• 한국해양학회지
• /
• v.26 no.2
• /
• pp.155-168
• /
• 1991

In order to study the community structure and distribution patterns of primary producers and their relations to abiotic environmental factors, phytoplankton and environmental parameter were determined during the five times from October, 1989 to July. 1990. 159 taxa of phytoplankton have been identified and the most important species group is diatom which contributes to 70.4% of the total number of species. Ratios of phytoplankton group (neritic species, fresh water species, oceanic species) clustered by habitats were 52%, 18%, 12%, respectively, suggesting study area be the typical estuarine environment which is strongly affected by both fresh water discharge and sea water penetration. Species composition could be governed by the variations of salinity. the standing stocks of primary producer in the study area vary with space and time, showing close correlation with water transparency, and exhibit relatively larger than those of other coastal regions in the Yellow Sea. Spectransies diversity also showed large variation with space and time. According to the cluster analysis, the study area could be divided into two regions (inner part and outer part): in fall and winter, outer area affected by the oceanic water, but in spring and summer, inner estuarine area heavily influenced by fresh water.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.1 no.1
• /
• pp.22-30
• /
• 1989

Wave propagation is changed by the effect of shoaling, current-depth refraction and shelter-ing etc. To solve these problems. numerous models have been developed. In the present study, a coordinate system is proposed based on the wave ray equation with the wave number equation including diffraction effects . The governing equation for the study was derived from the mild slope wave equation in non-steady state, including current effects (Kirby, 1986a) and trans-formed into an orthogonal curvilinear coordinate system on the basis of the wave ray equation. To obtain a numerical solution, an explicit finite difference scheme was used, and solved by the relaxation method. This model was tested for various cases: Firstly a submersed circular shoal and a constant unit depth. Secondly a submerged elliptic shoal on a slope, and finally a breakwater harbour with obliquely incident waves on a slope. The model was found to simulate the experimental results and other theoretical results in wave height and wave angle fairy well, and the applicability of the model around an arbitrary shaped coastal structure was also verified. To demonstrate the general usefullness of the present approach , the model is to be applied to a field situation with a complex bed topography.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1B
• /
• pp.10-15
• /
• 2009

Recently, there are tendency that wireless sensor network is one of the important techniques for the future IT industry and thereby application areas in it are getting growing. Researches based on the hierarchical network topology are evaluated in good at energy efficiency in related protocols for wireless sensor network. LEACH is the best well known routing protocol for the hierarchical topology. However, there are problems in the range of message broadcasting, which should be expand into the overall network coverage, in LEACH related protocols. Thereby, this paper proposes a new clustering scheme to solve the co-shared problems in them. The basic idea of our scheme is using the inherent memory restrictions in sensor nodes. The results show that the proposed scheme could support the load balancing by distributing the clusters with a reasonable number of member nodes and thereby the network life time would be extended in about 1.8 times longer than LEACH.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.8
• /
• pp.855-862
• /
• 2003

This paper suggests the PIFA structure modified antenna in which short-circuit plate is located between planar element and ground plane, in order to solve the problem of narrow band of existing internal antenna, PIFA. It is also suggested that internal antenna has the perturbation in the patch to broaden the frequency bandwidth. It is possible that the antenna is installed into the mobile telephone with a low profile condition(h=0.015 λ) to use internally, and acquired desired bandwidth(5.2 %) through double resonance structure, remodeling the PIFA that is already well-known as an internal antenna. This paper investigated how characteristic is affected by the feeding point(Yf, Zf), short strip plate(Zs), short strip width(Ws), perturbation width(w), length(d), short plate height(h), dielectric($\varepsilon$$\_$r/) to be slim type antenna. It is compared with existing PIFA bandwidth, and is suggested pattern as the H.E plane. It is simulated using the Microwave Studio of the CST Inc. based on FIM(Finite Integration Method) method and analyzed antenna characteristic following the variation each parameters. The result proved the practical use of PIFA antenna by comparing the measured and simulated data of the antenna.

