• KIEAE Journal
• /
• v.9 no.4
• /
• pp.17-22
• /
• 2009

It is common to design the duct branches where to supply the required air flow for individual room in residential apartment house. However it is difficult to adjust the air volume adequately in small air duct branches in residential ventilation system. The purpose of this study is to figure out the performance of Multidrop chamber coupling system for the residential ventilation system. The experiments were designed to simulate apartment of $84m^2$ and established multidrop chamber duct and general duct on the ceiling of the apartment. Distribution performance of air supply rate were evaluated in this experiments. As a result, distribution performance of air supply rate in the general duct is different from designed air supply rate by about 35% ~ 50% and about 10% in the multidrop chamber system. In additional the sound insulation performance of the multidrop chamber system decreased about 20% compared with general duct system. Therefore, the multidrop chamber system is considered to satisfy proper air supply rate of each room and to improve the sound insulation performance in apartment Houses.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.3
• /
• pp.451-456
• /
• 2020

In this paper, we studied the method of designing a embedded antenna for mounting on the JTDLS complete aircraft. The proposed antenna satisfies the MIDS-LVT operation frequency band and is designed as a broadband in consideration of expandability. As a result of the design, it was confirmed that the proposed antenna has similar electrical performance to the existing blade antenna and has broadband characteristics. As a result of EM analysis, the antenna was mounted on the top and bottom parts of the aircraft to check the mount of the aircraft, and it was confirmed that both the top and bottom parts had good radiation characteristics. The technology acquired through this study is judged to be applicable to the JTDLS completed aircraft.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.2
• /
• pp.355-361
• /
• 2009

This paper proposes a new basic unit level rate control algorithm which generates the output bits corresponding to the target bits. The H.264 standard uses various coding modes and optimization methods to improve the compression performance, which makes it difficult to control the generated traffic accurately. In the proposed scheme, the allocated bits to a frame are distributed to all basic units properly to encode each basic unit according to the bit budget. After encoding the frame, the encoding parameters are adjusted according to the difference between the target and the resulting values. It is shown by experimental results that the new algorithm can generate output bit rates accurately corresponding to the target bit rates with the PSNR performance better than that of the existing rate control algorithm.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.649-652
• /
• 2015

Previous marking policy for the AF service of TCP traffic in the Diffserv network have no sufficient consideration on the effect of RTT and target rate. In this paper, in order to improve fairness Index by the effect RTT difference of TCP traffic, we propose the modified TSW3CDM(Time Sliding Window Three Color Dynamic Marker) based on average transfer rate estimation and the flow state. The proposed algorithm is dynamic marking policy that do allocate band width in proportion to transmission rate. To evaluate the performance of the proposed algorithm, We accomplished a computer simulation using NS-2. From simulation results, the proposed TSW3CDM algorithm improves fairness index by comparison with TSW3CM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.2B
• /
• pp.145-150
• /
• 2002

This paper presents an implementation methodology of unified PCS base station system which, is capable of providing PCS services for 3 PCS carriers concurrently. We have built up an unified PCS BTS using a unification module, which is consisted of a multi-channel combiner, duplexer, LNA, power divider, feeder line, and a common set of antennas. PCS unification module is featured with wide-band and high power handling capability and electrical characteristics like insertion loss, isolation have been greatly improved. It was shown that performance of the system in terms of Ec/Io and mobile receive power within the total 30MHz PCS frequency range is uniformly acceptable and measured signal quality and coverage are equivalent to that of the individual PCS base station.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.7 no.4
• /
• pp.19-26
• /
• 2003

In this paper, the result of the conceptual study of a tipjet driven propulsion system is presented. The concept of a tipjet driven propulsion system is to employ tipjet as power source to drive a rotor Because the vehicle is supposed to takeoff and land vertically, a rotor system, which has tipjet nozzles, is adopted to fly like a helicopter. Exhaust gas, which is generated by an engine, Passes through an internal duct system and divided into four blade ducts. The design code is consists of two parts, engine model and internal duct model. Inside a rotating duct, compressible flow is affected by two additional force terms, centrifugal force and coriolis force and they govern the performance in rotary mode, The intention of this paper is to address the issues associated with sizing and optimizing configurations of a tipjet driven propulsion system especially in rotary wing mode.

• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.446-452
• /
• 2020

In this paper, we propose a energy-saving LED module using K-band microwave motion detecting sensor. To oscillate K-band microwave signal, An oscillator using a hairpin-type microstrip resonator was designed to increase stability and make fabrication easier. To radiate the microwave signal, a two-channel(TX/RX) patch antenna arrays was developed. Wilkinson power divider and ring hybrid mixer were developed and applied to obtain Doppler shift from the received signal. Shield cans were installed to protect the stability of the signals and unwanted external noise. The proposed motion detection sensor was mounted on a demonstration LED module and the energy saving performance through pre-test was verified.

• Proceedings of the SAREK Conference
• /
• 2009.06a
• /
• pp.1055-1060
• /
• 2009

Noise is one of the major environmental problems in human life. But hot water distributers with the flow rate control valve bring about often noise according to the heating control condition in residential buildings. The sound power level increased as the flow rate and pressure difference increased. And thus, experimental analyses for the flow rate control and the pressure difference control were carried out in this study to reduce the noise emitted from the flow rate control valve. As the results, the flow rate control method using a SMA(Shape Memory Alloy)-valve and the flow rate control system using a pressure difference sensor can be expected to control noise in the region of below 50 dB of sound power level.

• The KIPS Transactions:PartC
• /
• v.9C no.4
• /
• pp.523-530
• /
• 2002

Earlier efforts on optical access concentrated on the design of PONs for the collection and distribution portion of the access network. PON architecture is very simple but it requires MAC protocol for control of upstream traffic. This paper proposes a MAC protocol for a broadband access network using an ATM Passive Optical Network supporting CBR/rtYBR, nrtYBR, UBR and ABR traffic. For the proposed MAC scheme, we present grant field format, minislot format, and bandwidth allocation algorithm. From the simulation result, we have confirmed that our proposed scheme can reduce the average cell delay in comparison to that of conventional MAC schemes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.4A
• /
• pp.344-350
• /
• 2007

Start after striking space key 2 times. Lately, a lot of researches have been done on the resource allocation for multiuser OFDM(Orthogonal Frequency Division Multiplexing) systems due to its spectral efficiency for high-rate multimedia data services. For multimedia services in which every user is guaranteed to have minimum required bit rate and bit error probability, it is critical to utilize the limited resources efficiently to improve the performance of the system. The introduced allocation method improves spectral efficiency to use the left subcarriers in Zhang's algorithm. By using this method, the system can provide services to more users constantly, except for a bit increasing complexity and memory for deciding the left subcarriers and reallocating the subcarriers.