• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.1
• /
• pp.89-96
• /
• 2013

Combustion pressures were measured to study combustion stability for an oxygen rich preburner by both of static and dynamic pressure sensors. The resolutions of each static and dynamic pressure sensor are the 1,000 Hz and 25,600 Hz, respectively. The nominal combustion pressure of the preburner was 200 bar but 80 bar was used at the several initial tests for the safety reason. Two stage ignition was applied to reduce the ignition impact for every tests including the tests with 200 bar combustion pressure. The tests lasted for 10 sec. max. and a little fluctuations of pressure was observed during the main mode. The measured pressures were studied by FFT analysis and no noticeable frequency coupling was found. Thus the preburner can be regarded as stable and it can be utilized for further study on staged combustion cycle liquid rocket engine.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.8 no.4
• /
• pp.91-101
• /
• 2004

With the mathematic linear model of a combustor which consists of a combustion chamber and injectors, the analysis of low frequency dynamic characteristics of a liquld-propellant rocket engine combustor was performed. Propellant mass flowrate was varied by combustion chamber pressure feedback, therefore low frequency oscillation was appeared. Increasing the time constant of a combustion chamber and injector pressure differences and decreasing combustion time delay increased the combustor system stability. The variation of injector time constant little affected stability. The system was always stable, when there was no combustion time delay. Increasing combustion time delay decreased oscillation frequency and damping ratio, and the system eventually became unstable.

• 한국연소학회:학술대회논문집
• /
• 2003.05a
• /
• pp.201-207
• /
• 2003

Characteristic of turbulent nonpremixed interacting flames are investigated experimentally 8 or 9 nozzles are arranged in the shape of matrix or circle. When there is no center nozzle, flame is more stable than with center nozzle case. It is shown that these blowout limit enlargements are related with the recirculation of burnt gases. The interacting flame base was not located at the stoichiometric point. NO concentrations of interacting flame are smaller than that of single flame using same area nozzle.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 1998.04a
• /
• pp.29-29
• /
• 1998

고체 추진제 연소불안정에 관한 해석은 준-정상 1차원 해석인 QSHOD(Quasi-Steady Homogcneous One-Dimension)에 의하여 단순화된 지배방정식을 이용하여 응축영역을 해석하는 것이 일반적이다. 이때 외부교란에 대한 기체영역과 표면반응 영역의 응답은 화학반응이 발생하지 않는 고체영역의 응답에 비하여 매우 빠르므로 준-정상적인 거동을 한다. 본 연구에서는 복사열전달에 의한 열속(heat flux)이 고체 추진제의 표면에 존재하며 이 중의 일부가 고체영역에서 흡수될 때 표면에서의 선형교란을 고려한 ZN(Zeldovich-Novozhilov) 방법을 이용하여 연소불안정 현상을 이론적으로 해석하여 연소불안정 현상을 설명할 수 있는 연소 응답함수를 구하였다. 본 연구에서 얻어진 응답함수를 해석함으로써, Zebrowski등$^{(5)}$ 에 의하여 얻어진 복사열 교란에 대한 응답함수가 과소 평가된 응답특성을 나타내고 있음을 알았다. 또한 응답함수의 고유불안정성을 판별하는 민감계수 r과 k의 영역의 해석으로부터 SOn등$^{(6)}$ 에 의하여 밝혀진 안정 경계선의 안정한 영역보다 본 연구에서 구한 안정 경계영역이 줄어드는 경향을 보여주고 있다. 이것은 (6)에서 과소 평가된 복사열전달의 영향을 수정한 결과 때문이다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.11a
• /
• pp.125-130
• /
• 2007

Firing tests have been performed for a 30 tonf-class full-scale regeneratively cooled combustion chamber. It was the first model which has welded construction of the injection head and the combustion chamber. A number of firing tests have been performed to evaluate combustion efficiency, regenerative cooling performance and durability of the combustor. This paper describes the results of firing tests performed at the design and off-design conditions which correspond to the chamber pressure of 60 bar, 68 bar respectively and the O/F ratio of 2.5 and 2.8 respectively. The data at each test condition have provided successful results in terms of combustion performance, combustion stability and durability. The tests are considered to be quite meaningful in the sense that the technologies for kerosene regeneratively cooled combustion chamber are successfully proven.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.14 no.5
• /
• pp.8-14
• /
• 2010

For the development of a liquid rocket engine, hot-firing tests of a regeneratively cooled thrust chamber were performed at chamber pressures of approximately 30 and 60 bars. In the paper, pressure fluctuation data, which were obtained from the dynamic pressure transducers installed in propellant manifolds and combustion chamber, were analyzed. Compared to the data at chamber pressure of 60 bar, the results at chamber pressure of 30 bar showed low-frequency oscillations around 150 Hz in the combustion chamber. The low-frequency waves in the combustion chamber were coupled with those in the manifolds. However, the RMS values of the chamber pressure fluctuations at chamber pressure of 30 bar were only 0.8% of the chamber pressures. Thus, it can be inferred that the thrust chamber operates in the stability boundary even at low chamber pressure.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.20 no.1
• /
• pp.20-27
• /
• 2016

The prediction of combustion instability is important to avoid an obvious threat to the structural safety and the motor performance because it affects the apparent response function of the propellant, the burning rate, and a mean flow Mach number at the local surface. The combustion instability occurs in case acoustic waves were coupled with the combustion/flow dynamic frequency. In this paper, an acoustic instability model is derived from the nonlinear wave equation for analysing acoustic dynamics in solid rocket motors. The chamber pressure and burning rate effects on combustion instability have been investigated.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.24 no.1
• /
• pp.24-33
• /
• 2020

In this study, model combustion tests were conducted to investigate the combustion instability characteristics of swirl coaxial injectors for a liquid rocket engine. To examine the effects of the combustion chamber resonant frequency and the injector mixing conditions, pressure fluctuations in the combustion chamber were measured by changing the combustion chamber length, injector recess length, and propellant mixture ratio. From the test results, the variation in the pressure fluctuations for each experimental condition was confirmed and the combustion stability was evaluated by stability mapping. It was found that the longitudinal mode and Kelvin-Helmholtz instabilities occurred due to the change in the combustion chamber and recess lengths.

• 한국연소학회:학술대회논문집
• /
• 2012.04a
• /
• pp.77-78
• /
• 2012

To predict combustion instability in actual full-scale combustion chamber of rocket engines, air-injection test is proposed with scaling techniques. From the data, damping factors have been obtained as a function of hydraulic parameter and the data give us instability map. Two instability regions are presented and it is found that they coincide reasonably with them from hot-fire test with full-scale flow rates. Accordingly, the proposed approach can be applied cost-effectively to stability rating of jet injectors when mixing of fuel and oxidizer jets is the dominant process in instability triggering.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.04a
• /
• pp.69-72
• /
• 2011

Hot-firing tests were performed on the third sub-scale gas generator for development of a 75 ton-class liquid rocket engine. This paper deals with the analysis results of low-frequency combustion instabilities that were encountered during combustion tests of the gas generator. The low-frequency pressure fluctuations seem to be related to chamber pressure and pressure drops through oxidizer/fuel injectors.