• Proceedings of the Korea Institutes of Information Security and Cryptology Conference
• /
• 2002.11a
• /
• pp.88-91
• /
• 2002

자기 수축 발생기(self-shrinking generator)는 Meier와 Staffelbach에 의해 제안되었으며[4], 구조가 간단하고 키수열을 생성하는 속도가 빠르기 때문에 스트림 암호시스템으로 각광받고 있다 [5]. 본 논문에서는 자기 수축 발생기의 새로운 구성방법을 제안한다. 제안된 자기 수축 발생기는 하나의 선형귀환회로와 주어진 짝수 m에 의하여 정의되며 일반적으로 선형귀환회로의 귀환다항식으로 원시다항식을 사용한다. 이 경우 키수열은 균형성을 만족하며, 선형귀환회로의 귀환다항식의 차수를 $d_{Y}$ 라고 하면 주기는 $d_{Y-2}$ 이다. m을 $2^{η}$ζ로 표현하면 선형복잡도 Lz는 $d_{Y}$ ＋η-3/$\leq$ $L_{Z}$ $\leq$m/2($d_{Y}$ -1 - ($d_{Y}$ -2))이다. 따라서 제안된 자기 수축 발생기는 기존의 자기 수축 발생기에 비하여 암호학적으로 우수한 성질을 갖는다.다.

• Journal of the Institute of Convergence Signal Processing
• /
• v.8 no.3
• /
• pp.217-221
• /
• 2007

This paper deals with the robust nonlinear controller design using output feedback for a Chua circuit which is one of the well-known nonlinear models. First, an exosystem for reference signal tracking is defined, and error dynamic equations are derived from the differentiation of the output tracking error equation. The normal sliding surface is modified using the integral type servo compensator. The parameters in the equations of the modified sliding surface and servo compensator are determined by using the Hurwitz condition of stability. Especially the error signals can't be obtained directly from the output because all parameters are assumed unknown. So instead, a high gain observer is designed. From this estimated error signals, a stabilizing controller is designed. Simulation is done for demonstrating the effectiveness of the suggested algorithm.

• 전기의세계
• /
• v.14 no.2
• /
• pp.53-55
• /
• 1965

본고의 내용은 다음과 같다. 1. 위상측정에 민감한 교직변환기 2. EHV 개폐시험 및 개폐써어지 3. 선형화에 의한 비선형 귀환계의 설계 4. 초도전재료의 응용에 관한 검토

• Journal of Ocean Engineering and Technology
• /
• v.14 no.2
• /
• pp.7-12
• /
• 2000

This paper presents a non-regressor based adaptive control scheme for the trajectory tracking of underwater vehicle-mounted manipulator systems(UVMS). The adaptive control system includes a class of unmodeled effects is applied to the trajectory control of an UVMS. The only information required to implement this scheme ios the upper bound and lowe bound of the system parameter matrices the upper bound of unmodeled effects the number of joints the position and attitude of the vehicle and trajectory commands. The adaptive control law estimates control gains defined by the combinations of the bounded constants of system parameter matrices and of a filtered error equation. To evaluate the performance of the non-regressor based adaptive controller computer simulation was performed with a two-link planar robot model mounted on an underwater vehicle. The hydrodynamic effects acting on the manipulator are included. It is assumed that the vehicle's motion is slow and can be predicted with a proper compensator.

• Journal of the Institute of Convergence Signal Processing
• /
• v.3 no.1
• /
• pp.67-73
• /
• 2002

This paper presents a new design method of optimal continuous deadbeat controller by using second-order smoothing elements. The continuous deadbeat controller is made of a serial integral compensator and a local feedback compensator introduced into the state feedback loop. The decision method of the damping factor and the natural angular frequency of the smoothing element is described. A numerical example is given to show how well input-output characteristics are improved. Especially according to the variable input and disturbance, corresponding CDBC design method is suggested. By computer simulations, control inputs and system outputs are shown to have desirable property such as smoothness.

• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.531-542
• /
• 2002

An input and output buffering ATM switch conventionally operates in either Queueloss mode or Backpressure mode. Recently, a new mode, which is called Hybrid mode, was proposed to overcome the drawbacks of Queueloss mode and Backpressure mode. In Hybrid mode, when both the destined output buffer and the originfted input buffer are full, a cell is dropped. This thesis analyzes the cell loss rate and the cell delay of Queueloss, Backpressure and Hybrid modes in a switch adopting output-port expansion scheme under uniform traffic. Output-port expansion scheme allows only one cell from an input buffer to be switched during one time slot. If several cells switch to a same destined output port, the number of maximum transfer cells is restricted to K (Output-port expansion ratio). The simulation results show that if an offered load is less than 0.9, Hybrid mode has lower cell loss rate than the other modes; otherwise, Queueloss mode illustrates the lowest cell loss rate, which is a different result from previous researches. However, the difference between Hybrid and Queueloss modes is comparably small. As expected, the average cell delay in Backpressure mode is lower than those of Queueloss mode and Hybrid mode, since the cell delay due to the retransmission of higher number of dropped cells in Backpressure mode is not considered.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.5
• /
• pp.1-8
• /
• 2013

This paper presents a variable gain amplifier(VGA) without passive devices. This VGA employes the architecture of current feedback amplifier and variable gain can be achieved by using the GM ratios of two trans-conductance(gm) circuits. To obtain linearity and high gain, it uses current division technique and source degeneration in feedback GM circuits. Input trans-conductance(GM) circuit was biased by using a tunable voltage controller to obtain variable gain. The prototype of the VGA is designed in $0.35{\mu}m$ CMOS technology and it is operating in sub-threshold region for low power consumption. The the gain of proposed VGA is varied from 23dB to 43dB, and current consumption is $2.82{\mu}A{\sim}3{\mu}A$ at 3.3V. The area of VGA is 1$120{\mu}m{\times}100{\mu}m$.

• Korean Journal of Optics and Photonics
• /
• v.8 no.4
• /
• pp.320-326
• /
• 1997

Broadband sources for fiber-optic gyroscope were constructed using erbium-doped fibers. Output power, linewidth, and mean wavelength were compared between four different source configurations. Among them, double pass configuration exhibited the highest output power, as high as 5.5 mW with 25 mW pumping at 1.48 ${\mu}{\textrm}{m}$ wavelength. It also showed nearly zero sensitivity of mean wavelength for the variation of pump power when a sufficient pumping was provided. Amplifier/Source configuration resulted in the highest detected power(power received by the gyro detector) that is more than 100 times larger than those of the other configurations, though it was the lowest of source output power. As the feedback level increased, the source power decreased while the linewidth increased, and mean wavelength varied significantly which would affect the scale factor of the gyroscope.

• Journal of Korea Society of Industrial Information Systems
• /
• v.5 no.1
• /
• pp.31-36
• /
• 2000

This paper presents a design method of deadbeat controller for DC motor driving a rotational system with gear. The deadbeat-response design developed for control system of a sampled continuous-data process does not guarantee zero intersampling ripples, but the proposed deadbeat control system that consists of the integral controller and the full-order state observer, and zero-order hold using in continuous systems, has many advantages such as an output response without the ripples and reaching the steady state without error after a given sampling period and faster settling time than the optimal control system in the same sampling period. The results of a case study through matlab simulation are shown that the efficiency of the proposed controller for DC motor driving a rotational system with gear is verified by comparing with optimal controller etc.

• Journal of KIISE:Software and Applications
• /
• v.29 no.7
• /
• pp.425-435
• /
• 2002

This paper introduces a macroblock-based rate control algorithm using the neural classifier based in Self Organization feature Maps (SOFM). In contrast to the conventional rate control methods based on the mathematical rate distortion (RD) model and the feedback regression, proposed method can actively adapt to the rapid-varying image characteristics by establishing the global model for bitrate control and by using the SOFM based neural classifier to manage that model. Proposed rate control algorithm has 0.2 dB ~ 0.6 dB better performances than MPEG-4 macroblock-based rate control algorithm by evaluating with the encoded Peak Signal to Noise Ratios while maintaining similar overall computational complexity.