• Geotechnical Engineering
• /
• v.13 no.4
• /
• pp.149-162
• /
• 1997

A series of torsion shear tests were performed to study the strength characteristics of sand under various stress paths during rotation of principal stress. These results can be classified into two groups of 25cm and 40cm according to the height of specimen, and toy que was applied only in the clockwise direction. In this study, strength characteristics of sand for the principal stress ratio in torsion sheartests were investigated and their results were compared with Lade's failure criterion. And the effect for specimen was considered. From the results of tests, friction angle of sand was affected by the deviatoric principal stress ratio $b:(\sigma_2 -\sigma_s)/(\sigma_2, -\sigma_3)$Failure strength of sand was determined not by the stress paths but by the current stress state. From comparison of specimens on 25cm and 40cm height, effect of end restraint could not be found. In the test where b is over 0.5 due to extension force, necking phenomenon by the strain localization was found.

• Journal of the Korean GEO-environmental Society
• /
• v.16 no.2
• /
• pp.27-31
• /
• 2015

In urban area, many design projects related to geotechnical projects are controlled by serviceability rather than stability requirements. Accordingly, control of ground deformation has become more crucial and many researchers have studied soil stiffness. Recent experimental studies on the stress-strain response of Chicago glacial clays showed that the nonlinearity and anisotropy are the two key factors in evaluating the soil stiffness. In this study, experimental results are applied to analyze the deep excavation site locating in downtown Chicago. The stress paths observed from the observation points located behind and front of the supporting wall yield typical stress paths. Changes in soil stiffness nonlinearity and anisotropy were discussed by comparing experimental and computed stress paths. The stiffness anisotropy were significant even at the first few excavations. The stiffness degradation characteristics are significantly different according to relative location to the support wall even at the same elevation.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.1
• /
• pp.171-181
• /
• 2013

The radial mapping rule in bounding surface model was experimentally investigated by analyzing the drained stress probe tests on Chicago clays. The experimental data obtained from 10 drained stress probe paths were analyzed to calculate the directions of the plastic strain increments. The anisotropic bounding surface model was adopted to represent a bounding yield surface which resides in the pre-consolidation yield stress of undisturbed clays. The projection origins were estimated by finding the interceptions of the straight lines passing through the current stress point and the imaginary yield stress point on the bounding surface. The results show that the projection origin is not fixed at a point but moves toward the direction of the stress probe path after it is established around the initial stress point.

• Journal of the Korean Society for Railway
• /
• v.14 no.1
• /
• pp.49-56
• /
• 2011

In this paper, it was compared the characteristics of the stress and settlement that occur from a track on the ground using a model test and has quantitatively analyzed the difference based on stress path and effect of the rotation of principal stress. Under identical roadbed conditions, the settlement generated by moving wheel loads were found to be 6 times and 3 times larger than that from static loads and cyclic loads, respectively. The deviator stress affecting shear deformation and the length of stress path generated by moving loads were twofold or greater increase than those by static loads. Furthermore, the stress path generated by moving loads was approached more closely to Mohr-Coulomb failure criteria compared to that by static loads. Also, it was found that ballasted track was occurred about 60% of maximum stress at $40^{\circ}$ of the rotation angle of principal stress and was affected with rotation of principal stress with moving wheel loading condition.

• Geotechnical Engineering
• /
• v.9 no.4
• /
• pp.65-82
• /
• 1993

A series of torsion shear tests were performed to study the drained stress -strain behavior of medium dense Santa Monica Beach sand under various stress paths. The torque was applied to both clockwise and counterclockwise directions at the end of hollow cylinder specimen. Two clip gages had been previously used to measure the changes in wall thickness and diameter of the specimen. In this study, however, the lateral strain was determined by measuring volume changes in specimen. Specimens were prepared by the air pluviation method and gaseous carbon deozide( CO2) was used to measure precisely volumetric strain in specimen. The drained stress -strain behavior of cohesionless Boils during rotation of principal stress directions was analysed based on the results of torsion shear tests. The coupling of mal stress were applied. It was also found from the test results that the atrial strain at failure decreased with increasing value.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.3
• /
• pp.159-168
• /
• 2012

