• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.124-131
• /
• 2014

This paper describes a design of an adaptive baseband modem based on TDMA(time division multiple access) with a relay protocol function for wireless personal area networks. The designed baseband modem is controlled by a master synchronization signal and can be configured a relay network up to 14 hops. For efficient data relay communications, the internal buffer design is optimized by implementing a priority memory bus controller to a single port memory. And the priority memory bus controller is also designed to minimize the number of synthesized logic gates. To implement the synchronization function of the narrowband TDMA relay communication, the number of gates has been reduced by dividing the frame synchronization circuits and the network slot synchronization circuits. By using these methods, the number of gates are used about 37%(34,000 gates) on Xilinx FPGA XC6SLX9 which has 90,000 gates. For the 1024-bit frame size with a 32-bit synchronization word, the communication reception rate is 96.4%. The measured maximum transmission delay of the designed baseband modem is 230.4 msec for the 14-hop relay communication.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.1
• /
• pp.259-266
• /
• 2013

Since the wireless communications have a limited transmission, the devices just around a master node can exchange data. Though Bluetooth and Zigbee support ad hoc, they are not appropriate for real-time voice communications. In this paper, we present a TDMA-based relay protocol for several users to communicate simultaneously. The proposed protocol can relay data or voice to other nodes in real-time by the multi-hop transmission method using TDMA. And the proposed protocol improves the network performance by allocating different frequencies to the slaves depending on the routing path scheduled by the routing table. NS-2 simulation shows that the performance of the proposed protocol is good in terms of the transmission delay and pecket loss probability in the real-time voice transmission.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2004-2010
• /
• 2009

The characteristic of the backbond for distribution service in WMNs(Wireless Mesh Networks) is that WMNs has multiple links connected to mesh points and dynamic routing protocol such as AODV to establish routing paths. When the terminal is communicating with the service through new AP, mobile nodes can resume communication by setting only the link between new AP and mobile node in the case of existing WLANs, but WMNs needs path establishment process in multihop networks. Our goal in this paper is to support the seamless communication service by eliminating path establishment delay in WMNs. We present the method that eliminates the handover latency by predicting the location of handover using GPS information and making the paths to their destination in advance. We implement mesh nodes using embedded board that contains proposed handover method and evaluate performance of handover latency. Our experiment shows that handover delay time is decreased from 2.47 to 0.05 seconds and data loss rate is decreased from 20~35% in the existing method to 0~10% level.

• Journal of KIISE
• /
• v.42 no.6
• /
• pp.791-800
• /
• 2015

In this paper, we propose the contribution-level-based opportunistic flooding in a wireless multihop network which achieves outstanding transmission efficiency and reliability. While the potential of the the predetermined relay node to fail in its receipt of broadcast packets is due to the inherent instability in wireless networks, our proposed flooding actually increases network reliability by applying the concept of opportunistic routing, whereby relay-node selection is dependent on the transmission result. Additionally, depending on the contribution level for the entire network, the proposed technique enhances transmission efficiency through priority adjustment and the removal of needless relay nodes. We use the NS-3 simulator to compare the proposed scheme with dominant pruning. The analysis results show the improved performance in both cases: by 35% compared with blind flooding from the perspective of the transmission efficiency, and by 20~70% compared to dominant pruning from the perspective of the reliability.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.4
• /
• pp.68-75
• /
• 2016

As the number of cores and IPs increase in multiprocessor system-on-chip (MPSoC), network-on-chip (NoC) has emerged as a promising novel interconnection architecture for its parallelism and scalability. However, minimization of the latency in NoC with legacy bus IPs must be addressed. In this paper, we focus on the latency minimization problem in NoC which accommodates legacy bus protocol based IPs considering the trade-offs between hop counts and path collisions. To resolve this problem, we propose separated address/data network for independent address and data phases of bus protocol. Compared to Mesh and irregular topologies generated by TopGen, experimental results show that average latency and execution time are reduced by 19.46% and 10.55%, respectively.

