• Proceedings of the Optical Society of Korea Conference
• /
• 2004.02a
• /
• pp.152-153
• /
• 2004

• Proceedings of the Optical Society of Korea Conference
• /
• 2006.07a
• /
• pp.23-24
• /
• 2006

• Korean Journal of Optics and Photonics
• /
• v.16 no.1
• /
• pp.13-20
• /
• 2005

Fiber-Bragg-grating external cavity laser(FGL) modules were fabricated and experimentally analyzed. Proposed as a cost-effective solution for optical sources in the WDM-PON access network, FGL modules were packaged to TO-CAN type. We obtained a low threshold current of 13 mA, and an optical output power of 3.6 mW with a bias current of 60 mA at $25^{\circ}C$. The lasing wavelength dependencies on current and temperature were as small as 5.2 pm/mA and 30 pm/$^{\circ}C$, respectively. These change rates of the wavelength with the temperature and current are smaller than those of the DFB laser. Single-mode oscillations with the side-mode suppression ratio(SMSR) over 30 dB are maintained above the threshold current level. The FGL modules can be directly modulated at 155 Mbps, PRBS(2$^{23}$ -1) NRZ signal. Through the BER plots, we did not see the significant degradations before and after the transmission over 20km of the SMF at 155 Mb/s.

• Korean Journal of Optics and Photonics
• /
• v.11 no.6
• /
• pp.429-433
• /
• 2000

A study of the tunable fiber DFB laser using PZT-stretcher is presented. The device has an laser ocsillator by using a fiber Bragg grating at 1559.4 nm written directly into a 3-cm long $Er^{3+}$ doped fiber. Post UV-exposure method to provide the necessary phase shift is used for a single mode operation. The device shows the single mode operation of $230\muW$ output power and has a narrow linewidth of 35 kHz. The lasing wavelength of the laser can be tuned in a range of 3 nm by stretching the grating.rating.

• Journal of Software Assessment and Valuation
• /
• v.16 no.1
• /
• pp.55-63
• /
• 2020

Lasers for optical broadband communication systems should have excellent frequency selectivity and modal stability. DFB lasers have low lasing frequency shift during high speed current modulation. In this paper, when a refractive index grating and a gain grating are simultaneously present in a DFB laser having a wavelength of 1.55 ㎛, the dielectric film is coated so that reflection does not occur on the right mirror surface, so that ρ_r=0. For the first mode, which requires a minimum gain at the threshold, the beam distribution of the oscillation mode in the longitudinal direction and the radiated power ratio P_l/P_r were analyzed and compared for the cases of the phase of ρ_l=π and π/2. If the phase of ρ_l=π, in order to obtain a low threshold current and high frequency stability, κL should be greater than 8. In the case of the phase of ρ_l=π/2, for low threshold current, κL is necessary to be 1.0, where the oscillation frequency coincides with the lattice frequency. DFB lasers with an anti-reflection coated mirror have excellent mode selectivity than 1.55um DFB lasers with two mirror facets

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.455-460
• /
• 2004

We have developed a mode-locked ultra-short pulse C $r^{4+}$:YAG laser, as well as a continuous wave C $r^{4+}$:YAG laser. The laser was pumped by a Nd:YAG laser and its characteristics were investigated. In continuous wave mode, we obtained as much as 600 mW at 1.436 ${\mu}{\textrm}{m}$ with pumping power of 6 W, by using an output coupler with a reflectivity of 98%. The power slope efficiency was 10%, when the gain medium was cooled to 19$^{\circ}C$. The tuning range was varied from 1.39 ${\mu}{\textrm}{m}$ to 1.55 ${\mu}{\textrm}{m}$ and the maximum power was 400 mW at 1.492 ${\mu}{\textrm}{m}$ with a 3-plate birefringent filter. The C $r^{4+}$:YAG laser was mode-locked by a Kerr lens mode locking method. Mode locking at 1.436 ${\mu}{\textrm}{m}$was initiated by slightly rocking a mirror mount. But the pulses were very unstable because of the strong water absorption at this region. So we shifted the lasing wavelength to 1.492 ${\mu}{\textrm}{m}$ by using a 3-plate birefringent filter. Then we obtained stable state mode-locking with the maximum average power of 280 mW for a pumping power of 6 W. The pulse width of 43 fs was measured using an autocorrelator and the repetition rate was 104.5 MHz.

