• The Journal of the Acoustical Society of Korea
• /
• v.26 no.8
• /
• pp.426-431
• /
• 2007

In this paper we have studied the underwater vector channel modeling for MIMO(Multiple Input Multiple Output) to increase the performance and efficiency for ultrasound communication in underwater channel environments. Also we have analyzed the MIMO techniques using the proposed channel modeling. For underwater MIMO channel modeling. experiments were done in real channel environments and the data were analyzed to estimate parameters such as fading, Doppler, time delay, angle of arrival, and receiving power. These were used for modeling of underwater vector channel modeling for MIMO. Additionally, we have analyzed the performance of MIMO systems using our proposed channel models. As a result we could see that the BER has decreased severely with the same SNR when using the MIMO system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.7C
• /
• pp.691-699
• /
• 2006

Despite of the in-depth effort to cantrol the variability in IP networks, quality of service (QoS) is still not guaranteed in the IP networks. Thus, it is necessary to deal with the audible artifacts caused by packet lasses. To overcame the packet loss problem, most speech coding standard have their own embedded packet loss concealment (PLC) algorithms which adapt extrapolation methods utilizing the dependency on adjacent frames. Since many low bit rate CELP coders use predictive schemes for increasing coding efficiency, however, error propagation occurs even if single packet is lost. In this paper, we propose an efficient PLC algorithm with consideration about the speech characteristics of lost frames. To design an efficient PLC algorithm, we perform several experiments on investigating the error propagation effect of lost frames of a predictive coder. And then, we summarize the impact of packet loss to the speech characteristics and analyze the importance of the encoded parameters depending on each speech classes. From the result of the experiments, we propose a new PLC algorithm that mainly focuses on reducing the error propagation time. Experimental results show that the performance is much higher than conventional extrapolation methods over various frame erasure rate (FER) conditions. Especially the difference is remarkable in high FER condition.

• Journal of the Korea Society for Simulation
• /
• v.17 no.4
• /
• pp.199-208
• /
• 2008

Lately, since Complementary Metal Oxide Semiconductor(CMOS) image sensor system has low power, low cost and been miniaturized, hardware and applied software studies using these strengths are being carrying on actively. However, the products equipped with CMOS image sensor based polling method yet has several problems in degree of completeness of applied software and firmware, compared with hardware’s. CMOS image sensor system has an ineffective synchronous problem due to superfluous message exchange. Also when a sending of data is delayed continually, overhead of re-sending is large. So because of these, it has a problem in structural stability according to Polling Method. In this study, polling cycle was subdivided in high-speed synchronization method of firmware -based through MCU and synchronization method of Stepwise was proposed. Also, re-connection and data sending were advanced more efficiently by using interrupt way. In conclusion, the proposed method showed more than 20 times better performance in synchronization time and error connection. Also, a board was created by using C328R board of CMOS image sensor-based and ATmega128L which has low power, MCU and camera modules of proposed firmware were compared with provided software and analyzed in synchronization time and error connection.

• The Transactions of the Korea Information Processing Society
• /
• v.4 no.4
• /
• pp.1059-1075
• /
• 1997

The transprot layer protocol for distrubuted multimedia applications in high speed network should gurantee the Quality of Serivce(QoS)requested by uwer.,The QoS Parmenters can be divied into two calssifications:those depend on the speed of a network such as bandiwidth,end-to-end transmission delay and throughput;and net- woek independent parameters such as various typed of group communications, retransmission method based on multimeda characteristic,acceptable packet wrror rate and transmission priority.In this proposed protocol,we divided user's QoS into performance redated parmeters and non-performance related parameters.The perform- ance-related paramenters are mapped into ATM traddic paramenters by the Distributed QoS Manger(DQM),the QoS manager,and the non-performance redlted paramenters are supported by the Distributed Multimedia Trans-port protocol(DMTP),a high-performance group transport protocol.Especially,becaues the DMTP is designed with considering the IP protocol,it can be efficiently used as an underlying protocol not onlu in ATM,but also in Ethernet,Token ring and FDDI LAN.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.97-107
• /
• 2013

Underwater wireless communication systems can be useful for underwater environment observation, catastrophe prevention, ocean resources exploration, ocean organism research, vessel sinking exploration, and so on. However, unlike terrestrial wireless communication, underwater wireless communication should consider factors such as long propagation delay, limited transmission capacity, high bit-error rate due to potential loss in power, ambient noise, man-made noise, multi-path, etc., because of the inherent characteristics of water. Thus, in this paper, we propose a suitable media access control(MAC) protocol that applies a combination of the ALOHA MAC protocol and the CSMA/CA MAC protocol to underwater environment. We further propose a mathematical analysis model to evaluate performance. We also verify performance improvement in the proposed scheme in comparison with existing MAC protocols.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.6
• /
• pp.553-563
• /
• 2010

