• Korean Journal of Applied Biomechanics
• /
• v.18 no.1
• /
• pp.107-115
• /
• 2008

The purpose of this study was to investigate muscle activity and vertical ground reaction force(F) in children with Down syndrome(DS) during vertical jump. Six DS and one healthy child performed vertical jump. Four muscles(Biceps femoris, Rectus femoris, Tibialis anterior & Gastrocnemius) and F were analyzed. Gastrocnemius in DS showed lower muscle activity in a propulsive phase. Impulse during 0.3sec before toe-off in DS displayed lower value than that in the healthy child. The second peak of F in DS occurred later than that in the healthy child, so DS performed landing with their knee more flexed. The first and second peak of F and loading rate to the second peak of F in DS showed lower value than those in the healthy child. Therefore, DS might have lower ability to absorb the force while landing from a vertical jump.

• PNF and Movement
• /
• v.4 no.1
• /
• pp.45-50
• /
• 2006

Purpose : This study shows the movements of the ankle and the foot in walking stages, and helps to diagnose and treat the problems of the ankle and the foot. The foot in human is a mean of the transportation, body support, and shock absorber. However, the slightest changes in the anatomical position can cause a significant increase of the stress and force in the ankle and the foot. The regular compressive force in the ankle of the normal person is generated by the contraction of the gastrocnemius and popliteus muscles, and transmitted to the achilles tendon. The plantar flexion about 10 degrees occurs immediately after the heel strike, getting ready for the weight acceptance. The shear force about 80 % of the body weight is generated immediately after the heel off of the mid stance phase. In those who have a problem in the ankle, the compression force at the ankle decreased to 1/3 of the body weight, and the shear force decreased, and the compressive force was reached at their maximum level earlier than the normal people. Conclusion : Analysis of the movements at the ankle and the foot in walking phase can make the effort to diagnose and treat the ankle and foot with the problems. However, the further study is necessary.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.3
• /
• pp.115-121
• /
• 2021

Human's landing strategies have been explained through lower extremity kinetics in various conditions. However, how lower extremity kinetics respond when the two conditions between a load and landing height are combined is not yet understood. To achieve the purpose of this study, a total of 20 men and women were subjected to drop landing according to a load(No load, 10%, 20%, 30% of the body weight) at various landing heights(0.3 m, 0.4 m, 0.5 m). As a result of the study, the main effect of a load was not statistically significant in all variables. But increasing of the landing heights showed more flexion angle which was statistically significant in knee joint. In addition, as the landing height increased, the medial-lateral, anterior-posterior, vertical force, and loading rate increased, while time to peak vertical force decreased which was statistically significant. Thus, humans can successfully perform the landing motion even if the load is changed at various heights. However, it reacted more sensitively to the change in landing height than that load condition. The landing height can be prepared for recognition and shock absorption through visual information, but the weight level is difficult for the body to perceive and explains why it is more difficult to apply it to the landing strategy mechanism for shock absorption.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.7
• /
• pp.4689-4696
• /
• 2015

The purpose of this study was to evaluate biomechanical characteristics of trekking shoes using 3D Bootie method as mimics barefoot form of F Co. that provides the best comfort and plantar pressure dispersion. The control group is normal trekking shoes of M Co. and K Co.. 13 healthy males measured the foot pressure, EMG and GRF. Collected data was analyzed using One-way ANOVA in order to investigate the effects of each trekking shoes. The results are as follows: Trekking shoe of F Co. was significantly wider in contact area than others at MF and significantly lower in maximum force, peak pressure than others at RF. In the case of muscle activity, acted in the same way as the effect of barefoot walking. In the case of GRF, effectively absorbed the impact force, so it is possible to efficient walking. As a result of the analysis, trekking shoe using of 3D Bootie method of F Co. can be efficient walking by reducing the load of foot during walking.

• Journal of Korean Orthopaedic Sports Medicine
• /
• v.3 no.1
• /
• pp.66-72
• /
• 2004

Purpose: To evaluate the compensatory mechanism in vivo and develop the treatment guide by performing the comprehensive functional tests of the posterior cruciate ligament (PCL) deficient subjects. Material and Methods: 10 PCL deficient subjects and 10 healthy control group were evaluated. Performed functional tests were range of motion, posterior drawer test, Telos, 30$^{\circ}$ flexion wt-bearing view, KT-1000 arthrometer, gait analysis, EMG test and isokinetic tests. Results: Physical, KT-1000, Telos posterior tests showed significant differences, but 300 full weight bearing lateral view, muscle strength test revealed no difference between two groups. Less knee flexion at initial contact and reduced maximum valgus moment were observed in PCL deficient group. In vertical drop landing, PCL group had increased plantar flexion angle at initial contact. Conclusion: Compensatory mechanisms such as reduced unstable components and absorbing the maximal load of the joint were occurred after PCL insufficiency, which result in good clinical and functional outcomes. Further investigations would be needed to understand the functional adaptations of PCL deficient subjects.

