• Journal of the Korean Institute of Telematics and Electronics
• /
• v.9 no.5
• /
• pp.27-33
• /
• 1972

This paper describes the computer-aided design, fabrication and performance of high Q and high gain active filters suitable for microminiaturization in the frequency range of 10-800MHz, based on the negative resistance operation of a transistor. 48 as high as 1000 and a transducer gain as high as 35dB can readily be obtained with a single-transistor amplifier and with an inductance as small as a few nH at higher frequencies and 150 nH at lower frequencies in tile above frequency range. The gain of the proposed active filter can be stoabilized within $\pm$ 1.5 dB over the temperature range -1$0^{\circ}C$ to +5$0^{\circ}C$ and the temperature dependence of the center frequency is tapicalla 50ppm/$^{\circ}C$. An experimental FM receiver utilizing these fitters and operating at a carrier frequency of 92 MH3 was built. The whole circuit was fabricated on eight alumina substrates of by the thick-film hybrid IC technique and the coils are constructed, for miniaturization, in a spiral form of 3 or 4 turns of enamel copper wire with an overall diameter of about 5mm. The test results are also reported in this paper.

• Annual Conference of KIPS
• /
• 2003.05c
• /
• pp.2161-2164
• /
• 2003

현재 사용되고 있는 침입 탐지 시스템들은 새로운 공격 패턴을 가진 침입을 탐지하기 위하여 규칙 데이터베이스를 지속적으로 갱신하고 있다. 그러나 이러한 침입 탐지 능력은 현재 알려진 기술이나 기법들에 한정된다. 따라서, 기존침입 탐지 시스템들은 공격을 받은 후, 현재까지 존재하지 않았던 새로운 기법이 적용된 공격이나 다소 변형된 공격을 받게 되면 침입을 탐지하지 못하거나 능동적 대처를 하지 못하였으며, tcpdump 또는 libpcap과 같은 응용 레벨의 프로그램을 사용하였기 때문에 실시간으로 패킷들을 감시할 수 없었다. 이러한 추가적인 공격들을 탐지하기 위해서 보다 강력하고 능동적인 네트워크 기반의 대응 기술이 요구되는데, 이에 본 논문에서는 이러한 요구 사항을 해결하기 위하여 패킷 감시의 정확성과 침입에 대한 실시간 대응성을 높이는 커널 레벨에서 동작하는 침입 탐지 모듈과, 악의적인 목적을 가진 패킷들을 차단하는 필터링 모듈 개발 기법을 제시하고자 한다.

• Korean Journal of Optics and Photonics
• /
• v.11 no.5
• /
• pp.353-359
• /
• 2000

A harmonically mode-locked fiber ring laser cavlty was theoretically analyzed. The measured charactenstlcs of a 10 GHz erbium-doped fiber ring laser were used as a basis of the theoretical analysis. From the nonlinear Schroedinger equation of an actively mode-locked erblUm-doped fiber laser. the effects of the components inside the laser cavity have been analyzed includmg nonlinear effects from group-velocity dispersion (GVD) and self-phase modulation (SPM). Usmg the analysls. we have designed a laser cavity with minimum pulsewidth and chirp by changing the intracavity optical intensity and the bandwidth of the filter. In the new design, the chirp i, reduced by 2 times and the pulsewidth by 2A times. compared to the laser used in the experiment. iment.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.2
• /
• pp.227-232
• /
• 2015

Nowadays, there are many innovative products in the pro-audio market thanks to advanced IT technology, DSP is very important technology to process high quality audio signal in SR(Sound Reinforcement) system. Digital audio technology that converged with IT technology can give new user-experience. In this paper, we present a new digital crossover system for active speakers using DSP and network technology. The prototype of crossover module consists of various audio process module such as filters, delay, phase controls and also it provides user to remote monitoring and remote control features by internet connection.