• Parasites, Hosts and Diseases
• /
• v.23 no.2
• /
• pp.313-323
• /
• 1985

Boophilus microplus (Canestrini, 1887) female specimens were subjected to scanning electron microscopy for the observation of surface fine structures. Morphological characteristics observed were summarized as follows: 1. The palpi were wider than long, and compressed, ridged dorsally and laterally. There were usually four pairs of ventro-internal setae on the articles. 2. The hypostome dentition was usually 4/4 but occasionally 5/5. 3. The basis capituli were hexagonal dorsally and the porose area was distinct with the holes developed well. 4. There were numerous folds resembling finger prints around the female genital pore. 5. A pair of anal lobes with specified setae on them was also rocognized as one of the morphological characteristics.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.16 no.4
• /
• pp.99-106
• /
• 2012

This study presents estimation method of temperature-dependent thermal conductivity by using solution of inverse heat conduction problem. Time and depth temperature distribution data from full-scale fire test were used for estimating temperature-dependent thermal conductivity on hybrid-fiber reinforced shield tunnel lining. At short heating time, estimated thermal conductivity sharply decreased within $100^{\circ}C$. On the other hand, it reflected thermal properties of concrete and effect of steel fiber at heating time of measured maximum heating temperature. Thus arbitrary time should be determined to estimate temperature-dependent thermal conductivity in time zone of measured maximum heating temperature. Estimated temperature-dependent thermal conductivity is similar to results of other study.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.191-198
• /
• 2011

In this paper, a method to approximate a multi-layer Green's function is proposed based on a FDTD scheme and a rational function approximation. For a given horizontal propagation wavenumber, time domain response is calculated and then Fourier transformed to the spectral domain Green's function. Using the rational function approximation, the pole and residue of the Green's function can be estimated, which are crucial for a calculation of a path loss. The proposed method can provide a wideband Green's function, while the conventional normal mode method can be applied to a single frequency problem. To validate the proposed method, We consider two problems, one of which has a analytical solution. The other is about multi-layer case, for which the proposed method is compared with the known normal mode solution, Kraken.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.9
• /
• pp.1642-1648
• /
• 2017

Ultra-wideband antennas are desired for several applications including satellite communications, radars, remote sensing system, telescopes, and microwave imaging systems. There are many types of wideband antenna structures, but the tapered slot Vivaldi antenna is advantageous in terms of cost, weight, scan angle capabilities, end-fire radiation, and ease of feeding and system integration. In this paper, a modified antipodal Vivaldi antenna is presented. A novel AVA with H-shaped parasitic patches has the capacity to improve the radiation characteristics in the whole operation frequencies. A prototype of the modified antenna with RT/duroid 5880 substrate of a relative dielectric constant (${\epsilon}_r$) of 2.2, and a thickness of 31mil is fabricated and experimentally studied as well. It measures a ${\mid}S_{11}{\mid}$ of less than -10dB and gain of 9-12dBi over 7.8-52.5GHz which shows reasonable agreement with the simulated one.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.6
• /
• pp.141-147
• /
• 2008

This paper describes the design of frequency down converting Mixer in the receiver to use compound semiconductor and CMOS product process. The basic theory and structure of frequency down converting Mixer is surveyed, and we design mixer circuit with active balun which use the compound semiconductor and CMOS process. This mixer convert a single ended signal to differential signal at input port of RF and LO instead of matching circuit to get dual band balanced mixer structure and characteristic broadband. This designed mixer has a conversion gain $-1{\sim}-6[dB]$ at $2{\sim}6[GHz]$ bandwidths. However, the simulation of the designed mixer with active balun has the result of a 7[dB] conversion gain for -2[dBm] LO input power and -10[dBm] input P1[dB] at 5.8[GHz].

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.2
• /
• pp.437-444
• /
• 2014

The unmanned ship control system controls the unmanned ship at a distance in ocean. Expecially, in order to control the unmanned ship, it needs the wireless communication networks and we use the IEEE 802.11 based WLAN. The IEEE 802.11 based WLAN technology for supporting a wide bandwidth is suitable for unmanned ship control system which has to transmit the multimedia data. First, we design the system structure for controlling the unmanned ship. Then, in order to overcome the limited communication area, we design the network structure for the unmanned ship communication network which can use a various communication network. we implemented and evaluated the unmanned ship system based on WLAN. We controlled the unmanned ship by use the WLAN and confirmed the signal feature of WLAN in the ocean.