• Journal of Conservation Science
• /
• v.6 no.1 s.7
• /
• pp.3-14
• /
• 1997

Twelve Punchong sherds collected in Hakbongni, Kongju where the well known iron-painted on white slip were manufactured from late 15C to early 16C were analyzed for their composition and microstructure. The composition of the body was analyzed by X-ray fluorescence and that of glaze by electron probe micro-analyzer. Microstructure was observed by optical microscope, polarizing microscope, EPMA, and X-ray diffractometer. The results of composition of body and glaze of Hakbongni were compared with those of Punchong from Yongsuri, Boryong which was close to Hakbongni. The composition of body and glaze of these two areas were compared by principal component analysis using SPSS program. Hakbongni bodies have higher silica and flux materials but lower alumina and their glaze have higher silica, soda, iron oxide but lower alumina, calcia. Hakbongni punchong itself is divided into two groups. Their glaze is lime type. There are many remnant minerals, such as quartz, large feldspar mass with partially melted surrounding area, albite, biotite, and iron-oxide. From such a microstructure we can assume that preparation of raw material was rather crude and firing temperature quite low. Iron-painted material is identified as Mg/Fe/Al spinel by composition analysis and XRD pattern.

• Journal of the Society of Disaster Information
• /
• v.9 no.1
• /
• pp.56-64
• /
• 2013

The study examines the quiet pavement using fine-size aggregates and warm-mix technique to reduce traffic noise. In order to evaluate the quality of pavement, mix design and laboratory tests were carried out. Test results showed that using 10mm aggregates can reduce the cantabro loss compared with 13mm aggregates due to increase contact area between aggregates. Mixing and compaction temperatures of warm mix quiet pavement should be determined by gyratory compactor test because it is used high viscosity asphalt binder. Using warm-mix additive could reduce compaction temperature by about $15^{\circ}C$. Noise measurement and permeability tests were conducted at the test road for evaluation of the field performance. All of quiet pavements meet the standard of permeability and have sufficient porosity. Noise reduction of the quiet pavement using fine-size aggregates is more effective than that using 13mm aggregates. In particular, the effect of noise reduction was noticeable at low speeds.

• International Journal of Highway Engineering
• /
• v.11 no.4
• /
• pp.127-132
• /
• 2009

This study presents the test results on the compaction characteristics of warm mix asphalt mixtures that include the additive in 3 different mixtures(hot mix asphalt, SBS and SMA). The tests were conducted to find out the compaction characteristics on the compactability with varying compaction time, different amount of the warm mix additive and lowering the compaction temperature. The Superpave gyratory compactor was used to find out the variation of the density when the number of the gyration is varied. A dense mixture and 3 different warm mix additives were employed to find the relationship between compactability and compaction time. The comparison of the compactability with lowering the temperature was conducted using dense mixture, SBS polymer modified mixture and stone matrix asphalt mixture(SMA). The difference of the density of warm mix asphalt mixtures was not found due to the lowering of compaction temperature when it was compared with the standard mixture and the warm mix showed the stable condition in density. In the mean time, depending upon the different warm mix additive and mixture, the difference of density and the variation trend of compaction is found to be existed and shows the relationship between these two variables.

