• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.10
• /
• pp.325-333
• /
• 2020

Current methods of measuring the sediment concentration of natural streams can be affected by weather conditions and have lower reliability in bed-load sections due to mechanical limits. Theoretical methods have to be used to solve this problem, but they have low reliability compared to the measured values and diverse results for the bed-load sediment concentration. This study proposes a new way to reliably determine the bed-load sediment concentration from the relation with theoretical depth-integrated concentration based on the informational entropy concept. Sediment distribution shows a uniform probability distribution under maximized entropy conditions under some constraints, so a function can be calculated for the sediment distribution and depth-integrated concentration. The parameters of a stream were estimated by a nonlinear regression method using the concentration data from a past experiment. Equilibrium N (EN) was estimated using the relation between two different formulas proposed in this study, which can ease the estimation of both the total sediment distribution and depth-integrated sediment concentration with high reliable results with an average R2 of 0.924.

• Journal of Korea Water Resources Association
• /
• v.41 no.6
• /
• pp.575-585
• /
• 2008

It is essential to obtain accurate and highly reliable streamflow data for water resources planning, evaluation and management as well as design of hydraulic structures. A new discharge computation method proposed in this research uses Chiu's velocity distribution and estimation of maximum velocity. This method shows acceptable channel discharges comparing these by the exiting velocity-area method. When velocity-area method is used, it is required to observe velocities at every specified point and vertical line using a velocity meter like Price-AA. If the method proposed in this research, is used, however it is not necessary to observe all point velocities needed in the velocity-area method. But this method can not be applied for the cases of very complex and strongly asymmetric channel cross-sections because Chiu's velocity distribution using entropy concept may be quite biased from that of natural rivers.

• Elastomers and Composites
• /
• v.42 no.4
• /
• pp.201-208
• /
• 2007

In this study, the thermal shrinkage and expansion stresses of filled NR and SBR vulcanizates were measured to investigate the dimensional stability at an elevated temperature. When a rubber sample was held at constant pre-strain, a thermal stress developed upon heating due to the entropic consideration. The peak shrinkage stress of carbon black or silica filled NR decreased with increasing filler content. In SBR compounds, however, the peak shrinkage stress of SBR with 30 phr filler content was higher than that of unfilled compounds. The expansion stress of carbon black filled NR was changed little, but that of filled SBR increased with increasing the filler content. The peak expansion stress of silica filled NR and SBR vulcanizates increased with increasing silica content.

• Journal of KIISE:Databases
• /
• v.28 no.3
• /
• pp.324-333
• /
• 2001

In this paper we present a novel color image segmentation algorithm based on a Gaussian Mixture Model(GMM). It is introduced a Deterministic Annealing Expectation Maximization(DAEM) algorithm which is developed using the principle of maximum entropy to overcome the local maxima problem associated with the standard EM algorithm. In our approach, the GMM is used to represent the multi-colored objects statistically and its parameters are estimated by DAEM algorithm. We also develop the automatic determination method of the number of components in Gaussian mixtures models. The segmentation of image is based on the maximum posterior probability distribution which is calculated by using the GMM. The experimental results show that the proposed DAEM can estimate the parameters more accurately than the standard EM and the determination method of the number of mixture models is very efficient. When tested on two natural images, the proposed algorithm performs much better than the traditional algorithm in segmenting the image fields.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.12
• /
• pp.6159-6166
• /
• 2012