본 연구에서는 해성 점성토에 대하여 반복 삼축시험을 실시하고 응력-변형률 관계 및 유효응력경로 특성 분석을 통해 동적 변형 및 강도 특성을 조사하였다. 시험에 사용된 시료는 일본 도쿠시마현의 코마츠시마 항 인근에서 채취된 점성토이며, 반복 삼축시험으로 동적 비배수 삼축시험, 동적 비배수 삼축시험 후 동적 삼축변형시험, 다단계 동적 비배수 삼축시험, 동적 삼축 변형시험 등 4종류의 시험을 수행하고, 시험 주파수로서 0.1 및 0.01 Hz을 적용하였다. 본 연구 결과 0.01 Hz로 수행된 동적 삼축시험 결과는 0.1 Hz로 수행된 삼축시험 결과보다 평균유효응력의 감소량이 크며, 반복 하중은 해성 점성토의 구조적 약화를 초래하고 초기 거동시 발생하는 간극수압과 밀접하게 관련이 있는 것으로 나타났다. 또한 미소변형률 영역에서 등가 탄성계수는 시험 횟수가 증가함에 따라 점차 감소하며, 감쇠비는 점차 증가하는 것으로 보아 변형계수는 반복 하중으로 인한 전단변형률의 축척에 따른 변형률 의존 거동에 관련하는 것으로 판단된다.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.5
• /
• pp.29-36
• /
• 2001

한반도 남해안의 광양만에서 채취한 연약 해성점토의 물리적 및 역학적 특성을 조사하기 위한 일련의 실내시험을 수행하였다. 물리적 성질 및 압밀시험 결과의 분석에 따르면, 시험에 사용된 시료는 정규압밀점토로 나타났다. 압밀비배수 삼축시험 결과로부터 새로운 간극수압계수(C)를 제안하였고, 이 계수는 유효응력경로를 예측하기 위한 방정식에 적용되었다. 또한, 비배수조건에서 전단변형률은 오로지 응력비만의 함수라는 사실이 실험결과로부터 밝혀졌다. 따라서 비배수 조건에서의 전단변형률 계산식이 제안되었으며, 이들 관계식을 이용하여 비배수(CIU) 및 배수조건(CID)에서의 점토의 거동을 예측하기 위한 새로운 구성방정식이 제안되었다. 이 구성방정식은 Roscoe와 Poorooshasb이 제안한 증분응력-변형률 이론을 기초로 하였으며, 제안된 구성방정식을 적용하여 예측한 배수전단특성을 실측된 결과에 매우 근접하는 경향을 나타내었다.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.1
• /
• pp.41-52
• /
• 2011

The hypothesis on effective stress of unsaturated soil is validated by $K_0$ consolidation results of triaxial tests for the compacted residual soil. The stress characteristic curve (SSCC) can describe unsaturated soil behavior on water contents, which was defined from shear strength or from soil water characteristic curves. In this study, it was found that the stress path of $K_0$ consolidation can also define the SSCC. The effective stress was defined by SSCC. $K_0$ paths for various matric suctions could be described as a unique line by effective stress. The measured values of $K_0$ were interpreted by effective stress as a constant with respect to matric suction. Since the SSCC from $K_0$ consolidation agrees with that from the shear strength, the SSCC from soil water retention curve could describe effective stress behavior consistently on both $K_0$ consolidation path and stress at failure. The effective stress based on SSCC can describe the entire unsaturated behavior from consolidation to failure.

• Geotechnical Engineering
• /
• v.10 no.3
• /
• pp.41-54
• /
• 1994

This study aims at investigating the mechanism and operation of cubical triaxial test developed by Lade in order to obtain analysis on the clayey foundation deformation. A comparison on deviator stress, pore water pressure and stress path is made between test results of clay using the cubical consolidated undrained test as well as plane strain test.

• Geotechnical Engineering
• /
• v.4 no.1
• /
• pp.17-28
• /
• 1988

Among several types of element tests to predict soil behalf.iota in a laboratory, the torsion shear apparatus, in which the directions of principal stresses could be rotated during shearing, wra explained. In this study, this torsion shear apparatus was improved so as to be used in tests on clay specimens . And some undrained torsion shear tests u.ere performed on remolded specimens of Ko-consolidated clay to investigate the influence of reorientation of the principal stress directions on the stress-strain behavior The soil behavior by the torsion shear apparatus without torque was compared It.ith that by the conventional triaxial compression tests . The stress path, provided by both vertical loads and torque during torsion shear tests, has much effect on the stress-strain behavior, the pore pressure and the effective principal stress ratio . The rotation angle of the principal stress and the b-value were gradually increased with increasing shear strain, but converged to the values at failure.