• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.6
• /
• pp.1053-1058
• /
• 2021

This paper presents the multi-band mixer which converts a X-, K- and Ka-band adaptively by adjusting the gate-bias voltage of an active device. The proposed mixer presented a conversion loss of -10 dB at -0.8 V gate-bias voltage for X-band, a conversion loss of -9 dB at -0.3 V gate-bias voltage for K-band and for Ka-band, a conversion loss of -7 dB at -0.2 V gate-bias voltage under the LO power of +6.0 dBm. The 1dB compression point (P1dB) is +0.5 dBm for all band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.1
• /
• pp.48-58
• /
• 2012

New digital predistortion technique is proposed for power amplifier linearization in multi-band transmission systems. We consider a system where muli-band signals are combined and amplified by a single power amplifier (PA). In this system, the PA output is distorted by the nonlinear cross-products between different band signals as well as their own nonlinear self-products. To compensate these nonlinear effects, we propose a multiple PD structure. Each PD removes the nonlinear cross-products and self-products to mitigate the spectral regrowth for the corresponding band. Since the PD parameters for different bands are linked together, it is difficult to find the PD parameters separately. Thus, we propose an iterative method for finding the PD parameters jointly. For demonstration of the proposed method, multi-band characteristics of PA are extracted from a commercial power amplifier. Computer simulation was executed based on the PA parameters. The simulation results show that the proposed method can effectively linearize the PA and remove spectral regrowth at each signal band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.12
• /
• pp.2615-2621
• /
• 2010

The multi-band six-port phase correlator using metamaterial was designed and fabricated in this paper. The lumped metamaterial structure that can process the dual-band receiving signal was analyzed. Based on the analyzed results, the small-sized metamatrial six-port phase correlator for multi-band direct conversion method was proposed and fabricated. Also, the resistive power divider and $90^{\circ}$ hybrid coupler that comprises the six-port phase correlator were implemented based on the scattering parameters of metamatrial six-port phase correlator. The measured results of the proposed six-port phase correlator show the good agreement with simulation results. The performance of the six-port phase correlator shows the reflection loss below -20 dB in the dual-band. Also, the proposed six-port phase correlator got a good transmission characteristic within 1 dB gain difference and ${\pm}4.1^{\circ}$ phase imbalance, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.6
• /
• pp.895-906
• /
• 1993

In this paper, MTSVQ(Multirate Tree-Structured Vector Quantization) is introduced for subband image coding. Original images are decomposed into a number of subband components, and multiresolution codebook is designed by MTSVQ algorithm. Optimal bit allocation among the subband components becomes the problem selecting the particular pruned subtree of MTSVQ which has the desired rate and distortion.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.1
• /
• pp.23-28
• /
• 2016

In this paper, a Multi-Band Ku-band down converter was designed for reception of multi-band digital satellite broadcasting. The Multi-band low-nose down converter was designed to form four local oscillator frequencies (9.75, 10, 10.75 and 11.3GHz) representing a low phase noise due to VCO-PLL with respect to input signals of 10.7 to 12.75GHz and 3-stage low noise amplifier circuit by broadband noise matching, and to select an one band of intermediate frequency (IF) channels by digital control. The developed low-noise downconverter exhibited the full conversion gain of 64dB, and the noise figure of low-noise amplifier was 0.7dB, the P1dB of output signal 15dBm, and the phase noise -73dBc@100Hz at the band 1 carrier frequency of 9.75GHz. The low noise block downconverter (LNB) for receiving four-band digital satellite broadcasting designed in this paper can be used for satellite broadcasting of vessels navigating international waters.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.4
• /
• pp.983-990
• /
• 2010

In this paper, we designed and implemented the MIMO antenna for LTE(Long Term Evolution), supposed to be a next generation communications network, DCS1800, DCS1900 and WCDMA. Using conventional monopole antenna with MD material results in good characteristics, miniaturization for LTE band and as well as broadbanding for DCS, WCDMA band. The performance of the proposed MIMO antenna shows VSWR < 2, under -10 dB of isolation and the gain is -1.66 ~ 1.33 dBi for LTE(Long Term Evolution), DCS1800, DCS1900 and WCDMA, which has omnidirectional radiation pattern.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.10
• /
• pp.2194-2200
• /
• 2010

In this paper, the power detectors using metamaterials were designed and fabricated for multi-band six-port direct conversion method. The RF short-stubs for power detector were designed by using metamaterials which provide multi-band characteristics. The power detectors with metamaterial RF short-stub were analyzed and fabricated by using lumped and distributed element. The measured results of metamaterial power detectors show the good agreement with the simulation results. The performance of lumped-metamaterial RF short-stub shows the insertion loss below 1 dB and the good frequency response characteristics. Also, the distributed-metamaterial RF short-stub shows the good frequency response characteristics and the insertion loss under that of lumped-metamaterial RF short-stub. The multi-band power detectors with metamaterial RF short-stub detect the input RF signal in the designed dual frequency bands very well.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.12
• /
• pp.718-728
• /
• 2014

The multi-band wireless local area network (WLAN) using 60 GHz band and the lower band (typically 2.4 GHz/5 GHz band) can support the very high data rate in short-distance communication using 60 GHz band and the long-distance communication using the lower band. For heightening the efficiency of multi-band WLAN, an band selection scheme is a necessity. In this paper, we propose an effective frequency band selection scheme for multi-band WLANs. By using computer simulation with NS-3, we show the performance of the proposed schemes when the stations suffer from the human blockage and the log-normal shadowing.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1995.06a
• /
• pp.211-215
• /
• 1995

명료하고 자연스러운 한국어 음성을 생성하기 위하여 다중대역 여기신호를 이용한 음성 합성 시스팀을 제안한다. 분석계에서는 켑스트럼 파라미터를 사용하여 유성/무성 판별 스펙트럼을 이용한 유/무성 구간 자동판별법을 제안하고, 현재 단순 임펄스와 백색잡음만으로도 구성된 음원과 간단한 유성/무성 판별로 구동되어지는 합성음의 음질상의 한계를 개선하기 위하여 합성계에서는 음질개선 방안으로 유성음 구동시 다중대역 여기신호를 도입하여 합성시 이용한다. 제안된 방법에 대한 청취실험을 한 결과, 유성음 부분 특히 잡음이 많이 섞여 있는 유성음화 마찰음과 모음의 천이부분 등에서 일반적으로 사용되고 있는 간단한 유성/무성 파라미터를 사용한 합성음에 비하여 다중대역 여기신호를 사용한 합성음의 명료도가 매우 우수함을 확인하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.4
• /
• pp.772-779
• /
• 2015

In this paper,a reconfigurable multi-band mobile antenna with switching line for LTE band 13, GSM, K-PCS, WCDMA band. The proposed antenna is planar strip line design and composed of stub shorted to the ground plane and two switching line for proposed band operation. To obtain the optimized parameters, we used the simulator, Using the obtained parameters is fabricated. The numerical and experiment results demonstrated that the proposed antenna satisfied the -6 dB impedance bandwidth requirement while simultaneously covering when the state of sw1 and sw2 on for LTE band 13, the state of sw1 off and sw2 on for GSM, K-PCS, the state of sw1 off and sw2 off for WCDMA. Respectively and characteristics of gain and radiation patterns are determined for a reconfigurable multi-band mobile terminal.