• Applied Chemistry for Engineering
• /
• v.7 no.5
• /
• pp.946-953
• /
• 1996

The effect of absorbed dose, dose rate, cationic salts and solvent on the grafting yield was evaluated when acrylic acid was grafted onto polypropylene fabric by simultaneous irradiation process. Low dose rate when irradiated with the same absorbed dose led to a high grafting yield. On the other hand, the grafting yield increased with dose rate in case the total irradiation times is equal, and the initial rate of grafting was found to be proportional to be 0.74 power of dose rate. $FeSO_4{\cdot}7H_2O$ was found to be the most effective additive for high grafting yield, while inhibiting homopolymer formation. It was impossible to induce radiation grafting without the addition of the certain amount of salt, but the grafting yield decreased with increasing metallic salt.

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.174-177
• /
• 1991

Fluorine-doped $SnO_2\;(SnO_2:F)$ films were prepared in ordinary atmosphere on borosilicate glass substrates using pyrosol deposition method starting from the solutions composed of $SnCl_4-5H_2O-NH_4F-CH_3OH-H_2O-HCl$ in an attempt to develop transparent conductors for use in amorphous silicon (a-Si) solar cello. The deposition rate of films increased with the increase in the content of $H_2O$, whereas it decreased with increasing the content of $CH_3OH$. When air was used as the carrier gas, the lowest electrical resistivity was obtained from a solution having $CH_3OH/H_2O$ mol ratio of about $2{\sim}3$ in the solution. The use of $N_2$ of the same flow rate as the carrier gab resulted always in the high resistive films, but the resistivity of the films decreased continuously with the increase in the content of $H_2O$. The surface morphology and preferred orientation of films were also affected by the solvent composition and the content of HCl in the solution. The room-temperature resistance of the films were fairly stable after heat-treatments up to $600^{\circ}C$.

• Applied Biological Chemistry
• /
• v.48 no.4
• /
• pp.421-424
• /
• 2005

The leaf of Petasites japonicus was extracted with 80% aqueous MeOH and solvent fractionated with EtOAc, n-BuOH and water successively. From the EtOAc fractions, two triterpenoids were isolated through the repeated silica gel and ODS column chromatographies. The chemical structures of the isolated terpenoids were determined as rosamutin (1) and peduncloside (2) through the interpretation of several spectral data including 2D-NMR such as $^1H-{^1H}$ gCOSY, gHSQC and gHMBC.

• Applied Chemistry for Engineering
• /
• v.9 no.2
• /
• pp.306-310
• /
• 1998

The soluble polyimides(PMDA/diamine/dianhydride) were prepared and investigated. After coating the prepared PMDA/diamine/dianhydride solution into the commercial tubular alumina ceramic membranes, gas permeation characteristics was investigated. $T_g{\prime}s$ of the polyimides were in the range of $337{\sim}358^{\circ}C$ and thermal stability was good. The polymer was soluble in NMP, DMAc, DMSO, THF, and m-cresol. The adhesion between the alumina membrane and the soluble polyimide was excellent. The soluble polyimide/alumina membranes containing 6FDA showed the highest permeability among others. The permeability of nitrogen of PMDA/1,3PDA/6FDA-alumina membrane was about $7.6{\times}10^{-7}(mol/m^2{\cdot}Pa{\cdot}s)$ in the gas permeation experiments. The ideal separation factor of $O_2/N_2$ and $H_2/N_2$ in PMDA/1,3PDA/6FDA-alumina membrane were 6.19, and 70.0, respectively.

• Applied Chemistry for Engineering
• /
• v.9 no.2
• /
• pp.159-164
• /
• 1998

Polycarbosilane(PCS) as a SiC precursor was synthesized from the rearrangement reaction of polydimethysilane(PDMS) in an autoclave, which prepared by dehalocoupling reaction of dichlorodimethylsilane. After fractional precipitation into three fractions in n-hexane-methanol mixture, they were characterized by FT-IR, NMR, GPC, TGA/DSC and XRD, and compared with the commercial product. We found that the molecular weight distributions of the PCS depended on the reaction pressures, temperatures and the reaction times, and affected thermal property and ceramic yield of the polymer. The monodispersed PCS containing less amount of oligomers and nonsoluble products was prepared by reaction of PDMS at $420^{\circ}C$ for 10 hrs, and it also gave the greatest amount of medium molecular weight($M_n=4,000$) fraction.

