• Journal of Yeungnam Medical Science
• /
• v.6 no.1
• /
• pp.121-131
• /
• 1989

The temperature-corrected values of blood gas analysis were compared to uncorrected values in 40 cases of open heart surgery under moderate hypothermic cardiopulmonary bypass. The results were as follows. 1. The corrected value of pH was significantly higher than uncorrected value, and it's relationship was ${\Delta}pH=-0.015$ ${\Delta}Temp+0.005$(r=0.81, P<(0.01). 2. The corrected value of $PCO_2$ was lower than uncorrected value, and it's relationship was ${\Delta}PCO_2=1.11$ ${\Delta}Temp+1.81$(r=0.50, P<0.01). 3. The corrected value of $PO_2$ was lower than uncorrected value, and it' s relationship was ${\Delta}PO_2=5.21$ ${\Delta}Temp-1.45$(r=0.32, P<0.01). But there was no clinical significance. 4. The corrected values of $HCO_{3^-}$, base excess, $CO_2$ content and oxygen saturation were similar with uncorrected values. In summery, the values of pH and $PCO_2$were significantly changed by temperature-correction. Because of the neutral point of water (pH=pOH) rises as temperature falls and it change in parallel with the changes in blood pH, a corrected pH of 7.4, $PaCO_2$ of 40mmHg during deep hypothermia would reflect a profound respiratory acidosis. Therefore, the use of the uncorrected value at $37^{\circ}C$ is more preferable and valid means of assessing acid-base management regardless of actual patient temperature.

• Resources Recycling
• /
• v.27 no.6
• /
• pp.30-37
• /
• 2018

A series of experiment was conducted to evaluate basic performances of low-pH, anti-washing grouts incorporating gypsum which applied for reinforcing underwater cavities in limestone- grounds. Various types of mix proportions were designed and the fluidity, strength and environmental impact of these mixtures were evaluated. The flowability was evaluated under two conditions, i.e., flows without and with pressing, respectively. Strength was measured for the hardened mixtures fabricated under conditions of air and water injections. The environmental impacts including the pH of the suspension and the suspended solids concentration for the mixtures were evaluated. The low pH of fresh mixture suspension, below than 10, was achieved by incorporation of gypsum. The mix proportions of cement-quartz powder-gypsum binders and chemical agents resulted in mortar natural flow 7-10 cm and uniaxial compressive strength 4 MPa were derived.

• Applied Chemistry for Engineering
• /
• v.32 no.2
• /
• pp.190-196
• /
• 2021

Desulfurization reaction in a bubble type reactor was carried out by adding three organic acids such as acetic acid, lactic acid, and antic acid to investigate the enhancement of the desulfurization performance of low-grade limestone. Desulfurization of limestone slurry without organic acids initiated to degrade at pH 5.2 or less, whereas organic acid-added limestone slurry exhibited a stable efficiency in the initial desulfurization with slurry pH ranging 4.2~4.5. At slurry pH below 4, the desulfurization performance of limestone slurry with addition of organic acids may be related to the amount of anions produced by dissociation of the organic acids. When limestone slurry had a large amount of anions, a rapid decrease in buffer capacity of slurry pH did not occur. These results were due to the acidity and dissociation of organic acids. The desulfurization performance of low-grade limestone slurry increased in the order of acetic acid (2.6%) < lactic acid (6.4%) < formic acid (16.7%).

• Journal of the Korean Institute of Gas
• /
• v.22 no.5
• /
• pp.53-61
• /
• 2018

Low-salinity water based polymerflooding (LSPF) is one of promising enhanced oil recovery (EOR) method that has the synergetic effect of combining polymer injection method and low-salinity water injection method. In order to maximize EOR efficiency, it is essential to design low-salinity water appropriately considering the properties of polymer. In this aspect, the main purpose of this study is to investigate the effect of pH and $SO_4{^{2-}}$ ion which one of PDI (Potential Determining Ion) on oil production when applying LSPF to carbonate oil reservoir. First, the stability and adsorption of polymer molecule were analyzed in different pH of injection water and $SO_4{^{2-}}$ concentration in injection water. As a result, regardless of pH and $SO_4{^{2-}}$ concentration, when $SO_4{^{2-}}$ ion was contained in injection water, the stability of polymer solution was obtained. However, from the result of polymer retention analysis, in neutral state of injection water, since $SO_4{^{2-}}$ interfered the adsorption of polymer, the adsorption thickness of polymer was thinner as $SO_4{^{2-}}$ concentration was higher. On the other hand, when injection water was acidic as pH 4, the amount of polymer adsorption increased with the injection of polymer solution, so the mobility of polymer solution was greatly lowered. From the results of wettability alteration due to low-salinity water effect, in the case of neutral injection water injected, as $SO_4{^{2-}}$ concentration was increased, more oil which attached on rock surface was detached, altering wettability from oil-wet to water-wet. On the other hand, in acidic condition, due to complex effect of rock dissolution and polymer adsorption, wettability of the entire core system was less altered relatively to neutral condition. Therefore, it was evaluated that better EOR efficiency was obtained when injecting low-salinity water based polymer solution containing high concentration of $SO_4{^{2-}}$ with neutral condition, enhancing the oil production up to 12.3% compared to low-salinity water injection method.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2000.05a
• /
• pp.126-127
• /
• 2000

Fe(III) 응집제는 pH 5～9범위에서 Al(III)계 응집제보다 보다 우수한 응집효과를 보였으며 또한 pH의 영향을 거의 받지 않는 것으로 나타났다. 잔류 Fe의 경우 응집제 주입농도와 pH 증가에 영향을 거의 받지 않고 저농도의 잔류 Fe농도를 나타낸 반면, Al(III) 응집제는 잔류 Al의 급격한 증가를 나타내었다.

