• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.6
• /
• pp.1399-1404
• /
• 2015

This paper analyzed the phenomenon of drain induced barrier lowering(DIBL) for the ratio of channel length vs. thickness of asymmetric double gate(DG) MOSFET. DIBL, the important secondary effect, is occurred for short channel MOSFET in which drain voltage influences on potential barrier height of source, and significantly affects on transistor characteristics such as threshold voltage movement. The series potential distribution is derived from Poisson's equation to analyze DIBL, and threshold voltage is defined by top gate voltage of asymmetric DGMOSFET in case the off current is 10^-7 A/m. Since asymmetric DGMOSFET has the advantage that channel length and channel thickness can significantly minimize, and short channel effects reduce, DIBL is investigated for the ratio of channel length vs. thickness in this study. As a results, DIBL is greatly influenced by the ratio of channel length vs. thickness. We also know DIBL is greatly changed for bottom gate voltage, top/bottom gate oxide thickness and channel doping concentration.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.3
• /
• pp.563-572
• /
• 2001

A conventional motor in a crane has a taco generator to feed back the number of turns to a main controller. The taco generator is contacted to a motor shaft through the coupling. Errors in a crane have often occurred because the coupling has worn out while the motor is turning. In this paper, we design the device of the frequency to voltage transducer in a motor. The device is composed of a rotary encoder, a speed measurement using PIC16F84 controller, a display, and a direction-decision block. The rotation of a motor is recognized by the rotary encoder and microcontroller counts the number of turns of a motor. The emergency signal is generated if the frequency goes over or below the speed limit of a motor. And the device can acknowledge the rotation direction of the motor after 6。 rotation. The simulation results and the test for a implemented device have shown that the transducer of a frequency to a voltage can replace a taco generator in a crane.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.2
• /
• pp.54-63
• /
• 2007

Recently, a fuel cell with low voltage and high current output characteristics is remarkable for new generation system. It needs both a DC-DC step-up converter and DC-AC inverter to be used in fuel cell generation system. Therefor, this paper, consists of an isolated DC-DC converter to boost the fuel cell voltage $380[V_{DC}]$ and a PWM inverter with LC filter to convent the DC voltage to single-phase $220[V_{AC}]$. Expressly, a tapped inductor filter with freewheeling diode is newly implemented in the output filter of the proposed high frequency isolated ZVZCS PWM DC-DC converter to suppress circulating current under the wide output voltage regulation range, thus to eliminate the switching and transformer turn-on/off over-short voltage or transient phenomena. Besides the efficiency of 93-97[%]is obtained over the wide output voltage regulation ranges and load variations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.5 s.96
• /
• pp.494-500
• /
• 2005

In this paper, optical noise is reduced by a differential detector with an optical fiber coupler in an optical wireless system. An $1\times2$ optical fiber coupler divides the received optical signal by 2 equally, and connects them to the two photodiodes in a differential detector. The output voltage variation due to the abrupt change of optical noise distribution in space disappears because the two photodiodes effectively detect the optical signal at the same point. The signal to noise ratio in a differential detector with a fiber coupler was 8 dB higher than in a single photodiode with an optical filter.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2007.05a
• /
• pp.404-409
• /
• 2007

To change rail tracks from main track to another track, it needs some device that is called turnout point. If the point which is composed of accurate parts and complex sensors does not work, serious problems will be arisen. However, there serious problems by the failure of the point. In this paper, after analyzing the failures of the conventional points, a new point is presented. The proposed point is not affected by surge caused by lighting.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.43 no.6 s.312
• /
• pp.27-32
• /
• 2006

A temperature-compensated hygrometer has been developed using resistive humidity sensors. It consist of a sine wave generator, logarithm converters, rectifiers, and amplifiers. The hygrometer accomplishes the linearization and temperature compensation of sensor characteristics. The theory of operation is presented and experimental results are used to verify theoretical predictions. The experimental results show that the conversion sensitivity of the hygrometer is about 24.8 mV/%RH and the linearity error of the conversion characteristic is less than 17.2 % over a relative humidity range from 30 to 80 %RH. The results also show that the temperature coefficient of the output voltage is less than $10149ppm/^{\circ}C$ over a temperature range from 22 to $40^{\circ}C$.

