• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.14 no.4
• /
• pp.1-7
• /
• 2000

In this paper, we study a cause of malfunction of switch to control drive motor in DFMS(Digital Flux Mapping System) which can measure incore neutron flux of the nuclear plant, and develope a method to solve this problem. DFMS has the type of generating contact signal by mechanical switch lever, which is operated whenever thimble detector inserted or withdrawed through thimble Guide Tube. However the characteristics of the lever tend to be changed by mechanical degrade or bad environment and the lever finally generates errotic contact signal. Therefore we installed electric coil ass'yin the outside of Guide Tube instead of mechanical switch assy's. In addition we applied resonance effect to control circuit and installed condenser in the input of power supply to protect noise and interference. After completion of this improvement, we tested this improved device repetitively under the various conditions. In conclusion, we identified the generation of the desired contact signal and the prevention of detector failure through plant surveillance test during normal plant operation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.5
• /
• pp.106-113
• /
• 2010

If leakage current is neglected, it can become a cause for disasters such as electric shock and fire, therefore a continuous monitoring is necessary. However in most cases, because management of substations is performed by unmanned systems, or walk-around inspections, continuous monitor is difficult. So when an accident occurs and the cause is not immediately resolved causing the emergency generator's OCGR getting activated by the leakage current that in turn cut off the ACB, the emergency generator may stop working. To prevent such a problem, a real-time integrated monitoring system for monitoring the leakage current returning to the grounding wire of neutral point of the low voltage side of transformer is proposed. Therefore in this paper, the effects of flow of leakage current, which is caused by insulation degradation phenomena or insulation destroy phenomena, were identified by simulation. And through cases studies; the excellence of integrated monitoring system was verified.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.212.2-212.2
• /
• 2012

지구 자기권에 존재하는 플라즈마 입자의 다중관측을 목적으로 개발된 초소형 탑재체 STEIN (SupraThermal Electron, Ion, Neutral) 은 경희대학교와 UC Berkeley가 공동으로 개발 중인 3대의 초소형 과학위성 TRIO-CINEMA (TRiplet Ionosphere Observatory - Cubesat for Ion, Neutral, Electron and MAgnetic fields) 에 탑재될 입자 검출기이다. 32개의 픽셀로 이루어진 STEIN 검출기는 2~300 keV의 전자, 4~300 keV의 이온과 중성입자(Energetic Neutral Atom: ENA) 를 분리 계측할 목적으로 설계되었으며, 하전입자가 정전장 편향기를 통과하여 서로 다른 검출기 픽셀에 도달함으로써 전자와 이온, 중성입자를 분리하여 계측할 수 있도록 하였다. 한편, STEIN 구조물에서 발생한 2차 입자의 검출을 방지하기 위해 정전 편향기 사이에 차단날(blade)을 설계하였다. 본 연구에서는 STEIN 모의실험 예비 결과로써 전기장에 크기 및 차단날에 의한 하전입자의 궤적과 이에 따른 분리 계측 성능을 알아보고자 Geant4 (GEometry ANd Tracking)를 사용하여 검출기 픽셀에 입사하는 전자의 초기 위치를 분석하였다. 전자의 입사 위치는 검출기로부터 5 cm 전방에서 6 mm * 20 mm 범위 내에서 무작위로 생성하여 검출기의 방향으로 수직 입사하였다. 분석 결과 전자들은 전기장의 방향에 따라 편향되는 결과를 보였으며, 저에너지 전자는 강한 전기장의 영향으로 차단날에 의해 차폐되어 검출되지 않았다. 따라서 전기장의 크기와 차단날에 따른 입자 분리 검출이 가능함을 본 모의실험을 통해 확인하였으며, STEIN 운용 시 입자 분리 검출 및 결과 분석 기반으로 본 연구 결과를 사용될 수 있을 것으로 기대된다.

• Fire Science and Engineering
• /
• v.28 no.5
• /
• pp.37-43
• /
• 2014

In the case of interior fire in an apartment building, contamination of vestibule area by fire smoke before air fan operating when fire doors are open makes the evacuation of people very difficult. In order to investigate the effect of heat release rate (HRR) and interior opening on fire flow velocity, numerical simulations using Fire Dynamics Simulator were carried out. In simulations, actual dimensions and configuration of an apartment building were considered and interior leakage and HRR were varied. From simulation results, it was found that fire flow velocity distribution is significantly influenced by HRR and interior opening resulting in the change of the location of a neutral plane. Also, it is shown that there is a larger difference of the fire flow velocity between upper and lower part of the fire door when the neutral plane becomes closer to the ceiling.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.8
• /
• pp.18-25
• /
• 2008

The paper presents a modeling of the grid-connected wind turbine generation system on MATLAB/Simulink and aims to perform simulations for analysis of the system's characteristics. It performs a pitch regulation for control of the wind generator's output with respect to wind speed variation, and presents a relationship between interconnecting transformer's connections and fault current by reviewing the variations of fault current according to transformer connections in a grid-connected wind power generation system. It also investigates the effect of grounding methods of the interconnecting transformer's neutral point on fault current variations. The simulation results show the differences of fault currents, voltages and generator's characteristics for a line-to-ground fault according to interconnecting transformer's four different connections, and the differences of fault currents of the system according to grounding methods of the transformer neutral point. Therefore, the case studies demonstrate the effectiveness of the proposed simulation model on Simulink.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.3
• /
• pp.275-284
• /
• 1999

