• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.5
• /
• pp.18-24
• /
• 2006

This paper proposed UPS system parallel connected in battery and ultracapacitor to compensate instantaneous voltage drop. Ultracapacitor parallel connected with battery compensate instantaneous voltage drop at failure and it's reduced the voltage regulation of output voltage. We are produced for fast instantaneous voltage drop compensation of ultracapacitor at UPS system and experiments are achieved. Experimental result was verified that the ultracapacitor indicated the fast compensation characteristics and regulation of the output voltage satisfied within 5[%] by using ultracapacitor.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.8
• /
• pp.54-61
• /
• 2001

A fully on-chip open-drain CMOS output driver was designed for high bandwidth DRAMs, such that its output voltage swing was insensitive to the variations of temperature and supply voltage. An auto refresh signal was used to update the contents of the current control register, which determined the transistors to be turned-on among the six binary-weighted transistors of an output driver. Because the auto refresh signal is available in DRAM chips, the output driver of this work does not require any external signals to update the current control register. During the time interval while the update is in progress, a negative feedback loop is formed to maintain the low level output voltage ($V_OL$) to be equal to the reference voltage ($V_{OL.ref}$) which is generated by a low-voltage bandgap reference circuit. Test results showed the successful operation at the data rate up to 1Gb/s. The worst-case variations of $V_{OL.ref}$ and $V_OL$ of the proposed output driver were measured to be 2.5% and 7.5% respectively within a temperature range of $20^{\circ}C$ to $90^{\circ}C$ and a supply voltage range of 2.25V to 2.75V, while the worst-case variation of $V_OL$ of the conventional output driver was measured to be 24% at the same temperature and supply voltage ranges.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.638-641
• /
• 2018

현재 선진국에서는 고출력 양성자 선형 가속기를 기반으로 한 의료용 암치료기인 BNCT(Boron Neutron Capture Therapy)에 대해 활발히 연구 중이며 다원시스도 2016년부터 A-BNCT 사업을 진행 중이다. A-BNCT에 적용된 양성자 선형 가속기의 RF(Radio Frequency)전원을 공급하기 위해 352 MHz, 1.5 MW의 고출력을 가지는 클라이스트론을 사용하였다. 클라이스트론의 출력인 RF의 크기와 위상을 안정적으로 제어하기 위해 90 kV, 30 A, 120 Hz, 1.7 ms의 구형파 출력을 가지는 고전압 전원장치를 적용하였다. 또한 고전압 전원장치의 출력전압 변동률을 0.5% 이내로 유지시키기 위해 전압보상회로를 적용하여 회로 시뮬레이션과 실부하 실험을 통해 펄스전원장치의 성능을 검증하였다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.1
• /
• pp.21-26
• /
• 2006

In this paper, to improve the variable and remote controllable digital power-supply design. It is able to RS-232 communication for remote control. And it can also observe the correct power. Finally, it intend to high ratio design that compare input power with output power. There are especially useful solution in korea to be under the unstable voltage environment.

• Journal of the Institute of Convergence Signal Processing
• /
• v.16 no.4
• /
• pp.182-188
• /
• 2015

An analog AVR has an advantage of short time constant, time to revert again from the abnormal state to a stable one depending on the voltage fluctuations of the load. But the Analog AVR has a disadvantage of large voltage variation according to the load fluctuation. Voltage regulation for digital AVR is very stable, but the time constant is very long compared to that of an analog AVR. Therefore, it indicates that the digital AVR shows unstable output performance in a very large load variations. In this paper, a mixed form of an analog AVR and a digital AVR is proposed. An implemented hybrid AVR has fast time constant and stable voltage regulation capability. Hybrid AVR voltage variations in the load is stable within 1[%] and the voltage stability is also improved. It also showed fast time constant to the level of the analog AVR. Thus hybrid AVR developed in this paper can be used as a power supply for a variety of uses in industry.