• Mineral and Industry
• /
• v.18 no.1
• /
• pp.1-17
• /
• 2005

국내의 납석 광상은 대부분 백악기의 화산암류들이 열수변질되어 형성된 광상으로서, 주로 전남 및 경남 지역에 밀집되어 분포한다. 납석은 지질 여건상 주로 경상분지 내에 국제적인 규모의 풍부한 부존자원이 있지만, 그 동안의 개발에 의해서 고품위 황석들은 상당히 채진된 상황이다. 현재 개발되고 있는 광체들은 몇 곳의 광산을 제외하고는 대부분 저품위 광상을 이루고 있기 때문에, 새로운 광체의 탐광이 이루어지지 않는다면 앞으로 고품위 광석에 관한 한 국내의 수요를 충당하기 어려운 상황에 이를 것으로 예견된다. 현재 국내에서 납석으로 개발되고 있는 광석의 상당수(대략 $40\%$ 정도)가 엄밀한 의미에서는 사실상 납석이 아닌 고령토나 견운모 광석인 것으로 밝혀졌다. 엽납석을 함유하는 정상적인 형태의 납석들은 그수반 점토광물상에 의거하여 (l) 엽납석질, (2) 딕카이트질. (3) 일라이트질 및 (4) 딕카이트-일라이트질 유형으로 구분될 수 있다. 고령토 광물로는 대부분 딕카이트가 수반되고 외국에서는 흔히 수반되는 것으로 알려져 있는 고령석은 거의 함유되지 않는 것이 특징이다. 석영은 납석에서 점토광물 못지않게 그 용도를 가름하는 주요 성분으로서 대부분의 광석 유형에서 수반되지만 특히 일라이트질 납석에서 흔히 그리고 보다 많이 수반되는 양상을 보인다. X-선회절 정랑분석법은 납석의 품위를 산정하는데 유력한 수단이 될 수 있다. 특히 납석 이외의 점토광물들의 조성, 특히 일라이트의 함유 정도는 납석의 용도별 품위와 품질을 가름하는 주요 사항이다. 화학분석에 의한 납석의 평가 방식은 특히 납석의 백색 도기류와 같은 각종 세라믹스 제조 용도에서의 품질 평가에 결정적인 단서를 제공하는 유력한 평가수단이다. 특히 착색유발 성분인 철분의 존재와 그 함량을 정하고 요업용도에서 중요한 $Al_3O_3$와 알칼리 성분 함량을 검증하는데 필수적인 평가 방법이다. 이외에 주사전자현미경 관찰을 통해서 납석의 주요 품질 기준이 되는 극미립상 엽납석의 결정형, 조직 및 미시적 산출상태를 보다 정밀하게 평가할 수 있는 방안을 제공한다. 현행 광업법상의 납석을 비롯한 관련 광종들의 광물분류 체계가 모호하게 설정되어 있고 관련 인허가 부서에서의 전문성 및 지도력 부족으로 관련 산업계에 심각한 비효율성과 오류가 야기되고 있는 실정이다. 이를 개선하기 위해서는 납석의 광석평가 방식이 그 품위와 품질 개념 하에서 응용광물학적으로 적용되어야 할 것이다.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.1
• /
• pp.39-50
• /
• 2010

Zeolites were formed by the alteration of volcanic glass in the volcaniclastics including tuff cone/rings and subsurface Seoguipo Formation, Jeju Island. Phillipsite and analcime were identified by X-ray diffraction and electron microprobe analysis. Si/(Si+Al) atom ratios of analcime and phillipsite were similar to that of parent basaltic glass. In comparison with the simple chemistry of analcime, phillipsite showed a range of cavity cation compositions. Na is the major cavity cations of phillipsite in the Dangsanbong and Yongmeori tuffs bearing analcime, while K and Ca in core samples of Seoguipo Formation. Microtextural analysis by scanning electron microscope showed a general sequence that early phillipsite encrustification of pores was followed by later analcime infilling. Zeolites are abundant in the older tuff cone/rings but nearly absent in the younger ones.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.12
• /
• pp.1638-1643
• /
• 2019

In this paper, we propose an adaptive-perturbation-aided opportunistic precoding (APOP) scheme for multiple-input multiple-output (MIMO) systems. To update a precoding matrix in MIMO systems, the proposed algorithm produces a random perturbation in each time slot. Then the additional adaptive perturbation is also applied, which depends on the reports of achievable data-rates from users. If the prior random perturbation increased the data rate, the adaptive perturbation is set to be the same as the prior random perturbation, otherwise the negative value of the prior random perturbation is applied for adaptive perturbation. Furthermore, to enhance the achievable data rates, the information on the stored precoding matrices in the memory as well as the currently generated precoding matrix is used for scheduling. Simulation results show that compared to conventional opportunistic precoding schemes, higher data rates are achieved by the proposed APOP scheme, especially when there are a relatively small number of users.

