• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.14 no.10
• /
• pp.825-832
• /
• 2002

The present study investigated the enhancement of the absorption performance by the spring wrapped around the outer surface of the vertical falling film absorber tube. Heat and mass transfer enhancements were experimentally investigated, and flow visualization was performed to observe the wettability and flow pattern of the solution. The key experimental parameters were spring diameter (0.5, 1.0 mm) and spring pitch (1, 3, 10 mm), film Reynolds number (50~150), and concentration of LiBr-$H_2O$ solution (55, 60, 65 wt%). As the spring diameter was increased, the absorption mass flux, Sherwood number, Nusselt number, heat flux, and heat transfer coefficient were increased The Nusselt and Sherwood numbers showed the maximum at the spring pitch of 3mm, and the ratio of pitch to diameter of approximately 3 and 6 for the spring diamter of 0.5 mm, respectively.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.13 no.9
• /
• pp.860-867
• /
• 2001

Absorption of water vapor into LiBr-$H_2O$ O solution flowing over a finned inclined surface is numerically investigated. The momentum, energy, and diffusion equation are numerically solved using a finite difference method. The four different shapes of the wall surfaces are considered to find the best surface for absorption assuming that the wall temperature and the surface tension are constant. The effects of the fin interval and Reynolds number are investigated. Based on the numerical results, it is known that the parabolic surface shows better absorption performance than the other surfaces, and that water vapor absorption increases gradually with decreasing the fin interval.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.3
• /
• pp.422-430
• /
• 1999

This paper concerns the study of a two-stage absorption heat pump cycle to utilize treated sewage. This two-stage cycle consists of coupling double-effect with parallel or series flow type and single effect cycle so that the first stage absorber and condenser produces hot water to evaporate refrigerant in the evaporator of the second stage. The effects of operating variables such as absorber temperature on the coefficient of performance have been studied for two-stage absorption heat pump cycle. The working fluid is lithium bromide and water solution. The efficiency of the two-stage absorption heat pump cycle has been studied and simulation results show that higher coefficient of performance could be obtained for the first stage with parallel flow type. The optimum ratio of solution distribution can be shown by considering the COP, the crystallization of solution and the generator temperature.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.21 no.12
• /
• pp.695-702
• /
• 2009

Dynamic behavior of Libr-water absorption system using low-temperature hot water was investigated numerically. Thermal-hydraulic model of single-effect/double-lift 100 RT chiller was developed by applying transient conservation equations of total mass, Libr mass, energy and momentum to each component. Transient variations of system properties and transport variables were analysed during start-up operation. Numerical analysis were performed to quantify the effects of bulk concentration and part-load operation on the system performance in terms of cooling capacity, coefficient of performance, and time constant of system. For an absorption chiller considered in the present study, optimum bulk concentration was found to exist, which resulted in the minimum time constant with stable cooling capacity. COP and time constant increased as the load decreased down to 40%, below which the time constant increased abruptly and COP decreased as the load decreased further.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.9
• /
• pp.1267-1276
• /
• 1998

Falling-film evaporation experiments with aqueous lithium bromide (LiBr) solution were performed to investigate the heat transfer characteristics of enhanced copper tubes. Enhanced tubes (a knurled tube, a spirally grooved tube, and a tube coated with $20{\mu}m$ aluminum particles) and a bare tube were selected as test specimens. Averaged evaporation fluxes of water were obtained from horizontal tubes with various film Reynolds numbers, system pressures, LiBr concentrations and degrees of wall superheat. The enhanced performance of steam generation was compared between tubes with varying parameters. The knurled tube geometry showed the most excellent performance among the tubes tested. The specified enhanced tubes were more useful for generating steam on a low grade heat source such as waste heat.