• Journal of Environmental Science International
• /
• v.3 no.3
• /
• pp.285-296
• /
• 1994

The objective of this study was to examine and compare to transient response to quantitative and hydraulic shocks which produce equal changes in mass rate of organic feed in aerobic fixed-film process. The general experimental approach was to operate the system at several growth rates under steady-state(pre-shock) conditions, then to apply step changes during day 3 in dilution rate(hydraulic shock) , or feed concentration(Quantitative shock) at the same organic mass loading rate. Performance was assessed in both the transient state and the new steady-state (post- shock). Shock load of different type did not produced equivalent disruptions of effluent quality for equal increases in mass loading rate. Based on effluent concentrations, a hydraulic and a Quantitative shock at the same mass loading caused equal increase in total effluent COD, but the increase was primarily a result of suspended solids the hydraulic shock and COD in the quantitative shock. The time which effluent COD came to peak values were about 32~48 hours at the low organic loads and 52 ~ 72 hours at the high organic loads, respectively A quantitative shock produced a much greater increase in effluent COD than did a hydraulic shock at the same mass loading. Mean and peak values of effluent concentration weve increased in 2.8~4.2 times at low organic loading rate, 5.2~6.6 times at the high organic loading rate, respectively. Key words : Aerobic fixed-film reactor, Quantitative shock, hydraulic shock, mass loading rate.

• Journal of Korea Multimedia Society
• /
• v.11 no.5
• /
• pp.651-660
• /
• 2008

Flash memory is widely used in embedded systems because of its benefits such as non-volatile, shock resistant, and low power consumption. However, NAND flash memory suffers from out-place-update, limited erase cycles, and page based read/write operations. To solve these problems, YAFFS and RFFS, the flash memory file systems, are proposed. However YAFFS takes long time to mount the file system, because all the files are scattered all around flash memory. Thus YAFFS needs to fully scan the flash memory. To provide fast mounting, RFFS has been proposed. It stores all the block information, the addresses of block information and meta data to use them at mounting time. However additional operations for the meta data management are decreasing the performance of the system. This paper presents a new NAND flash file system called ERFFS (Efficient and Reliable Flash File System) which provides fast mounting and recovery with minimum mata data management. Based on the experimental results, ERFFS reduces the flash mount/recovery time and the file system overhead.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.481-484
• /
• 2008

Recently, the recycling and reusing of construction and demolition waste concrete is urgently required because waste concrete is greatly increased according to the rapid increasing of urban redevelopment project, but the problem solution for demand and supply unbalance of fine aggregate is urgently required because of the restriction of collecting sea fine aggregate. So the utilization of high quality recycled fine aggregate using construction and demolition waste concrete as new fine aggregate for construction industry is urgently. Accordingly, In this study, As recycled fine aggregate manufacturing technology with exceeding in economical efficiency, reduction efficiency of environmental load and quality improvement effect of recycled fine aggregate, it is to develop dry manufacturing system composed specific gravity separator of high-speed rotation impact type and centrifugal Force Powder Collector, etc. And it is to examine mechanism of recycled sand dry manufacturing system.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.11
• /
• pp.1157-1162
• /
• 2011

The parking brake is an essential unit embedded in the track-driving motor of an excavator. The parking brake plays an important role in keeping the excavator in place not only when it is parked, but also during the digging operation. In fact, the load placed on the parking brake during the digging operation is significantly higher than the parking load, because the impact and rating loads caused by the bucket digging force cycle frequently and have very high load ranges. Therefore, the load conditions during the digging operation should be taken into account in the parking brake certification test. In this study, a series of experiments was carried out in which various operating pressures were applied to the parking brake, where repeated loads were reciprocally placed on the brake by locking the multifriction disc and releasing the hydraulic cylinder. The characteristics of the parking brake were investigated by comparing the obtained experimental results and the theoretical design specifications.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.6
• /
• pp.669-679
• /
• 2022

Lithium-ion battery has been used for lots of electronic devices. With the popularization of batteries, researchers have focused on batteries' electrochemical performances by environmental conditions, such as temperature, vibration, shock and charging state. Meanwhile, due to very serious global warming, car companies have started using lithium-ion batteries even in cars, replacing internal combustion engines. However, batteries have been developed based on non-moving systems which is totally different from vehicles. In the line of the differences, researchers have tried to reveal relationship between variables from dynamic systems and batteries. In this review, we discuss the comprehensive effect of vibration and shock on batteries. We firstly summarize vibration profiles and effect of normal vibration on batteries. We also sum up effect of shock and penetration on batteries and introduce how ultrasound influences on batteries. Lastly, outlook for the battery design as well as dynamic design of EVs are discussed.