• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.41 no.11
• /
• pp.699-707
• /
• 2017

This study presents a comparative thermodynamic analysis of subcritical and transcritical organic Rankine cycles for the recovery of low-temperature heat sources considering nine substances as the working fluids. The effects of the turbine inlet pressure, source temperature, and working fluid on system performance were all investigated with respect to metrics such as the temperature distribution of the fluids and pinch point in the heat exchanger, mass flow rate, and net power production, as well as the thermal efficiency. Results show that as the turbine inlet pressure increases from the subcritical to the supercritical range, the mismatch between hot and cold streams in the heat exchanger decreases, and the net power production and thermal efficiency increase; however, the turbine size per unit power production decreases.

• Food Engineering Progress
• /
• v.23 no.2
• /
• pp.87-93
• /
• 2019

Temperature distribution studies were performed in steam-air retort to investigate the influence of various processing conditions (come-up time, sterilization temperature, and internal pressure throughout the steam-air retort). Retort temperature data were analyzed for temperature deviations during holding phase, maximum temperature difference between test locations at the beginning and after 1, 3, and 5 min of the holding phase, and box-and-whiskers plots for each location during the holding phase. The results showed that high sterilization temperature led to a more uniform temperature distribution than low sterilization temperature (pasteurization). In pasteurization condition, the temperature stability was slightly increased by increasing pressure during the holding phase. On the other hand, the temperature stability was slightly decreased in high sterilization temperature condition. Programming of the come-up phase did not affect the temperature uniformity. In addition, the slowest cold spot was found at the bottom floor during the holding phase in all conditions. This study determined that the temperature distribution is affected by retort processing conditions, but the steam-air retort needs more validation tests for temperature stability.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.103.2-103.2
• /
• 2013

위성체는 우주공간의 고진공 상태와 태양 복사열에 의한 고온 및 극저온이 반복되는 가혹한 환경으로 인해 주요 부품의 기능장애가 초래되므로 발사전 지상에서 열진공 시험장비를 이용한 열진공시험을 수행한다. 우수한 성능의 위성체 부품의 검증을 위해서 열환경 시험 요구에 따라 균일한 복사열이 매우 중요하나, 시험 조건을 비롯하여 여러 원인으로 인하여 열전달의 불균일성이 발생하게 된다. 이로 인해 시스템에 큰 영향을 미칠 수 있으므로, 시험 조건에 의한 열전달량을 고려하여 적절한 히터파워를 선정하고 챔버 내에 적절한 방열판과 챔버 슈라우드의 열교환이 간섭이 없도록 장비를 운용해야 한다. 본 연구에서는 상용프로그램인 FLUENT를 이용하여 열진공 챔버 내부 벽면의 불균일한 복사열에 따른 비정상 열전달 특성에 대하여 수치해석을 수행한 뒤 시편의 온도 분포 및 열전달 특성에 대해 비교분석하였다.

• Proceedings of the KAIS Fall Conference
• /
• 2010.05b
• /
• pp.1137-1140
• /
• 2010

PP에 용융온도 조절을 위한 첨가제로 ZnO와 ADCA를 첨가하여 발포제의 온도를 약 $165^{\circ}C$로 조절 하였다. 이러한 혼합 분말은 $178{\sim}208^{\circ}C$ 온도범위의 금형에서 약 3분 동안 가압성형 되었다. $198^{\circ}C$, 발포제 1.0wt%에서 비교적 우수한 기공 분포를 나타냈다. 그 보다 낮은 온도에서는 기공형성이 충분치 않았고, 그 이상에서는 기공이 불균일하게 분포하여 측면이나 상부에 밀집되면서 더욱 큰 기공을 형성하는 경향을 보였다. 이렇게 제조된 PP 시트의 밀도는 0.518g/cc이었고, 기공률로 약 47%에 해당하였다.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.29 no.6
• /
• pp.251-256
• /
• 2019

In the process of ZnO ceramic sintering at a temperature of 1385℃, higher than the normal sintering temperature, some grains were growth up to mm scale. When sintered at 1400℃ for 8 hours, the size of the grains that are not involved in the abnormal growth is as large as 30~40 ㎛, but the size of the abnormal grown grain reaches 1,000 ㎛, which is more than 10,000 times bigger in volume than the normal one within 8 hr growth. As a cause of rapid and abnormal grain growth, primary particle size distribution, compaction density variation within sample and doping of impurities could be considered. The primary particle size distribution could be considered main reason for abnormal grain growth but no solid evidence was obtained. Through the observation of the microstructure, it is presumed that the giant grains grow absorbing the neighbor grains through a grain rotation process.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.285-292
• /
• 1998