• Proceedings of the KAIS Fall Conference
• /
• 2004.06a
• /
• pp.193-197
• /
• 2004

The four-leg Voltage Source Converter(VSC) can use the DC link voltage effectively by the 3-D SVPWM method. Hence the DC battery voltage can be reduced by $15\%$ in comparison to that of the conventional line-interactive UPS system. In this paper a novel line interactive Uninterruptible Power Supply(UPS) using the two four-leg VSCs is proposed. One VSC is in parallel with the ac link reactor of the power source side, and the other is in series with the load. The parallel four-leg voltage source inverter controls the three-phase line voltage independently in order to control the line reactor current indirectly. It eliminates the neutral line current and the active ripple power of the source side using the pqr theory so that unity power factor and the sinusoidal source current can be achieved even though both the source and the load voltages have zero sequence components. The series four-leg voltage source inverter compensates the line voltage and allows it to be balanced and harmonic-free. Both of the parallel and series four-leg voltage source inverters always act as independently controllable voltage sources, so that the three-phase output voltage shows a seamless transition to the backup mode. The feasibility of the proposed UPS system has been investigated and verified through computer simulations results.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.1
• /
• pp.99-104
• /
• 2013

In this paper, we developed a fully integrated downconverter MMIC (monolithic microwave integrated circuit) including Lange coupler and output active balun for millimeter wave applications. Concretely, ${\lambda}$/4 transmission line was added to Lange coupler for size reduction of RF/LO input, and mixed RF/LO signals were applied to gate of the FET of mixer. Active balun was used at output port for a coupling of out-of-phase IF output signals. According to measured results, the proposed downconverter MMIC showed good RF performances. For example, the downconverter MMIC showed an LO leakage power of -25 dBc at IF output port, and a RF-LO isolation of 18 dB. Therefore, off-chip components such as LO rejection filters were not required for a normal operation of the proposed downconverter MMIC. The proposed downconverter MMIC showed a conversion gain of 10.3 dB at RF frequency of 63 GHz. The size of the downconverter MMIC including all active and passive components was $2.2{\times}1.4mm^2$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.4
• /
• pp.707-714
• /
• 2016

Active driving safety systems for vehicle, such as the front collision avoidance, lane departure warning, and lane change assistance, have been popular to be adopted to the compact car. For improving performance and competitive cost, FMCW radar has been researched to adopt a phased array or a multi-beam antenna, and to integrate the front and the side radar. In this paper we propose several efficient methods to implement the signal processing module of FMCW radar system using low cost DSP. The pulse width modulation (PWM) based analog conversion, the approximation of time-eating functions, and the adoption of vector-based computation, etc, are proposed and implemented. The implemented signal processing board shows the real-time performance of 1.4ms pulse repetition interval (PRI) with 1024pt-FFT. In real road we verify the radar performance under real-time constraints of 10Hz update time.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.10
• /
• pp.629-636
• /
• 2016

This study presents the development of an acid resistance velocity sensor that is used for measuring velocity inside a copper sulfate plating bath. First, researchers investigated the acid resistance coating to confirm the suitability of the anti-acid sensor in a very corrosive environment. Then, researchers applied signal processing methods to reduce noise and amplify the signal. Next, researchers applied a pressure-resistive sensor with an operation amplifier (Op Amp) and low-pass filter with high impedance to match the output voltage of a commercial flowmeter. Lastly, this study compared three low-pass filters (Bessel, Butterworth and Chebyshev) to select the appropriate signal process circuit. The results show 0.0128, 0.0023, and 5.06％ of the mean square error, respectively. The Butterworth filter yielded more precise results when compared to a commercial flowmeter. The acid resistive sensor is capable of measuring velocities ranging from 2 to 6 m/s with a 2.7％ margin of error.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.4
• /
• pp.354-360
• /
• 2013

In this paper, it is discussed that the detection and tracking performance of the piecewise linear path underwater target is improved using clutter reduction algorithm in heavy clutter density environment. Through clutter reduction algorithm using Hough Transform, measurements which represent clutter features are removed and the performance of target tracking on the remaining measurements is demonstrated applying CMKF-L(Converted Measurement Kalman Filter with Linearization) as tracking filter. Algorithm performance test is conducted using simulation data and real sea-trial data and by applying the proposed algorithm in heavy clutter density environment, it is confirmed that the target is tracked consistently and stably with clutter rejected measurements.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.16 no.2
• /
• pp.1-7
• /
• 2007

Active magnetic bearing has been adopted to support the rotor by electomagnetic force without mechanical contact and lubrication process. A property of the control system for magnetic bearing is improved in accordance with making higher system gain. If the control system has integral part, an excessive overshoot response is shown by making higher integral gain. Therefore, this paper suggests a PID control system in order to eliminate the overshoot at the first stage and improve response characteristics to an impact disturbance at the status of levitation. The control gain was obtained by LQR design method which has the structure of I-PD control system in the state space. The PID control system containing prefilter has the same structure as the I-PD control system. Therefore, the PID control system adopted is able to be tuned by LQR design method. Finally, this paper shows the effect of the prefilter on the active magnetic bearing system through response experiments for levitation responses.