• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.05a
• /
• pp.941-946
• /
• 2001

In this study, three kinds of fine aggregate (river sand, sea sand, crushed sand) were used and four different s/a (38%, 40%, 42%, 45%) were applied separately to this experimental for get the conclusion written below. Regardless of kinds of fine aggregate and casting-curing condition, maximum unit weight is seen at 40% of s/a and also to be seen in case of crushed sand. It's for that specific gravity of crushed sand is bigger comparatively than river sand and sea snad's one. Compressive strength is measured river sand, crushed sand, sea sand by order of size ; Regardless of variation of s/3, casting-curing condition and age. Compressive strength recorded maximum when s/a is 42% whatever sort of fine aggregate are. As the result, according to references, the optimum s/a of underwater antiwashout concrete is 40% but in this study, from compressive strength of view, the optimum s/a of underwater antiwashout concrete is 42%.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.427-432
• /
• 2001

In this study, crushed sand is blended with river sand and sea sand, to investigate the quality change of antiwashout underwater concrete with variation of blend ratio of crushed sand(0%, 20%, 40%, 60%, 80%, 100%). To see experiment conclusion, the more blend ratio of crushed sand increases, the more unit weight increases. Because the for that specific gravity of crushed sand is higher comparatively than that of river sand and sea sand. Higher compressive strength is measured following the order of river sand, crushed sand, sea sand regardless of age and casting-curing condition. Except for case of using river sand, blend ratio of 40% is appeared on most compressive strength. So the optimum blend ratio of crushed sand is 40% from the view point of compressive strength.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1995.04a
• /
• pp.1-7
• /
• 1995

The objective of this experimental investigation was to examine the fundamental properties of antiwashout underwater concrete. Expriments were conducted on the antiwashout property in underwater, the compressive strength in the air and in underwater, setting time, slump flow loss. As a result, a dosage of 2.0-2.5kg/$\textrm{m}^3$ antiwashout admixture was found to be appropriate not to cause water pollution and to provide a reliably good compressive strength in underwater concrete. Also, the experimental results showed that the amount of less than 50mg/$\ell$ suspended solid was required to obtain the underwater to air compressive strength ratio of more than 80%

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.609-612
• /
• 1999

Recently, the antiwashout underwater concrete with an antiwashout admixtures has been increasingly used for underwater structures. However, the credibility of antiwashout underwater concrete was brought up as problems because it seldom was applied to fields. In this study, experiments were made on the basic properties of antiwashout underwater concrete replaced with fly ash up to 30% to improve its properties. Resultant to the test, we got the results as follow; funnel flow time was decreased, the slump flow was increased and the elevation of head was decreased rapidly whereas the amount of suspended solids became high, pH became low. In view of 70%, the standard ratio of compressive strengths between cast in water and in air, it was obtained the result that the ratio was over 90% at 28days.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.117-122
• /
• 1999

The antiwashout concrete which is a type of specific concrete is manufactured by using a plenty of superplasticizer with the non-dispersible underwater concrete admixture, and the application of it on construction site is being increased. But when we measure choride ion content by using the potentiographic tester, because it is over total chloride ion content(0.3kg/㎥ under) of Korean Concrete Specification, the claim of construction site is being presented on the quality of antiwashout concrete. Accordingly, hte aim of this study is to verify actual chloride ion content of antiwashout concrete by chloride ion analysis due to chemical admixtures by performance of antiwashout concrete. In conclusion the actual chloride ion content of antiwashout concrete is overestimated by anion($OH^-, SO4^{-2}, S^{-2}, etc) of chemical admixtures, and is proved to be as low as that of ordinary concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.141-146
• /
• 1999

An experimental study is carried out to estimate the effects of mixing and placing condition on the mechanical properties of anti-washout concrete. According to the test results, mixing method and placing temperature do affect the characteristics of rrsh concrete, while they do not affect the strength development of anti-washout concrete. But, concrete strength was greatly affected by the placing condition and placing height. Concrete strength decreases linearly as the placing height increased. Compared to the normal concrete, the increase in strength is not associated much with an increase in the elastic modulus of anti-washout concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.153-159
• /
• 1999

The objective of this study was to investigate the bond strength properties of antiwashout underwater concrete. The fine aggregate(river sand, blended sand (river sand : sea sand = 1 : 1), condition of cast and cure(sea water, fresh water), and compressive strength of proportion(210kgf/$\textrm{cm}^2$ ~ 330kgf/$\textrm{cm}^2$) were chosen as the experimental parameters. The experimental results show that the underwater segregation resistance was increased, but flowability (slump flow) and air contents were decreased as the compressive strength of proportion increased. Bond strength of antiwashout underwater concrete was similar to plain concrete. From this study, rational analytic formula for the modulus of rupture and bond stress are to be from compressive strength of concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.10a
• /
• pp.447-450
• /
• 2000

Recently, antiwashout underwater concrete has used for underwater structure such as high strength massive concrete structures. When, concrete is placed in seawater the quality and durability of concrete could be doubt to especcially because the amount of cement placed in the concrete can be diminished by flowing seawater. In this study, antiwashout underwater concrete mixed with mineral admixtures for improvement of properties was placed in air, water, and salt water. Half-cell potential and current density was of specimens which made under different conditions measured for estimating corrosion degree. The experimental results demostrate that corrosion resistantce in saltwater was little and mineral admixtures improved properties of concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.10a
• /
• pp.345-350
• /
• 2000

The objective of this study makes investigation into the effect on the properties of underwater antiwashout concrete. which is followed by mixing time and mixing quantity. There is an tendency that (the compressive strength of underwater antiwashout concrete made and cured in fresh water or sea water) is increase when dry mixing time, mixing quantity, total mixing time is increase as unit weight grows. The difference of compressive strength (in case of no dry mixing time and 60 second) is averagely 46.8kgf/㎠ in the fresh water and 35.6kgf/㎠ in sea water. it's considered that dry mixing is dispersed by underwater antiwashout admixture.

• Journal of the Korea Concrete Institute
• /
• v.12 no.1
• /
• pp.89-99
• /
• 2000

The objective of this study is to investigate the bond strength properties of antiwashout underwater concrete. The arrangement of bars (vertical bar, horizontal upper bar, horizontal lower bar), condition of casting and curing (fresh water, sea water), type of fine aggregate (river sand, blended sand(river sand : sea sand = 1:1), and proportioning strength of concrete (210, 240, 270, 300, 330kgf/$\textrm{cm}^2$)are chosen as the experimental parameters. The test results(ultimate bond stress) are compared with bond and development provisions of the ACI Building Code(ACI 318-89) and proposed equations from previous research(which was proposed by Orangun et. al). The experimental results show that ultimate bond stress of antiwashout underwater concrete which arranged bar on the horizontal lower, used the blend sand, and was cast and cured in the fresh water are higher that other conditions. The ultimate bond stress were increased in proportion to {{{{( SQRT {fcu }) }}3 2. From this study, rational analytic formula for the ultimate bond stress are to be from compressive strength of concrete.