• Journal of Advanced Navigation Technology
• /
• v.6 no.1
• /
• pp.52-62
• /
• 2002

Electrical characteristics of two types of 20 GHz Push-Push GaAs MESFET dielectric resonator oscillators having Wilkinson and T-junction power combiners for the output stage have been investigated. The Push-Push oscillator for suppressing fundamental frequency 10 GHz and enhancing 20 GHz has been designed and realized in microstrip configuration on 20 mil thick RT-Duroid(${\varepsilon}_r$=2.52) teflon substrate. Two different types of power combiners, T-junction and Wilkinson, have been considered. Whenever one type of the combiners has been adopted for the output circuit, output power, phase noise and fundamental frequency suppression characteristics of the oscillator have been measured. When the Wilkinson power combiner was used, a maximum output power of 5.67 dBm, a phase noise of -105.5 dBc/Hz at an offset frequency of 100 kHz and a fundamental frequency suppression of -29.33 dBc have been measured. When the T-junction power combiner was used, a maximum output power of -1.17 dBm, a phase noise of -102.2 dBc/Hz at an offset frequency of 100 kHz and a fundamental frequency suppression of -17.84 dBc have been measured.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.1
• /
• pp.69-74
• /
• 2021

This paper introduces a low-power voltage-controlled oscillator(VCO) with filters that consist of resistors and capacitors. The proposed VCO contains a 5-stage current mode buffer, and each buffer cell has a resistor-capacitor filter that connects input and output terminals. The filter adds a zero to the buffer cell. Because the zero moves the oscillation condition to high frequencies, the proposed VCO can generate a high frequency clock with low power consumption. The proposed circuit has been designed with 0.18 ㎛ CMOS process. The power consumption is 9.83 mW at 2.7 GHz. The proposed VCO shows 3.64 pJ/Hz in our simulation study, whereas the conventional circuit shows 4.79 pJ/Hz, indicating that our VCO achieves 24% reduction in power consumption.

• Korean Journal of Optics and Photonics
• /
• v.8 no.1
• /
• pp.52-57
• /
• 1997

We report an investigation of the statistical fluctuations of the two-mode laser output as the asymmetry parameter is varied. The above results relate to computer solutions of the coupled Langevin equations both with and without pumping fluctuations. We find that as the asymmetry parameter is changed positively, the mean intensity of one mode is increased because the normalized intensity auto-correlation is decreased so that the natural dwell time is lengthen. The laser output does respond to a sinusoidally injected asymmetry parameter for small pump parameter.

• Proceedings of the Optical Society of Korea Conference
• /
• 2001.02a
• /
• pp.24-25
• /
• 2001

광 밴드 갭(photonic band gap)을 가지는 광 결정(photonic crystal)을 이용하여 만들어진 미세 공진기(micro-resonator)를 통해 상온 연속 동작하는 레이저가 최근 개발되었다. 이 미세 공진기는 이득매질(gain medium)이 성장된 반도체의 기판방향과 기판에 수직한 방향을 각각 이차원 광 결정과 판 도파로(slab waveguide) 구조의 전반사를 이용하여 제한하는 구조이다 이러한 광 밴드 갭 공진기의 공진 모드는 그 동안 계산적인 방법을 통해 이론적으로 연구되어 왔으며, 직접 모드의 특성을 측정하는 실험의 필요성이 크게 대두되고 있다. 본 연구에서는 광 밴드 갭에 의해 형성된 2차원 미세 공진기내에서 레이저 발진된 모드의 특성을 먼장 영역(far-field regime)에서 측정 분석한 결과를 보고한다. (중략)