A discharge measurement is difficult in flood season which is especially important in the water resources field and the continuous discharge measurement for all rivers is impossible on the present system. So, the stage-discharge curve has been used for a long time to produce discharge data of rivers. However, there has been problems from a reliability angle due to the fact that this method uses only stage-discharge relationship, although the stage-discharge curve has the convenience. Therefore, a new mean velocity equation was derived by using Chiu's 2D velocity formula of the entropy concept in this paper. The derived equation reflected hydraulic characteristics such as the depth, gravity acceleration, hydraulic radius, energy slope, kinematic coefficient of viscosity, etc. and estimated also a maximum velocity. In addition, this method verified the relationship between a mean and maximum velocity and estimates an equilibrium state ${\phi}(M)$ well presenting properties of a river cross section as the results. The mean velocity was estimated by using the equilibrium state ${\phi}(M)$, and then the discharge was estimated. To prove this equation to be accurate, the comparison between the measured and estimated discharge is conducted by using the measured laboratory data in the unsteady condition flow showing loop state and the results are consistent. If this study is constantly carried out by using various laboratory and river data, this method will be widely utilized in water resources field.

• Journal of the Korean earth science society
• /
• v.27 no.2
• /
• pp.159-176
• /
• 2006

Geographic factors and mathmatical location of the Korean Peninsula have great influences on the variation patterns and appearances over a period of ten days of summer precipitation. In order to clarify the influence of several climate factors on precise climate classification in the middle part region of the Korea, weather entropy and the information ratio were calculated on the basis of information theory and of the data of 25 site observations. The data used for this study are the daily precipitation phenomenon over a period of ten days of summer during the recent thirteen years (1991-2003) at the 25 stations in the middle part region of the Korea. It is divided into four classes of no rain, $0.1{\sim}10.0mm/day,\;10.1{\sim}30.0mm/day$, 30.1mm over/day. Their temporal and spatial change were also analyzed. The results are as follows: the maximum and minimum value of calculated weather entropy are 1.870 bits at Chuncheon in the latter ten days of July and 0.960 bits at Ganghwa during mid September, respectively. And weather entropy in each observation sites tends to be larger in the beginning of August and smaller towards the end of September. The largest and smallest values of weather representative ness based on information ratio were observed at Chungju in the beginning of June and at Deagwallyeong towards the end of July. However, the largest values of weather representativeness came out during the middle or later part of September when 15 sites were adopted as the center of weather forecasting. The representative core region of weather forecasting and climate classification in the middle part region of the Korea are inside of the triangle region of the Buyeo, Incheon, and Gangneung.

• Land and Housing Review
• /
• v.15 no.2
• /
• pp.57-71
• /
• 2024

This study aims to develop an evaluation method for solar power facilities considering disaster impacts and to analyse the vulnerabilities of existing facilities. Haenam-gun in Jeollanam-do, where the reassessment of existing facilities is urgent, was selected as the study area. To evaluate the vulnerability from a more objective perspective, principal component analysis and entropy methods were utilised. Seven vulnerability assessment indicators were selected: maximum hourly rainfall, maximum wind speed, number of typhoon occurrence days, number of rainfall days lasting more than five days, maximum daily rainfall, impermeable area ratio, and population density. Among these, maximum hourly rainfall, maximum wind speed, maximum daily rainfall, and number of rainfall days lasting more than five days were found to have the highest weights. The overlay of the derived weights showed that the southeastern regions of Haenam-eup and Bukil-myeon were classified as Grade 1 and 2, whereas the northern regions of Hwawon-myeon, Sani-myeon, and Munnae-myeon were classified as Grade 4 and 5, indicating differences in vulnerability. Of the 2,133 facilities evaluated, 91.1% were classified as Grade 3 or higher, indicating a generally favourable condition. However, there were more Grade 1 facilities than Grade 2, highlighting the need for countermeasures. This study is significant in that it evaluates solar power facilities considering urban disaster resilience and is expected to be used as a basic resource for the installation of new facilities or the management and operation of existing ones.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.5
• /
• pp.541-547
• /
• 2010