• Journal of KIISE:Computing Practices and Letters
• /
• v.14 no.4
• /
• pp.352-362
• /
• 2008

In the mobile ad hoc network, network nodes are continuously capable of movement, but have battery limitations and these characteristics of MANET cause network link failure. Therefore, when performing ubiquitous services with the application of MANET, a technique is required to improve the packet transmission rates as to enable continuous packet transmission while flexibly adapting to topology changes caused by the mobility of nodes. In this paper, we are proposing PAOMDV(Possibility based AOMDV) and OLSR-ME(OLSR with Modified Energy Efficiency) which are mixed-type protocols to solve the problem for design a more efficient protocol. Especially by classifying mobile ad hoc networks as clusters, OLSR-ME protocol is implemented on communication within the clusters, while PAOMDV is used in protocols between clusters. In addition, a selection algorithm for forwarding nodes that responding packet relays in the case of increased hops was proposed for designing a more efficient protocol than existing protocols. We verified the performance of the proposed protocols through a comparative experiment with AODV, AOMDV, ZRP, and the existing protocols. We confirmed the results of the experiment revealed that the proposed protocol had the best packet transmission rate, the shortest delay between nodes, and showed better results in routing overhead.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.9
• /
• pp.1665-1671
• /
• 2007

Mobile Ad hoc Networks (MANETs) refer to autonomous networks in which wireless data communications are established between multiple nodes in a given coverage area without a base station or centralized administration. Because of node mobility and limited battery life, the network topology may changes frequently. Selecting the most reliable path during route discovery process is important to improve performance in ad-hoc networks. In this study, we proposed an enhanced routing protocol based on AODV by monitoring variation of receiving signal strength. New metric function that consists of node mobility and hops of path is used for routing decision. From extensive experiments by using NS-2, The performance of the proposed routing scheme has been imp개ved by comparison to AODV protocol.

• Journal of KIISE:Information Networking
• /
• v.35 no.6
• /
• pp.521-528
• /
• 2008

Such conventional maritime communication technologies as radio have short some comings in their transmission quality. It can be overcome by wireless channels provided by satellites such as INMARSAT, which nevertheless suffer from the high costs. In this paper, we propose a novel technology resolving the above problems, featuring in the establishment of maritime communication networks with multi-hop structures. The inter vessel and ship-to- shore networks previously modeled after MANET are remodeled by SANET (Ship Ad Hoc Networks) in the present work. Fan-shaped Search Zone Routing (FSR) protocol also is presented, which utilizes not only static geographical information including the locations of ports and the navigations of courses but also the unique characteristics of ships in terms of mobile nodes. The FSR finds the fan-shaped search zone on which the shortest path is located. The performance of LAR protocol is compared with that of FSR in several ways. First, FSR does not make use of a type of control packets as beaconing data, resulting in a full utilization of the bandwidth of the wireless channels. Second, the delivery rate by the FSR is 100% for the fan-shaped search zone includes at least one route between source and destination nodes on its border line, where as that of LAR has been turned out to be 64%. Third, the optimality of routes searched by the FSR is on a 97% level. Of all, the FSR shows a better performance than LAR by about 50%.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.1
• /
• pp.275-281
• /
• 2012

Community network is a communication environment where heterogeneous devices can access and communicate with each other at any time and at any space to share information. To do so, mobile devices are required to be self-configured even in absence of communication infrastructures. Semi-infrastructured wireless ad-hoc network is a promising solution to meet with such a requirement. This paper proposes the VTC(virtual topology coordinator) system as an evaluation tool for examining network protocols that are intended to be deployed in the semi-infrastructured ad-hoc networks. VTC emulates multi-hops wireless network topology virtually using a mechanism of selective receiving MAC frame in a small area, where only a single hop communication is available. VTC system cannot consider all properties introduced in real wireless network, but do more wireless properties than verification through simulation.

• Journal of Digital Convergence
• /
• v.12 no.1
• /
• pp.339-345
• /
• 2014

This study has a purpose that improves efficiency of energy management and adaptation followed by movement of node better than the various early studied routing techniques. The purpose of this paper is the technique that uses RSSI value and location of sensor that is received by each sensor node to routing. This sduty does not save node information of 1-hop distance. And it solves energy-inefficient traffic problem that happens during data exchange process for middle node selection in close range multi hop transmission technique. The routing protocol technique that is proposed in this study selects a node relevant to the range of transmission which is set for RSSI value that is received by each node and selects the closest node as a middle node followed by location data. Therefore, it is for not exhaustion of node's energy by managing energy efficiently and cutting data transmission consuming until the destination node.