• Journal of the Korean Geotechnical Society
• /
• v.24 no.7
• /
• pp.37-42
• /
• 2008

This paper estimates the long-term settlement of Incheon unsanitary solid waste landfill, which is 20 years old. The unsanitary solid waste landfill was subjected to pre-loading system over a period of 1 year, and 300 settlement monitoring provided the long term settlement data. This landfill contains relatively small amount of organic component, and therefore the initial stage of settlement was very small. The existing settlement models were examineed by comparing the observed behaviors of this site, and also they were used to predict the long-term settlement. Power Creep Law (PCL) model showed good agreement with the measured settlement obtained from the initial stage of the measurement, but other models showed satisfactory agreements after $50{\sim}70$ days of measurement.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.1C
• /
• pp.41-51
• /
• 2008

The load distribution and deformation of single piles which is embedded in Jumunjin sand and Kimhae clay are investigated, based on small scale model tests. Special attention is given to the consideration of flexural rigidity in laterally loaded piles. To consider the flexural rigidity of the pile, tests are performed with the aluminium piles of three different length under different relative densities and undrained shear strength. The test results indicate that the initial slope from the results of tests is proportional to the depth and pile-soil rigidity in both soils. But the increasing rate of the initial slope in the clay is less than in the sand. In addition, the soil resistance is more related to the depth and soil condition than the pile rigidity. Base on the test results, an empirical formula is proposed, which is good agreement with previously published small scale model test and field lateral load test.

• Geotechnical Engineering
• /
• v.12 no.4
• /
• pp.157-178
• /
• 1996

Current design methods for reinforced earth structures take no account of the magnitude of the strains induced in the tensile members as these are invariably manufactured from high modulus materials, such as steel, where straits are unlikely to be significant. With fabrics, however, large strains may frequently be induced and it is important to determine these to enable the stability of the structure to be assessed. In the present paper internal design method of analysis relating to the use of fabric reinforcements in reinforced earth structures for both stress and strain considerations is presented. For the internal stability analysis against rupture and pullout of the fabric reinforcements, a strain compatibility analysis procedure that considers the effects of reinforcement stiffness, relative movement between the soil and reinforcements, and compaction-induced stresses as studied by Ehrlich 8l Mitchell is used. I Bowever, the soil-reinforcement interaction is modeled by relating nonlinear elastic soil behavior to nonlinear response of the reinforcement. The soil constitutive model used is a modified vertsion of the hyperbolic soil model and compaction stress model proposed by Duncan et at., and iterative step-loading approach is used to take nonlinear soil behavior into consideration. The effects of seepage pressures are also dealt with in the proposed method of analy For purposes of assessing the strain behavior oi the fabric reinforcements, nonlinear model of hyperbolic form describing the load-extension relation of fabrics is employed. A procedure for specifying the strength characteristics of paraweb polyester fibre multicord, needle punched non-woven geotHxtile and knitted polyester geogrid is also described which may provide a more convenient procedure for incorporating the fablic properties into the prediction of fabric deformations. An attempt to define improvement in bond-linkage at the interconnecting nodes of the fabric reinforced earth stracture due to the confining stress is further made. The proposed method of analysis has been applied to estimate the maximum tensions, deformations and strains of the fabric reinforcements. The results are then compared with those of finite element analysis and experimental tests, and show in general good agreements indicating the effectiveness of the proposed method of analysis. Analytical parametric studies are also carried out to investigate the effects of relative soil-fabric reinforcement stiffness, locked-in stresses, compaction load and seepage pressures on the magnitude and variation of the fabric deformations.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.2
• /
• pp.75-86
• /
• 2002

This paper presents sedimentation and consolidation characteristics of dredged soils mixed with sand materials through the self-weight consolidation tests adopting stepwise filling method. After completely throwing away dredged soils daily by flour kinds of S-C, which is the quantity of sand contained, results fi:om laboratory tests are compared with those from a new method using hyperbolic, which considers stage settling and consolidating characteristics, and those from the existing analyzing method. Liquid limit up to 65% had a large effect on consistency properties. Assuming that the settlement occurred only by clay content of dredged soils, it is shown that the clay void ratio is less than 2 and 4 respectively in case S-C is 0% and 50%. In the applied hyperbolic method, reinitialized curve has a linear behavior of a coefficient of correlation of almost 1, and the coefficient of slope and intercept except fur the specimen with the height of 10cm and 20cm had a tendency to fellow exponent function and a shape of zone settling and dispersing settling. The results computed by the applied hyperbolic method rather than the existing analyzing method coincide with those of laboratory tests. It is shown that the former is more suitable than the latter for the area considering the influence, of sand materials.

• Korean Journal of Agricultural Science
• /
• v.25 no.2
• /
• pp.225-234
• /
• 1998

This study was compared the degree of consolidation by Hyperbolic, Curve fitting, Asaoka's, Monden's methods using measured value with theoretical curve in consideration of smear effect and well resistance. The results of the study were summarized as follows ; 1. The degree of consolidation by Hyperbolic method was underestimated than the degree of consolidation by Curve fitting, Asaoka's, and Monden's methods. 2. Typical range of horizontal coefficient of consolidation was $C_h=(2{\sim}3)C_v$ in the case considering smear effect and well resistance, and $C_h=(0.5{\sim}2.5)C_v$ in the case disregarding smear effect and well resistance. 3. The degree of consolidation obtained by ground settlement monitoring was nearly same value when the coefficient of permeability of smear zone by back analysis was shown the half that of in-situ and the diameter of smear zone was shown double that of mendrel. 4. Increasing of diameter reduction ratio of drain, the time of consoildation was delayed. The affection of well resistance the case of small coefficient of permeability was much more than that in the case of large coefficient of permeability. It was recommended that design of diameter reduction of drain consider smear effect and well resistance.

