• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2007.04a
• /
• pp.161-162
• /
• 2007

(1-102) R-면 사파이어 기판 위에 플라즈마 분자선 에피탁시 법으로 성장시킨 비극성 ZnO 박막의 표면 형상을 원자력간현미경(AFM) 및 투과전자현미경으로 분석하였다. AFM 관찰 결과 ZnO<0001> 방향으로 길쭉한 제방 모양의 표면 형상이 나타남을 알 수 있었고, 고분해능 투과전자현미경 관찰을 통해 박막 성장 중에 관찰되는 V(chevron 모양) 형상의 in-situ RHEED 패턴을 야기시키는 박막 표면의 facet 면을 원자 level에서 확인하였다.

• Journal of the Korean Vacuum Society
• /
• v.12 no.4
• /
• pp.251-256
• /
• 2003

Indium aluminum arsenide(InAlAs) was grown by molecular beam epitaxy on (001) indium phosphide (InP) substrate and the effects of growth temperature on the properties of epitaxial layers were studied. In the temperature range of 370-$400 ^{\circ}C$, we observed that the surface morphology, optical quality and structural quality of InAlAs epilayers were improved as growth temperature increased. However, the InAlAs epilavers grown at $430 ^{\circ}C$ have the bad surface morphology and show the same trends as structural and epical quality. As a result of these measurements, it is suggested that the InAlAs epilayers of very good properties can be grown at $400 ^{\circ}C$.

• 한국전자현미경학회:학술대회논문집
• /
• 2005.11a
• /
• pp.85-88
• /
• 2005

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.1
• /
• pp.7-13
• /
• 2010

We have investigated effects of the rapid thermal annealing of GaN epilayers by molecular beam epitaxy in nitrogen atmosphere. The improvement of structural properties of the samples was observed after rapid thermal annealing under optimum conditions. This improvement in crystal quality is due to a reduction of the spread in the lattice parameter in epilayers. The annealing has been performed in a rapid thermal annealing furnace at $950^{\circ}C$. The effect of rapid thermal annealing on the structural properties of GaN was studied by x-ray diffraction. The Bragg peak shifts toward larger angle as the annealing time increases. As the thermal treatment time increases, FWHM(full width at half maximum) of the peak slightly increase with its decreases followed and it increases again. Results demonstrate that rapid thermal annealing did not always promote qualities of GaN epilayers. However, rapid thermal annealing under optimum conditions improve structural properties of the samples, elevating their crystal quality with a reduction of inaccuracy in the lattice parameter of the epilayers.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.5
• /
• pp.80-86
• /
• 1998

Material characterizations were performed for In$_{0.53}Ga_{0.47}As/In$_{0.52}Al_{0.48}$/As MQWs grown on InP substrates by low-temperature modlecular beam epitaxy. MQW samples were grwon at different temperatures of 200.deg.C, 300.deg. C and 500.deg. C, and doped with 10$^{18}$ cm$^{3}$ Be. High resolution x-ray diffraction measurement showed the change in crystal qualities according to growth temperature. Hall measurement showed the changes in carrier concentrations and mobilities for different growth temperatures. The optical properties of MQW samples were investigated with photoluminescence and fourier-transform infrared spectroscopy measurements.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2006.06a
• /
• pp.289-290
• /
• 2006

We report a study of Zn(S)Se/GaAs heterojunction solar cells grown by molecular beam epitaxy (MBE). Zn(S)Se/GaAs heterostructures prepared under different conditions were characterized in-situ by reflection high-energy electron diffraction (RHEED). Structural and electrical properties were investigated with double crystal X-ray diffraction and current-voltage characteristics, respectively. The fabricated $n-ZnS_{0.07}Se_{0.93}/p-GaAs$ solar cell (SC #2) exhibited open circuit voltage($V_{oc}$) of 0.37 V, short circuit current($I_{sc}$) of $1.7{\times}10^{-2}$ mA, fill factor of 0.62 and conversion efficiency of 7.8 % under 38.5 $mW/cm^2$ illumination.

• Korean Journal of Materials Research
• /
• v.12 no.3
• /
• pp.195-199
• /
• 2002

Planar Hall effect of ferromagnetic GaMnAs thin films was investigated for the first time. The films were grown in an optimized growth condition via molecular beam epitaxy at low temperatures. For the optimization of the growth conditions, we used reflection high-energy electron diffraction, electrical conductivity, double crystal x-ray diffraction, and superconducting quantum interference device measurements techniques. We observed that the difference between the longitudinal resistance and the transverse resistance matches the planar Hall resistance. The ratio of the planar Hall resistance at saturation magnetic field to that at zero reached above 500%.

• Korean Journal of Materials Research
• /
• v.12 no.5
• /
• pp.387-390
• /
• 2002

A new approach of using double buffer layers of AlN and GaN for growth of GaN films on Si has been undertaken via molecular beam epitaxy using ammonia. The first buffers layer of AlN was grown using $N_2$plasma and the second of GaN was grown using ammonia. The surface roughness of the grown films was investigated by atomic force microscope and was compared with the normally grown films on sapphire. Double crystal x-ray rocking curve and low temperature photoluminescence techniques were employed for structural and optical properties examination. Donor bound exciton peak at 3.481 eV with full width half maximum of 41 meV was observed at 13K.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.468-472
• /
• 1997

The effect of the surface state on the quantum efficiency of underlying GaAs/AlGaAs multi-quantum well(MQW) structures consisting of three GaAs quantum wells with different thickness, is studied by low temperature photoluminescence(PL). The structure was grown by molecular beam epitaxy(MBE) on (100) GaAs substrate. The thickness of three GaAs quantum wells was 3, 6 and 9 nm, respectively. The MQWs were placed apart from 50 nm AlGaAs edge-barriers including two inner-barriers with 15 nm in thickness. The samples used in this study were prepared with different growth temperatures. Particularly, the hydrogen passivation effect to the 9 nm quantum well located at near surface appeared much stronger than any others. Transition energy and optical gain related to the hydrogen passivation effects on the multi-quantum well structure was calculated by transfer matrix method.

• Journal of the Korean Vacuum Society
• /
• v.15 no.3
• /
• pp.280-286
• /
• 2006

A distributed Bragg reflector (DBR) for the application of $1.3{\mu}m$ vertical cavity surface emitting laser (VCSEL) has grown by digital-alloy AlGaAs layer using the molecular beam epitaxy (MBE) method. The measured reflection spectra of the digital-alloy AlGaAs/GaAs DBR have uniformity in 0.35% over the 1/4 of 3-inch wafer. Furthermore, the TEM image showed that the composition and the thickness of the digital-alloy AlGaAs layer in AlGaAs/GaAs DBR was not affected by the temperature distribution over the wafer whole surface. Therefore, the digital-alloy AlGaAs/GaAs DBR can be used to get higher yield of VCSEL with the active medium of InAs quantum dots whose gain is inhomogeneously broadened.