• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.6
• /
• pp.1-14
• /
• 2011

The surrogate safety assessment model which was developed based on the conflict theory by FHWA in the US is software to analyze traffic conflicts using the individual vehicle trajectory data from a microscopic traffic simulation model. This study aims at assessing the safety of different signal control strategies, including pre-time and actuated signal control, using the SSAM. To this end, this study effort has developed a microscopic traffic simulation model using VISSIM through a field study, and then produced the surrogate measures, including TTC, PET, DR, MaxS and DeltaS, and the numbers of conflicts, including rear-end, right angle and lane-changing conflicts. The assessment results indicated that the actuated signal control may produce more conflicts in terms of rear-end conflicts. The use of SSAM in the safety assessments for diverse traffic alternatives in a safe and fast way may contribute to the improvement of safety in the roadway transportation.

• Journal of Korean Society of Transportation
• /
• v.21 no.5
• /
• pp.31-40
• /
• 2003

Unsignalized intersections are classified into two-way-stop-controlled(TWSC) and all-way-stop-controlled(AWSC) intersections for the analysis of capacity and level of service. There is no AWSC intersection in Korea, but non-controlled intersections are common. Non-controlled intersections are operated only by the driver's decision without any control. However, the study for the analysis of capacity and level of service of the non-controlled intersection has been rare. As the first stage research, this study aims to determine the measure-of-effectiveness (MOE) for the performance evaluation of non-controlled intersections. The relationships between traffic volume and the intersection passing time (delay) and number of conflicts on each intersection are analyzed. It was found that the number of conflicts were more sensitive to the traffic volume compared with the delay. It means that number of conflicts can be the MOE for the performance of non-controlled intersection. The analysis of the number of conflicts and traffic volume showed a linear relationship, so that traffic volume can also be an MOE. The level of service of non-controlled intersection can be determined with either of the MOE's. Since the performance is also influenced by the ratio of traffic volumes of crossing streets, the traffic volume should be adjusted by the ratio. The capacity of non-controlled intersection was suggested to be 2,000veh/hr referring that of AWSC intersection in the USHCM. The criteria was suggested by evenly dividing the traffic volumes based on the capacity.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.22 no.5
• /
• pp.30-42
• /
• 2023

Various studies have been conducted using microtraffic simulation (VISSIM) to analyze the safety of traffic flow when introducing autonomous vehicles. However, no studies have analyzed traffic safety in mixed traffic while considering the driving behavior of general vehicles as a parameter in VISSIM. Therefore, the aim of this study was to optimize the input variables of VISSIM for non-autonomous vehicles through genetic algorithms to obtain realistic behavior. A traffic safety analysis was then performed according to the penetration rate of autonomous vehicles. In a 640 meter section of US highway I-101, the number of conflicts was analyzed when the trailing vehicle was a non-autonomous vehicle. The total number of conflicts increased until the proportion of autonomous vehicles exceeded 20%, and the number of conflicts decreased continuously after exceeding 20%. The number of conflicts between non-autonomous vehicles and autonomous vehicles increased with proportions of autonomous vehicles of up to 60%. However, there was a limitation in that the driving behavior of autonomous vehicles was based on the results of the literature and did not represent actual driving behavior. Therefore, for a more accurate analysis, future studies should reflect the actual driving behavior of autonomous vehicles.

• Korean Journal of Environment and Ecology
• /
• v.25 no.5
• /
• pp.799-813
• /
• 2011

Increasing mountain biking (MTB) in forest recreation areas is changing the behavioral patterns in the areas where hiking has been a dominant activity, and it may cause ecological and social impacts to the areas. This study examined hikers' perceived conflicts by MTB including the relationship between socio-demographic and visiting characteristics and perceived conflict. On-site survey was conducted in Mudeungsan Provincial Park (MPP), Korea, during September, 2010. Out of 388 hikers participated in the survey, 374 responses were used for data analysis. 30.2% of the respondents encountered or saw MTB (avg.: 1.7 times) in MPP. Overall, 77.1% of respondents thought MTB in MPP was a problem. 73.5%~83.2% of respondents perceived conflict by four major MTB behaviors (e.g., too fast running MTB in trails; MTB bikes occupying trails; MTB bikes passing by hikers too closely; MTB bikers doing unpleasant behaviors to hikers). Based on the type of conflict, 48.5~62.4% of respondents fell in the type of "social values conflict (SVC)", 11.1~32.4%, "interpersonal conflict (IC)", and 16.8~26.6%, "no conflict (NC)", respectively. Types of conflicts were related with sociodemographic (e.g., gender, age, education) and visiting characteristics (e.g., number of visits, experience of encountering MTB). Such relationships were nonexistent in most cases when the "experience of encountering MTB" was controlled.

• Proceedings of the Korea Contents Association Conference
• /
• 2010.05a
• /
• pp.322-324
• /
• 2010

교통량이 적은 신호교차로에서는 신호에 의한 불필요한 지체가 발생하는 경우가 많다. 특히 지방부 신호교차로의 경우 불필요한 신호 대기로 인해 운전자가 신호위반을 하거나 불필요한 지체를 경험하게 된다. 이를 해결하기 위한 방안으로 비교적 교통량이 적은 신호교차로를 회전교차로로 운영하여 해결할 수 있다. 본 연구에서는 지방부에 설치된 신호교차로를 분석하고 이를 회전교차로로 개선하였을 경우 그 효과를 비교분석하였다. 분석 결과 지체감소 효과가 있었으며, 통행시간 및 평균속도의 증가를 가져오는 것을 확인하였다. 또한 안전성 측면에서 교차로 상충횟수도 감소하는 것을 확인하였다.