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.534-539
• /
• 2007

The objectives of the present work is to investigate the influence of the solution cooled absorber(SCA), refrigerant drain heat exchanger(RSX), exhaust gas/solution heat exchanger(ESX) and high efficiency solution heat exchanger on COP for a double-effect series-flow absorption chiller. A simulation program has been prepared for the cycle analysis of absorption chillers. As a result, Solution heat exchangers(LSX, HSX) are a most effective element for the COP than the others. In spite of the poor contribution to COP, SCA make a rule to reduce the crystallization phenomena of LiBr solution at solution heat exchanger. And the optimum solution split ratio are varied with the relative size of RSX and LSX.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.13 no.12
• /
• pp.1214-1222
• /
• 2001

The present study investigated the effect of diameter and length on the absorption performance of a vertical falling film type absorber using $LiBr-H_2$O solution of 60 wt%. The parameters were diameter of absorber (17.2, 23.4, 31.1 mm), length of absorber (771, 1150, 1528 mm), and film Reynolds numbers (50, 70, 90, 110, 130, 150). As the diameter of the absorber was increased, the absorption mass flux, Sherwood number, heat flux, and heat transfer coefficient were increased, in which Sherwood number and heat transfer coefficient were increased up to 13% and 30% respectively. As the length of the absorber was increased, the total absorption rate and heat transfer coefficient were increased by 37% and 35% respectively, while the absorption mass flux was decreased.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.12 no.2
• /
• pp.218-225
• /
• 2000

In the present study, the effects of film Reynolds number (60∼200) and volumetric content of non-absorbable gases (0∼10%) in water vapor on the absorption process of aqueous LiBr solution were investigated experimentally. The formation of solution film on the horizontal tubes of six rows were observed to be complete for Re>100. Transition film Reynolds number were found to exist above which the Nusselt number and Schmidt number diminishes with solution flow rate. As the concentration of non-absorbable gases increased, mass transfer rate decreased more seriously than heat transfer rate did. The degradation effects of non-absorbable gases seemed to be significant especially when small amount of non-absorbable gases were introduced to the pure water vapor.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2011.11a
• /
• pp.1512-1515
• /
• 2011

과거에는 책이나 브로마이드 형식의 학습 자료를 이용하여 유아들에게 수에 대해 가르쳤다면 휴대폰이나 스마트폰 등 휴대용 기기를 좋아하는 유아에게는 애플리케이션을 이용하는 것이 더욱 효과적이다. 이에 본 논문에서는 스마트폰을 이용하여 유아들을 대상으로 하는 수 개념 학습 애플리케이션을 설계 및 구현하였다. 수에 대해 알지 못하는 유아를 대상으로 유아가 좋아하는 색깔과 그림을 이용하여 1에서 10까지의 수에 대한 개념들을 학습할 수 있도록 콘텐츠를 제공한다. 또한 학습한 1에서 10까지의 수들의 원리를 이해하고 학습한 수들을 조합하여 활용할 수 있도록 애플리케이션을 구성하였다.

• Journal of Environmental Health Sciences
• /
• v.45 no.6
• /
• pp.675-687
• /
• 2019

Objective: Methyl bromide (MB) fumigant has been shown to be fatal to human when was exposed. However, it were still used the significant amount in quarantine disinfection sites. The purposes of this study were to assess the MB exposure status and characteristics by fumigation-related workers and to provide supporting data for management plan. Methods: For this study, the three groups related to fumigation work were composed. A total of 107 workers were directly exposed, 20 field inspectors were indirect, and 20 general quarantines were not exposed. The urinary bromide ion concentrations in each group were analyzed by using HPLC/ICP-MS, and the working characteristics were identified using the structured questionnaire. Results: The urinary bromide ion concentration in the exposed group of fumigation workers was higher than the indirect and non-exposed groups. In the work characteristics of workers, there was a significant tendency to increase urinary bromide ion concentrations with higher fumigation work years (≤4 years: 2.84 (1.13-7.11) mg/g cr, >4-15 years: 5.36 (4.37-6.57) mg/g cr, >15-37 years: 6.69 (5.27-8.49) mg/g cr, p=0.034). In the comparison of the average number of working days per month, the more working days, the higher the urinary bromide ion concentration was statistically significant (≤12.5 days: 2.59 (1.19-5.65) mg/g cr, >12.5-19.25 days: 5.46 (4.62-6.44) mg/g cr, >19.25-27.25 days: 7.93 (5.93-10.59) mg/g cr, p=0.002). Conclusion: This study was the first nationwide survey including biological monitoring in workers exposed to methyl bromide. The results of this study were expected to be used as a reference for workers' health rights in relation to fumigation, prevention of addiction accidents, and safe management plan.