• Journal of Navigation and Port Research
• /
• v.35 no.10
• /
• pp.811-816
• /
• 2011

In this paper, we analysis to consider the performance of PSPM (Phase Shift Pulse-position Modulation), the one of the low power communication technique, in near-field underwater sound channel by sea trial. PSPM is a QPSK(Quadrature Phase Shift Keying) modulation combined with PPM(Pulse Position Modulation) for low power communication in WBAN(Wireless Body Area Network). It is known that the bandwidth efficiency of PSPM is lower than conventional PSK but the power efficiency increases. In this paper, we will analyze the BER performance of PSPM using data acquired from the sea trials. The BER of QPSK was $6.04{\times}10^{-2}$, PSPM was $3.5{\times}10^{-1}$. Also, PSNR of QPSK was 9.37 dB and in case of PSPM was 9.11 dB.

• The Journal of the Acoustical Society of Korea
• /
• v.42 no.3
• /
• pp.233-242
• /
• 2023

In this paper, the effect of mass injection on the control of tip vortex cavitation was studied experimentally. A mass injection system for a 3D hydrofoil was designed to control the location of injection as well as the injection rate. A series of cavitation tests were carried out in a cavitation tunnel for different injection locations and rates. The cavitation behaviour was observed using a high-speed camera and the corresponding noise was measured using a hydrophone installed in the observation window. The results showed that the tip vortex cavitation was suppressed under certain conditions and the noise was reduced in some frequency bands. It was also found that there is a location where the effect of mass injection could be maximized and hence the noise reduction.

• The Journal of the Acoustical Society of Korea
• /
• v.43 no.1
• /
• pp.89-94
• /
• 2024

Since Ultra-Short BaseLine (USBL) uses an array with narrow sensor spacing, precise synchronization is required to improve source localization performances. However, in the underwater environment, synchronization errors occur due to relatively strong noise and underwater acoustic channels such as multipath and Doppler, which deteriorates the source localization performances. This paper proposes a covariance-based synchronization compensation method to improve the source localization performances of the underwater USBL systems. The proposed method arranges the received signals through cross-correlation and calculates the covariance of the arranged signals. The synchronization error is related to the phase difference in the covariance. Thus, the phase difference is estimated as the covariance and compensated. Computer simulations demonstrate that the proposed method has better source localization performances than the conventional cross-correlation method.

• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.311-314
• /
• 1999

본 연구에서는 저주파 대역에서 고출력 수중 음향센서로 사용되는 Class IV Flextensional 트랜스듀서의 여러 설계변수들에 따른 음압 변화 및 열 발생 경향성을 유한요소 해석법으로 해석하였다. 나아가 해석되어진 결과를 바탕으로 최대 음압을 구현하고, 열 발생이 최소인 중심 주파수 1 kHz를 가지는 Class W Flextensional 트랜스듀서의 최적구조를 설정하였다. 본 연구에서 설정한 최적구조는 기본모델에 비해 음압이 2배 이상 크고, 열 발생은 아주 작은 것으로 나타났다. 본 연구의 결과는 향후 다양한 중심 주파수 및 최대 음압을 구현하고 열 발생이 최소인 Class W Flextensional 트랜스듀서를 설계함에 있어 유용한 자료로 활용될 수 있을 것이다.

• Journal of Sensor Science and Technology
• /
• v.7 no.1
• /
• pp.9-16
• /
• 1998

This paper describes how the directivity pattern of the scattered sound pressure is distributed when a plane acoustic wave is incident on a rigid or soft spherical shell underwater. A coupled Finite Element-Boundary Element method is developed as a numerical technique. The result of the coupled FE-BE method is agreed with theoretical solution for algorithmic confirmation.

• Journal of Sensor Science and Technology
• /
• v.9 no.4
• /
• pp.307-315
• /
• 2000

To set up the arrays system of FBG(Fiber Bragg Grating) Hydrophone sensor and realize the multi-point signal detection for the wide scope underwater, using WDM(Wavelength Division Multiplexing) method and Passive band-pass filter system, underwater acoustic signal detection of the newly designed two FBG Transducers is successfully experimented. As a result of the experiment, it was possible each signal with different frequent signals is detected for the multi-point up to 1.3KHz in underwater. We can, therefore, prove the possibility on the system design of Hydrophone sensor arrays, using the newly made FBG Transducers.

• The Journal of the Acoustical Society of Korea
• /
• v.26 no.1
• /
• pp.48-54
• /
• 2007

In this paper we have implemented a 3-D PL (Position Location) system to estimate the 3-dimensional position of a moving object in underwater environments. In this research, we let four sensors fixed in different Positions and moving sensorsto communicate with each other to find the 3-dementianal positions for both the fixed and moving objects. Using this we were also able to control the moving object remotely. When finding the position, we calculated the norm of the Jacobian matrix every iteration in the Newton algorithm. Also by using a different initial value for calculating the solution when the norm became higher than the critical value and the solution from the inverse matrix became unstable, we could find a more reliable position for the moving object. The proposed algorithm was used in implementing a DSP system capable of real-time position location. To verify the performance, experiments were done in a water tank. As a result we could see that our system could located the position of an object every 2 seconds with a error range of 5cm.

• The Journal of the Acoustical Society of Korea
• /
• v.34 no.3
• /
• pp.200-209
• /
• 2015

An underwater sound surveillance system detects and tracks enemy ships in real-time using hydrophone arrays, in which seabed-mounted sensor arrays play a pivotal role. In this paper the conceptual design of seabed-mounted, cylindrical hydrophone arrays for use in shallow coastal waters is performed via finite element calculations. To stabilize the receiving characteristics under the ocean ambient noise, a technique for whitening the ambient noise spectrum using a metal baffle is proposed. Optimization of the array configuration is performed to achieve the directivity in the vertical and azimuthal directions. And the effects of the sonar dome shape and material on the structural vibration and sound scattering properties are studied. It is demonstrated that a robust hydrophone array, having a sensitivity deviation less than 4 dB over the frequency range of interest, can be obtained through the whitening of the ambient noise, the optimization of the array configuration, and the design of acoustically transparent sonar domes.

• 대한공업교육학회지
• /
• v.35 no.2
• /
• pp.224-237
• /
• 2010

When the underwater structure sails high speed, noise and vibration propagate to the sensor in the nose of the dome. In this paper, to avoid this kind of noise and vibration CRP(Carbon Reinforced Plastic) material and SNORE ring(Self-NOise REduction Ring) are attached at the curved structure and simulates its isolation characteristics using commercial software. Vibration displacement and stress are calculated at the planar sensor array. The material of the curved structure is aluminum and maximum outer diameter is 53Omm, 215mm in length, 270mm in planar diameter, respectively. Based on the simulation results, reduction ratio of the received normal stress at the sensor is above 95% at the frequency of 12kHz and 15kHz. At the mid point of the planar sensor the normal stress is higher than 20mm and 40mm apart. This results can be used to increase the sensitivity of the acoustic sensor as a basic data.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.2
• /
• pp.117-124
• /
• 2004

In this paper, we have been implemented the QPSK-based underwater transmission systems using DSP in order to transmit the underwater image data. We have adopted a BDPA (Block Data Parallel Architecture) to control multiple DSPs used in the transmitter and receiver in order to transmit the image data in real-time. We also have developed GUI software in order to drive and to debug the implemanted system in real-time. We have executed open sea tests in order to analyze the performance of the implemented system at East Sea near Kosung in Kangwon-Do. As a result of these experiments, it has been demonstrated that 10 kbps image data can be received without errors at 30m and 80m depth points, while the distance between the transmitter and the receiver is up to 20m.