The rigorous validation of the accuracy of metamodels is an important topic in research on metamodel techniques. Although a leave-k-out cross-validation technique involves a considerably high computational cost, it cannot be used to measure the fidelity of metamodels. Recently, the mean$_0$ validation technique has been proposed to quantitatively determine the accuracy of metamodels. However, the use of mean$_0$ validation criterion may lead to premature termination of a sampling process even if the kriging model is inaccurate. In this study, we propose a new validation technique based on the mean and variance of the response evaluated when sequential sampling method, such as maximum entropy sampling, is used. The proposed validation technique is more efficient and accurate than the leave-k-out cross-validation technique, because instead of performing numerical integration, the kriging model is explicitly integrated to accurately evaluate the mean and variance of the response evaluated. The error in the proposed validation technique resembles a root mean squared error, thus it can be used to determine a stop criterion for sequential sampling of metamodels.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2003.11a
• /
• pp.61-64
• /
• 2003

무손실 이미지 압축은 (Lossless Image Compression)은 손실이미지 압축(Lossy Image Compression)에 비해, 압축률(compression ratio)은 떨어지지만, 반면 원이미지와 복원이미지가 완전히 일치하므로, 원인이미지의 품질을 그대로 유지학 수 있다. 따라서, 이미지의 품질(Quality)과 압축효율(compression ratio)은 서로 상반된 관계에 있으며, 지금도 좀 더 놀은 압축효과를 얻으려는 여러 무손실 압축 방법이 발표되고 있다. 무손실 이미지 압축은 이미지의 정확성과 정밀성이 요구되는, 의료영양분야에서 가장 널리 쓰이고 있으며, 그밖에, 원본이미지를 기본으로 다른 이미지프로세싱이 필요한 경우, 압축 복원을 반복적으로 수행할 필요가 있을 때, 기타 사진 예술분야, 원격 영상 등 정밀성이 요구되는 분양에서 쓰이고 있다. [7]. 무손실 이미지 압축의 가장 대표적인 CALIC[3]과 JPEG_LS[2]를 들 수 있다. CALIC은 비교적 높은 압축률을 나타내지만, 3-PASS의 과정을 거치는 복잡도가 지적되고 있다. 반면 JPEG-LS는 압축률은 CALIC에 미치지 못하지만 빠른 코딩/디코딩 속도를 보인다. 본 논문에서는 여거 가지의 예측 모드를 두어, 블록단위별로 주변 CONTEXT에 따라, 최상의 예측 모드를 판단하여, 이를 적용, 픽셀의 여러 값을 최소화하였다. 그 후 적응산술 부호기(Adaptive arithmetc coder)를 이용하여, 인코딩을 하였다. 이때 최대 에러값은 64를 넘지 않게 했으며, 또한 8*8블록별로 에러의 최대값을 측정하여 그 값을 $0\~7$까지의 8개의 대표값으로 양자화하는 방법을 통하여 그에 따라 8개의 보호화 심볼 모델중 알맞은 모델에 적용하였다. 이를 통해, 그 소화값의 확률 구간을 대폭 넓힘으로써, 에러 이미지가 가지고 있는 엔트로피에 좀 근접하게 코딩을 할 수 있게 되었다. 이 방법은 실제로 Arithmetic Coder를 이용하는 다른 압축 방법에 그리고 적용할 수 있다. 실험 결과 압축효율은 JPEG-LS보다 약 $5\%$의 압축 성능 개선이 있었으며, CALIC과는 대등한 압축률을 보이며, 부호화/복호화 속도는 CALIC보다 우수한 것으로 나타났다.

• 한국HCI학회:학술대회논문집
• /
• 2009.02a
• /
• pp.257-262
• /
• 2009

This paper studies an automatic expansion of dialogue examples using the logs of an example-based dialogue system. Conventional approaches to example-based dialogue system manually construct dialogue examples between humans and a Chatbot, which are labor intensive and time consuming. The proposed method automatically classifies natural utterance pairs and adds them into dialogue example database. Experimental results show that lexical, POS and modality features are useful for classifying natural utterance pairs, and prove that the dialogue examples can be automatically expanded using the logs of a dialogue system.