This paper presents a tapered slot-antenna(TSA) for optimal impulse-signal transmission in ultra-wide band(UWB). The proposed TSA provides radiates in end-fire direction, which meets an impulse-radio UWB(IR-UWB) system demands(e.g., low loss, thus less error throughout the UWB band). In order to minimize the pulse distortion, we used an wideband impedance transformer and a microstrip slotline. The pulse fidelity characteristics was evaluated with finite-difference time-domain(FDTD) analysis technique and pulse fidelity correlation equation. Approximately 93.89 % pulse fidelity was obtained between the two antennas in 0.5 m range. Additionally, derived chirp Z-transform algorithm enables us to utilize the zoom-in option on the pulse signal in few nano-seconds below. Thus, it is possible to analyze the pulse signal distortion, delay or dispersion characteristics.

• The KIPS Transactions:PartC
• /
• v.8C no.1
• /
• pp.97-104
• /
• 2001

In this paper, we present a new hierarchical model for performance analysis of channel allocation and packet service protocol in wireless n network. The proposed hierarchical model consists of two parts : upper and lower layer models. The upper layer model is the structure state model representing the state of the channel allocation and call service. The lower layer model, which captures the performance of the system within a given structure state, is the wireless packet retransmission protocol model. These models are developed using SRN which is an modeling tool. SRN, an extension of stochastic Petri net, provides compact modeling facilities for system analysis. To get the performance index, appropriate reward rates are assigned to its SRN. Fixed point iteration is used to determine the model parameters that are not available directly as input. That is, the call service time of the upper model can be obtained by packet delay in the lower model, and the packet generation rates of the lower model come from call generation rates of the upper model.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.7B
• /
• pp.1322-1330
• /
• 1999

The major source of errors in high-speed networks such as Broadband ISDN(B-ISDN) is buffer overflow during congested conditions. These congestion errors are the dominant sources of errors in high-speed networks and result in cell losses. Conventional communication protocols use error detection and retransmission to deal with lost packets and transmission errors. As an alternative, we have presented a method to recover consecutive cell losses using forward error correction(FEC) in ATM(Asynchronous Transfer Mode) networks to reduce the problem. The method finds the lost cells by observing new cell sequence number($SN^{\ast}$). We have used the LI field together with SN and ST fields to consider the $SN^{\ast}$ which provides more correcting coverage than SN in ATM standards. The $SN^{\ast}$ based on the additive way such as the addition of LI capacity to original SN capacity is numbered a repeatedly 0-to-80 cycle. Another extension can be based on the multiplicative way such that LI capacity is multiplied by SN capacity. The multiplicative $SN^{\ast}$ is numbered in a repeatedly 0-to-1025 cycle.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.3A
• /
• pp.217-225
• /
• 2005

This paper presents specialized DSP instructions and their architecture for the Viterbi algorithm used in various wireless communication standards. The proposed architecture can significantly reduce the Trace Back (TB) latency. The proposed instructions perform the Add Compare Select (ACS) and TB operations in parallel and the architecture has special hardware, called the Offset Calculation Unit (OCU), which automatically calculates data addresses for the trellis butterfly computations. Logic synthesis has been Performed using the Samsung SEC 0.18 μm standard cell library. OCU consists of 1,460 gates and the maximum delay of OCU is about 5.75 ns. The BER performance of the ACS-TB parallel method increases about 0.00022dB at 6dB Eb/No compared with the typical TB method, which is negligible. When the constraint length K is 5, the proposed DSP architecture can reduce the decoding cycles about 17% compared with the Carmel DSP and about 45% compared with 7MS320c15x.

• Journal of KIISE:Information Networking
• /
• v.35 no.1
• /
• pp.1-10
• /
• 2008

Once the sensor node in wireless sensor networks is installed, it usually operates without human intervention for a long time. The remote code update scheme is required because it is difficult to recall the sensor node in many situations. Therefore, studies on the reliable and efficient transport protocol for code propagation in wireless sensor networks have been increasingly done. However, by considering only the stability aspect of transmission, most of previous works ignore the consideration on the fast code propagation. This results the energy inefficiency by consuming unnecessary energy due to the slow code propagation. In this paper, in order to overcome limitation of the previous code propagation protocols, we propose a new code propagation protocol called "FCPP(Fast Code Propagation Protocol)". The FCPP aims at improving the reliability at well as performance. For this purpose, the FCPP accomplishes the fast code propagation by using the RTT-based transmission rate control and NACK suppression scheme, which provides a better the network utilization and avoids a unnecessary transmission delay. Based on the ns-2 simulation result, we prove that the FCPP Improves significantly both reliability and performance.