• Journal of the Korean Institute of Gas
• /
• v.26 no.3
• /
• pp.21-26
• /
• 2022

Zinc is emerging as a environment-friendly plating material to replace cadmium, which is harmful to the human body, to prevent hydrogen gas penetration or release from metal materials. Electroplating of Zn and Zn alloys, which is usually performed in an aqueous acidic atmosphere, has disadvantages such as low coulombic efficiency, corrosion, and hydrogen release, resulting in industrial use difficult. In this study, a deep-eutectic solvent was synthesized using choline chloride and ethylene glycol. Using this as a solvent, an electrolyte for Zn plating was prepared, and then zinc was plated on the STS 304 substrate. The surface microstructure and roughness were observed using SEM and AFM. The crystal structure of the electro-plated film was analyzed using XRD. Finally, the preventing effects of hydrogen release through Zn-based deep-eutectic plating on the STS 304 substrate were compared with the uncoated substrate.

• Composites Research
• /
• v.34 no.6
• /
• pp.350-356
• /
• 2021

When a ship with a planing line operates or turns in a straight line, the floating position and trim change according to the speed, and a large resistance is generated on the hull. In this paper, the resistance to a planing line was estimated through the computational fluid dynamics of a leisure boat with improved hull weight and durability by applying a carbon composite material to the hull. The resistance performance of the bow and stern of the 18ft class leisure boat was checked and the flow field of the entire vessel was estimated, and the stability of the planing line was confirmed by comparing the resistance of each trim through numerical analysis. In addition, it was confirmed that the designed planing line could withstand it sufficiently because the force applied to the hull was not large, and The stability of the boat was analyzed by calculating the wavelength of the wave and the length of the ship as the ratio of gravity to the inertial force and checking how much force the rolling occurred.

• Korean Journal of Social Welfare
• /
• v.66 no.2
• /
• pp.287-317
• /
• 2014

The study conducts a comparative study of the supporting systems and methods of social enterprises in Korea, Japan, and Hong Kong to propose a policy on sustainable growth of social enterprises and their long-term activation. By investigating previous studies, this researcher drew the frame of a comparative analysis and conducted the comparative analysis. First, regarding the supporting system for social enterprises, it was found that Korea had better institutional foundation and system, whereas Japan had better activation, cooperation and network of intermediary support organizations. In Korea there is the law related to social enterprises, and the government takes control of all of the organization in charge of the policy, intermediary support organizations, cooperation and network, and authentication system. However, Hong Kong has yet to establish a basic institutional system to grow and activate social enterprises, and foreign intermediary supporting organizations increase the network and cooperation level to support social enterprises. Thirdly, for supporting methods for social enterprises, there were direct financial support, indirect business support and other kinds of support in Korea, whereas indirect support was activated in Japan. Although The Hong Kong government barely supports social enterprises, it comes up with a plan to support the firms serving as social enterprises under its the 12th 5-year development plan. For sustainable growth of Korean social enterprises, this study suggested the change of the government policy to the direction of creating social enterprise ecosystem through cooperation and network activation, indirect support in the middle of process, and activation of intermediary support organizations.

• Journal of the Mineralogical Society of Korea
• /
• v.21 no.3
• /
• pp.289-295
• /
• 2008

We studied the difference between the clay mineral content in the bulk marine sediments (absolute clay mineral composition) and clay mineral content only in total clay minerals (relative clay mineral composition) of the Yellow Sea marine sediments, and correlated the relationship between their distribution patterns. We used 56 Yellow Sea Surface sediments collected at the second cruise in 2001 of KORDI, and determined the absolute mineral composition using the quantitative X-ray diffraction analysis. Yellow Sea surface sediments consist of primary rock forming minerals including quartz (average 44.7%), plagioclase (15.9%), alkali feldspar (10.0%), hornblende (2.8%) together with clay minerals (illite 15.3%, chlorite 2.6% and kaolinite 1%) and carbonates (calcite 1.7%, aragonite 0.6%). Absolute clay mineral contents are very high in the region extending from the southeast of Sandong Peninsula to the southwest of Jeju Island. In contrast, it is very low along the margin of the Yellow Sea. Such distribution patterns of absolute clay mineral content are very similar to those of fine-grained sediments in the study area. The average relative clay mineral composition of illite, chlorite, and kaolinite is respectively 80.3%, 14.9% and 4.8%. The distribution pattern of relative mineral composition shows very different phenomenon when compared with those of absolute mineral composition, and also do not exhibit any positive relationship with that of fine-grained sediments in which clay mineral composition is abundant. Therefore, we suggest that the relative clay mineral compositions and their distribution patterns must be used very carefully when interpreting the origin of sediment provenance.