• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.4
• /
• pp.441-454
• /
• 2018

Since the permanent shutdown of Kori Unit 1 in 2017, a full-scale decommissioning project for a commercial nuclear reactor has been approaching. It is estimated that about 160,000 t of low-activity concrete waste will be produced from decommissioning of one unit of this commercial nuclear power reactor. Accordingly, it is necessary to review whether the effectiveness of the current regulatory framework for clearance waste (i.e. waste stream that meets activity concentration guidelines or dose criteria for clearance set forth in NSSC Notice No. 2017-65) can be maintained for the clearance of a bulk amount of concrete waste. In this regard, the IAEA SRS No. 44, which was used as a basis for revision of the Korean clearance regulations, is thoroughly analyzed and the radiological effects from four different clearance scenarios, along with input values and parameters derived from industrial practices in Korea, were evaluated. Though it is shown that the maximum annual dose from most recycling scenarios will be less than the clearance dose criterion for the normal scenario (i.e. an order of magnitude of $0.01mSv{\cdot}y^{-1}$), the radiation dose, estimated with conservative assumptions for the banking scenario, may exceed the above clearance dose criteria. Therefore, for safe and sustainable clearance of the bulk amount of concrete waste, it is required to diversify the concrete waste processors, perform more detailed site-specific assessment, and apply limiting conditions to the banking scenario.

• Journal of the Korean Geosynthetics Society
• /
• v.21 no.3
• /
• pp.41-48
• /
• 2022

Generally it was known that member forces in the earthquake resistant design is lower than those in the general design. But it is not true in cases of water treatment underground structures, which is different in each case like water treatment plant, sedimentation basin, and utility-pipe conduit. Also, looking at the scale of earthquakes that have recently occurred in Korea, large-scale earthquakes are frequent, so when the magnitude of the design seismic force increases, it is necessary to investigate the seismic behavior of the water treatment underground structure and to deal with it. In this study the change rate of member forces was investigated by the change of design load factor (earthquake acceleration design criteria), earth depth, underground water level. The pseudo-static analysis and response displacement method was applied, and various analyzes were conducted depending on the ground water and soil depth. The proposed formula in this study will be efficient when the earthquake design code of water treatment underground structures is revised.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.3
• /
• pp.185-190
• /
• 2016

Damages of the main engine aftmost bearing and the after stern tube bearing tend to increase due to misalignment. And as the shafting system becomes stiffer due to the large engine power, whereas the hull structure becomes more flexible due to optimization by using high tensile thin steel plates. And this is the reason that more sophisticated shaft alignments are required. In this study, the optimum shafting alignment calculation was carried out, considering the thermal expansion effect, exploiting the sensitivity index, which indicates the reasonable position of forward intermediate shaft bearing for shaft alignment. and as the main subject in this study, the elastic deformation on intermediate shaft and main engine bearings occurred by vertical load of shaft mass were examined thoroughly and analyzed allowable load of bearings, reaction influence numbers of all bearings. As the result, a reliable optimum shafting alignment was derived theoretically. To verify these results, they were referred to the engine maker's technical information of main engine installation and being used shafting alignment programs of both Korean Register of Shipping and Det Norske Veritas, their reliability were reviewed.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.4D
• /
• pp.595-601
• /
• 2011

There is currently applied to the unit cost per a distance (KRW/km) for estimating the conceptual cost of civil work on basic planning stage of high speed railroad. This unit cost is an arithmetic average value based on historical data, which could be in big error. It also is difficult to explain the deficiency comparing the estimated cost derived from next basic design stage. This study provides the conceptual estimation model using by the parametric method and regression analysis. Independent variables are the distance and the geological materials (earth, weathered rock, soft-rock, hard-rock), extracting from the actual data to 36 contracts. The deviation between the unit costs estimated using the developed model and the actual cost data is presented in the range from -0.4% to +31%. This range is acceptable compared the typical range "-30% to + 50%". This model will improve the accuracy of existing method and be expected to contribute to effective total cost management and the economic aspects, reduce the financial expenditure.

• Convergence Security Journal
• /
• v.12 no.1
• /
• pp.79-87
• /
• 2012

Future Internet has been designing and developing in the world because of overcoming limits of current Internet and accepting new requirements. Therefore it is totally different from architectures of current Internet and it is based on Clean-Slate. Future Internet already has been studying with enormous investment by advanced countries such as USA, EU etc. Technical characteristics of Future Internet can be categorized into Infra techniques, Architectures and Service techniques. Especially, our country is in a superior position in Infra techniques and Service techniques. We can have competitiveness to develop trust communication in Future Internet because we have advantages of various Services such as mobile communication, Machine to Machine and Sensor Networks. This paper aims to analysis reference model of trust communication in Future Internet. To achieve this, we studied analysis of security techniques in four Future Internet researches of NSF.

