• Journal of Astronomy and Space Sciences
• /
• v.19 no.3
• /
• pp.207-214
• /
• 2002

One of the way to derive design parameters of the fuel feeding system in satellite propulsion system is to analyze unsteady flow of liquid propellant (hydrazine). During steady thruster firing the flow rate is constant: if a thruster valve is abruptly shut down among a set of thrusters, pressure spikes much higher than the initial tank pressure occur. This renders the fuel flow unsteady, and the fluid pressure and flow rate to oscillate. If the pressure spikes are high enough, there are possibilities that propellant explosively decomposes, thruster valves we damaged, and adiabatic detonation of the hydrazine propellant is potentially incurred. Reflected shockwaves could also affect the calibration and operation of the pressure transducers. These necessitate the analysis of unsteady flow in the propulsion system design, and pressure behavior inside the propellant line obtained through some governing parameter variation is presented in this work.

• The Korean Journal of Zoology
• /
• v.32 no.3
• /
• pp.275-280
• /
• 1989

Present study examined the endogenous release of luteinizing hormone releasing hormone (LHRH) from superiused hypothalamic sBces derived from Korean native cattie (KNC). In addition, the in vitro secretory pattern of LHRH release in '(NC was compared with that in imported cattle such as Holstein cow. The median eminences (ME) of hypothalamic tissues were disseded out, sliced and quici'ly placed in ice-cold superfilsion chamber. Superhision chambers containing ME slices were maintained in a constant temperature water-bath at 37$^{\circ}C$. Effluents were colleded on ice at 10 min intervals for a 4 hr superfusion period, and kept -2$0^{\circ}C$ prior to LHRH radloimmunoassay. LHRH release was analyzed by the PULSAR algorithm. The spontaneous release of LHRH from both cows was episodic during a 4 hr superhision period. The mean LHRH release, pulse amplitude and pulse interval m KNC were 11.08 $\pm$ 1.50 pg/min/mg x 10-$^2$, 21.43 1 7.28 pg/mg x 10-$^2$, and 39.42 $\pm$ 3.08 min, which were quite similar to those observed in Holstein cows. The basic charaderistics of the LHRH pulse generator of '(NC appears important for a better understanding about the endocrine function of KNC.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.3
• /
• pp.129-135
• /
• 2021

Switched Reluctance Motor (SRM) has a characteristic that the inductance changes very nonlinearly depending on the magnitude of the current and the relative position of the rotor and stator, and the torque is generated In consideration of these problems, many studies have been conducted on a topology for driving that can improve efficiency and performance in an existing asymmetric bridge converter in order to simplify the circuit and economic efficiency. Therefore, in this paper, we want to check the performance by comparing and analyzing each converter used by applying it as a topology for SRM driving. The driving converters applied to the comparison and analysis are Conventional C-dump, Modified C-dump, Energy efficient C-dump, Resonant C-dump converter with C-dump converter type structure and the most widely used asymmetric bridge converter and 6-Switch inverter that used for general motors.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.2
• /
• pp.138-147
• /
• 2009

In this paper, improved direct torque control(DTC) system for five-phase squirrel-cage induction motor(IM) is proposed. Due to the additional degrees of freedom, five-phase 1M drives present unique characteristics. Also five-phase motor drives possess many other advantages compared with the traditional three-phase motor drive system, such as reducing an amplitude of torque pulsation and increasing the reliability. The DTC method is advantageous when it is applied to the five-phase IM, because the five-phase inverter provides 32 space vectors in comparison to 8 space voltage vectors into the three-phase inverter. However, five-phase motor has structural drawback of 3rd space-harmonics current component, it is necessary to controlled 3rd harmonic current. So to control 3rd harmonic current and enhance dynamic characteristics of five-phase squirrel-cage IM drive, modified DTC method should be demanded. The characteristics and dynamic performance of traditional five-phase DTC are analyzed and new DTC for five-phase IM is presented. A more precise flux and torque control algorithm for the drives can be suggested and explained For presenting the superior performance of the proposed direct torque control, experimental results are presented using a 32-[bit] fixed point TMS320F2812 digital signal processor with 2.2[kW] induction motor.

