• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.2
• /
• pp.182-188
• /
• 2018

In order to increase the robustness of the uplink for UAS(Unmanned Aerial System), we propose a jamming signal rejection algorithm. In the UAS datalink system, DSSS (direct sequence spread spectrum) is used to reduce the radio noise or jamming signal. In general, jamming signals below the spreading gain are recoverable but the signals beyond the spreading gain can not be recovered. In this paper, these jamming signals beyond spreading gain are detected using the threshold detector in the spectrum area then, generate the estimated signals from the sine wave generator. Finally, we obtain the desired signal to remove jamming signals from the received signals. The proposed scheme can eliminate jamming signals while minimizing the hardware complexity and the original signal loss.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.4
• /
• pp.116-125
• /
• 2020

Incalculable damage will be incurred if the national infrastructure that provides services using GNSS signals is affected by jamming signals. To prevent this, a nationwide GNSS jamming monitoring network is necessary to detect the occurrence of a jamming signal, determine the type, and properly localize the jammer position. In this paper, 2-D images for live GNSS signals were generated to verify the environment of the jamming signals through the presence and type of GNSS jamming signals at K-City, which are the test beds for self-driving vehicles, and Incheon International Airport. The analysis was also conducted to detect the occurrence of the jamming signals, determine the type, and measure the jamming signal strength. As a result, a CWI type of jamming signal was detected in L2 band at K-City and in L5 band at Incheon International Airport.

• Journal of Convergence for Information Technology
• /
• v.9 no.5
• /
• pp.125-129
• /
• 2019

This paper describes the jamming effect of phase-coded pulse compression(PCPC) radar. Barker code radar, a typical PCPC radar, separates transmission pulses into 13 or 31 small pulses and phase modulates and transmits each pulse signal to increase radar detection efficiency and reduce the influence of jamming. Generally, when the radar is subjected to jamming, the detection distance becomes shorter and the detection error rate becomes higher. In the case of noise jamming or carrier jamming on the PCPC radar, the jamming effect is very small for no phase-coded convergence. However, the jamming effect is large in the case of synchronous jamming using the pulse-coded signal as a jamming signal with DRFM. It can be seen that the jamming effect increases when the storage time of the pulse-coded signal is prolonged. This study is considered to be useful for PCPC radar and EW jamming system design.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.451-456
• /
• 2016

Because GPS signals are weak, system jamming is a real and present danger. This can happen when the receiver is subjected to intentional or unintentional interference by a transmitter. If the jamming signal is strong enough, the receiver can be operated to take corrective action automatically. Current methods to protect GPS receiver from jamming condition are based on spatial filtering. In this paper, the beamforming as referred to in signal processing technique used in arrays for directional signal reception was suggested and analyzed for anti-jamming. In order to change the directionality of the array when receiving a jamming signal, a beamformer can control the signal at each sensor. Therefore, cutoff angle ${\theta}$ was measured in the opposite direction of the jammer. GPS signals are only processed when the antenna element is within inside the cutoff angle. As a result, GPS positioning can be used in condition under cutoff angle $30^{\circ}$.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.12
• /
• pp.55-63
• /
• 2015

Recently, terroristic threats using a radio controlled improvised explosive device (RCIED) that is remotely controlled and exploded have been increased around the world. In order to prevent the explosion of an RCIED, jamming techniques that interrupt an RCIED receiver can be used, so that the receiver can not demodulate the trigger code. Conventional jamming technique is a type of active barrage jamming that always emits the noise jamming signal for all the frequency band. However, it needs large power consumption and thus is limited in operation time for a vehicle. In order to overcome the shortage of the active barrage jamming, reactive jamming technique has drawn attention. In reactive jamming, all the frequency band is firstly scanned, and then if any trigger signal exists, one emits the jamming signal to the corresponding frequency band. Therefore, the reactive jamming is superior to the active barrage jamming in terms of power efficiency. However, a reactive jammer emits a jamming signal only after the trigger signal is intercepted, which means that the jamming signal may be late for interrupting an RCIED receiver. In this sense, it is needed to evaluate a delay in an RCIED receiver. To achieve this, we analyze the reaction time and present the simulation result for jamming performance of reactive jamming against an RCIED using mobile devices.

