• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.1389-1391
• /
• 2005

본 논문은 시스템 파워 모듈에 적용하기 위해 CMOS 공정을 통해서 제작된 PFC IC와 성능 검증을 위한 1kW급 직류전원용 테스트베드의 개발에 대해서 기술하고 있다.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.7
• /
• pp.118-127
• /
• 2010

Current TCP/IP-based Internet architecture has been used for over 30 years, however it will confront with fundamental problems due to new protocol extension limitation since communication environments will change drastically and various user requirements will be emerging in near future. To solve these problems, major countries have started Future Internet researches based on clean slate approach and they will deploy large-scale testbed to experiment and verify new functions. OpenFlow switch technology has been proposed as a new experimental technology for independent protocol that can utilized the legacy network devices and does not interfere with the production Internet traffic. Korea also started Future Internet testbed project called FIRST and OpenFlow switch with NetFPGA card will be used to deploy this testbed. To interconnect distributed testbed using OpenFlow switches, logical tunnel should be established by encapsulating MAC frame inside a unicast IP packet between OpenFlow switches because OpenFlow switches are not directly connected. In this paper, we have implemented a NetFPGA-based that performs MAC in IP tunneling between various OpenFlow switch sites implemented in domestic research network KOREN. The performance evaluation shows that the NetFPGA-based capsulator reveals better performance than the software-based tunneling and it can be utilized as a testbed for experimentation of Future Internet technologies.

• Journal of the Korean Society for Precision Engineering
• /
• v.31 no.5
• /
• pp.403-409
• /
• 2014

For ground-based telescope application, the performance assessment of tip-tilt actuator is important because the optical quality of telescope depends upon the windshake compensation ability of the fast steering secondary mirror. But it is difficult to measure the performance characteristics of the actuators due to the large size mirror and test facilities including the vacuum support and structural frame. In this paper, the full-scale tip-tilt test bed for the large size secondary mirror with diameter of 1m is built and the several tests are performed including the range, resolution and frequency response function. From the measurement results, it is shown that the tip-tilt actuator can successfully compensate the windshake with frequency of maximum 12 Hz and be a candidate for the Giant Magellan Telescope.

• KIPS Transactions on Computer and Communication Systems
• /
• v.10 no.5
• /
• pp.137-144
• /
• 2021

The IETF has recently been standardizing the QUIC protocol for HTTP/3 services. It is noted that HTTP/3 uses QUIC as the underlying protocol, whereas HTTP/1.1 and HTTP/2 are based on TCP. Differently from TCP, the QUIC uses 0-RTT or 1-RTT transmissions to reduce the connection establishment delays of TCP and SCTP. Moreover, to solve the head-of-line blocking problem, QUIC uses the multi-streaming feature. In addition, QUIC provides various features, including the connection migration, and it is available at the Chrome browser. In this paper, we analyze the performance of QUIC for HTTP-based web and streaming services by comparing with the existing TCP and Streaming Control Transmission Protocol (SCTP) in the network environments with different link delays and packet error rates. From the experimental results, we can see that QUIC provides better throughputs than TCP and SCTP, and the gaps of performances get larger, as the link delays and packet error rates increase.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.6
• /
• pp.666-671
• /
• 2023

As international environmental regulations on ship emissions are gradually strengthened, interest in electric propulsion and hybrid propulsion ships is increasing, and various solutions are being developed and applied to these ships, especially stabilization of the power system and system efficiency. The direct current distribution system is being applied as a way to increase the power. In addition, verification and testing of safety and performance of marine DC distribution systems is required. As a result of establishing a DC distribution test bed, verifying the performance of the DC distribution (variable speed power generation) system, and analyzing fuel consumption, this study applied a variable speed power generation system that is applied to DC power distribution for ships, and converted the power output from the generator into a rectifier. A system was developed to convert direct current power to connect to the system and monitor and control these devices. Through tests using this DC distribution system, the maximum voltage was 751.5V and the minimum voltage was 731.4V, and the voltage fluctuation rate was 2.7%, confirming that the voltage is stably supplied within 3%, and a variable speed power generation system was installed according to load fluctuations. When applied, it was confirmed through testing that fuel consumption could be reduced by more than 20% depending on the section compared to the existing constant speed power generation system.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.2
• /
• pp.488-496
• /
• 2000

this paper describes the design and implementation of node scheduling for MX Server that is CC-NUMA System COMSIX, the operating system of MX Server, is designed to suit for CC-NUMA Architecture. MX Server consists of up to 8 nodes, and each node is connected by SCI ring. This node scheduling scheme considers data locality for performance improvement of Oracle8i DBMS on the CC-NUMA architecture. For DBMS such as Oracle8i, a multi-threaded process may be run to tie on particular disk. We have developed a CG binding function that the multi-threaded process bound the node. Currently, We don't have an available CC-NUMA Platform. Instead of MX Server, we developed the Node scheduling scheme for multi-threaded process to suit server platform on the PC test-bed and tested completely.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2004.11a
• /
• pp.17-20
• /
• 2004

