• Environmental engineer
• /
• s.174
• /
• pp.22-26
• /
• 2001

(1) 토양오염의 특성과 현황 - 토양오염은 지하에서 일어나는 오염문제이므로 눈으로 직접 확인하기가 어려울 뿐만 아니라 한번 오염되면 복원을 위해서 많은 시간과 경제적 노력이 필요함 - 우리나라에서는 폐광지대 그리고 공업단지 내 유류 저장시설 주변 토양이 중금속과 유기화합물로 심각하게 오염되어 있는 것으로 나타남 (2) 오염토양 정화기술의 분류와 주요기술 - 오염토양 정화기술은 크게 비원위치 기술과 원위치 기술로 분류되며 각각 물리적, 화학적, 생물학적

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.199-202
• /
• 2004

In this study the field-scale tests were performed in which in-situ E/K remediation technologies were applied, and then the results were present. For traditional E/K remediation method the efficiency of remediation is not large, but the enhanced method with citric acid significantly increases the removal efficiency. Also EDTA, reported as a good enhancement agent for removal of heavy metals, is similar to that of citric acid. Therefore citric acid is preferred rather than EDTA in view of the cost on the contaminant removal per unit concentration.

• Journal of the KSME
• /
• v.32 no.3
• /
• pp.290-299
• /
• 1992

대기질의 악화와 오염원이 많아짐에 따라, 실내공기 정화장치 또한 재래식의 방법을 벗어난 방 식으로 설계 시설되어야 한다. 인위적으로 만들어진 유해 물질과 작은 먼지들을 제거하기 위한 새로운 환풍장치는 지역의 특수성을 고려하여 설계되어야 한다. 더욱이 대도시의 생활은 오염 원과 작업장 및 거주지가 가까이 위치하기 때문에 특별히 지역의 특수성을 고려하여 환풍장치가 설계되어야 한다. 끝으로 작업장안에서 오염원 격리수용하는 것은 매우 바람직하여, 청정공 간(clean room)을 요구하는 반도체 및 제약회사 등은 건축물자체 오염원에서 멀리 떨어져서 지 역의 영향을 최소화하는 것과 건축물의 자재 및 공기정화장치가 새롭게 연구되어 설계되야 한다.

• Journal of Soil and Groundwater Environment
• /
• v.7 no.4
• /
• pp.77-86
• /
• 2002

Surfactant enhanced in-situ soil flushing was performed to remediate the soil and groundwater at an oil contaminated site, where had been used as a military vehicle repair area for 40 years. A section from the contaminated site (4.5 m $\times$ 4.5 m $\times$ 6.0 m) was selected for the research, which was composed of heterogeneous sandy and silt-sandy soils with average $K_d$ of 2.0$\times$$10^{-4}$cm/sec. Two percent of sorbitan monooleate (POE 20) and 0.07% of iso-prophyl alcohol were mixed for the surfactant solution and 3 pore volumes of surfactant solution were injected to remove oil from the contaminated section. Four injection wells and two extraction wells were built in the section to flush surfactant solution. Water samples taken from extraction wells and the storage tank were analyzed on a gas-chromatography (GC) for TPH concentration in the effluent with different time. Five pore volumes of solution were extracted while TPH concentration in soil and groundwater at the section were below the Waste Water Discharge Limit (WWDL). The effluent TPH concentration from wells with only water flushing was below 10 ppm. However, the effluent concentration using surfactant solution flushing increased to 1751 ppm, which was more than 170 times compared with the concentration with only water flushing. Total 18.5 kg of oil (TPH) was removed from the soil and groundwater at the section. The concentration of heavy metals in the effluent solution also increased with the increase of TPH concentration, suggesting that the surfactant enhanced in-situ flushing be available to remove not only oil but heavy metals from contaminated sites. The removal efficiency of surfactant enhanced in-situ flushing was investigated at the real contaminated site in Korea. Results suggest that in-situ soil flushing could be a successful process to remediate contaminated sites distributed in Korea.

• Journal of Energy Engineering
• /
• v.28 no.3
• /
• pp.55-64
• /
• 2019

This study identified key patents on U.S. underground water technology through patent network analysis. As a result, there were many technologies that used the technology to remove heavy metals to prevent contamination of groundwater. While patents between groundwater technology patents were in charge of intermediaries, the connectivity between groundwater technologies is not high. The patented technologies related to groundwater were largely distinguishable by pumping, monitoring, and decontamination. Monitoring includes techniques that enable identification of physical and biological properties, such as the type of contaminants, as well as geographic characteristics for analysis of groundwater flow, flow or water quality. Pollution purification technology refers to the process of physiochemical and biological purification for soil and groundwater. U.S. technology cases showed that the U.S. had high technology in water treatment area. And patent protection were also needed to cope with water shortages caused by climate change.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05a
• /
• pp.206-209
• /
• 2002