• Applied Biological Chemistry
• /
• v.49 no.1
• /
• pp.82-85
• /
• 2006

The fruits of Cornus kousa Burg. were extracted with 80% aqueous MeOH, and the concentrated extract was partitioned with EtOAc, n-BuOH and $H_2O$, successively. From the EtOAc fraction, three sterols were isolated through the repeated silica gel and ODS column chromatographies. According to the results of physico-chemical data including NMR, MS and IR, the chemical structures of the compounds were determined as ${\beta}-sitosterol$ (1), $stigmast-4-en-6{\beta}-ol-3-one$ (2) and daucosterol (3). They were the first to be isolated from Cornus kousa Burg.

• Journal of the Korean Applied Science and Technology
• /
• v.30 no.4
• /
• pp.612-621
• /
• 2013

Microwave-assisted extraction (MAE), which is known as less time and less solvent than current extraction methods, was applied to hydrocarbons extraction from irradiated soybean. Among the transported agricultural products, soybean was selected as representative samples for possible application of irradiated treatment and identification of radiation-induced markers. Using 4 kGy-irradiated soybean, different microwave extraction conditions (extraction time and microwave power) were applied and the changes in hydrocarbon concentrations were monitored. The predicted optimum extracted condition for hydrocarbon analysis of soybean was found to be microwave extraction with a microwave power of 97 W and extraction time of 2.2 min. This extraction time was significantly lower compared to the common extraction time of 12-24hr.

• The Journal of the Korea Contents Association
• /
• v.16 no.5
• /
• pp.660-667
• /
• 2016

Conventional decontamination methods utilize water-based systems, which generate high amounts of secondary wastes. Herein, we describe an environmentally benign decontamination method using liquid and supercritical $CO_2$. The use of $CO_2$ as a solvent affords effective waste reduction by its ability to be recycled, thereby leaving be hind only the contaminants upon its evaporation. In this study, a $CO_2$ solution process was assessed using t-salen(t-butylsalen), DC18C6 (dicyclohexano-18Crown6), 8-HQN(8-hydroxyquinoline), NEt4PFOSA(perfluoro-1-octanesulfonic acid tetra-ethyl ammonium salt), and NEt4PFOA(pentadecafluorooctanoic acid ammonium salt) to extract spiked radioactive contaminants(Nb,Zr,Co,Sr) from an inert sample matrix, namely filter paper. With the static extraction method, Sr was extracted with a maximum extraction rate of 97%, and Nb was extracted with a maximum extraction rate of 75%. Additionally, we were also able to extract Co and Zr with maximum extract ion ratesof 73% and 64%, respectively.

• Microbiology and Biotechnology Letters
• /
• v.48 no.3
• /
• pp.310-315
• /
• 2020

Orostachys japonicus (O. japonicus) is known as a medicinal plant for the treatment of various symptoms. This study investigated the anti-inflammatory effect of the hexane fraction from O. japonicus (OJH) on the LPS-stimulated response in RAW 264.7 macrophage cells. This study was conducted to confirm the effect of cell cytotoxicity and production of reactive oxygen species (ROS) in OJH-treated macrophage cells. Additionally, pro-inflammatory cytokines and transcription factors were determined using RT-PCR and western blotting assay. OJH showed no change in lactate dehydrogenase (LDH) levels and exhibited reduced ROS levels in LPS-induced inflammatory cells. Moreover, OJH significantly suppressed the mRNA levels of proinflammatory cytokines, including IL-1β, IL-2, IL-6, TNF-α, and IP-10. Furthermore, OJH effectively inhibited the protein levels of AP-1 (p-c-Jun and p-c-Fos) and p-IRF3 in a dose-dependent manner. In conclusion, our results demonstrate that OJH exhibits strong anti-inflammatory activities via regulation of inflammatory factors.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.23 no.2
• /
• pp.48-62
• /
• 1997

Chitosan oligosaccharides having aldehyde group at reducing end were prepared by oxidative-deamination reaction of chitosan by using sodium nitrite, and the resulting aldehyde group was reduced to 2, 5-anhydro-D-mannitol group. The obtained chitosan oligosaccharides showed an average degree of polymerization 2~3 by gel permeation chromatography analysis. It was highly soluble in hydrophilic solvents and thermally stable. N, N-diacyl, O-acyl chitosan oligosaccharides were obtained from the reaction between chitosan oligosaccharides and acyl chloried under dimethylaminopyridine. From differential scanning calorimetric measurement, N, N-dilauroyl, O-lauroyl chitosan oligosaccharides showed mesophase region, which was confirmed by polarized microscope as a thermotropic liquid crystalline state. X-ray diffraction pattern revealed that N, N-dilauroyl, O-lauroyl chitosan oligosaccharedes were highly crystalline, whereas chitosan oligosaccharides were not.