가정 내에 방송과 총신을 통합하여 제공하기 위한 방법으로서 수동광가입자망(Passive Optical Network)이 제안되고 있다 이를 구현하기 위해 여러 방식들이 연구되고 있는데 크게는 방송과 통신에 각기 다른 파장을 이용하는 방식과, 이들을 시간 다중화 하여 한 개의 과장으로 송신하는 방식으로 나눌 수 있다. 또한 동신에 이용하는 과장의 경우 각 가입자에게 다른 파장을 적용하는 WPON 방식과 모든 가입자에게 한 개의 파장만을 이용하되 시간영역에서 다중화하고 이터넷 프로토콜을 적용하는 EPON 방식으로 구분할 수 있다. WPON의 경우 EPON에 비해 수월하게 광대역 서비스를 할 수 있는 장점이 있으나, 각 가입자 과장의 제어 및 관리가 복잡하며, 고비용을 요구한다. 반면 EPON의 경우 채널의 효율성은 극대화할 수 있으나, 동시 이용자가 많을 경우 전송 속도가 하락한다. 한편, 방송과 통신을 통합한 채널의 특성을 살펴보면 가입자 방향으로의 하향 신호의 양이 중양국 방향으로의 상향 신호의 양에 비해 훨씬 많은 비대칭 구조이다. 따라서 본 연구에서는 이러한 채널 특성에 맞도록 하향 전송에는 WPON의 구조를 이용하고, 상향 전송에는 EPON의 구조를 적용하는 새로운 구조의 광가입자망을 제안하였다. 제안된 구조에 적합한 MPCP (Multi-Point Control Protocol) 프로토콜을 제시하고, 가입자 장치의 여러 종속 신호를 다중화하고 전송할 수 있는 ONU (Optical Network Unit)의 구조를 제안하였다. 또한 이러한 구조를 갖는 W-EPON 테스트베드를 구현하고 전송 시험을 통해 제시된 구조의 적합성을 측정한 결과를 보인다.4 Textual format) 파일을 생성한다. 또한, 콘텐츠 전송 및 저장의 효율성을 위해 이진 포멧인 IPMP화된 MP4 파일을 생성할 수 있다.으로써, 에러 이미지가 가지고 있는 엔트로피에 좀 근접하게 코딩을 할 수 있게 되었다. 이 방법은 실제로 Arithmetic Coder를 이용하는 다른 압축 방법에 그리고 적용할 수 있다. 실험 결과 압축효율은 JPEG-LS보다 약 $5\%$의 압축 성능 개선이 있었으며, CALIC과는 대등한 압축률을 보이며, 부호화/복호화 속도는 CALIC보다 우수한 것으로 나타났다.우 $23.87\%$($18.00\~30.91\%$), 갑폭 $23.99\%$($17.82\~30.48\%$), 체중 $91.51\%$($58.86\~129.14\%$)이였으며 성장율은 사육 온도구간별 차는 없었다.20 km 까지의 지점들(지점 2에서 지점 6)에서 매우 높은 값을 보이며 이는 조석작용으로 해수와 담수가 강제혼합되면서 표층퇴적물이 재부유하기 때문이라고 판단된다. 영양염류는 월별로 다소의 차이는 있으나, 대체적으로 지점 1과 2에서 가장 낮고, 상류로 갈수록 점차 증가하며 지점 7 상류역이 하류역에 비해 높은 농도이다. 월별로는 7월에 규산염, 용존무기태질소 및 암모니아의 농도가 가장 높은 반면에 용존산소포화도는 가장 낮다. 그러나 지점 14 상류역에서는 5월에 측정한 용존무기태질소, 암모니아, 인산염 및 COD 값이 7월보다 다소 높거나 비슷하다. 한편 영양염류와 COD값은 대체적으로 8월에 가장 낮으나