• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.9
• /
• pp.18-26
• /
• 1999

Recently, multiuser detection has been investigated as an interesting topic because of its capability of eliminating multiuser interference and resistance to the near-far problem. In this paper, we consider a quasi maximum likelihood detector in the reverse link system which used antenna arrays in quasi-synchronous channels. It is also shown that the proposed system can suppress the interuser interference without using the side information of the other users. It is also shown that the performance of the proposed system is superior to that of the conventional matched filter system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.7 s.349
• /
• pp.132-142
• /
• 2006

In this paper, we present a candidate high data rate space time coded OFDM system for short range personal networking. The system transmits the complex space time coded signals with a hybrid orthogonal frequency division multiplexing (OFDM) based on ultra wideband (UWB) pulses. The transmitted signals are sparse pulse trains modulated by a frequency selected from a properly designed set of frequencies. Additionally, a widely linear (WL) receive filter and a space time frequency transmission are designed by using two simple parallel linear detectors. To overcome the deeply fade in the propagation system, a beamforming combined with space time block codes also 따 e briefly discussed.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.6
• /
• pp.21-30
• /
• 1975

A method by which one can optimize the complex responses of electronic circuits has been suggested. represented in the complex forms, the optimization methods presented so far have dealt with real magnitude and phase responses of circuits. Design examples are shown on the optimal designs of an amplifier, filter, operational circuits transmission lines. and a wave-shaping circuit.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.271-275
• /
• 2014

A New Single Phase Active Power Filter Controller is proposed using Rotating Synchronous Frame d-q transformation. Instantaneous Active Power is calculated using d-q transformation. Average Value of Instantaneous Active Power is obtained using Low Pass Filter. Because power factor is corrected, source current is in phase with source voltage. Amplitude of source current is calculated using single phase power formula. Reference signal of compensated current of Active power filter is obtained from source current reference signal minus load current. Simulation is performed using hysteresis current controller in proposed new controller. Simulation result shows that because active power filter compensates load current, source current is in phase with source voltage and source current is sinusoidal. And Hilbert transformer is builded using all pass filter.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.11
• /
• pp.10-22
• /
• 1998

In this paper, as a way of improving the availability and spectral efficiency of radio relay system, a co-channel radio relay system based upon the synchronous digital hierarchy is developed and its performance measured by 64-QAM with a never-seen multi-purpose ASIC chip is illustrated. This system provides a couple of transmission capacity compared with alternative channel arrangement. By adopting a powerful complex 13-tap adaptive time domain equalizer and cross-pol interference canceller, improvement of more than 1.5 ~ 2.0 dB in signature is obtained in comparison to 9 or 11-tap adaptive time domain equalizer, and about 22.5 dB in improvement factor of cross-pol interference canceller is achieved at C/N of 24.5 dB. In addition, digital filter makes it possible to optimize the occupied bandwidth by selecting an appropriate roll-off factor externally. It is expected that co-channel radio relay system with the powerful multi-purpose ASIC chip plays a key role in creating a value-added product, reliability, and reducing the outage time.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.4
• /
• pp.25-30
• /
• 1971

Fabrication and measurements of the magnetically tunable YIG band pass or stop filter at X-band are discussed. Using two YIG spheres located at the region of r-f circularly polarized magnetic field between the strip lines, the pass or stop characteristics of the filter are obtained. In the case of band stop, the output level is typically 25db lower than the input power. Contrarily for the pass band, the pass band level is 22db higher than the stop frequency region. The experimental results are in good agreement with the theoretical values of FMR. Further it is shown that the structure can be used for a directional coupler.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.18 no.3
• /
• pp.25-34
• /
• 1981

Aluminum anodization method has been investigated for fabricating charge coupled device(CCD) with two-level aluminum gate structure. Al2O3 films were formed to a thickness of 400-500A, by anodizing aluminum with 30-35V of anode voltage for 2 hours using 2 % ammonium tartrate solution as an electrolyte. Breakdown voltage of these films were about 30 volts. Using above mentioned Al2O3 film as an insulator between two aluminum electrodes, CCD transversal low pass filter has been fabricated. CCD transversal low pass filter with 17 tap coefficients has shown 22 dB stop-band attenuation. The operating clock frequency range of the fabricated device was from 3 KHz to 100 KHz.

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2003.11a
• /
• pp.205-207
• /
• 2003

In this paper, we propose novel, small and integrated microwave chip filter using high dielectric substrates. A variety of dielectric substrates can be selected for the specifications of products according to dielectric, Q-factors, temperature stability ect. This paper describes an application of the very high dielectric constant (K=133) substrate for design of a band pass filter to a 5.8GHz Transmitter/receiver(T/R) module.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.33B no.1
• /
• pp.128-132
• /
• 1996

In [1], it is shown that a subclass of ETBFs, which are self-dual ETBFs, can be expressed as a weighted average of median subfiltered outputs. In this paper, we extend this result to general ETBFs. In particular, we show that any ETBF can be represented as a weighted average of minimum (or maximum) subfiltered outputs. These representations naturally lead to a subclass of ETBF, called the K-th order ETBF (K-ETBF) that employs only those subfilters whose window sizes are less than or equal to K. By designing K-ETBFs under the mean square error criterion for various values of K and applying them to restore noisy signals, the tradeoff between the performance and the complexity of this class of filters is examined.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.36-40
• /
• 2013

A novel design method of ultra wideband bandpass filter using CRLH transmission line with Dumbell type DGS is presented in this paper. Defected Ground Structure and microstrip interdigital capacitor are used to design the ultra wideband (UWB) filter. CRLH transmission line has composite characteristics of low pass and high pass filter. As control of cutoff frequency of low pass and high pass response on CRLH transmission line, we can get characteristic of UWB filter. We designed and simulated for CRLH transmission lines with one, two, four, and eight cells. A UWB filter using four cells CRLH is designed and fabricated to verify the results. The characteristics of designed filter have center frequency of 5GHz and relative bandwidth of 88%.