• Journal of the Institute of Convergence Signal Processing
• /
• v.9 no.4
• /
• pp.245-252
• /
• 2008

In this paper, we propose a new method for improving the H 264 encoding process and motion estimation part. Our approach is a method to reduce the encoding running time through the omission of reference frame in the mode selection process of H 264 and an improvement of SAD computing process. To evaluate the proposed method, we used the H 264 standard image of QCIF size and TIN 4:2:0 format. Experimental results show that proposed SAD algorithm 1 can improve the speed of encoding runnung time by an average of 4.7% with a negligible degradation of PSNR. However, SAD algorithm 2 can improve the speed of encoding runnung time by an average of 9.6% with 0.98dB degradation of PSNR.

• Journal of Broadcast Engineering
• /
• v.16 no.6
• /
• pp.996-1008
• /
• 2011

This paper proposes a PSNR estimation algorithm of H.264/AVC bitstream for hierarchical B-picture structure. The proposed method consists of a modeling method for DCT coefficients for I-pictures and an error estimation method for blocks encoded by skip mode. The modeling method selects an appropriate model between Laplacian and Cauchy model, and the error of skip mode is estimated from MSE values of reference pictures. Experimental results show that the modeling method predicts more accurate PSNR values than Laplacian and Cauchy model and the error estimation method of skip mode enhances PSNR estimation of hierarchical B-picture structure.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.12
• /
• pp.2527-2533
• /
• 2011

In this paper we propose a new pre-processing algorithm applied to multi-view video coding using color compensation algorithm based on image features. Multi-view images have a difference between neighboring frames according to illumination and different camera characteristics. To compensate this color difference, first we model the characteristics of cameras based on frame's feature from each camera and then correct the color difference. To extract corresponding features from each frame, we use Harris corner detection algorithm and characteristic coefficients used in the model is estimated by using Gauss-Newton algorithm. In this algorithm, we compensate RGB components of target images, separately from the reference image. The experimental results with many test images show that the proposed algorithm peformed better than the histogram based algorithm as much as 14 % of bit reduction and 0.5 dB ~ 0.8dB of PSNR enhancement.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.13 no.4
• /
• pp.241-248
• /
• 2010

This paper deals with the performance analysis and design of the Darrieus-type vertical axis turbine to evaluate the effect of key design parameters such as number of blade, blade chord, pitch and camber. The commercial CFD software FLUENT was employed as an unsteady Reynolds-Averaged Navier-Stokes (RANS) solver with k-e turbulent model. Grid system was modelled by GAMBIT. Basic numerical methodology of the present study is appeared in Jung et al. (2009). Two-dimensional analysis was mostly adopted to avoid the barrier of massive calculation required for parametric study. It was found that the highly efficient turbine model could be designed through the optimization of design parametrrs.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2011.07a
• /
• pp.578-581
• /
• 2011

H.264/AVC에서는 율-왜곡 최적화 기법을 사용하여 부호화 성능을 이전 보다 대폭 향상시켰다. 율-왜곡 최적화 기법은 선택할 수 있는 모든 코딩 모드들의 비용을 계산한 후, 최소의 비용을 가진 모드를 선택하여 부호화를 한다. 따라서 코딩 모드들이 많아질수록 복잡도 역시 증가하며, 기존 표준보다 다양한 코딩모드를 지원하는 H.264에서는 복잡도가 더 많이 증가한다. 본 논문에서는 SAHTD(Sum of Absolute Hadamard Transform Difference)를 이용하여 화면 내 모드 결정부에서 빠른 화면내 모드 결정을 하면서도 압축 손실이 적게 발생하는 방법을 제시하였다. 휘도 신호 $16{\times}16$블록, 휘도 신호 $4{\times}4$블록, 색차 신호 $8{\times}8$블록 모두 SAHTD를 기준으로 최적의 모드가 결정된다. 휘도 신호 $16{\times}16$블록에서 SAHTD값에 따라 $4{\times}4$블록 부호화 과정을 조기 종결이 가능하게 하는 것과, 휘도 신호 $4{\times}4$에서는 SAHTD 값이 가장 낮은 3개의 모드와 MPM(Most Probable Mode)을 후보 모드로 선택하여 율-왜곡 최적화를 수행하는 방식이 사용되었다. MPM이 SAHTD값이 가장 낮을 경우 MPM이 휘도신호 $4{\times}4$블록의 최적의 모드로 선택되고 종료된다. JM 참조 소프트웨어를 통한 실험결과 제안된 기법은 기존 JM의 방식에 비해 화면 내 프레임의 부호화 시간의 84.7% 감소와 0.049dB의 PSNR 감소율, 0.595%의 비트 증가율을 보여주었다.