본 논문에서는 폴리실리콘의 재결정화 공정에서 발생하기 쉬운 폴리실리콘의 엉김현상, 슬립, 부분적인 실리콘 기판의 녹음현상 등을 방지하기 위한 방법을 제시한다. 그리고 재결정화 된 박막의 질을 향상시키기 위한 폴리실리콘과 보호 산화막(capping oxide)의 두께 변화에 따른 실험 결과를 살펴본다. 폴리실리콘의 엉김현상은 매몰 산화막(buried oxide)과 액체 상태의 실리콘 사이의 wetting angle과 관계되는데, 이를-방지하기 위해서는 재결정화할 폴리실리콘과 산화막의 계면에 질소를 주입시켜주면 되는데, 이는 재결정화할 시료를 암모니아 가스 분위기에서 열처리를 통하여 해결할 수 있다. 그러고 실러콘 기판의 국부적 녹음 현상 및 슬립은 실리콘 기판의 윗면을 mechanical damage에 의해서 약 $20{\mu}m$ 정도의 거칠기를 가지도록 하면 이러한 현상을 방지할 수 있다. 그러고 폴리실리콘이 재결정활 될 때 부피의 변화가 발생하며, 이로 인하여 재결정화된 박막의 두께는 위치에 따라 변화한다. 재결정화된 박막 두께의 균일도를 유지하기 위해서는 재결정화할 폴리실리콘 두께의 3배 이상이 되는 보호 산화막을 사용하였을 때 원하는 균일도를 얻을 수 있었다.

• Journal of the Korean Society for Railway
• /
• v.18 no.5
• /
• pp.466-470
• /
• 2015

In this study, Fenton oxidation was applied to railroad track ballasts contaminated with small amounts of oil. In order to perform the experiment on Fenton oxidation, petroleum contaminated ballast was collected from the railroad track and experiments on major factors of the remediation process were implemented in the laboratory. Then, the feasibility of insitu Fenton oxidation was investigated for the railroad track that was partially contaminated with oil. As a result, the residual TPH concentration of ballast was reduced to about 1,000 mg/kg-ballast in laboratory experiments using 0.1 mol Fe/L $H_2O_2$. Due to the drainage structure of the track bed, a considerable amount of $H_2O_2$ was released below the ballast without the sufficient reaction with the contaminated ballast; therefore, additional studies are necessary for the effective field application of Fenton oxidation.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2006.04a
• /
• pp.224-225
• /
• 2006

점토성 오염토양을 원위치 정화하는데 효과적인 것으로 알려진 Electrokinetic정화기술을 이용하여 폐광산의 광미를 대상으로 실험을 수행하였다. 실험은 초기 인가 전류 0.01A, 170V의 정전압모드로 약 950시간동안 운전하였으며, 투입된 총전력량은 5671.455 WH으로시간당 5.97W의 전력이 투입되는 것이다. 중금속류(As,Pb,Cd,Zn,Cu,Ni)에 대하여 $50{\sim}90%$의 제거효율을 보였으며 중금속 농도는 점차 감소하고 중금속별로 $Zn{\cong}Cd>Ni>Cu{\cong}Pb{\cong}As$ 의 경향을 보였다.

• Journal of Soil and Groundwater Environment
• /
• v.11 no.6
• /
• pp.8-17
• /
• 2006

Laboratory scale experiments were performed to investigate the removal efficiency of the in-situ chemical oxidation method and the air-sparging method for diesel contaminated soil and groundwater. Two kinds of diesel contaminated soils (TPH concentration : 2,401 mg/kg and 9,551 mg/kg) and groundwater sampled at Busan railroad station were used for the experiments. For batch experiments of chemical oxidation by using 50% hydrogen peroxide solution, TPH concentration of soil decreased to 18% and 15% of initial TPH concentration. For continuous column experiments, more than 70% of initial TPH in soil was removed by using soil flushing with 20% hydrogen peroxide solution, suggesting that most of diesel in soil reacted with hydrogen peroxide and degraded into $CO_2$ or $H_2O$ gases. Batch experiment for the air-sparging method with artificially contaminated groundwater (TPH concentration : 810 mg/L) was performed to evaluate the removal efficiency of the air-sparging method and TPH concentration of groundwater decreased to lower than 5 mg/L (waste water discharge tolerance limit) within 72 hours of air-sparging. For box experiment with diesel contaminated real soil and groundwater, the removal efficiency of air-sparging was very low because of the residual diesel phase existed in soil medium, suggesting that the air-sparging method should be applied to remediate groundwater after the free phase of diesel in soil medium was removed. For the last time, the in-situ box experiment for a unit process mixed the chemical oxidation process with the air-sparging process was performed to remove diesel from soil and groundwater at a time. Soil flushing with 20% hydrogen peroxide solution was applied to diesel contaminated soils in box, and subsequently contaminated groundwater was purified by the air-sparging method. With 23 L of 20% hydrogen peroxide solution and 2,160 L of air-sparging, TPH concentration of soil decreased from 9,551 mg/kg to 390 mg/kg and TPH concentration of groundwater reduced to lower than 5 mg/L. Results suggested that the combination process of the in-situ hydrogen peroxide flushing and the air-sparging has a great possibility to simultaneously remediate fuel contaminated soil and groundwater.

• Journal of the Korean Geosynthetics Society
• /
• v.5 no.2
• /
• pp.17-22
• /
• 2006

This paper presents preliminary field investigations on the electrokinetic (EK) remediation coupled with permeable reactive barrier (PRB) system. unregulated and old-fashioned landfills are one of the primary contributors to various contaminated soil problems. In-situ EK remediation technology has been successfully applied to the environs of unregulated landfill site, located in Kyeong-Ki province, Korea. Atomizing slag was adopted as a PRB reactive material for the remediation of groundwater contaminated with inorganic and/or organic substances. From the preliminary investigations, the coupled technology of EK with PRB system would be effecitve to remeidate contaminated grounds without the extraction of pollutants from subsurface due to the reactions between the reactive materials and contaminants.