• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.7
• /
• pp.68-73
• /
• 2009

This paper describes design and implementation of a spread spectrum clock generator (SSCG) for the DisplayPort. The proposed architecture generates the spread spectrum clock using a sigma-delta fractional-N PLL. The SSCG uses a digital End order MASH 1-1 sigma-delta modulator and a 9bit Up/Dn counter. By using MASH 1-1 sigma-delta modulator, complexity of circuit and chip area can be reduced. The advantage of sigma-delta modulator is the better control over modulation frequency and spread ratio. The SSCG generates dual clock rates which are 270MHz and 162MHz with 0.25% down-spreading and triangular waveform frequency modulation of 33kHz. The peak power reduction is 11.1dBm at 270MHz. The circuit has been designed and fabricated using in 0.18$\mu$m CMOS technology. The chip occupies 0.620mm$\times$0.780mm. The measurement results show that the fabricated chip satisfies the DispalyPort standard.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1096-1103
• /
• 2008

This paper proposes an individual order predistortion linearizer using intermodulation distortion(IMD) generator for cancellation the third and the fifth IMD of power amplifier. The IMD generator for controlling the third and the fifth IMD consist of common Emitter amplifier and Schottky diode. These signals are generated by series feedback of Schottky diode to obtain the inverse AM/AM and AM/PM characteristics of power amplifier. The individual order predistorters are consisted of individual IMD generator, power splitter and combiner. The test results show that the third and the fifth IMD can be improved by a maximum 13.5 dB and 0.9 dB in case of CW 2-tone signals. Also, the Adjacent Channel Leakage Ratio(ACLR) can be improved 2.3 dB, 2.5 dB at ${\pm}0.885$ MHz, ${\pm}1.23$ MHz offset frequency for CD-MA IS-95 2FA signals.

• Journal of Satellite, Information and Communications
• /
• v.4 no.2
• /
• pp.34-38
• /
• 2009

This paper is related with optimum burst structure design for high efficient TDMA satellite return link transmission. In general, some typical burst structure for data transmission is composed of a pair of preamble and traffic data in the DVB-RCS (Digital Video Broadcasting. Return Channel via Satellite) and IPOS (IP over Satellite) standard. This structure has some difficulties to increase spectral efficiency that it requires a large of preamble length, high SNR environment, or receiver complexity. To cope with them, burst structure with distributed pilot symbol can be used to alleviate the residual frequency offset effect by calculating accurate frequency offset than conventional one. In particular, we investigate some relevant to proposed distributed pilot structure, previously and analyze their strong points/drawbacks in terms of synchronization to draw the most appropriate one.

• The Journal of the Convergence on Culture Technology
• /
• v.9 no.6
• /
• pp.1103-1109
• /
• 2023

Today, as the number of audio files submitted as legal evidence increases with the proliferation of smartphones, the integrity of audio files has become an important issue. Accordingly, the purpose of this study is to explore whether the metadata and file structure of audio files recorded on Samsung smartphones can be manipulated to be identical to the original. This study was based on Samsung smartphones, the most widely used in Korea, and conducted experiments on the built-in voice recording app and the 'Easy Voice Recorder' app, which is the most popular recording app. Through the experiments of this study, it was proven that the metadata and file structure of audio files can be manipulated. Therefore, this study reveals that metadata and file structure analysis have limitations in proving the integrity when audio files are analyzed for adoption as legal evidence. They also argue for the need to develop new voice file forgery technology that does not rely on metadata and file structure analysis.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.7
• /
• pp.39-46
• /
• 2016

This paper describes the third order feedforward delta-sigma modulator with inverter-based integrators and a 1.5bit comparator for the application of audio signal processing. The proposed 3rd-order delta-sigma modulator is multi-bit structure using 1.5 bit comparator instead of operational amplifier. This delta-sigma modulator has high SNR compared with single-bit 4th-order delta-sigma modulator in a low OSR. And it minimizes power consumes and simplified circuit structure using inverter-based integrator and using inverter-based integrator as analogue adder. The modulator was designed with 0.18um CMOS standard process and total chip area is $0.36mm^2$. The measured power cosumption is 28.8uW in a 0.8V analog supply and 66.6uW in a 1.8V digital supply. The measurement result shows that the peak SNDR of 80.7 dB, the ENOB of 13.1bit and the dynamic range of 86.1 dB with an input signal frequency of 2.5kHz, a sampling frequency of 2.56MHz and an oversampling rate of 64. The FOM (Walden) from the measurement result is 269 fJ/step, FOM (Schreier) was calculated as 169.3 dB.

• Journal of IKEEE
• /
• v.15 no.1
• /
• pp.23-28
• /
• 2011

This paper describes design and implementation of a spread spectrum clock generator(SSCG). The proposed architecture generates the spread spectrum clock controlling a input voltage signal for VCDL(Voltage Controlled Delay Line). Spread charge pump is controlled by the SSC modulation logic block provides a control signal to VCDL through LPF in DLL. By using this architecture, chip area and power consumption can be reduced because it is not necessary additional circuit to control modulation rate. This circuit has been designed and fabricated using the UMC 0.25um CMOS technology. The chip occupies an area of 290${\times}$120um^2.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.2
• /
• pp.371-380
• /
• 1997

A lot of efforts have been made to develop low-cost and reliable broadband optical subscriber loop systems. Here we propose a new loop system with shared ligh sources and remote modulation method. This system uses an external modulation method for both directions and all the light sources are maintained inside a central office. Moreover, the ligh source is not dedicated to each subsriber link but shared among many subscriber links. We expermentally demonstrated that one shared light source could accommodate about 2, 000 deownstream links(2.5 Gb/s per link), 500 upstream links(155 Mb/s per link).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.11
• /
• pp.1201-1207
• /
• 2010

As the mobile services have been increased, the PIMD(Passive Inter-Modulation Distortion) as well as the active-IMD of the CDMA system should be considered for the design of base station antenna systems, because they have an interference of the neighboring base stations. In this paper, in order to reduce the nonlinearity of current caused by the local point contact, we have investigated an influence of the combination of nuts, contact torque(kgf.cm), and the contact area on the PIMD. We propose the improvement techniques of PIMD by investigating the effects of the distance of nuts, the contact area, and the type of nuts.

• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.579-585
• /
• 2020

In this study, we used byte-inversion transmission method to prevent the flicker of lighting source in a visible light data communication link. In the transmitter, the non-return-to-zero (NRZ) signal with 9.6 kbps was on-off keying (OOK) modulated with a 100 kHz square wave carrier and byte-inversion signal was added after each byte to make the average optical power of the light-emitting diode (LED) constant. In the receiver, we used a band-pass filter to eliminate the interference of the 120 Hz noise which was induced from the adjacent light lamps, and an OOK demodulator to recover the original NRZ signal This scheme is useful in constructing wireless data networks using the illumination of visible light lamps.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.12
• /
• pp.1765-1767
• /
• 2016

Non-coherent UWB receivers are promising due to the low hardware complexity while the coherent receiver such as the rake receiver requires the complex hardware to estimate channel characteristics and get the synchronization. In this letter, the block coded modulation scheme as one of the most promising method is enhanced in terms of the performance. The performance enhancement is carried out by the modification of the block structure with unequal frame length for each pulse. Simulation results show that the proposed method has the performance enhancement by the transmission rate or bit error rate.