to obtain surface settlement characteristic in the two-dimensional deformation related reinforcement.

• Geotechnical Engineering
• /
• v.3 no.4
• /
• pp.55-70
• /
• 1987

The use of reinforced earth is not new. But available information on basic proper.ties like strength and deformation behavior of reinforced earth materials is not adequate. Therefore, tile purpose of this present investigation is first to research the frictional characteristics of the reinforcement and standard rand using a shear testing appratus. The second purpose of this articles are to report the results of comparison test on the strength and stress-strain behavior of a dry sand einforced with aluminium fcils and geotextiles under different confining pressures. Finally, the paper explores the possibility of geotextile reinforced earth masonry walls. It was observed that the stress-strain response of sand ai.e considerably improved by the introduction of geotextiles. The results of tests are used in developing the geotextile reinforced earth masonry walls. It is hoped that this paper will be helpful in providing the basic data for the rational design and construction methods of reinforced earth structures.

• Journal of the Korean Geosynthetics Society
• /
• v.17 no.4
• /
• pp.73-79
• /
• 2018

In the west coast, south coast, and river basin, the use of geotextile mats has been increasing to improve the soft ground for making industrial facilities space and farmland. As an initial step to improve the vast and soft ground, the geotextile mats are laid and bonded to increase the bearing capacity of the wide ground for supporting construction equipment. Seam strength of geotextile mats exert a force only about 50% of the tensile strength of the fabric, which causes problems such as uplift and sinking in the soft ground. In this study, various types of geosynthetic matting techniques were investigated and the tensile strength of each method was compared and analyzed. Numerical analysis shows that stress increment in the ground due to the overburden load decreases when the seam strength of the geosynthetics mats is increased. When the seam strength was increased to 60, 70 and 80%, the bearing capacity of ground by geotextile mat was increased.

• Proceedings of the Korean Fiber Society Conference
• /
• 2007.11a
• /
• pp.289-290
• /
• 2007

• Proceedings of the Korean Fiber Society Conference
• /
• 1998.10a
• /
• pp.356-359
• /
• 1998

지오텍스타일은 수분차단을 제외한 분리, 보강, 여과 배수등의 기능을 가지며, 현재 제방공사, 해안ㆍ하천의 호안공사, 간척공사 또는 도로, 철도 노상 안정 등의 분야에 광범위하게 이용되고 있다. 또한 지오텍스타일은 모래, 흙, 자갈 등의 환경에 노출, 사용되는 고분자 재료로서 토목공사의 시공기술과 밀접한 관계를 가지는 토목용 섬유제품이다. (중략)

• Proceedings of the Korean Fiber Society Conference
• /
• 1998.10a
• /
• pp.307-310
• /
• 1998

연약지반상에 고속도로 노체를 형성하기 위해서는 다양한 지반개량공법이 적용되며 그 중 가장 보편적인 개량공법이 연직배수를 통한 압밀촉진 공법이다. 이와 같은 압밀촉진공법이 효율적으로 이루어지기 위해서는 연약층 내부에 타입하는 연직배수재의 역할도 중요하지만, 연직배수재를 통해서 상승하는 압밀수를 신속히 제체 밖으로 배출시킬 수 있는 수평배수기능도 매우 중요하다. (중략)