• The Korean Journal of Financial Management
• /
• v.18 no.1
• /
• pp.1-21
• /
• 2001

주가가 장기기억과정에 의하여 생성되면 주가과정에 가해진 충격은 쌍곡선감소율로 소멸한다. 따라서 충격의 영향이 대단히 느리게 감소하여 충격이 지속성을 가진다. 반면 주가가 단기 기억과정을 따르면 지수율로 감소하여 소멸한다. 지수율감소는 충격의 영향을 급속히 소멸시키므로 충격의 영향이 조만간 소멸한다. 따라서 충격으로 변화된 주가는 평균으로 회귀한다. 충격의 영향이 영원히 존재하는 과정도 존재한다. 장기기억과정은 쪽거리차분과정 또는 분수차분과정이다. 차분모수가 분수일 것이 요구되는 시계열은 장기기억과정이다. 주가가 장기기억과정에 의하여 생성되고 있는지의 여부를 검정하였다. 장기기억과정을 형성시키는 차분모수는 분수차분모수이다. 일별 주가지수의 수익률을 사용하여 차분모수를 추정하였는 바 그 값이 0에 근접하고 있음이 밝혀졌다. 그러나 Kospi, Nasdaq과 Mib30은 장기기억모수가 0에 접근하고 있으나 0이 아니다. 따라서 이 지수들은 장기기억과정에 의하여 생성된다고 할 수 있다. 반면 Dow Jones, S&P 500와 Dax는 장기기억모수가 0이라는 가설이 기각되지 않고 있어 이 지수들은 단기기억과정을 따르고 있다. 따라서 평균회귀과정에 의하여 생성되고 있음을 알 수 있다.

• Journal of the Korean Chemical Society
• /
• v.19 no.5
• /
• pp.304-316
• /
• 1975

A formal theory to explain the Stark effect in molecular exciton states is developed using the second-quantization formalism. In this theory not only the Stark effect but also the Davydov effect are explicitly taken into consideration since the observed spectral splitting in the UV spectra for molecular crystals with two or more molecules per unit cell may be the result of combination of the above two effects. Especially for molecular crystals containing two molecules in a unit cell the splitting is shown to be hyperbolically dependent upon the strength of an externally applied, uniform electric field, from which informations regarding the excited state dipole moments of a single molecule may be obtained.

• Journal of the Korean Institute of Navigation
• /
• v.13 no.1
• /
• pp.1-10
• /
• 1989

Nowadays Hyperbolic Navigation System-LORAN, DECCA, OMEGA, OMEGA-is available on the ocean, and Spherical Navigation System, GPS (Global Positioning System) is operated partially. Hyperbolic Navigation System has the blind area near the base line extention because divergence rate of hyperbola is infinite theoretically. The Position Accuracy is differ from the cross angle of LOP although each LOP has the same error of quantity. GDOP(Geometric Dilution of Precisoin) is used to estimate the position accuracy according to the cross angle of LOP and LOP error. Hyperbola and ellipse are crossed at right angle everywhere. Hyperbola and ellipse are used to LOP in Rectangular Navigation System. The equation calculating the GDOP of rectangular Navigation System is induced and GDOP diagram is completed in this paper. A scheme that can improve the position accuracy in the blind area of Hyperboic Navigation System using the Rectangular Navigation System is proposed through the computer simulation.

• Journal of Urban Science
• /
• v.9 no.2
• /
• pp.51-56
• /
• 2020

The installation of soft ground instruments and the performance of measurement and management of the measurement shall be carried out in order to ensure the safety of the construction work and to improve the quality of the construction work. The purpose of the pressure density deposition calculation is to determine the stability of the foundation ground and the formulation by measuring and calculating the density conditions generated on the soil through the period of neglect after completion of the soil at each stage. In practice, it is judged that the analysis by the hyperbolic method can be applied to the safety side.

• Journal of the Society of Naval Architects of Korea
• /
• v.33 no.1
• /
• pp.1-8
• /
• 1996

A potential-based panel method has been developed for numerical computation of wave resistance on a hybrid hydrofoil. Hybrid hydrofoil is composed of a main body, two struts and two hydrofoils. The main body, which is assumed to be an axisymmetric body for the present analysis, is normally used to support displacement of a body with its buoyancy. Normal dipoles and the sources are distributed on the body(main body, struts, hydrofoils) and the sources are distributed on the free surface. Linearized free surface and the radiation conditions are satisfied using the fourth order finite difference operator and the semi-linear pressure Kutta condition is used for the numerical computation of the hydrofoils. Poisson type free surface condition has been used for the numerical computation and hyperboloidal panel method has been used for better numerical accuracy. To verify this numeric method, model tests are performed in circulation water channel. From the comparison of experimental results with numeric ones, the present method can be used as a useful tool for the design of high speed vessels.