• Aerospace Engineering and Technology
• /
• v.6 no.1
• /
• pp.157-164
• /
• 2007

For a GPS antenna to normally receive GPS satellite signals during full flight mission of a satellite launch vehicle, it should be installed on skin of the vehicle. The surface of a launch vehicle is drastically heated up due to aerodynamic heating effect during flight, so that the GPS antenna mounted on surface of the launch vehicle is directly exposed to extremely hot temperature environment. Hot temperature test specification of the GPS antenna, therefore, is severer than inner components. This paper describes that procedures and results of performance analysis of the GPS antenna for KSLV-I under hot temperature environment. The GPS antenna was not deformed physically and inner LNA(Low Noise Amplifier) operated normally without performance degradation.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.34 no.12
• /
• pp.82-89
• /
• 2006

This paper describes the development results of electrohydraulic actuation system which performs the attitude and trajectory control of pitch and yaw motion using thrust vector control for high altitude launching vehicle operated in high vacuum environment (altitude higher than 300 km). As compared with electrohydraulic actuation system for low altitude launch vehicle which operated under altitude of stratosphere, the intensified development requirements, newly adopted design and manufacturing technologies, newly developed test equipments and test results are summarized in this paper. The development test and evaluation of actuation system were successfully accomplished. The developed actuation system will be installed on KSLV-I after finishing verification of interface and integration compatibility with related other systems.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.19 no.5
• /
• pp.98-103
• /
• 2015

A flow passage opening device utilizing an acceleration follow-up technique allows fuel to flow continuously through a pressurized fuel tank system. It is very difficult to test the device in a real flight situation because of severe test condition and a cost problem. In this paper, therefore, the results of a basic negative g test conducted by low-speed airplane are compared with RecurDyn simulation. Dynamic behavior of the device in total flight profile of a high-speed vehicle is also analyzed by using RecurDyn to predict its performance.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.3
• /
• pp.213-220
• /
• 2010

This paper presents the analysis results of trajectory, performance and attitude control based on the first flight data of the KSLV-I. The KSLV-I had a fairing separation problem and failed to inject spacecraft into the orbit. In this paper, the trajectory, flight performance, and attitude control was analyzed considering the influence of unseparated fairing. Moreover, the flight results and performance of the inertial navigation and guidance system were presented. As a results of post-flight analysis, any other problem besides the fairing separation problem was not happened and onboard equipment functioned normally.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.11
• /
• pp.115-120
• /
• 2005

This paper describes the design and implementation of engineering model(EM) of Mass Memory Unit(MMU) for Science and Technology Satellite 2(STSAT-2) and the results of integration test. The use of Field-Programmable Gate Array(FPGA) instead of using private electric parts makes a miniaturization and lightweight of MMU possible. 2Gbits Synchronous Dynamic Random Access Memory(SDRAM) module for mass memory is used to store payload and satellite status data. Moreover, file system is applied to manage them easily in the ground station. RS(207,187) code improves the tolerance with respect to Single Event Upset(SEU) induced in SDRAM. The simulator is manufactured to verify receiving performance of payload data.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.229.2-229.2
• /
• 2012

지금까지 해외의 여러 달 궤도선에서 달의 영상을 다양한 방법으로 관측한 것에서 알 수 있듯이 영상 관측은 달 탐사에서 중요한 부분이다. 특히 그 중에서 입체 영사기(Stereo Imager)는 달의 3차원적 영상을 관측하여 달 표면의 구조를 파악할 수 있고 분광 카메라(Hyperspectral Camera)는 달 표면을 이루고 있는 물질을 분광 정보를 통해서 알아낼 수 있다. 본 연구에서는 우리나라가 2020년경 독자적인 달 궤도선을 계획하고 있는 것에 발맞추어 이 두 관측 장비를 설계해 보았다. 본 연구에서 설계한 탑재체는 하나의 광학계를 이용해 가시광 영역에서 동시에 입체 영상과 분광 영상을 얻을 수 있는 장치이며, 달 표면에서의 궤도선의 속도와 저장 가능한 정보의 양을 고려하여 100 km의 고도에서 속도를 1.6 km/s로 가정할 때 interline CCD가 17.5 m의 공간 분해능을 갖기 위해 92 frame/s 이상의 frame rate로 관측을 수행할 수 있게 하였다. 특히 분광 카메라는 wedge filter를 사용하여 광학계의 부담을 줄였으며 검출기로는 interline CCD를 사용하여 channel 수를 조절할 수 있도록 하였다. 또한 달 표면을 구성하는 입자의 크기에 대한 정보를 얻을 수 있는 편광판도 설치 하였다. 시험 모델의 문제점을 분석하여 새롭게 개선된 탑재체를 설계하여 개발하였다. 렌즈를 수정해 vignetting과 왜곡 현상을 보정하였고 전체 무게를 1.5 kg으로 줄여서 시험 모델보다 30% 이상 줄일 수 있었다. 파장 분해능은 20nm로 시험모델보다 더 개선된 분해능을 얻을 수 있었다. 출력 효율의 증대를 위해 power board의 수정을 수행하였다.