• Clinical and Experimental Pediatrics
• /
• v.49 no.9
• /
• pp.1000-1004
• /
• 2006

Atretic cephalocele is a degenerative form of encephalocele, which is detected as a cystic mass in the head, primarily in infants. Its presentation and prognosis vary and depend on various factors, including the nature of the tissues within the cyst, other concomitant anomalies, the site of development, and the presence or absence of an embryonic straight sinus. We here report 2 cases of atretic encephalocele, that were transferred to our hospital because round tumors, misdiagnosed as dermoid cysts, were detected in their parietal lobes immediately after birth. On diagnostic and differential MRI, an embryonic straight sinus was detected while histochemical results indicated that the lesions contained cerebral tissues. Despite these structural anomalies, the two patients developed normally neurologically and no other anomalies were detected. We here discuss these two cases and present a review of the relevant literature.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.11 no.5
• /
• pp.395-403
• /
• 2006

This paper has proposed a new dead time compensation method for a voltage-fed PMW inverter. In the voltage-fed PMW inverter, a voltage distortion is generated by the dead time effect and the nonlinear characteristics of the switching devices. Especially, the distorted voltage causes 5th and 7th harmonics in the stationary phase currents, and 6th harmonic in the synchronous phase currents. As a result, the integrator output of the synchronous PI current regulator has the ripple corresponding to six times of the inverter output frequency. In this paper, the signal of the integrator output of the d-axis current regulator is used as the control signal for the dead time compensation. The experimental and simulation results are presented to verify the validity of the proposed method.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.26 no.8
• /
• pp.1565-1576
• /
• 2002

By way of driving a 2-way on/off solenoid hydraulic valve with a pulse width modulation (PWM) signal, control of the pressure in a certain volume is frequently used in various applications. However, the pressure built-up according to the duty ratio and carrier frequency of the PWM signal is not so well understood. In order to clarify the characteristics of 2-way valve hydraulic pressure control systems, in this paper two formula fur the mean and ripple of the load pressure were derived through theoretical analysis. And the accuracy of the derived formula were verified by comparison with the experimental test result. Generally 2-way valve systems are constructed as a bleed-off circuit, while 3-way valves are used as a control element in a meter-in circuit pressure control system. In a bleed-off circuit, the system supply pressure from a hydraulic power pack does not remain constant, but changes according to their external load. In turn, the relief valve in the hydraulic power pack reacts accordingly showing complicated dynamic behavior, which makes an analytical study difficult. In order to resolve the problem, simple but accurate empirical dynamic models fer a bleed-off system were used in the course of formula derivation. As the result, selection criteria for two major control parameters of the driving signal is established and the basic strategy to suppress the unnecessary pressure fluctuation can be provided for a hydraulic pressure control system using a 2-way on/off solenoid valve.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.5
• /
• pp.1067-1072
• /
• 2012

Recently, linear motors have been widely researched and have been increasingly used in various industrial applications. Especially, permanent magnet linear synchronous motors(PMLSMs) have been getting the spotlight in the transportation system. A PMLSM is structurally simple and has a lot of merits such as high speed, high thrust force, etc. However, in case of a long stator system which arranges armature to the full length of transportation lines, a PMLSM has some disadvantages such as the material cost increase and long manufacturing time. Hence, in order to overcome these problems, the PMLSM with stationary discontinuous armature structure and concentrated windings was proposed. However, this method occurs undesirable cogging force by outlet edge effect. The cogging force causes thrust force ripples and generates noise and vibration. Therefore, in this paper, we proposed installation method of auxiliary pole PMLSM with concentrated winding applying bifurcating in order to reduce cogging force by the outlet edge when the armature is placed in a discontinuous arrangement. Also, we have examined characteristics of outlet edge cogging force using 2-D finite element analysis(FEA).

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.5
• /
• pp.523-530
• /
• 2013

In this work, we study a heat transfer enhancement technology using fan-shaped small-scale fins. Fins having a thickness of 10 ${\mu}m$ move up-down by a pulsating flow. Owing to these motions, the heat transfer on a surface increases dramatically. The two-way FSI (fluid-structure interaction) method was applied for the analysis, and the analysis model was evaluated using a single fin model by comparing the experimental results. In summary, a maximum 40% increase in heat transfer capacity using a single and multiple small-scale fins was obtained in comparison with the results obtained without using fins. From this work, we believe that the proposed method can be a promising method for heat transfer enhancement in real applications.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.1
• /
• pp.34-40
• /
• 2006

This paper proposed power system for new DC 49[V] telecommunication using forward three-phase PWM rectifier power factor and efficiency for improvement of ripple voltage. Proposed power system for DC 48[V] telecommunication that consists of power conversion devices including switch, inductor and condenser were made between each line, in power inverter device of each switch control turn-on in period of continuity time control to get power factor '1' of sine wave current and on-off of switch lessens peak current that was happened and got conversion efficiency 92.1[%] composing in PWM rectifier of forward form instead of general PWM rectifier. Also, harmonic input regulation value(IEC61000-3-2 Class-As) satisfy input current and reduce ripple factor of output voltage in state that distortion of three-phase supply is overlapped each other.