• Journal of Korean Society of Transportation
• /
• v.30 no.4
• /
• pp.21-32
• /
• 2012

Exclusive bus lane (EBL) is typically located in the roadway median, and is accessed by weaving across the GPLs(general purpose lanes) before entering from the left lane of the GPLs. To maximize the potential for successful EBL operations, a critical design issue that requires special attention is the length of bus weaving section before entering EBL. The process of developing guidelines for the length of bus weaving section can be supported by a sensitivity analysis of performance measure (safety) with respect to the bus weaving distance. However, field data are difficult to obtain due to inherent complexity in creating performance measure (safety) samples under various interesting flows and bus weaving distance that are keys to research success. In this paper, VISSIM simulation is applied to simulate the operation of roadway weaving areas with EBL, and based on vehicle trajectory data from microscopic traffic simulation models, the Surrogate Safety Assessment Model (SSAM) computes the number of surrogate conflicts (or degree of safety) with respect to the bus weaving distance. Then, a multiple linear regression (MLR) model using safety data (number of surrogate conflicts) is developed. Finally, guidelines for bus weaving distance are established based on the developed MLR. Developed guidelines explicitly indicate that a longer bus weaving distance is required to maintain desired safety as weaving volume increases.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.23 no.2
• /
• pp.32-49
• /
• 2024

In this paper, we analyzed the impacts of road traffic conditions and speed limit changes on traffic flow and safety. Travel speed and moving speed were set as traffic flow indicators and'moving speed-travel speed',speed deviation, large speed deviation ratio, and number of conflicts were set as safety indicators, and the impacts of changes in road traffic conditions and speed limits on these were analyzed. According to the analysis results, the speed limit had a significant impacts on the traffic indicators, but did not significantly affect the safety indicators. As a result of the statistical validity test, it was proven that the traffic flow index increases as the speed limit increases. However, although safety indicators often increase, their validity has not been proven statistically. Therefore, if the speed limit is set and operated by properly considering the traffic flow status according to various road conditions and changes in traffic volume, it can be said to match the speed at which drivers drive and improve traffic flow and safety. Therefore, it is expected that calculating the speed limit considering the traffic flow indicators and safety indicators presented in this paper and operating the speed limit according to changes in traffic volume will contribute to stabilizing the traffic flow on the road.

• Journal of Korean Society of Transportation
• /
• v.33 no.5
• /
• pp.478-487
• /
• 2015

This study proposed a Variable Speed Limits(VSL) algorithm to use traffic information based on Cumulative Demand-Capacity Analysis and evaluated its performance. According to the analysis result, the total of delay consisted of 3 separate parts. There was no change in total travel time although the total of delay decreased. These effects was analysed theoretically and then, evaluated through VISSIM, a microscopic simulator. VISSIM simulation results show almost same as those of theoretical analysis. Furthermore in SSAM analysis with VISSIM simulation log, the number of high risk collisions decreased 36.0 %. However, the total delay decrease effect is not real meaning of decrease effect because the drivers' desired speed is same whether the VSL model is operated or not. Nevertheless this VSL model maintains free flow speed for longer and increases the cycle of traffic speed fluctuation. In other words, this is decrease of delay occurrence and scale. The decrease of speed gap between upstream and downstream stabilizes the traffic flow and leads decrease number of high risk collision. In conclusion, we can expect increase of safety through total delay minimization according to this VSL model.

• Journal of the Korean Society for Railway
• /
• v.19 no.4
• /
• pp.555-563
• /
• 2016

Line capacity of railways is a core criterion to decide maximum trips in accordance with traffic demand and a priority in railway investment to improve transportation capability. Particularly, because two operators will start revenue services in the HSR from mid-2016, the line capacity should be carefully calculated and controlled to avoid conflicts between the maximum number of KTXs, and the number needed to guarantee the effective competition of the operators. Meanwhile, there have been many arguments about calculating the line capacity, because this number is affected by the number of trips by train types, stopping pattern and dwell time in each station, journey time, crossing or passing, safety headway between trains, etc. To deal successfully with these kinds of problems, this study proposes a simulation method to calculate the line capacity that considers train operation according to the operator's service policies.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2021.11a
• /
• pp.423-425
• /
• 2021

전기 자동차 에너지 시스템을 개발하기 위해서는 열 유체-전자기장 연성해석이 필요하다. 이를 위해 열 유체와 전자기장 각각의 해석에 특화된 패키지들을 사용하고, 이 패키지의 실험 결과를 저장 장치를 통해 주고받는다. 하지만 이는 저장장치 I/O 횟수를 늘려서 전체 계산 과정을 느리게 만들 수 있다. 데이터 교환을 MPI 패키지를 이용하여 DRAM 을 통해 이루어지도록 만들 수 있지만, 이는 계산 결과의 지속성을 악화시킨다. 즉, 열 유체 및 전자기장 연산과정에서 속도와 결과의 지속성은 상충적인 관계 갖는다. 본 연구는 이러한 관계를 실험적으로 분석하고 데이터의 지속성을 완화했을 때 이에 의해 얻을 수 있는 성능 이익을 분석한다.