• Journal of Space Technology and Applications
• /
• v.2 no.2
• /
• pp.121-136
• /
• 2022

Automatic Identification System used in ship communication is required for marine control way, including monitoring of vessel operation in coastal and exchanging of information for safety navigation between them. But, it uses a very high frequency band of approximately 160 MHz, and at the same time, due to the curvature of Earth, there is a limit to the communication distance. Several demonstrations were made successfully over satellite, but not much work has been done yet through cube-satellite which has low-orbit at 500 km altitude. Here, we demonstrate a reception test of AIS (automatic identification system) receiver for a cube-satellites using software-defined radio (SDR). We collected AIS data from ship at port of Busan, Korea, using R8202T2 SDR and established to transmit them using Adam-Pluto and Matlab Simulink. The process of weakening the signal strength to a satellite was constructed using attenuator. Through above process, we demonstrated whether AIS data was successfully received from the AIS payload.

• Bulletin of the Korean Space Science Society
• /
• 2009.10a
• /
• pp.49.2-49.2
• /
• 2009

소형우주발사체 KSLV-I의 상단부 전자장비 탑재 구조체의 외부면에는 텔레메트리, 원격추적, GPS, 비행종단 시스템의 안테나가 두 개 또는 세 개씩 장착된다. 발사체의 표면에 안테나를 부착할 수 있는 위치는 제한되어 있기 때문에 각 안테나 들은 서로 인접되어 부착된다. 또한 상단부 전자장비들과 지상장비의 성능을 검증하기 위해 수행되는 경비행기를 이용한 비행시험은 각 안테나들이 더욱 근접하여 장착된 상태로 수행된다. 따라서 각 하부시스템의 안테나 사이에 발생하는 간섭현상을 분석하기 위한 연구가 요구된다. 이 논문에서는 시간영역 유한차분법을 이용하여 서로 다른 하부시스템의 안테나 간에 발생하는 간섭영향을 해석하였다. 수행된 해석 과정은 우주발사체의 안테나 방사패턴을 해석하는데 이용될 수 있으며, 향후 우주발사체의 시스템 설계 과정에서 안테나의 배치 방법과 각 하부시스템의 성능 요구조건을 결정하는데 효과적으로 사용될 수 있다.

• Korean Journal of Remote Sensing
• /
• v.35 no.3
• /
• pp.471-482
• /
• 2019

The mission of the high-resolution camera for the lunar exploration is to provide 3D topographic information. It enables us to find the appropriate landing site or to control accurate landing by the short distance stereo image in real-time. In this paper, the ground verification and analysis system using the multi-application stereo camera to develop the high-resolution camera for the lunar exploration are proposed. The mission test items and test plans for the mission requirement are provided and the test results are analyzed by the ground verification and analysis system. For the realistic simulation for the lunar orbiter, the target area that has similar characteristics with the real lunar surface is chosen and the aircraft flight is planned to take image of the area. The DEM is extracted from the stereo image and compose three dimensional results. The high-resolution camera mission requirements for the lunar exploration are verified and the ground data analysis system is developed.

• Journal of Advanced Navigation Technology
• /
• v.8 no.1
• /
• pp.49-57
• /
• 2004

In This paper the embedded linux based embedded control system was used and the tracking antenna system was studied for data link and communication between moving vehicles. A microprocessor based embedded controller is equipped with SA-1110 board and this embedded controller can control the azimuth and the elevation angle of the antenna. The relative position and attitude for pointing are calculated by using the GPS position signals from the moving vehicle. To verify the performance of the designed embedded antenna system, the orbit information of the Arirang satellite(from KARI) is used.