The vacuum vessel of the KSTAR tokamak has a so large poloidal cross- section that workers can enter into the inside the vessel. To produce a clean plasma with low impurity concentrations it is planned that the whole vessel including plasma facing components will be baked out at $350^{\circ}C$ and the base pressure of the vessel will be kept in the range of ultra high vacuum. Large thermal stresses are expected during bake-outs to a three-dimensionally complex structure of the vessel, consequent ununiformity of the temperature distribution and support systems to resist forces acting on the vessel. In this report variations of the thermal stress according to temperature gradients on the vessel and constraint conditions of supporting structures are studied and some possible counterplans are discussed.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2002.07a
• /
• pp.176-181
• /
• 2002

국내 저온저장고의 문제점은 재래식 제어방식과 냉각방식으로 인한 온도분포의 불균일과 시스템 성능 저해, 청과물의 생리적인 특성을 고려하지 알은 냉기의 유속과 습도제어, 청과물의 저온저장 중 발생되는 환경가스 제거기술의 미흡으로 인한 땀은 감모율 발생 그리고 청과물의 생리적인 특성을 고려하지 않은 저온저장고의 최적 설계기술 미흡 등을 들 수 있다. (중략)

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.5
• /
• pp.1012-1022
• /
• 1989

Numerical analysis has been performed on three-dimensional natural convection in inclined concentric annuli with the nonuniform temperature distribution of the inner cylinder. The governing equations are numerically solved by successive over-relaxation methods for various inclination angles at $R_{a}$=3*10$^{4}$, $P_{r}$=7.0 and $r_{1}$ / $r_{2}$=0.6. Temperature and Nusselt number distributions are obtained and calculated results are compared with those of published uniform temperature distributions. It is found that the mean Nusselt numbers for the nonuniform temperature distributions increase more than those for the uniform temperature distributions by about 9. 6% at .delta.= 0.deg., 7.5% at .delta. = 30.deg. and 4.6% at .delta. = 60.deg.. In the case of .delta. = 0.deg., the maximum local Nusselt numbers on the inner and outer cylinder walls show at .xi. = 0.5, 1.5 of .psio=100 .deg. and .xi. = 0.4, 1.6 of .psi. = 180 .deg.. But in the case of .delta. = 30.deg. and .delta. = 60.deg., the maximum local Nusselt numbers on the inner and other cylinder walls show at .xt. = 0.0 of .psi. = 180 .deg. and .xi. = 2.0 of .psi. = 180 .deg...

• Proceedings of the KAIS Fall Conference
• /
• 2012.05a
• /
• pp.356-359
• /
• 2012

SNCR 기술은 SCR에 비해 탈질 효율은 떨어지지만 촉매없이 고온 배출가스에 NH3 또는 요소수를 직접 분사하여 질소와 물로 환원시키는 방법이므로 초기 투자비 및 운영비가 적어 최근 국내 대다수의 소각장, 산업용 보일러 등에 널리 적용되고 있다. 단, SNCR 기술은 급격한 온도 강하나 접근의 불용이성, 불균일한 혼합, 액적의 증발시간 지연, 불균일한 운전 조건 등의 영향을 크게 받으며, 특히 반응 온도가 가장 중요한 변수로서 최적 반응 온도 영역대가 약 800~$1,000^{\circ}C$라는 점에서 이상적인 반응 온도 조건을 찾아서 환원제를 분무하는 것이 매우 중요하다. 이에 본 연구에서는 열유동 전산해석을 통해 스토커식 소각로의 폐기물 성상별 화염 온도 분포를 예측하고 적정 반응 온도 영역을 확인하여 요소수 주입 고도를 선정, 폐기물 성상별 분무 조건을 확립하고자 수치 해석적 연구를 수행하였다. 폐기물 성상(고질/중질/저질 폐기물)별로 화염 온도를 예측한 결과, 최적 반응 온도 영역대가 약 800~$1,000^{\circ}C$, 폐기물 성상의 심한 변화 때문에 소각로의 효율적인 연소 조건 제어에 어려움 등을 고려하여 약 700~$1,000^{\circ}C$ 온도 영역대를 환원제 분무 온도로 선정하였다. 폐기물별로 발열량에 따른 화염 온도가 모두 다르기 때문에 환원제 분무 위치를 3지점으로 선정하여 각 지점별로 분무 운전 조건을 확립하였다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.6
• /
• pp.609-617
• /
• 2012

The impact, spreading and recoil processes of a nanoparticle-laden droplet impacting on a horizontal solid surface are numerically investigated by solving the conservation equations for mass, momentum, energy and mass fraction. The liquid-air interface is tracked using a level-set method that is modified to include the effect of contact angle hysteresis at the wall. The species transport equation including a thermal diffusion term is additionaly solved to determine the nanoparticle distribution in the droplet. The effect of nanoparticle concentration and contact angle are also studied.