Unbalanced source voltage in the 3-phase power system is decomposed into positive, negative and zero sequence c components. Also, assuming there is no neutral path in the system, the zero sequence component is not shown on the l load side. Therefore, in the unbalanced power system without neutral path. it is possible to provide balanced voltage to t the load side by compensating negative sequence component and also to regulate the voltage amplitude by controlling t the positive sequence component. In addition, the symmetrical components due to voltage unbalance can be effectively d detected on the synchronous reference frame by using dlongleftarrowq transformation. In this paper, an algorithm not only c compensating unbalanced source voltage by canceling the negative sequence component on the synchronous reference f frame but also maintaining load voltages constantly is proposed. Also a novel method for phase angle detection s synchronized by positive sequence component under unbalanced source voltage is suggested and this detected phase a angle is used for d-q transformation. The performances and characteristics of the proposed compensating system are a analyzed by simulation and verified through experimental results.

• Korean Journal of Food Science and Technology
• /
• v.34 no.3
• /
• pp.390-395
• /
• 2002

Concentrations of minerals (Ca, K, Mg, Na, Se, Zn, Fe, and Mn) in 50 different Korean foodstuffs were determined through neutron activation analysis. To check the accuracy of this method, the U.S. NIST standard reference materials were analyzed. Anchovy, sesame, perilla, and laver were found to contain relatively higher concentrations of Ca, Mg, Fe, and Zn than the other foodstuffs.

• Journal of the Korea Society of Computer and Information
• /
• v.26 no.1
• /
• pp.201-208
• /
• 2021

This study aims to provide the relevant basis upon which prediction of dyslipidemia should be made based on body information. Using the National Health Insurance big data (3,312,971 people) canonical correlation analysis was performed between body information and lipid-profile. Body information included age, height, weight and waist circumference, while the lipid-profile included total cholesterol, triglycerides, HDL cholesterol and LDL cholesterol. As a result, when the waist circumference and the weight are large, triglycerides increase and HDL cholesterol level decreases. In terms of age, weight, waist circumference, and HDL cholesterol, the canonical variates (the degree of influence) were significantly different according to sex. In particular, the canonical variate was dramatically changed around the forties and fifties in women in terms of weight, waist circumference, and HDL cholesterol. The canonical correlation results of the health care big data presented in this study will help construct a predictive model that can evaluate an individual's health status based on body information that can be easily measured in a non-invasive manner.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.2
• /
• pp.305-310
• /
• 2004

The present study was aimed at investigating effects of chicory inulin and three kinds of oligosaccharides on lipid metabolism in rats fed a high-cholesterol diet. Nine Sprague-Dawley male rats weighing, about 190g were given one of five experimental diets, which were basal cholesterol diet (Control) isomaltooligosaccharide diet (IMO), Iructooligosaccharide diet (FO), chicory inulooligosaccharide diet (CIO) and chicory inulin diet (CI) for 5 weeks. In the oligosaccharide and inulin diets, 6% was added at the expense of sucrose. Rats were pair-fed to the intake of FO group which consumed the least amount, and their feces were collected during the last 4 days. Body weight gain was lower in Fo and CI groups compared with the Control group. Plasma glucose levels of FO and CIO groups were lower and plasma triglyceride concentrations of FO, CIO, and CI groups were lower than those of IMO group. Plasma cholesterol concentration did not differ among groups. Relative liver weight was lower in CIO group. Hepatic triglyceride and cholesterol did not differ among. groups. Fecal excretion of neutral steroid and bile acid were not different among groups, but fecal triglyceride excretion was significantly increased in FO and CI groups compared with the Control group. In conclusion, supplementation of oligosaccharides and chicory inulin at 6% of diets showed no significant hypolipidemic effect in rats fed a high cholesterol diet.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.1
• /
• pp.83-90
• /
• 2004

This study was conducted to examine the effects of $\beta$3-adrenergic receptor polymorphism on the blood glucose level and obesity in 530 volunteers, who attended a weight loss program in a local obesity clinic. The age differences in total subjects and the distribution of male and female were 26.55$\pm$0.31 yr, 9.1% (n=48), 90.9% (n=492). The genotype distribution of $\beta$3-AR gene polymorphism were WW type 75%, WR type 22% and RR type 3%. Among many parameters, fasting blood glucose was significantly higher in WR＋RR type (p=0.001) compared with WW type. When the subjects were divided into two groups by 6.105 mmol/L of the fasting blood glucose level, the frequency of hyperglycemia was 23.3% in WW type subjects, while there was a increase to 35.6% in WR＋RR type subjects (p=0.011, $\chi$$^2$-analysis). When hyperglycemia group was compared with normoglycemia group, obesity index (p=0.044), %body fat (p=0.046) and TG (p=0.000) were significantly higher, and HDL (p=0.006) was significantly lower in the hyperglycemia. When all of the above factors were included in stepwise logistic regression analysis to find risk factors of hyperglycemia, the results were that the odds ratio for hyperglycemia were 2.015 (p=0.011) for WR+RR type of $\beta$3-AR gene, 2.165 (p=0.000) for TG and 0.419 (p=0.059) for HDL cholesterol. There was a significantly positive correlation between the blood glucose vs BMI, WHR, body fat in the WW type (r=0.099, 0.119, 0.082) However, in the WR and RR type there were no significance between the blood glucose vs BMI, WHR, body fat. These data suggest that the WR＋RR genotype of $\beta$3-AR has a very strong association with increased blood glucose level and might be a significant risk factor for hyperglycemia among Korean subjects.