• Resources Recycling
• /
• v.25 no.6
• /
• pp.98-104
• /
• 2016

The purpose of this study is to obtain an optimum condition of the concentrate by floatation using Australian low grade copper ore of suitable particle size by crushing, grinding and sizing. The effect of the dosage of collector, activator, depressant and change of acidity on the floatation was investigated. The floatation conditions comprising of pH 9.0 acidity, 500g/t $CuSO_4{\cdot}5H_2O$ activator, 500g/t K.E.X. collector, 1500g/t $Na_2SO_3$ depressant and 25wt.% plup density were optimized. Grade and recovery of copper in the concentrate obtained by froth floatation under optimum conditions were 4wt.% and 65wt.% respectively.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.26 no.4
• /
• pp.312-320
• /
• 1993

Low-salted and fermented squid products, squid jeotkal was prepared and fermented at $10^{\circ}C$. During fermentation of squid, microbiological and chemical changes were examined. Sensory evaluation was also carried out. After 20 days of fermentation, taste and flavor of the squid jeotkal containing $10\%$ NaCl were proven to be the best; in contrast, the jeotkal with $7\%$ NaCl exhibited the highest sensory score. At the period showing the best flavor and taste, viable cell count reached to $10^8/g$. Throughout the fermentation period, types of microorganisms isolated were significantly different in squid jeotkal of different salinity. In general, protease producer and bacteria producing components of jeotkal-flavor and organic acids more likely contributed to producing the jeotkal of the best quality. pH of the squid jeotkal with $10\%$ salinity maintained under pH 7.0 throughout the fermentation periods; however, in the case of the jeotkal with $7\%$ salinity, pH increased over pH 7.0 after day 25. Similar tendency was observed in the results from VBN and hypoxanthine formation. Total nitrogen was decreased as fermentation proceeded; in contrast, total free amino acids were increased.

• Honam Mathematical Journal
• /
• v.2 no.1
• /
• pp.13-18
• /
• 1980

모든 기호(記號)는 G.E Bredon의 저(著) Sheaf Theory의 기호(記號)를 따른다. A가 torsion free이며 elementary sheaf이라 하자. 그리고 L을 injective L-module이라 하자 $dim_{\varphi}X<{\infty}$이라면 support의 $family{\varphi}$와 locally subset z에 대하여 ${\Gamma}_{z}(^{\sim}Hom({\Gamma}_{\varphi}(L),L){\otimes}A){\simeq}H_0{^{z}}(X:A)\;H_{-p}{^{z}}(X:A)=0,\;p=1,2,3,$⋯⋯ 이며 support의 family c와 compact subset z에 대하여도 ${\Gamma}_{z}(^{\sim}Hom({\Gamma}_{c}(L),L){\otimes}A){\simeq}H_0{^{z}}(X:A)\;H_{-y}{^{z}}(X:A)=0,\;p=1,2,3,$⋯⋯ A가 elementary이면 locally closed z와 z에서 closed인 $z^{\prime}$ 그리고 $z^{\prime\prime}=z-z^{\prime}$에 대하여 exact sequence ⋯⋯${\rightarrow}H^{z^{\prime}}_{p}\;(X:A){\rightarrow}H^{z}_{p}(X:A){\rightarrow}H^{z^{\prime\prime}}_{p}\;(X:A){\rightarrow}$⋯⋯ 가 존재(存在)한다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.4 no.3
• /
• pp.236-241
• /
• 2003

산업체 발생 VOC를 효과적으로 처리하는 Biofilter 시스템을 고안하였다. 재질과 다공성이 다른 3기의 시스템으로부터 황화수소, 벤젠, 톨루엔, 크실렌의 단일성분과 복합성분계의 성능을 고찰하였다 저 pH Biofilter(pH 2-3)의 장기운전이 가능하였고 벤젠의 경우 경쟁적 저해를 나타내었으나 일정기간의 순응 이후 혼합처리시 양호한 처리능력을 보여주었다.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.11a
• /
• pp.191-202
• /
• 2005

비정질 실리콘 태양전지 대신에 열화가 더 적은 프로터결정 실리콘(pc-Si:H)을 상층전지 흡수층으로 사용한 고효율 실리콘계 적층형(pc-Si:H/$\mu$c-Si:H) 박막 태양전지를 개발하였다. 우선, 높은 전도도와 넓은 에너지 밴드갭 특성을 갖는 p-a-SiC:H 박막을 개발하였고, p/i 계면의 특성 향상을 위해 p-nc-SiC:H 완충층을 개발하였다. 프로터결정 실리콘 다층막을 제작하고 FTIR, 평면 TEM, 단면 TEM 측정을 통해 프로터결정 실리콘 다층막의 우수한 열화 특성의 원인을 규명하였다. 적층형 태양전지의 성능향상을 위해 n-p-p 구조의 터널접합을 제안, 제작하고 특성을 분석하였으며, pc-Si:H/a-Si:H 적층형 태양전지에 적용하여 성능향상을 이루었다. 양질의 하층전지용 마이크로결정 실리콘 박막을 증착하기 위하여 광CVD법과 플라즈마CVD법을 결합한 2단계 마이크로결정 실리콘 증착법을 개발하였다.