• Proceedings of the KIPE Conference
• /
• 2019.11a
• /
• pp.46-48
• /
• 2019

본 논문은 Discontinuous Conduction Mode(DCM) 플라이백 컨버터로 생성한 고전압 펄스를 스파크 갭으로 펄스 상승 시간을 줄이는 방법에 관하여 다룬다. 이러한 방법으로 생성된 빠른 상승률 특성을 가지는 고전압 펄스 전원장치는 친환경 가스 처리 분야에 사용할 수 있다. 기존 스태킹 구조의 펄스 전원 장치는 많은 수의 스위치들과 에너지 저장 소자가 필요하므로 부피가 커지고 제조 단가가 증가하는 반면, 분 논문에 제안된 전원 장치는 구조를 단순화하여 전체 시스템의 소형화 및 제조 단가를 낮춘 점을 특징으로 한다. 제안된 설계 토폴로지는 플라이백 변압기 2차 측에 다이오드의 사용 유무에 따라 두 개의 변형된 회로로 응용 가능 하다. 변압기 2차측에 다이오드를 사용하면, 음의 성분 없이 깨끗한 고전압 출력 펄스를 만들 수 있지만 사용한 다이오드의 전압 정격을 고려해야 한다. 다이오드를 사용하지 않는다면, 고전압 출력 펄스에 음의 성분이 발생하지만 비용과 부피를 최대한 줄일 수 있다. PSIM 시뮬레이션을 사용하여 제안하는 전원 장치의 23kV, 0.5 ㎲, 10 ns rising time의 출력 펄스 발생 성능을 검증하고, 다이오드 사용에 따른 출력 펄스의 차이점을 비교하였다.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.36 no.11
• /
• pp.826-835
• /
• 1987

In this paper, the horizontal output and flyback transformer (FBT) stages during the retrace time are represented by a new simplified equivalent circuit. The circuit analysis is performed by means of this equivalent circuit and the computed results are compared with those of experiment The results show that for fixed other circuit parameters, the high voltage regulation depends upon the coupling factor of transformer, the V-I characteristics and the charge storage of the high voltage rectifying diodes. The computed output voltages are found to be about 3.9 to 5.8% higher than the measurements and these are probably due to the neglection of the transformer losses. These acceptable errors show that the newly suggested equivalent circuit is reasonable.

• Proceedings of the KIPE Conference
• /
• 2007.07a
• /
• pp.182-184
• /
• 2007

본 논문에서는 2단 AC/DC 컨버터와 단일단 AC/DC 컨버터가 가지고 있는 단점들을 개선 할 수 있는 새로운 준 단일 전력단 컨버터를 제안한다. DC/DC 단으로는 동적 특성이 좋은 LLC 컨버터를 채용하여 별도의 제어기 없이 고정 주파수 및 고정 Duty(50%) 발생기에 의해 Open Loop로 구동 시킴으로써 저가격화 및 고효율화를 획득 할 수 있다. 또한 역률개선단은 Boost 컨버터를 채용하고 간단한 제어기 1개를 사용하여 역률 개선과 동시에 DC/DC 단의 최종출력을 제어한다. 기존 2단 PFC 컨버터와는 다르게 PFC 링크전압을 Feedback 하지 않고 DC/DC 단의 최종 출력을 Feedback 하여 제어한다. 제안된 회로의 우수성 검증을 위해 600W급 시작품을 이용한 실험 결과를 제시한다.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.5
• /
• pp.460-466
• /
• 2001

The oxidizing power of ozone is the greatest of all commercially available oxidizers and thus ozone is taking the place of chlorine for water treatment. For energy-effective treatment of water, ozone should be generated in high concentration. A silent glow discharge ozonizer is high effective in industrial aspect and thus is the most widely used. We found that the key parameters associated with the ozone generation rate are the driving voltage of the discharger, the discharge rate and the temperature of the ozone generation tube. For an easy control of these parameters, we build a monitoring system with graphical user interface. This system is based on Windows-98 PC, programmed with C++ and LabView.