• Journal of Navigation and Port Research
• /
• v.36 no.3
• /
• pp.181-187
• /
• 2012

Highly plastic clays in their normally consolidated states are not always linear but are concave downwards. Thus their compression index deceases with the increase of consolidation pressure. The $e-{\log}{\sigma}_{\upsilon}{\prime}$ curves of plastic or non-plastic silty clays are not linear but are convex upwards. In this paper, consolidation tests were conducted with several undisturbed field soils of Korea south coast and their $e-{\log}{\sigma}_{\upsilon}{\prime}$ plots are not always linear. In case of using Butterfield's method(liquid limit 50~100%), ${\ln}{\upsilon}-{\ln}{\sigma}_{\upsilon}{\prime}$ plots are linear. But some undisturbed samples which have void ratio over 2.24, liquid limit over 100% and plasticity index over 60% are not linear. In results of consolidation tests with remolded samples which contain silt(fly ash) contents of 90% has compression index increasing with the increase in consolidation pressure.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.6
• /
• pp.371-378
• /
• 2003

The compression index of clay distributed in the west and south coast of the Korean Peninsula had been studied. Compression index was obtained from the conventional consolidation test, and was conducted accordingly to obtain the field virgin compression curve by means of Schmertmann's graphical correction. To examine a correlation closely between physical properties of soils($e_o$, LL, w) and compression index(Cc), linen. and non-linear regression analysis were employed based on the data collected from tests. The conclusions are as follows. The compression index obtained by means of Schmereann's graphical correction is about 1.16 times for the value of original oedometer test curve for U/D samples. Non-liner regression curve was preferable to establish a correlation equation rather than linear regression curve. All derived equations so far achieved have been summarized and given. However, linear equation is better for practical use so that part by part simplified linear equations were also suggested alternatively together with their own non-linear regression curve.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.5C
• /
• pp.183-190
• /
• 2009

It is necessary to predict the deformation and stresses on soils to establish the nonlinear stress-strain relationship of geomaterials at various strain levels. Especially, a need exists to establish the pre-failure nonlinear characteristic of cemented granular geomaterials used in road constructions. In this paper, therefore, conventional granular soils were mixed with various cementing materials, such as cement and fly ash from coal combustion by-products. Then, the normalized nonlinear behavior of cemented geomaterials was assessed using unconfined compression test. In addition, various constitutive models of soils were evaluated for estimating pre-failure non-linear behavior of cemented geomaterials from the test results.

• The Bulletin of The Korean Astronomical Society
• /
• v.45 no.1
• /
• pp.52.3-52.3
• /
• 2020

천문학적 유체는 강하게 자화되어 있는 경우가 많은데, 이러한 강한 자기장을 얻는 한 방법이 난류에 의한 자기장의 증폭이다. 플라즈마 효과나 기타의 이유로 약한 씨앗 자기장이 유체에 생길 경우, 난류는 이 씨앗 자기장을 매우 효과적으로 증폭시킬 수가 있다. 이 과정을 난류 다이너모라 하는데, 난류 다이너모는 주로 비압축성 난류 구동력을 사용하여 연구해 오고 있다. 비압축성 구동력을 사용할 때의 난류 다이너모 과정은 비교적 잘 규명되어 있다. 기존의 연구 결과에 의하면, 자기장의 세기는 지수 함수적 성장을 거친 후 선형적 성장 단계를 겪는다. 이후, 자기장의 에너지 밀도가 난류의 에너지 밀도와 비슷해지면 자기장은 더 이상 성장하지 못하고 포화 상태에 접어든다. 결론적으로 난류는 자기장이 동력학적으로 중요한 수준까지 증폭을 시킬 수 있다. 압축성 난류 구동력을 사용한 난류 다이너모 연구도 일부 존재하는데, 기존의 연구 결과에 의하면 다이너모 효과가 비압축성 구동력의 경우보다 비효율적이다. 본 연구에서는 압축성 구동력을 사용하여 난류 다이너모를 체계적으로 연구하였다. 특히 압축성 구동력과 비압축성 구동력이 난류 다이너모 효과에 어떤 차이를 주는지 체계적으로 비교하였다.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.15 no.1
• /
• pp.19-28
• /
• 2011

In this study, nonlinear finite element analysis procedures are presented for the structural performance assessment of damaged reinforced concrete structures. A computer program, named RCAHEST (Reinforced Concrete Analysis in Higher Evaluation System Technology), for the analysis of reinforced concrete structures was used. Material nonlinearity is taken into account by comprising tensile, compressive and shear models of cracked concrete and a model of reinforcing steel. This paper defines a damage index based on the predicted inelastic behavior of reinforced concrete structures. The proposed numerical method for the structural performance of damaged reinforced concrete structures is verified by comparison with reliable experimental results.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.5
• /
• pp.303-311
• /
• 2016