• Information and Communications Magazine
• /
• v.26 no.3
• /
• pp.32-40
• /
• 2009

최근 전자전 (EW : Electronic Warfare)은 현대전의 핵심으로 자리매김하고 있다. 전자전에서 재밍 (Jamming)은 적군의 통신을 교란시키는 전자공격 (EA : Electronic Attack)을 의미하는 것으로 재밍 전술은공격 대상에 따라서 여러 가지로 나눌 수 있다. 본고에서는 군통신에서 사용되는 전자방해책 (ECM : Electronic Counter Measure)인 재밍 기술을 소개하고, 재밍 신호에 대한 대책으로 재밍 신호를 효과적으로 검출하고 제거할 수 있는 전자방해방어책인 (ECCM : Electronic Counter Counter Measure) 항재밍 (Anti-Jamming) 방안도 함께 분석 소개하고자 한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12C
• /
• pp.1201-1207
• /
• 2005

When the isolation between transmitter and receiver in Electronic Warfare equipment is not sufficient, the radiated noise jamming signal from the transmitter feeds back into the receiver and interferes with receiving radar pulse signal. Therefore pulse jamming and noise jamming can't be performed together in the same frequency bands. In this paper, we present a time-sharing TX/RX control technique of the switch matrix which inhibits the transmission of noise jamming signal by using the predicted gate of pulse train and also makes the corresponding channel filter operate to receive the radar pulse signal during the predicted gate pulse. This technique was implemented by EPLD and confirmed by experiment. The proposed technique enables the pulse jamming and the noise jamming to be simultaneously executed in multiple jamming environments.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.8
• /
• pp.837-845
• /
• 1992

This paper shows the performance of FH /BFSK communication systems under worst case Jamming interference. The channel Is modeled with ratio-threshold technique, and as a lamming signal the tone Jamming and Gaussian Jamming are used. The performance is analyzed by using the channel capacity which is the code rate and bit signal-to-Jammer ratio, and we show that the performance degration becomes large as background noise Is big and obtain the best performance when the threshold level f is about 1.5.

• Journal of Satellite, Information and Communications
• /
• v.10 no.4
• /
• pp.58-63
• /
• 2015

Due to GPS signal's vulnerability of jamming attack, various enhancement techniques are needed. Among variety of techniques, we focused on GPS receiver's anti-jamming techniques. There are many anti-jamming methods at GPS receivers which include filtering methods in time domain, frequency domain and space domain. However, these methods are ineffective to signals, which include both jamming and noise. To solve the problem, this paper proposes a jamming separation scheme by using a BSS method in a jamming environment. As separated GPS signals include noise after the jamming separation method, it is difficult to receive accurate GPS signals. For this reason, this paper also proposes a wavelet de-noising method to effectively eliminate noise. Experimental results of this paper are based on a real field test data of an integrated GPS/QZSS/Wi-Fi positioning system. At the end, the simulation result demonstrates its superiority by showing improved positioning accuracy.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.10
• /
• pp.1-9
• /
• 1990

The performance of noncoherent FH/FSK system in the presence of multitone jamming and noise is analyged. Random and the structured jammings are considered as a multitone jamming model. The probability density function is derived and then optimum decision rule is applied to determine error probability of each cases. As a result, error probabilities of random and structured multitone jamming are shown as a function of number of jamming tones, jamming to signal power ratio, jamming signal phase and one jamming tone power to signal power ratio under Worst-case Jamming interference. It is found that error probability is maximam when one jamming tone power to signal power ratio is 1. Also we know that error performance of random and structured jamming is almost equal.