• Journal of the Korea Convergence Society
• /
• v.10 no.4
• /
• pp.1-6
• /
• 2019

Neural networks have been used to predict the direction of stock index movement from past data. The conventional research that predicts the upward or downward movement of the stock index predicts a rise or fall even with small changes in the index. It is highly likely that losses will occur when trading ETFs by use of the prediction. In this paper, a neural network model that predicts the movement direction of the daily KOrea composite Stock Price Index (KOSPI) to reduce ETF trading losses and earn more than a certain amount per trading is presented. The proposed model has outputs that represent rising (change rate in index ${\geq}{\alpha}$), falling (change rate ${\leq}-{\alpha}$) and neutral ($-{\alpha}$ change rate < ${\alpha}$). If the forecast is rising, buy the Leveraged Exchange Traded Fund (ETF); if it is falling, buy the inverse ETF. The hit ratio (HR) of PNN1 implemented in this paper is 0.720 and 0.616 in the learning and the evaluation respectively. ETF trading yields a yield of 8.386 to 16.324 %. The proposed models show the better ETF trading success rate and yield than the neural network models predicting KOSPI.

• Korean Journal of Optics and Photonics
• /
• v.15 no.4
• /
• pp.337-342
• /
• 2004

Laser optical power stabilization of a radio frequency excited $CO_2$ slab laser using the opto-Hertzian effect generated from the laser itself is achieved on the peak of the Doppler broadened gain curve. The opto-Hertzian signal was generated by a modulation of the optical flux circulating inside the laser cavity from a variation in the cavity length caused by the vibrations of the PZT. The opto-Hertzian signal is directly coupled from a RE discharge chamber via a loop antenna into a detector and applied to a lock-in stabilizer as an reference signal. The power stability of an RF excited slab laser is estimated to be better then 0.2%.

• Journal of the Korean Solar Energy Society
• /
• v.32 no.1
• /
• pp.25-31
• /
• 2012

This paper presents the characteristics of power generation output at Haeng-won wind farm and how to determine the optimized ESS capacity for power stabilizing. Depend on the fluctuation rate of wind power output variation, wind farm capacity and site, power stabilization will be impacted. Therefore, we need to determine proper ESS capacity. Using the actual data of Haeng-won wind farm from 2009. 3 to 2010.2., capacity of ESS was determined by moving average value. To verify the proposed algorithm, simulations are carried out with PSCAD/EMTDC program. As a result, optimal ESS capacity of Haeng-won wind farm in Jeju is estimated about 1.63 MWh.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.548-552
• /
• 2007

본 논문에서는 연료전지자동차의 저전압 배터리 충${\cdot}$방전을 위한 3상 양방향 DC-DC 컨버터를 제안한다. 제안한 3상 컨버터는 기존의 단상 컨버터에 비해 인터리빙 효과의 증대로 인한 입${\cdot}$출력 필터 사이즈 감소와 변압기의 이용률 증가로 인한 VA정격의 감소가 가능하며, 기존의 위상제어 방식의 3상 컨버터와 달리 입${\cdot}$출력전압이나 부하변동에 따른 무효 전류의 중가 문제가 없다. 또한 MOSFET 스위치를 사용하여 고전압 측에서는 비대칭 소프트 스위칭을 성취할 수 있고, 저전압 측에서는 동기정류 방식을 적용하여 도통손실을 감소시킬 수 있어 효율과 전력밀도를 더욱 향상 시킬 수 있다. 본 논문에서는 제안하는 3상 양방향 DC-DC 컨버터의 동작원리와 기존방식과의 비교분석을 수행하였으며 시뮬레이션을 통해 검증하였다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.3 no.2
• /
• pp.131-137
• /
• 1998

The solar cells should be operated at the maximum power point because its output characteristics are greatly fluctuated on the variation of insolation, temperature and load. Photovoltaic system needs an inverter which can interface the dc output power of solar cell with the residential ac load. The inverter has to supply a sinusoidal current and voltage to the load and the utility line with a high power factor. This paper proposes an utility interactive photovoltaic system designed with a step-up chopper and a PWM voltage source inverter. The step-up chopper operates in continuous mode by adjusting the duty ratio so that the photovoltaic system tracks the maximum power points of solar cell without any influence on the variation of insolation and temperature. The voltage source inverter operates in a manner that its output voltage is in phase with the utility voltage. The inverter supplies an ac power with high factor and low level of harmonics to the load and the utility power system.