From having an experimental study of physical and consolidation characteristics of soft clay in Nakdong river lower basin, we come to the conclusion as follow. Clay minerals in Nakdong river lower basin are classified into Kaolinite and Illite. Water content($W_n$) is similarly distributed in a range of 50.4% to 92.8% in Noksan and 46.6% to 99.0% in Jangyu, and liquid limit(LL) of both areas appears lower than water content. In the case of compression index, the index of jangyu is a little higher than that of Noksan because Jangyu is in a range of 0.67 to 1.94 and Noksan in a range of 0.44 to 1.5. The second compression index of Jangyu in a range of 0.027 to 0.092 is also higher than Noksan in a range of 0.024 to 0.075. As a result of regression analysis, a relation between water content and compression index is linear, and between initial void ratio and compression index is shown to $C_c=0.80e_o-0.58$. The ratio of $C_{\alpha}/C_c$ in a range of 0.03 to 0.08 expresses a wide range.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.12 no.3
• /
• pp.101-109
• /
• 2008

Many researchers have reported that adding steel fiber to concrete improved its tensile and flexural strength significantly, but relatively few studies have been made on the compressive behavior of steel fiber-reinforced concrete. It is still less in case of high strength steel fiber-reinforced cementitious composites(SFRC). The main objective of this research is to examine the effect of adding steel fiber on the compressive strength of high strength SFRC using fiber reinforcing index(RI, $V_f(I_f/d_f)$). It was found from the study that compressive strength was noticeably increased in proportion to RI. In conclusion, the relationship between Reinforcing Index(RI) and compressive strength in case of high strength steel fiber-reinforced cementitious composites was suggested.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.1
• /
• pp.91-99
• /
• 2017

The purpose of this paper is to evaluate the flexural performance of reinforced concrete (RC) beams repaired with polymer mortar. The repaired and non-repaired 13th beams which was fabricated by considering repair position, repair depth, and curing age of polymer mortar as test variables were tested under three point loading. All specimens repaired in compressive and tensile zone did not fail due to interfacial failure between polymer mortar and concrete but failed when the strain of repaired mortar exceeded the ultimate tensile strain of polymer mortar. Maximum load of specimens repaired in compressive zone was similar to that of non-repaired specimen, reference specimen. Additionally, their ductility index was higher than that of reference specimen. On the other hand, specimens repaired in tensile zone failed very brittlely and have a lower ductility index than reference specimen. Nonlinear analysis by using OpenSees was performed to predict the behavior of RC beam repaired with polymer mortar. Two dimension frame element was used to simplify an analysis model and fiber model was applied to consider the material non-linearity. It was confirmed from the analysis results that nonlinear analysis properly predicts the behavior of specimens repaired in compressive zone and overestimates the behavior of specimens repaired in tensile zone.

• Explosives and Blasting
• /
• v.21 no.4
• /
• pp.23-35
• /
• 2003

This study is to clarify the comparative relationship and a mechanical anisotropy of rock on the subject of granite distributed in the Namwon area Uniaxial compressive and Brazilian strengths with respect to the horizontal and vertical axes of granite are shown the linear relation. In the case of the result of the p-wave velocity measurement. it is represented that the velocity of vortical direction is faster about 10 to 15% than other two horizontal directions. The difference between velocities is caused by a developmental pattern of microcracks distributed in rock. Moreover, this result is very consistent with the result investigated through thin sections. The proportion of uniaxial compression strength to Index of point load strength ($Is_{(50)}$) is 18~20 times in case of granite. Uniaxial compressive strength is relatively good relationship with point load strength, Schmidt hammer rebound value, and tensile strength point load strength of them is the best comparative relationship. It is indicated that point load test is the most useful tool to estimate uniaxial compressive strength, comparing with other experimental methods.

• Journal of the Korean Geosynthetics Society
• /
• v.23 no.1
• /
• pp.39-47
• /
• 2024

In this study, physical property tests and standard consolidation tests were conducted on the marine clay of Busan New Port and North Port, the middle and lower reaches of the Nakdong River including Gimhae and Yangsan, and Ulsan regions. The moisture content, a property unrelated to sample disturbance with small individual test errors, was used for regression analysis with the compression index, virgin compression index, consolidation coefficient, expansion index, and secondary compression index, among others. Subsequently, the correlation and accuracy were evaluated. Upon analyzing the correlation between the moisture content, void ratio, and liquid limit commonly used physical properties for calculating compression indexes, it was confirmed that the liquid limit had the lowest correlation. Through a linear regression analysis of the consolidation constants using the current moisture content in the natural state, a high correlation was demonstrated. Relationship equations were then presented to determine settlement and settlement time. This study suggests that moisture content can be utilized as an alternative for evaluating and calculating consolidation constants when examining ground settlement in sedimentary clays distributed in the Busan and Gyeongnam regions.